电除尘器船型灰斗内部粉尘在停机后的温度研究

本文以土耳其SILOPI 2#机电除尘器为工程分析对象,对燃煤电厂电除尘器船型灰斗内的粉尘在停机后的温度变化情况进行分析计算和有限元模拟,通过粉尘随时间的温度变化数据判断粉尘的凝结情况,得出该项目在最低气温-9.3℃环境下,119小时内船型灰斗不会因粉尘凝结而发生严重堵塞情况,模拟结果与实际一致。本文为工程上电除尘器因故停机的检修提供时间参考。     

祁连山老虎沟12号冰川积雪中飞灰颗粒物的特征

冰川积雪中的飞灰颗粒物可指示由大气沉降的人类活动污染物.本研究基于2012年6月在青藏高原东北缘的祁连山老虎沟12号冰川夏季野外观测取样、实验室扫描电子显微镜与X射线能谱仪联用系统(SEM-EDX)分析了积雪粉尘中球形颗粒物的特征信息,以弄清冰川区沉降的球形飞灰颗粒物的理化特征及其环境意义.结果表明,在所选取的雪层不同深度的9个积雪样品中,都存在着一定数量的飞灰颗粒,这些颗粒物通常是人类生产活动中的化石燃料高温燃烧所形成的.基于EDX能谱分析了飞灰颗粒物的化学元素成分组成,认为沉积在祁连山冰川积雪中的飞灰主要分为3种类型,分别为"富Si类"、"富Fe类"和"富Ti类"颗粒物.总体上,"富Si类"和"富Fe类"颗粒占了球形飞灰颗粒的绝大部分.这些不同组分的飞灰代表了污染物的不同生产活动来源,其平均粒径要相对大于雪层中自然来源的所有矿物粉尘颗粒物,反映了大气传输远距离中密度对粉尘颗粒的重要性.结合NOAA Hysplit气团后向传输轨迹分析认为,中亚地区和我国新疆地区城市、及研究区周边的工业燃烧物通过大气传输是祁连山老虎沟12号冰川积雪中飞灰颗粒的主要可能来源.     

秸秆烟尘和灰烬中元素碳的稳定同位素组成

选取稻草、麦草和玉米秸秆各6个品种,进行室内模拟焚烧试验,用同位素质谱计测定了灰烬和烟尘中元素碳(EC)的同位素比值.结果表明,稻草明火和闷烧烟尘中EC的δ13C平均值分别是-28.3‰、-28.7‰,比稻草总碳分别轻2.7‰、3.0‰.麦草明火和闷烧烟尘中EC的δ13C平均值分别为-28.5‰、-28.0‰,比麦草总碳分别轻0.1‰、重0.4‰.玉米秸秆明火和闷烧烟尘中EC的δ13C平均值分别为-17.2‰、-13.6‰,比秸秆总碳分别轻3.4‰、重0.2‰.在稻草明火和闷烧灰烬中,EC的δ13C平均值分别是-27.5‰、-27.3‰,比稻草总碳分别轻1.8‰、1.6‰.在麦草的明火和闷烧灰烬中,EC的δ13C平均值分别为-27.4‰和-26.0‰,比麦草总碳分别重0.9‰和2.4‰.在玉米秸秆的明火和闷烧灰烬中,EC的δ13C平均值分别为-15.0‰和-14.8‰,比玉米秆总碳分别轻1.2‰和1.0‰.3类秸秆,尤其是稻草和玉米秸秆,其烟尘和灰烬中的EC均发生了明显的同位素分馏.其同位素组成对于识别和估算大气气溶胶中此类秸秆燃烧来源的EC有参考意义.     

TiO2/粉煤灰光催化降解双氯芬酸钠研究

以燃煤电厂外排的废弃物粉煤灰(CFA)为载体,采用混合泥浆法将TiO2负载在CFA的表面,得到一种新型的复合光催化剂TiO2/CFA.对TiO2/CFA进行了扫描电镜分析、X射线衍射分析和氮吸附测试,并以双氯芬酸钠的光催化降解为评价手段,研究了TiO2负载量对TiO2/CFA光催化性能及重复使用性能的影响.结果表明,TiO2负载量的增加有助于提高TiO2/CFA的光催化性能,但当TiO2负载量过高时,CFA上的TiO2在水处理过程中容易脱落,对TiO2/CFA光催化剂的重复使用性能不利.本研究中,最佳的TiO2负载量约为50%,循环使用6次,其光催化降解效率没有明显降低,双氯芬酸钠的降解率均可达70%以上.     

中国危险废物和医疗废物焚烧处置行业二（口恶）排放水平研究

通过调研全国危险废物和医疗废物焚烧处置设施,对包含二噁英排放水平的设施按处置对象、炉型和处理量分类,并作系统分析和研究.结果表明现有危险废物焚烧设施烟气中二噁英的浓度比医疗废物低,达标率为74.19%;危险废物选用回转窑处置效果较好,达标率为66.67%;而医疗废物选用回转窑或热解炉,要综合考虑处置规模、生产成本和二英排放总量等因素;危险废物介于10~30 t·d-1和医疗废物介于10~20 t·d-1的处置设施要尤其注意二噁英的排放问题;医疗废物焚烧飞灰中二噁英的均值浓度为危险废物6倍以上,仅有16.67%满足填埋要求.二者烟气中二英的浓度分布以1,2,3,4,6,7,8-HpCDF、2,3,7,8-TCDF和OCDD为主.     

