预缺氧池配水比对Johannesburg工艺脱氮除磷效果的影响

以处理城市污水的中试规模Johannesburg工艺为对象,探讨不同配水比对预缺氧池的反硝化及Johannesburg工艺脱氮除磷效果的影响。在总HRT为12.86 h,预缺氧池HRT为0.6 h的条件下,当配水比分别为0%、10%、20%和30%时,预缺氧池硝酸盐去除率分别为37.67%、78.95%、87.62%和94.95%,对应的厌氧池磷酸盐浓度分别为8.72、19.37、16.1和12.99 mg/L。预缺氧池最佳配水比为10%,此时厌氧段释磷速率、好氧吸磷速率和缺氧吸磷速率分别为6.94、3.17和2.12 mg/(g MLSS·h),厌氧池中磷的最大浓度和污泥中的磷最大含量可达到19.37 mg/L和25.7 mg TP/g MLSS。出水COD、NH3-N、TN和TP等各项水质指标有80%以上的概率达到《城镇污水处理厂污染物排放标准(GB18918-2002)》一级A标准。     

Experimental investigation into performance of integrated hotbox in 1-kW solid oxide fuel cell system

An experimental investigation is performed to evaluate the performance of an integrated hotbox in a 1-kW solid oxide fuel cell (SOFC) system fed by natural gas. The integrated hotbox comprises all the main balance of plant components of an SOFC system, i.e. afterburner, reformer, and heat exchanger, and it not only reduces the physical size of the system but also yields improved system efficiency. The experimental results show that under optimal operating conditions, the combined H₂ and CO content of the reformate gas is approximately 70%, while both anode and cathode in-gas temperatures are around approximately 750°C.     

Effect of culture time on the growth curve and power performance in a microbial fuel cell at a fixed amount of liquid culture

The microbial fuel cell uses the microorganism biochemistry to carry on the energy conversion. Concerning the experimental precision, the colony culture would be replaced by a fixed amount of liquid culture for Microbial fuel cell of Escherichia coli. The anode and cathode chambers whose each volume is 100 mL were utilized, the effective surface area of proton exchange membrane Nafion-117 is about 9 cm². In addition, the electrode area of carbon cloth is 20 cm². Three kinds of Escherichia coli, named as BCRC No. 10322, 10675 and 51534, respectively, would be selected. Results show that the electricity performance of Escherichia coli of BCRC No.51534 is better than the other microorganism studied because of having a larger open circuit voltage of 1.01 V and limiting current 22 mA, the maximum power density of 1342 mW/m^2, and average working power density of 295 mW/m² would be produced. These results would be useful to improve the performance of microbial fuel cell.     

Updraft gasification of juniper wood biomass using CO2–O2 and Air (N2–O2)

Biomass gasification is being considered as one of the most promising technologies for converting low-quality solid biomass fuel into gaseous fuel. Redberry juniper (Juniperus pinchotii), one of the woody species that dominate uncultivated lands in the southern great plains, USA, may have a great potential for bioenergy utilization. In this study, the results of gasification of juniper are presented. Juniper wood chips were gasified in an adiabatic fixed bed updraft gasifier using air and the mixture gas of carbon dioxide and oxygen (CO₂:O₂) as gasification medium. The effect of gasification parameters such as moisture contents, gasification mediums, and gasification temperature on produced gas properties and the tar yield were investigated. It was observed that oxy fuel gasification (the reaction of woody fuels with carbon dioxide) of juniper resulted in the increase of production of carbon monoxide, especially at higher peak gasification temperatures. As a result, the CO₂ gasification resulted in producing higher heating value gas (6264 kJ/nm³ with dilution of CO₂ and 19,750 kJ/nm³ inert free) compared to air gasification. For air gasification, it was observed that the updraft gasification produced large amount of the tar in the product gas (more than 100 g/nm³) for the fuels with moisture content between 6% and 11%. Generally, the tar yield increased with the increase of equivalence ratio (er) and moisture content. However, when the fuel moisture content reached 23.5%, the tar yield reduced significantly due low gasification temperature which reduced the less tar cracking.     

