Kinetic-spectrophotometric determination of free cyanide by stopped-flow reversed flow injection analysis

A stopped-flow reversed flow injection method for the determination of free cyanide is proposed. Pyridine-barbituric acid mixture is injected in the flow system as reagent to form the colour species with cyanide. The flow is stopped when the reagent zone comes in the flow cell, where absorbance-time data are collected at 580nm wavelength. The linear range of the determination is 0.1 -10μg/ml CN-. The sampling rate is 60h-1 and the relative standard deviation is 1.6% (n=16) at 5.0 μg/ml CN-1 level. With satisfactory results, the proposed method was applied to the determination of free cyanide in wastewater without sample pretreatment.     

2-Chlorophenol oxidation kinetic by photo-assisted Fenton process

Experimental data are presented to test and validate a kinetic model for the oxidation of 2-chlorophenol wastewater by photo-assisted Fenton process. The data showed that this process had produced good effects under acidic conductions. Up to 90% 2-chlorophenol was removed after 90-minute reaction time with H2O2 of 25% CODCr. in, while in UV/H2O2 system ordy 16.8% 2-chlorophenol was removed after one hour treatment. The optimal pH in this reaction occurred between pH 3.0 and pH 4.0. The reaction kinetics for photo-assisted Fenton process experimented in this research was investigated. Kinetic models were proposed for the treatment of 2-chlorophenol wastewater. The reaction was found to follow the 2nd order. The equations of reaction kinetics are as follows:-d[RH]/dt=KRH[RH][H2O2]0exp(-KH2o2t);-d[CODCr]/dt=KCODCr[CODCr][H2O2]0exp(-K′t).The prediction of the models was found to be in a good agreement with experimental results, thus confimfing the proposed reaction mechanism.     

镧、铈对厌氧颗粒污泥产甲烷的Hormesis效应及其动力学研究

间歇培养条件下研究了单一稀土元素镧(La3 )和铈(Ce3 )在不同浓度水平下对厌氧颗粒污泥活性及其动力学行为的影响.结果表明,La3 和Ce3 对厌氧颗粒污泥比产甲烷活性有促进作用的浓度范围均为0.01～0.1 mg·L-1,促进作用浓度峰值均为0.05mg·L-1,最大促进百分比分别为10.35%和20.79%;La3 和Ce3 对SMA(比甲烷活性)的半抑制浓度分别为5mg·L-1和1000mg·L-1,La3 较易对污泥产生抑制作用.米-门方程可以用来描述厌氧消化过程中甲烷发酵阶段的动力学行为,稀土元素La3 和Ce3 投加至反应系统后,提高了甲烷发酵过程的动力学常数Vmax和半饱和常数Ks.     

Determination and discussion hydraulic retention time in membrane bioreactor system

Based on the microorganism kinetic model, the formula for computing hydraulic retention time in a membrane bioreactor system (MBR) is derived. With considering HRT as an evaluation index a combinational approach was used to discuss factors which have an effect on MBR. As a result, the influencing factors were listed in order from strength to weakness as: maximum specific removal rate K, saturation constant Ks, maintenance coefficient m, maximum specific growth rate ,ua and observed yield coefficient Yobs. Moreover, the formula was simplified, whose parameters were experimentally determined in petrochemical wastewater treatment. The simplified formula is θ= 1.1( 1/β -1)(Kｓ S)/KXo , for oetroehemical wastewater treatment K and Ko eaualed 0.185 and 154.2, resoectively.     

钙类化合物固硫作用动力学分析

通过钙类化合物对动力用煤固硫作用的模拟试验 ,对不同钙化合物固硫率 (J)与Ca/S及助剂关系的研究 ,得到了钙类化合物固硫率的次序 ,即 :JNaOH +CaO>JCaCO3>JCaO>JCa(OH) 2 ,结果说明固硫率与钙类化合物的存在形式有关 ,并解释了其固硫作用机理     

