PW—W膜分离式活性污泥法处理中小规模高浓度有机废水

阐述ＰＷ－Ｗ膜分离式活性污泥法处理高浓度有机废水的原理、工艺流程及特点。处理系统集生化处理功能和固液分离于一体，对高浓度有机废水的处理取得了良好的效果，且剩余污泥量少，处理水质稳定，维护管理方便，运行费用低。     

Determination and discussion hydraulic retention time in membrane bioreactor system

Based on the microorganism kinetic model, the formula for computing hydraulic retention time in a membrane bioreactor system (MBR) is derived. With considering HRT as an evaluation index a combinational approach was used to discuss factors which have an effect on MBR. As a result, the influencing factors were listed in order from strength to weakness as: maximum specific removal rate K, saturation constant Ks, maintenance coefficient m, maximum specific growth rate ,ua and observed yield coefficient Yobs. Moreover, the formula was simplified, whose parameters were experimentally determined in petrochemical wastewater treatment. The simplified formula is θ= 1.1( 1/β -1)(Kｓ S)/KXo , for oetroehemical wastewater treatment K and Ko eaualed 0.185 and 154.2, resoectively.     

液化石油气储罐火灾爆炸事故分析

应用基于可能性分布的模糊事故树分析法，对引发液化石油气储罐发生火灾爆炸事故的可能因素进行了定量分析。     

低床层烟炱吸附法脱硫试验及机理探讨

研究了以锅炉烟气沉降物为吸附剂的烟炱吸附法脱除SO2的工艺条件，结果表明该法较适宜的工艺条件为SO2浓度小于2400mg/L,烟气流速小于36m/h，烟气温度低于100℃，此时脱硫效率可达30％以上。初步探讨了烟炱吸附法脱硫的作用机理。     

膜生物反应器在污水处理中的应用前景

介绍了膜及膜分离技术。膜生物反应器（MBR）的原理。综述了膜生物反应器在污染处理领域应用开发情况；指出了膜生物反应器在发展中存在的主要问题；展望了膜生物反应器技术的发展前景。     

过滤捕集法处理含DEP雾废气的研究

为了探讨玻璃纤维过滤器处理含DEP雾废气的效率问题,在实验室进行了DEP雾去除实验。考查了不同气体入口浓度、过滤流速下玻璃纤维过滤捕集装置对含DEP雾废气的净化能力,结果表明:利用玻璃纤维过滤器去除DEP雾,在DEP雾粒径主要分布为0.48～3.4μm之间,DEP雾浓度小于220 mg/m3,过滤流速小于10 cm/s情况下,玻璃纤维过滤器对DEP雾的去除率大于99%,最大气体流量下的压力降小于1610Pa;同时对含油(酸)雾废气除雾效果好,特别是对于粒径特别细微的油(酸)雾,捕集效率也很高,还可回收利用,不会产生二次污染。     

小型炭素焙烧炉沥青烟气净化技术初探

阐述了颗粒层吸附技术在小型炭素焙烧沥青烟气净化中的应用。     

现代电化学技术与环境保护

介绍了电化学技术在清洁工艺的开发、清洁产品的制备、废水与废气的处理、被污染土壤的修复和环境污染物监测方面的应用情况。电化学技术具有能量利用率高、经济实用以及污染物产生量少或污染物去除率高等特点，在环境保护领域具有广阔的应用前景。     

黄磷尾气现场脱硫试验

黄磷尾气的主要成分是CO，其中含硫杂质主要以硫化氢的形式存在。测定了黄磷尾气中硫化氢、氧气的含量，分别采用吸收、吸附工艺及其组合工艺对黄磷尾气进行了现场脱硫试验，得出了最佳的黄磷尾气净化脱硫工艺，即吸收、活性炭变温吸附。出口气中H2s的质量浓度为1—5mg/m^3，净化效率达到99．7％。     

Drying of granulated wood ash by flue gas from saw dust and natural gas combustion

At the district heating plant of Kalmar, Sweden an on-line unit for production of granulated wood ash for nutrient recycling on forest soils is being applied. Currently, the granules are dried by hot air from an oil-fired burner. The objective of this work was to investigate how drying by flue gas affects the hardening of granules, or impacts their chemical composition and properties. Ninety-six granule samples were treated by flue gas from natural gas combustion in a laboratory pilot scale flue gas generator. CO₂, CO, O₂, C₃H₈ and NO concentrations were varied during the experiment. Additionally, some samples were treated by flue gas from combustion of sawdust at the heating plant in Kalmar. Drying by flue gases did not affect the chemical composition of granules, but minor effects were seen in their mineralogy. The carbonate content was slightly higher in granules treated with flue gas from natural gas combustion compared to the granules dried by hot air only, when measured by wet chemical methods. Results from XRD analysis imply that the calcite content is higher and the portlandite and arcanite content slightly less in granules treated with flue gas from sawdust combustion compared to the granules dried by hot air only. The results from this investigation showed no negative effects on ash granule composition or physical structure by the use of a flue as a drying medium.