用好氧-厌氧反复耦合固定床生物反应器处理肌苷生产废水

利用由多孔微生物载体构建的好氧-厌氧反复耦合固定床生物反应器进行了高浓度肌苷生产废水处理中试研究。连续84d的运行结果表明，当进水COD为1500-2700mg／L、水力停留时间为22．1h时，出水COD可维持在150mg／L左右，COD去除率达90％～95％。装置运行稳定后，未经沉淀的出水中的固体悬浮物质量浓度小于50mg／L，表明该反应器可避免剩余污泥的产生。中试结果验证了该反应器处理高浓度肌苷废水的可行性和优势，同时为装置放大提供了理论依据。     

Polymeric Complexes from Casein and Starch Phosphate: Characteristics and Enzyme Susceptibility

Novel biodegradable materials were prepared from potato starch enriched in phosphato moieties (DS 0.018 and 0.033) and casein in defatted milk. The components were blended in proportions providing starch: casein ratios of 2:1, 1:1, and 1:2 and were then precipitated with hydrochloric acid. Aqueous solubility, water-binding capacity, infrared spectra, and thermal analysis (thermogravimetry[7] and differential thermogravimetry of the precipitates revealed that they were not simple physical mixtures of the components. The components interacted with one another electrostatically with involvement of the phosphate groups of starch and the peptide bond of casein, as documented by infrared spectra. Because of insolubility in 7 M aqueous urea solution, they might also be considered as complexes in which the components were chemically bound.     

五大连池老黑山火山的两次喷发活动

老黑山是五大连池火山群中最年轻的火山.通过对老黑山火山锥体结构及其形态分析指出,老黑山火山并非单锥,而是由先、后不同时期形成的两个锥体叠加组成的复合锥,表明它有两次喷发活动.通过对新发掘出的史料的分析,进一步指出,老黑山火山的第一次喷发时间为1720(不是1719年)-1721年,第二次可能为1776年.两次喷发活动的确认为研究老黑山火山喷发历史、喷发过程、喷发危险性评价和灾害预测等提供了新依据.     

超高强度钻杆低温断裂性能及裂纹扩展特征研究

超高强度钻杆在冬季低温环境下容易发生脆性断裂事故,为了从断裂力学角度揭示其冷脆现象的本质,采用ZBC2302-D型示波冲击试验机,获得了不同温度下超高强度钢在冲击断裂过程中的力-位移曲线,并对比分析了冲击功、起裂功和裂纹扩展功之间的变化关系。采用国家标准GB 4161—2007中的计算公式,计算了冲击试样的裂纹扩展量Δa和阻抗应力强度因子K_R;同时,引入K_R阻力曲线,得到超高强度钻杆在不同温度下的剩余强度图。结果表明,当冲击试样开始出现裂纹时,随温度降低,钻杆的初始起裂应力有所增加,出现硬化现象。当钻杆出现一定长度的裂纹时,随温度降低,阻抗应力强度因子越来越小,而且降低速度越来越快,剩余强度也表现出相同的变化趋势。随温度降低,材料抵抗裂纹扩展的能力逐渐下降,表明钻杆在低温下更容易断裂。     

Leaching behaviour of different scrap materials at recovery and recycling companies: Full-, pilot- and lab-scale investigation

Scrap material recovery and recycling companies are confronted with waste water that has a highly fluctuating flow rate and composition. Common pollutants, such as COD, nutrients and suspended solids, potentially toxic metals, polyaromatic hydrocarbons and poly chlorinated biphenyls can exceed the discharge limits. An analysis of the leaching behaviour of different scrap materials and scrap yard sweepings was performed at full-scale, pilot-scale and lab-scale in order to find possible preventive solutions for this waste water problem. The results of these leaching tests (with concentrations that frequently exceeded the Flemish discharge limits) showed the importance of regular sweeping campaigns at the company, leak proof or covered storage of specific scrap materials and oil/water separation on particular leachates. The particulate versus dissolved fraction was also studied for the pollutants. For example, up to 98% of the polyaromatic hydrocarbons, poly chlorinated biphenyls and some metals were in the particulate form. This confirms the (potential) applicability of sedimentation and filtration techniques for the treatment of the majority of the leachates, and as such the rainwater run-off as a whole.     

建筑材料隐含环境影响评估

我国建筑业快速发展,建筑开发使用大量的建筑材料给资源和环境带来严重负荷.以上海市为案例,运用生命周期评价方法,基于北京工业大学和Ecoinvent数据库中的建筑材料生产数据,采用ReCiPe法对上海市建筑物的材料隐含环境影响进行评估,并对未来的环境影响潜值进行预测.结果表明:在上海市居住建筑和非居住建筑所产生的各类环境影响中人类毒性、金属损耗最为突出,约占总环境影响的45%和20%;环境影响主要来源于钢筋和木材的生产,对各类环境影响贡献度分别约为47%、17%;高层居住建筑和非居住建筑中的工厂建筑物化环境影响在各自类型中所占比例最高.按现有趋势发展,2020年上海市居住建筑开发规模和环境影响潜值均将达到2014年的1.52倍,非居住建筑则可达到2014年的1.14倍.针对上海市建筑材料环境影响分析结果,为有效减轻上海市建筑物的环境影响,需重点关注钢筋、铝材、木材以及混凝土的生产,识别生产过程中污染物转移环节进而改进工序;在设计阶段考虑选择环境影响负荷低的绿色建材,如混凝土砌块、高性能混凝土等,从而降低环境影响;同时,应重点关注隐含环境负荷高的高层居住和工厂建筑类建筑,通过降低建材使用量等方案降低环境影响.      

