Thioarsenate formation upon dissolution of orpiment and arsenopyrite

Thioarsenates were previously determined as dominant species in geothermal and mineral waters with excess sulfide. Here, we used batch leaching experiments to determine their formation upon weathering or industrial leaching of the arsenic-sulfide minerals orpiment (As₂S₃) and arsenopyrite (FeAsS) under different pH and oxygen conditions. Under acidic conditions, as expected based on their known kinetic instability at low pH, no thioarsenates formed in either of the two mineral systems. Under neutral to alkaline conditions, orpiment dissolution yielded mono-, di- and trithioarsenate which accounted for up to 43-55% of total arsenic. Thioarsenate formation upon arsenopyrite dissolution was low at neutral (4%) but significant at alkaline pH, especially under suboxic to sulfidic conditions (20-43%, mainly as monothioarsenate). In contrast to orpiment, we postulate that recombination of arsenite and sulfide in solution is of minor importance for monothioarsenate formation during alkaline arsenopyrite dissolution. We propose instead that hydroxyl physisorption lead to formation of As-OH-S surface complexes by transposition of hydroxyl anions to arsenic or iron sites. Concurrently formed ironhydroxides could provide re-sorption sites for the freshly released monothioarsenate. However, sorption experiments with goethite showed slower sorption kinetics of monothioarsenate compared to arsenite, but comparable with arsenate. The discovery that thioarsenates are released by natural weathering and industrial leaching processes and that, once they are released, have a higher mobility than the commonly-investigated species arsenite and arsenate requires future studies to consider them when assessing arsenic release in sulfidic natural or mining-impacted environments.     

超声辐射浸渍法制备Fe-Ni-Mn/Al_2O_3催化剂及性能研究

以Al2O3为载体,分别采用超声辐射浸渍法和普通浸渍方法制备Fe-Ni-Mn/Al2O3催化剂。采用BET、XRD和SEM对催化剂的理化性质和孔结构进行了分析,以模拟酸性绿B废水为研究对象考察催化剂的催化性能。实验结果表明,浸渍溶液pH值和焙烧温度显著影响催化剂的性能。与普通浸渍法相比,超声浸渍法制备的Fe-Ni-Mn/Al2O3催化剂对酸性绿B脱色反应表现出较高的催化活性。     

C/N和pH值对高温好氧反硝化菌产N2O的影响研究

以50℃高温、好氧条件下能进行高效好氧反硝化的菌株TAD1为研究对象,在不同C/N和pH值培养条件下,对其24 h的反硝化效率和反硝化过程中N2O的逸出量进行了研究。结果显示,C/N和pH值对菌株TAD1的反硝化效率和N2O产生量有明显影响.菌株TAD1最适宜的C/N为9,pH值为7,此时反硝化效率达到99.12%,N2O产生量仅为3.35×10-2 mg/L,N2 O转化率为0.045%,反硝化产物以氮气为主。另外,菌株TAD1不适宜在酸性条件下生长,pH值为6时反硝化效率为83.18%,N2O产生量为13.88×10-2 mg/L,是pH值为7时的4.14倍,是pH值为8时的5.07倍。     

Fe3O4/SDS磁性纳米颗粒吸附水体中的Cd2+和Zn2+

一种新型纳米固相萃取吸附剂,由阴离子表面活性剂十二烷基磺酸钠(SDS)包裹在Fe3O4磁性纳米颗粒表面形成,用于吸附水溶液中的重金属离子。研究了吸附过程的主要影响因素(如SDS浓度、溶液pH等)以及解吸过程的最佳条件,并对其机理进行了初步的探讨。研究结果表明,共沉淀法制备的Fe3O4颗粒粒径分布均匀,平均粒径约为54 nm;SDS浓度为300 mg/L时,Fe3O4/SDS磁性纳米颗粒吸附Cd2+和Zn2+的能力最强;在一定浓度范围内,Fe3O4/SDS体系对Cd2+和Zn2+的吸附平衡数据符合Langmuir吸附等温方程,饱和吸附量分别为22.42 mg/g和13.95 mg/g。最终结果表明,Fe3O4/SDS磁性纳米颗粒具有较强磁分离能力和较好的吸附效果。     

微量元素对牛粪低温厌氧发酵的影响

为考察较低温度(<17℃)条件下添加微量金属元素对厌氧发酵产气量的影响,在发酵底物TS(含固率)为10%下采用10 L玻璃瓶作反应器,以牛粪为原料,向厌氧生物反应器中分别添加MnSO4、FeSO4·7H2O、电解锰渣,分析了厌氧消化系统运行过程中的产气量、COD(化学需氧量)和pH的变化。结果表明,锰元素能促进低温下牛粪的厌氧发酵,加速反应启动。当添加6 g MnSO4、100 g电解锰渣时,单位质量VS产气率分别为0.26 mL/g和0.64 mL/g,添加6 g FeSO4·7H2O与空白对照组均未见明显产气。     

水滑石与磷酸银可见光催化剂的活性对比研究

本文合成了具备水滑石结构(LDH)的Zn-Cr LDH、Zn-Ti LDH以及Ag3PO43种半导体光催化剂,并对它们的催化性能进行对比研究。XRD和SEM分析表明,Zn-Cr LDH、Zn-Ti LDH具有层状结构而Ag3PO4呈纳米球状结构。UV-Vis分析表明,Ag3PO4和Zn-Cr LDH能够吸收可见光(>420 nm)。在可见光照射与添加AgNO3作为电子受体的条件下,Zn-TiLDH几乎没有光催化活性,而Ag3PO4的光催化活性高于Zn-Cr LDH。Ag3PO4在光解水实验中180 min内氧气产量约1.2mL,而Zn-Cr LDH约为0.65 mL。光催化降解有机污染物实验中,在Ag3PO4催化作用下,120 min内亚甲基蓝(MB)被完全降解,在240 min内46%的对硝基酚(PNP)被降解,而Zn-Cr LDH相应的去除率分别为61%和27%。     

电解锰渣中锰的浸出条件及特征

采用水洗-酸解法回收电解锰渣中锰,探讨了清水量、酸量以及温度在不同阶段对锰浸(洗)出条件的影响,分析了回收锰的主要因素及浸出特征。实验结果表明,50 g电解锰渣经m渣∶m水=1∶10的清水水洗后,采用10%的硫酸在70℃的水浴温度下酸解2 h,Mn2+浸出量为1.673 g,回收率达到97.3%,而温度和酸度对锰离子的浸出影响明显,酸度调控可有效分离酸浸锰液中金属成分,为减少电解锰渣环境污染的同时,实现电解锰渣资源化利用。     

不同改性多壁碳纳米管对Cr3+的吸附性能

通过催化裂解法制备多壁碳纳米管,利用不同化学试剂对多壁碳纳米管改性,研究了不同化学改性对多壁碳纳米管表面物理化学特性的影响和Cr3＋的吸附特性。结果表明,所制备的多壁碳纳米管孔隙均匀,外径为30～50 nm,长度为0.5～2μm,经过不同化学改性表面有效地引入了含氧基团。未改性、H2SO4、HNO3、H2SO4-HNO3改性碳纳米管对Cr3＋的吸附动力学均符合Langergren模型;吸附等温线均符合Freundlich模型。温度和pH升高均有利于改性多壁碳纳米管对Cr3＋的吸附。