隔膜压滤机滤室最优空腔厚度

利用UG软件对隔膜压滤机滤室内流体进行三维建模,导入Gambit中进行网格划分及边界条件的设定,结合Fluent选用RNG k-ε湍流模型,采用多孔介质模型模拟隔膜压滤机滤室内固-液两相流分离,得到不同空腔厚度下滤室内流体的体积分数轮廓图、压强云图,得出滤饼含水率与空腔厚度大小的关系。实验结果表明,模拟和实验结果具有较好的一致性。在压滤机滤室空腔厚度为12 mm时,滤饼含水率为48%,每天污泥处理量为102 t,隔膜压滤机工作效率最高。     

光/电法氨氮降解过程中协同作用的研究

为了研究光/电法在氨氮降解过程中的协同作用,采用光/电法降解模拟工业循环冷却水中的氨氮,并对氨氮降解过程中的各影响因素进行了研究,考察了氯离子浓度和溶液p H对降解效率的影响。结果表明,与传统的光催化法和电化学法相比,光/电法在氨氮降解过程中存在良好的协同效应,因而具有更高的氨氮去除率,这主要归功于溶液氯离子的促进作用。另外,在酸性条件下,氨氮降解效率得到进一步加强。当p H在4~5之间,电流密度为10 m A/cm2,Na Cl浓度为100 mg/L时,在经过90 min光/电法处理后氨氮去除率高达95%,且N2占总氨氮降解产物的84.2%。     

中国工业水污染及其成因的de Bruyn模型分析

选取废水、挥发酚、氰化物、COD、石油类和氨氮为中国工业水污染指标,利用分解分析方法将2004—2010年间的污染变化分解为规模效应、结构效应、污染治理效应、清洁技术效应和广义技术效应。结果显示,这5类效应的平均作用强度分别为2.08%、3.04%、15.61%、17.37%和32.88%,其中规模效应和广义技术效应是影响工业水污染的主导效应。各类效应对不同污染物的作用方向并不完全一致,规模效应促进污染物排放量的增加;结构效应以加重污染为主,污染治理效应和清洁技术效应以减轻污染为主;广义技术效应的平均作用强度和负向作用概率均最大,是现阶段中国工业水污染控制最为有效的手段。     

Using multivariate regression modeling for sampling and predicting chemical characteristics of mixed waste in old landfills

Municipal solid waste landfills pose a threat on environment and human health, especially old landfills which lack facilities for collection and treatment of landfill gas and leachate. Consequently, missing information about emission flows prevent site-specific environmental risk assessments. To overcome this gap, the combination of waste sampling and analysis with statistical modeling is one option for estimating present and future emission potentials. Optimizing the tradeoff between investigation costs and reliable results requires knowledge about both: the number of samples to be taken and variables to be analyzed.This article aims to identify the optimized number of waste samples and variables in order to predict a larger set of variables. Therefore, we introduce a multivariate linear regression model and tested the applicability by usage of two case studies. Landfill A was used to set up and calibrate the model based on 50 waste samples and twelve variables. The calibrated model was applied to Landfill B including 36 waste samples and twelve variables with four predictor variables.The case study results are twofold: first, the reliable and accurate prediction of the twelve variables can be achieved with the knowledge of four predictor variables (Loi, EC, pH and Cl). For the second Landfill B, only ten full measurements would be needed for a reliable prediction of most response variables. The four predictor variables would exhibit comparably low analytical costs in comparison to the full set of measurements. This cost reduction could be used to increase the number of samples yielding an improved understanding of the spatial waste heterogeneity in landfills.Concluding, the future application of the developed model potentially improves the reliability of predicted emission potentials. The model could become a standard screening tool for old landfills if its applicability and reliability would be tested in additional case studies.     

西北干旱地区农宅雨水转化为可饮水技术

雨水集流工程对于解决干旱地区人民生活用水问题起着重要作用,甘肃省兰州市榆中县北山地区处于严重缺水的地区,人畜的饮用水为雨水、雪水直接沉淀后的水窖水。经过对北山饮用水进行水质检测,发现水中浊度、锰含量、微生物数量均超过《生活饮用水卫生标准》(GB5749-2006)的规定值。通过对传统滤池进行改造并结合阳光消毒研制出了一种新型水处理器——阳光消毒-生物砂滤池(SBF)家庭水处理设备,通过生物砂滤池中微生物对雨水中污染物的氧化分解及河砂的过滤使水浊度及锰得到有效地去除,日光高温灭活和光氧化降解综合作用杀灭水中致病微生物。用SBF家庭水处理设备对雨水进行处理,水中浊度、锰含量、微生物数量均达到标准的规定值。     

城市生活污水及二级处理水中手足口病病毒及肠道病毒的赋存状态

手足口病是由多种肠道病毒引起的传染病,其主要病原体有EV71、CVA16及CVA10。为了研究污水处理厂的生活原污水及二级处理水中此类病毒的存活情况,实验利用手足口病3种主要病毒的通用引物对其进行分型检测,同时使用肠道病毒通用引物检测所有肠道病毒,并对常规水质指标进行分析。结果表明,原污水及二级处理水的手足口病病毒阳性率分别为83.3%与36.7%,而肠道病毒阳性率更高达100%及93.3%。说明生活污水中的肠道病毒可以稳定存在,且若未进行有效消毒处理,可能存在于二级处理水中。在3种手足口病主要病毒中,CVA10检出率最高,达45.0%,CVA16及EV71检出率分别为8.3%及10.0%。可推断,CVA10为实验阶段该地区主要的手足口病病毒。通过相关性分析,肠道病毒的存活与水质条件密切相关。     