土壤重金属钝化修复剂生物炭对镉的吸附特性研究

目前以生物炭为代表的生物质对重金属的吸附表现出良好的应用前景.为确定生物炭对溶液中镉的吸附性能,选用由棉花秸秆制备的生物炭,研究吸附等温线、吸附动力学以及温度、pH和离子强度等对生物炭吸附Cd2+的影响.研究表明,生物炭对Cd2+的吸附可以用Freundlich等温线较好地拟合,在不同温度下其饱和吸附量分别为9.738 mg.g-1(288.15 K)、10.14 mg.g-1(298.15 K)、10.40 mg.g-1(308.15 K)和10.71 mg.g-1(318.15 K),热力学参数表明生物炭吸附Cd2+的过程是自发的吸热过程;吸附动力学过程符合二级动力学模型,在40 min即可达到平衡;pH对生物炭吸附Cd2+的影响较大,在pH2～8范围时,生物炭对Cd2+的吸附量随pH的增加先上升后下降;生物炭对Cd2+的吸附量随着溶液离子强度的增大呈降低趋势.该项研究可为生物炭在土壤重金属污染修复中的应用提供一定的理论基础.     

零价铁去除废水中的汞

研究了零价铁(zero-valent iron,ZVI)去除废水中Hg2+的动力学特征及其影响因素,初步探讨了ZVI与Hg2+的作用机制.结果表明,ZVI对废水中Hg2+的最佳去除条件:Hg2+的初始浓度为0.10 mg·L-1、pH为5、ZVI用量为0.050 g、温度为25℃,获得Hg2+的去除率为94.5%.ZVI对废水中Hg2+有一个快速的去除过程,可用准一级反应动力学方程描述,速率常数为0.010 min-1.ZVI去除废水中Hg2+的机制主要是氧化还原反应、铁氧化物和氢氧化物的吸附和共沉淀作用,ZVI表面钝化是降低Hg2+去除率的主要原因,其钝化成分主要是FeOOH和Fe2O3-Fe3O4.胡敏酸可与ZVI还原产生的Fe2+、Fe3+结合形成Fe-HA复合物,增加可溶性铁的比例,缓解ZVI的钝化,对细铁氧化物和铁氢氧化物胶体具有稳定作用,增强对废水中Hg2+的吸附作用.     

生物过滤塔净化甲醛废气的动力学研究

选用榛子壳作为反应器的填料,利用沈阳北部污水处理厂的活性污泥对填料进行挂膜,由低到高通入甲醛气体进行驯化。在系统稳定后进行了生物过滤塔净化甲醛气体的实验研究,并建立了生物过滤塔降解甲醛气体的动力学模型。结果表明,入口气体浓度在低于25mg/m3时,甲醛废气的净化效率可保持在97％以上,超过此浓度值时,效率明显下降。随着进口气体流量的增加,净化率逐渐下降,由入口流量为0．2m3／h时的97．25％下降到入口流量为0．8m弧时的57．2％。根据现有动力学模型及本实验得出数据所建立的生物过滤塔净化甲醛气体的动力学模型,可以较好地模拟系统处理甲醛废气的实验结果,验证了模型的正确性。     

除镉最佳混凝剂的筛选及应用条件研究

通过采用聚合氯化铝铁（PAFC）、氯化铁（FeCl3）及聚合硫酸铁（PFS）对含镉废水的处理研究表明,三种混凝剂对含镉水体均有良好的处理效果,同等条件下,三种混凝剂对含镉水体去除率分别为98.22%、92.19%和93.63%。研究了PAFC对含镉水体的混凝沉淀效果,实验结果表明：碱性条件有利于镉离子的沉淀,当pH为9～11时,去除率可达98.00%左右;对于初始浓度为4.000 0 mg.L-1的含镉废水,经处理后,水体浓度可降至0.184 0 mg.L-1,对于初始浓度为0.400 0 mg.L-1的含镉废水,经处理后水体浓度降至0.007 2 mg.L-1;废水中投加一定量的石灰乳对PAFC除镉起一定的作用,投加量达30.00 mg.L-1时,其去除率达99.91%;通过对PAFC除镉动力学拟合,符合一级线性动力学方程。     

活性炭纤维电极电还原产H2O2的实验研究

利用活性炭纤维作为阴极,比较了活性炭纤维电极和石墨板电极产H2O2的浓度,并对影响活性炭纤维电极产H2O2的因素(pH、电流密度和电解质浓度)进行了研究.研究发现,活性炭纤维电极电还原产生H2O2的浓度远大于石墨板电极.当实验在pH=3.00、电流密度8.89 mA/cm2和电解质(Na2SO4)浓度0.05 moL/...