粉煤灰负载Fe2O3脱除气态单质汞的试验研究

在固定床反应器中研究了利用燃煤电厂固废粉煤灰(FA)负载Fe2O3所制备的Fe2O3/FA催化剂对气态Hg0的脱除情况,发现Fe2O3/FA具有较高的脱除Hg0的能力.同时,考察了Fe2O3负载量、温度、空速、Hg0浓度、烟气成分等对Fe2O3/FA脱除Hg0的影响.结果表明,Fe2O3/FA对Hg0的脱除能力随Fe2O3负载量(1%~10%)的增加和温度(120~200℃)的升高而增强;Fe2O3/FA在较低的空速和Hg0浓度条件下表现出了更高的脱除Hg0的活性;HCl和O2促进了Fe2O3/FA对Hg0的脱除,而SO2和H2O抑制了Fe2O3/FA对Hg0的脱除.逐级化学提取实验结果证实,Fe2O3将Hg0氧化为Hg2+的化合物并吸附在FA上,这是Fe2O3/FA具有较高的脱除Hg0能力的原因.     

改性粉煤灰处理黑化集团焦化含酚废水的研究

焦化废水是一种典型的含有难降解有机污染物的工业废水,除含有酚类化合物外,还含有多种芳香烃和杂环类有机污染物,成分复杂,水量大,对环境污染严重。因此,焦化废水处理技术越来越受到环保部门的重视。本文摸索了改性粉煤灰处理焦化含酚废水的试验工艺条件,确定了反应条件,反应时间和反应温度。     

碱熔融法合成NaA和NaX型粉煤灰沸石的品质表征

以粉煤灰为原料采用碱熔融法合成了2种单一沸石矿物种的NaA和NaX型沸石,并对产物的结构、性能和应用指标进行了详细表征.经x射线衍射和IR光谱分析,表明合成产物是无杂晶生成的NaA和NaX型沸石相;在扫描电镜观察下,产物分别具有NaA和NaX型沸石的立方体和八面体晶体骨架结构.DTA分析表明了合成产物中沸石水的存在,且产物热稳定性较好.通过对比,粉煤灰合成的NaA和NaX型沸石的比表面积达到了相应商品沸石的66.9%和83.6%;孔容为41.1%和70.2%;阳离子交换容量(CEC,cation exchange capacity)为82.93%和84.31%.通过比较化学组成表明,大规模应用合成产物不会对环境造成危害.     

Protection of ash (Fraxinus excelsior) trees from ozone injury by ethylenediurea (EDU): roles of biochemical changes and decreased stomatal conductance in enhancement of growth

Treatments with ethylenediurea (EDU) protect plants from ozone foliar injury, but the processes underlying this protection are poorly understood. Adult ash trees (Fraxinus excelsior), with or without foliar ozone symptoms in previous years, were treated with EDU at 450ppm by gravitational trunk infusion in May-September 2005 (32.5ppmh AOT40). At 30-day intervals, shoot growth, gas exchange, chlorophyll a fluorescence, and water potential were determined. In September, several biochemical parameters were measured. The protective influence of EDU was supported by enhancement in the number of leaflets. EDU did not contribute its nitrogen to leaf tissue as a fertiliser, as determined from lack of difference in foliar N between treatments. Both biochemical (increase in ascorbate-peroxidase and ascorbic acid, and decrease in apoplastic hydrogen peroxide) and biophysical (decrease in stomatal conductance) processes regulated EDU action. As total ascorbic acid increased only in the asymptomatic trees, its role in alleviating O(3) effects on leaf growth and visible injury is controversial.     

Optical and Chemical Methods of Metal Ash Analysis and Tin Recovery

‘Metal ash’ presents a waste disposal problem in most of the developing countries as the industries employ obsolete technologies. In this paper we describe analysis of tin ash, zinc ash and aluminium ash by means of optical methods, such as X-ray diffraction (XRD), inductively coupled plasma mass spectrometry (ICP-MS), electron probe micro analysis (EPMA), scanning electron microscopy (SEM) and chemical methods. The results of tin ash obtained by XRD method matched well with the cassiterite, a naturally occurring mineral of tin. ICP-MS studies reveal the presence of a large number of tracer metals, which may cause pollution by tertiary dispersion and this aspect is discussed. Conversely, the data generated by chemical methods are limited. However, the methods are simple and cost-effective. Then, they can easily be adopted by low-budget industries. Simple and cost-effective process to recover tin from tin ash is described. It is based on heating tin ash with sodium cyanide to about 900°C to separate tin component from the metal ash. The process recovers good quality tin and offers a very high yield. The process can be scaled up to small pilot plant.