Application of integrated micro sensor in internal measurement of high temperature fuel cell

This study developed an integrated (flow, voltage, and temperature) micro sensor using the micro-electro-mechanical systems (MEMS) technology. It was inserted into the high temperature proton exchange membrane fuel cell (HT-PEMFC) for local real-time measurement. The integrated micro sensor is made of 40 µm thick stainless steel base material, and its protective layer is formed by polyimide (PI) that has better temperature resistance. The integrated micro sensor has three functions, and is favorably characterized by small size, good acid resistance and temperature resistance, quick response, real-time measurement, and being able to be put in any place for measurement. After calibration, and its reliability confirmed, the integrated micro sensor is inserted into the HT-PEMFC for local microcosmic measurement.     

生命线系统的震害耦联

在震害分析时,弧立地评价一个生命线系统的功能,不考虑与其它生命线系统间的耦联关系,可能会低估地震造成的损失。将地理信息系统（ＧＩＳ）与现有的震害预测方法结合起来,有利于推动新方法的研究。本文在ＧＩＳ环境下定义了网络失效率,提出了一种考虑不同生命线系统之间耦联关系的震害分析方法,给出了一个算例,并建议了相应的生产能力相关的震后应急抢修决策方案。     

泥石流堆积模式的试验研究

泥石流的堆积形态和范围是泥石流危险区划分的重要参数,它们不仅与泥石流体浓度（Ｇｖｔ）、下游流路坡度（Ｑｕ）有关,还与流通过 坡度（Ｑｃ和冲出量有关。本文通过小型水槽试验,求得了泥石流堆积范围与形态比的堆积模式,并根据野外测量的堆积形态进行了泥石流体浓度的计算和验证,该模式可为泥石流防治工程的设计提供有科学依据的参数。     

长江中游水沙灾害形成机理研究

对长江中游泥沙输移规律进行了综合分析,建立了螺山至汉口河段和洞庭湖区泥沙淤积比霽与三口分沙比λS之间的定量关系.通过分析得知.洞庭湖区和螺山至汉口河段各时期多年平均泥沙淤积总量基本保持在180×106t,分沙比的减小调整了上述河段与洞庭湖区之间的淤积关系,使洞庭湖区减少淤积的泥沙转移到上述河段淤积.在此基础上对长江中游泥沙淤积与该区域水位抬高进行了计算分析.文章指出,长江中游防洪的核心是如何正确处理宜昌每年多来的180×106t泥沙淤积问题.     

乌鲁木齐市煤改气工程对采暖期 SO2和 NO2浓度变化的影响分析

通过对乌鲁木齐市2011-2013年采暖期SO2、NO2、PM10的年均浓度、月均浓度、日均浓度的变化比较,分析了乌鲁木齐市煤改气工程实施前后大气环境发生的变化趋势,论证了乌鲁木齐市煤改气工程对城市大气环境的改善作用,为该工程今后的推广与发展得到了可靠的实践依据。     

Sex ratio, sexual dimorphism and mating structure in bethylid wasps

Sexual dimorphism has been linked to parasitoid mating structure by several authors. In turn mating structure has an important influence on predicted sex ratio optima. Here we test the relationship between sexual dimorphism and sex ratio using data from 19 species of bethylid wasps. Using phylogenetically based comparative methods we confirm the findings of a previous cross-species analysis that sex ratio (proportion of males) is strongly and negatively correlated with clutch size. Using cross-species comparisons we show an additional positive correlation of sex ratio and relative male size, as predicted. The relationship however is not significant when using phylogenetically based methods. The cross-species result is largely due to differences between two bethylid sub-families: the Epyrinae have relatively large males and relatively high sex ratios, whereas the Bethylinae have relatively small males and lower sex ratios. Our study illustrates the benefits and drawbacks of using cross-species versus phylogenetically based comparisons. Received: 13 May 1997 / Accepted after revision: 12 January 1998