酸性矿井水中和沉淀法除铁优化

针对山西某煤矿高矿化度、高铁酸性矿井水除铁效果差、出水容易返色等问题,采用NaOH中和调pH、曝气及化学氧化等处理工艺进行酸性矿井水中和沉淀法除铁优化实验研究。结果表明,采用NaOH中和沉淀法除铁时,投加中和剂使出水pH达6.7以上时,出水中铁含量低于10 mg/L,满足排放要求。对于本实验废水NaOH所需投加量为2.8 g/L,铁的去除率可达到99.75%;以H2O2对原水进行氧化处理,可迅速将Fe(Ⅱ)氧化成Fe(Ⅲ),其用量与原水中Fe(Ⅱ)的含量成正比。当其用量为1.6 mL/L时,可将原水中的Fe(Ⅱ)完全转化为Fe(Ⅲ),投加中和剂使出水pH达到4.5以上时,能使出水中铁含量满足排放要求。对于实验废水所需的NaOH投加量为2.0 g/L,比直接中和沉淀所需的NaOH用量要节省28.6%。曝气处理对原水中Fe(Ⅱ)的氧化效果不明显。     

内源电子受体产生及其在抑制富磷剩余污泥释磷行为中的应用

根据生物脱氮除磷系统产生的富磷剩余污泥含有硝化细菌和生产废水含有高浓度氨氮的特点,将生产废水中的氨氮转化为硝酸盐(内源电子受体),并将获得的内源电子受体利用在富磷剩余污泥浓缩过程,同步实现内源电子受体反硝化及其抑制富磷剩余污泥释磷行为。结果表明,将富磷剩余污泥(excess activated sludge,EAS。EAS1是在好氧方式下添加,EAS2是在缺氧方式下添加)与生产废水(reject water)按4种比例(Ⅰ、生产废水∶EAS1∶EAS2=15%∶85%∶0%;Ⅱ、生产废水∶EAS1∶EAS2=15%∶80%∶5%;Ⅲ、生产废水∶EAS1∶EAS2=15%∶75%∶10%;Ⅳ、生产废水∶EAS1∶EAS2=15%∶65%∶20%)混合曝气用于产生内源电子受体时,最佳硝化时间均为12 h,可将液相中的氨氮分别由初始的(113.16±0.85)mg/L、(117.18±4.39)mg/L、(129.48±4.85)mg/L及(142.53±0)mg/L降至(0.74±0.41)mg/L、(0.45±0.15)mg/L、(0.41±0.15)mg/L及(0.38±0.08)mg/L;同时,硝酸盐氮分别由初始的(7.48±7.91)mg/L、(12.87±5.81)mg/L、(12.87±5.81)mg/L及(13.55±6.18)mg/L升为(128.37±11.03)mg/L、(141.43±12.71)mg/L、(148.01±14.84)mg/L及(146.22±7.53)mg/L。内源电子受体可将重力浓缩过程中释磷量分别削减85%、63%、64%及83%,同时使得由生产废水回流引起的氨氮积累量分别减少89.25%、69.93%、74.31%及85.40%。在整个内源电子受体产生及其应用于抑制污泥释磷阶段,TN去除率分别为39.59%、44.54%、51.86%及57.33%。上述内源电子受体胁迫条件下的浓缩过程中,不仅可以有效降低由重力浓缩释磷引起的磷积累量,且可同步实现减少由生产废水回流引起的氨氮积累量。     

Remediation of alachlor and atrazine contaminated water with zero-valent iron nanoparticles

Zero-valent iron nanoparticles (nZVI, diameter < 90 nm, specific surface area = 25 m² g^?1) have been used under anoxic conditions for the remediation of pesticides alachlor and atrazine in water. While alachlor (10, 20, 40 mg L^?1) was reduced by 92–96% within 72 h, no degradation of atrazine was observed. The alachlor degradation reaction was found to obey first-order kinetics very closely. The reaction rate (35.5 × 10^?3–43.0 × 10^?3 h^?1) increased with increasing alachlor concentration. The results are in conformity with other researchers who worked on these pesticides but mostly with micro ZVI and iron filings. This is for the first time that alachlor has been degraded under reductive environment using nZVI. The authors contend that nZVI may prove to be a simple method for on-site treatment of high concentration pesticide rinse water (100 mg L^?1) and for use in flooring materials in pesticide filling and storage stations.     

QSPR prediction of chromatographic retention times of pesticides: Partition and fractal indices

The high‐performance liquid‐chromatographic retentions of red‐wine pesticide residues are modeled by structure–property relationships. The effect of different types of features is analyzed: geometric, lipophilic, etc. The properties are fractal dimensions, partition coefficient, etc., in linear and nonlinear correlation models. Biological plastic evolution is an evolutionary perspective conjugating the effect of acquired characters and relations that emerge among the principles of evolutionary indeterminacy, morphological determination and natural selection. It is applied to design the co‐ordination index that is used to characterize pesticide retentions. The parameters used to calculate the co‐ordination index are the molar formation enthalpy, molecular weight and surface area. The morphological and co‐ordination indices barely improve the correlations. The fractal dimension averaged for non?buried atoms, partition coefficient, etc. distinguishes the pesticide molecular structures. The structural and constituent classification is based on nonplanarity, and the number of cycles, and O, S, N and Cl atoms. Different behavior depends on the number of cycles.