碱性高炉矿渣制备多孔混凝土掺合料及其净化酸性水的试验研究

碱性高炉矿渣和多孔混凝土都有良好的净水性能,将碱性高炉矿渣作为掺合料制成掺高炉矿渣多孔混凝土(BSPC),对其处理模拟酸性水的效果进行研究。结果表明:经BSPC处理后,进水p H由2~3变成8.5~9.1。与普通多孔混凝土相比,添加高炉矿渣的混凝土对酸性水浊度、CODcr、TP和Cd的平均去除率依次提高了6.2%,8.8%,5.2%和4.5%,分别达到74.3%,74.5%,91.7%和86.5%。同时,BSPC孔隙率在处理酸性水前后有所下降,下降幅度较小,为6.2%,不影响BSPC对酸性水的处理。实验最后对混凝土表面白色絮状物进行了红外和XRD表征,初步分析其中含有CaCO_3、SiO_2和水化硅酸钙(C-S-H)等无机物,初步判定来源于BSPC的溶出物。     

有机质胶体对卡马西平在多孔介质中迁移影响模拟实验

有机质胶体与有机污染物的相互作用会影响污染物在多孔介质中迁移转化等环境行为.为研究有机质胶体对药物和个人护理品(PPCPs)在土壤环境中迁移的影响,本实验以卡马西平(CBZ)为目标污染物,用商用腐殖酸制备有机质胶体,分别选择石英砂、标准土和野外所取土样为研究介质,通过室内土柱模拟实验探究有机质胶体存在时污染物在多孔介质中的迁移行为.结果表明,描述一维溶质运移的两点化学非平衡模型能够较好模拟CBZ在各介质土中的运移过程,说明污染物运移过程中与介质间发生了化学非平衡吸附作用;石英砂柱中加入胶体后,对CBZ的吸附过程无明显影响,但在解吸时阻滞因子及滞留量变小,可见胶体与石英砂间作用微弱,解吸过程中胶体与污染物结合形成复合体后对污染物有增溶作用;胶体存在时,标准土和自然土对CBZ的吸附量和迁移阻滞强度均明显大于石英砂,其中有机质及黏土矿物的作用最为明显,有机质中的低能/高能吸附位点以及黏土矿物极性表面均能够固定污染物;由于有机质含量较高,自然土对CBZ在吸附-解吸过程中的阻滞截留强度大于标准土.针对本实验中CBZ的迁移情况,提出了疏水性有机污染物在含有机质胶体土壤中的迁移过程中各种作用的概念模型.     

Shear cutting and counter shear cutting of sandwich materials

New lightweight sandwich materials challenge existing forming processes as well as following process steps. As such the manufacturing potential of shear cutting has to be evaluated. Two cutting methods are compared. Method commonly used is shear-cutting within one stroke engaged, the other one is known as counter-shear cutting, which uses two strokes.The challenges of cutting sandwich materials are variation of hole diameter within the different layers, fraying of the textiles, deformation of the hole contour and burr formation. These effects occur in conventional shear cutting as the intermediate layer and the lower sheet metal are cut by the scrap of the upper sheet instead of the cutting punch.The following methodology included shear cutting with closed cutting edge i.e. cutting of holes into five different sandwich materials. The sandwiches exemplarily represent multiple kinds of possible material designs. For instance, aluminum and steel face sheets, different thicknesses of intermediate layers and different intermediate layers materials such as integrated textile fibers have been used. Adequate cutting parameters such as die clearance and the use of a blank holder have been determined. To achieve good results a stiff machine design with good guidance and precise control of punch position was crucial.Observations of conventional shear cutting revealed the need of small cutting clearance of 4%. High burnish area is possible for the upper face sheet due to the superimposed force by the lower face sheet. The major conclusion depicted that high cutting quality of sandwich materials requires counter shear cutting. Hence, the roll-over of the lower sheet facing the intermediate layer, the burnish area at the lower sheet, good cutting quality of the fibers improve significantly and burr formation is avoided completely. Summarized this paper provides cutting parameters for sandwich materials based on experimental work.     

平朔安太堡矿区复垦地土壤微生物与土壤性质关系的研究

调查安太堡大型露天矿区西排土场植被恢复与土壤微生物的关系.结果表明,土壤中微生物量与土壤中的水分、速效磷、土壤有机质、有效性氮和海拔高度有明显的关系.麦地、林地、草地的土壤中呈现出:细菌》放线菌》固氮菌》霉菌;撂荒地呈现为:细菌》放线菌》霉菌》固氮菌;裸地呈现出:细菌》放线菌》霉菌.细菌、放线菌和霉菌呈现麦地最高,裸地最低,固氮菌为林地高于其他样地.在撂荒地和裸地中,细菌占微生物总量的一半以上.麦地、林地、草地、撂荒地中的各种菌、速效磷、土壤有机质、有效性氮含量明显高于裸地中的含量.微生物总量和样地的海拔、样地土壤的含水率有明显的关系,土壤中的含水量直接影响微生物总量.微生物总量与速效磷含量和有机质含量成正比,有机质含量与有效性氮含量成正比.细菌与海拔呈极显著负相关,与其他几种养分指标呈极显著正相关,放线菌与海拔和速效磷呈极显著相关,与其他指标相关性不显著,固氮菌与几种养分指标相关性均不显著.按全国土壤养分划分标准,安太堡大型露天矿区复垦地等级不高,还需要用科学的方法加快复垦区土壤的恢复.