不同生产阶段产生的压电陶瓷废品对氯化丁基橡胶阻尼减振性能的影响

将压电陶瓷生产过程中不同生产阶段产生的废品应用于氯化丁基橡胶阻尼减振材料，并比较了它们对阻尼减振性能的影响。     

UV/Fenton法预处理橡胶促进剂生产废水

采用UV／Fenton法对橡胶促进剂废水进行预处理。当原水COD约为3000mg／L时，COD去除率可达65％以上，并得到最佳操作条件为：H2O2投加量为8mL／L，Fe^2＋投加量为0．8g／L，反应时间为30rain，pH=5；同时得到Fenton试剂处理该废水的最佳条件为：H2O2投加量为10mL／L，Fe^2＋投加量为0．966g／L，反应时间为30min，pH=5；单独UV作用的最佳工艺条件为：反应时间为20min，pH=5；并就3种处理方法进行了比较，发现UV对Fenton试剂处理橡胶促进剂废水具有一定促进作用。反应前后的紫外光谱说明，经UV／Fenton或Fenton反应后原水中的苯胺、硝基苯等物质已得到了彻底的氧化分解。     

白炭黑补强氟硅橡胶热空气老化机理研究

目的研究热空气老化过程中白炭黑补强氟硅橡胶的老化机理。方法开展不同加速老化温度点下白炭黑补强氟硅橡胶热空气老化试验,对老化过程中材料的力学性能进行研究,同时采用热重分析、衰减全反射红外光谱、交联密度分析以及固体核磁等技术,对200℃热空气老化过程中材料的微观结构变化进行分析。结果低温环境中白炭黑氟硅橡胶拉伸强度和扯断伸长率变化较小,高温环境中变化趋势增大,邵尔A硬度在整个老化过程中没有明显变化。结论白炭黑补强氟硅橡胶的老化机理主要是交联键的断裂和侧链三氟丙基的分解,同时还可能伴随有部分主链的破坏。     

橡胶林在间种砂仁与咖啡的模式下土壤微生物生物量

探讨了橡胶与砂仁、橡胶与咖啡间种和纯橡胶林3种栽培模式下的土壤微生物生物量及其与土壤有机碳和土壤微生物呼吸强度的关系。结果表明,在这3种模式下,土壤微生物生物量平均值由高到低的顺序为:橡胶 砂仁林地>纯橡胶林>橡胶 咖啡林地。其Cmic范围是380.8~568.3 mg/kg。橡胶 咖啡林地土壤微生物生物量在旱季高于雨季,而其余两种林地则在雨季较高。橡胶林间种作物后,林地土壤表现出比纯橡胶林地有较高的土壤微生物生物量和较短的土壤微生物的转化周期,年转化代数较多;同时,间种也大大改善了林内生态环境。     

Bacteria Associated with Degradation of Wastes from Rubber Processing Industry

An investigation of bacteria found in rubber processing wastes was carried out. Rubber wastes which include effluents from washing tanks and natural rubber waste serum (NRWS) were obtained from Greenpark Rubber Industries Limited, Umutu, Delta State, Nigeria. Five bacterial species were isolated from the wastes. These include Arthrobacter sp., Bacillus sp., Lactobacillus sp., Psuedomonas sp. and Streptococcus sp. Apart from these a number of coliforms were also encountered. Arthrobacter sp. was found to be the dominant species and its potential to utilize rubber hydrocarbon was determined. It was found that the growth of Arthrobacter in both effluent and NRWS was related to pH with the highest growths recorded at pH of 8.5 and 7.5 for effluent and NRWS respectively. It was also found that at controlled pH of 7.5 in NRWS, the growth of Arthrobacter was consistent and was accompanied by a reduction in biological oxygen demand (BOD) which was the the main index for measuring pollution strength of the wastes. It is therefore being recommended that rubber wastes be treated with Arthrobacter under controlled pH to reduce their pollution potentials before disposal. It is however suggested that a combined biological treatment using both Arthrobacter and Mucor as was earlier suggested be used. It is also recommended that chemical flocculants should be used to remove suspended solids in the effluent. A combination of these two cheap methods will go a long way in alleviating the problems of pollution caused by rubber effluents from some tropical rubber processing factories.     

Plankton filtration with compressible crumb rubber packs

The experiments described provide insight into the feasibility of using compressible particulate packs to filter live plankton. The pore constriction sizes are controlled by subjecting the filter pack to isotropic confinement, thereby allowing for: (1) enhanced filtration upon confinement and (2) enhanced unclogging upon relaxation. Results show that filtration efficiency increases with increasing confinement; however, complete plankton retention is difficult to attain due to the plankton’s ability to pass through pore constrictions that are smaller than the plankton size. The results are anticipated to offer potential benefits to ballast treatment and aquatic filtration operations.     

微波辐照活性炭/铁屑处理橡胶促进剂生产废水

通过微波辐照活性炭与废铁屑的混合物处理橡胶促进剂生产废水。考察了炭铁混合物投加量、炭铁质量比、废水初始pH值、微波功率和微波辐照时间等对废水COD去除率的影响。结果表明,工艺的最佳参数为:炭铁混合物投加量65 g/L,炭铁质量比2∶1,微波功率200 W,微波辐照5 min,此条件下的废水COD去除率为76%;反应的表观过程近似符合一级动力学规律,动力学方程为:ln(C0/C)=0.1012t+0.8887,速率常数k=0.1012 min-1,半衰期t1/2=6.85 min;橡胶促进剂生产废水的微波辐照活性炭/铁屑处理工艺比单纯微波辐照及活性炭/铁屑处理工艺有明显的优越性。     

我国废旧橡胶综合利用的现状及发展建议

随着我国橡胶资源消耗量的增大和废旧橡胶总量的增多,正确合理地引导扶持废旧橡胶综合利用产业已成为不容忽视的问题。本文介绍了废旧橡胶综合利用的主要途径,分析了我国废旧橡胶的综合利用现状,提出了废旧橡胶综合利用的发展建议。     

防屈曲支撑的有限元模拟及滞回性能分析

结合防屈曲支撑拟静力实验的研究成果,本文采用有限元软件ABAQU S对其进行了数值模拟分析。在模拟过程中,应用金属Com b ine本构模型设置内芯钢板材料属性。该模型是对传统双线性本构模型的改进,模拟结果很好地符合了实验结果,同时验证了防屈曲支撑具有良好的减震耗能性能,其在轴向加载达到7倍屈服位移时,依然能保持良好的滞回特性。通过对模型中橡胶无粘结层的合理设置,研究了内芯钢板在失稳变形中无摩擦滑移与能量缓冲转化的形变特点。分析表明,当外包约束强度和刚度足够时,内芯钢板在受轴向压力时只发生多波微幅弯曲失稳;随着内芯钢材与外包有效约束间隙的增大,支撑的失稳波幅也随之增大,支撑承载力与耗能能力显著降低。     

椰糠填料用于人工湿地处理制胶废水

以椰糠作为湿地工作层主要填料,采用复合垂直流人工湿地处理海南天然橡胶加工业低浓度废水。结果表明,在144 mm/d水力负荷条件下,椰糠填料人工湿地对废水中的COD、BOD5、NH3-H及TP的去除率分别达到68.99%、66.49%、59.55%和75.22%,显著高于无椰糠对照组。当水力负荷提高至216 mm/d,系统运行稳定,出水水质仍能达到污水排放标准(GB 8978-1996)和《农业灌溉水质标准》(GB5084-92)。