氧气顶吹炼钢尘泥湿式回转窑制粒法

用湿式回转窑工艺设备,在窑内相继对真空过滤机产生的尘泥(含水40％左右)进行初步干燥、造粒、烧结三个过程。经烧结的粒块粒径大于等于3mm的占92.4％。这种粒块返回炼钢工序作造渣剂,实现尘泥厂内消纳。产品生产燃料消耗为3.18×10~6kJ/t。     

城镇污水处理厂脱氮除磷好氧污泥颗粒化研究

采用序批式生物反应器(SBR)培养好氧颗粒污泥处理模拟废水,优化好氧颗粒污泥内部好氧-兼氧-厌氧微环境,在反应器的快速启动、稳定运行阶段分别考察不同优化条件下系统的脱氮除磷性能。提出了优化污泥沉降时间、调控曝气方式等好氧污泥快速颗粒化途径,并研究排泥方式对颗粒污泥反应器稳定性的影响,通过强化脱氮除磷功能菌富集,实现氮磷同步高效去除。     

脉冲上流式厌氧污泥床反应器的应用

将传统的连续式改为间歇式配水,可改善反应器的水力环境,促进基质与生物体之间的有效接触。脉冲配水使污泥的有机负荷ＣＯＤ达２７．５ｇ／（Ｌ．ｄ）．ＨＲＴ降到约３ｈ,加速了污泥的颗粒化进程,４７ｄ培养出良好的颗粒污泥。脉冲配水不会造成冲击负荷和中间产物积累,也不会造成大量的污泥流失。在高负荷条件下,颗粒污泥中确实出现了大量的八叠甲烷球菌凝块。     

Formation of aerobic granules in the presence of a synthetic chelating agent

This paper examines the development of aerobic granular sludge in the presence of a synthetic chelating agent, nitrilotriacetic acid (NTA), in sequencing batch reactors (SBR). The growth of seed sludge at 0.26 mM, 0.52 mM and 1.05 mM of NTA was found to be significantly lower as compared to that in the absence of NTA. Aerobic granulation was significantly enhanced in the three SBRs (R2, R3 and R4), which were fed with 0.26 mM, 0.52 mM and 1.05 mM of NTA as a co-substrate, in comparison to the acetate-alone fed SBR (R1). After 2 months of operation, the mean diameter of the biomass stabilized at 0.35 mm in R1 (acetate alone), as compared to 2.18 mm in R4 (1.05 mM NTA+acetate). NTA degradation was established in SBRs, with almost complete removal during the SBR cycle. Batch experiments also showed efficient degradation of NTA by the aerobic granules.     

Insights into sludge granulation during anaerobic treatment of high-strength leachate via a full-scale IC reactor with external circulation system

In this study, a full-scale internal circulation(IC) reactor coupled with an external circulation system was developed to treat high-strength leachate from a municipal solid waste(MSW)incineration plant, in which anaerobic sludge granulation was intensively investigated. Results showed that the IC reactor achieved excellent treatment performance under high organic loading rates(OLR) of 21.06–25.16 kg chemical oxygen demand(COD)/(m3? day). The COD removal efficiency and biogas yield respectively reached 89.4%–93.4% and 0.42–0.50 m3/kg COD.The formation of extracellular polymeric substances(EPS) was closely associated with sludge granulation. Protein was the dominant component in sludge EPS, and its content was remarkably increased from 21.6 to 99.7 mg/g Volatile Suspended Solid(VSS) during the reactor operation. The sludge Zeta potential and hydrophobicity positively correlated with the protein/polysaccharide ratio in EPS, and they were respectively increased from-26.2 m V and 30.35% to-10.6 m V and 78.67%, which was beneficial to microbial aggregation. Three-dimensional fluorescence spectroscopy(3 D-EEM) and Fourier transform infrared spectroscopy(FT-IR)analysis further indicated the importance of protein-like EPS substances in the sludge granulation. Moreover, it was also found that the secondary structures of EPS proteins varied during the reactor operation.     

SBR加载不同粒径磁性活性炭对其污泥颗粒化进程的影响机制

在相同序批式活性污泥反应器(SBR)中分别加载1.5 g·L~(-1)的80、140、200、和300目不同粒径的磁性活性炭(反应器编号依次为2、3、4、5号),同时以不投加磁性活性炭的SBR反应器(1号)作为对照组,研究各反应器污泥体积指数(SVI)、粒径分布特征、胞外聚合物(EPS)中胞外蛋白(PN)、胞外多糖(PS)的含量变化规律以及除污性能.结果表明,不同粒径磁性活性炭对污泥颗粒化进程有一定的影响,粒径过大、过小对促进污泥颗粒化进程的强化作用不明显,当磁性活性炭的粒径为140目和200目时,活性污泥很容易以其作为"成核"载体快速形成好氧颗粒污泥,并且形成的颗粒污泥结构紧密,沉降速率快.采用高斯函数分析污泥粒径分布和标准偏差发现,反应器运行的第50 d,3号和4号反应器内污泥平均粒径均达到了780μm以上,明显高于其他反应器,标准偏差分别为318.9μm和362.3μm,两反应器内形成的颗粒污泥粒径较均匀,处理系统较稳定.与此同时,投加不同粒径的磁性活性炭均有利于促进污泥胞外蛋白质PN含量的增加,对胞外多糖PS的含量影响不大;但合适的磁性活性炭粒径(140目和200目)越有利于污泥PN的分泌,颗粒化程度明显的3号和4号反应器的PN/PS比值均高于其他3个反应器.磁性炭基好氧颗粒污泥的形成符合"惰性内核模型".此外,3号、4号反应器对废水TN和TP的去除率分别达到50%和60%以上,均高于其他反应器.     

好氧污泥颗粒化过程的影响因素分析

影响好氧颗粒污泥性质的因素多且复杂,具有灰色系统的特点.应用了灰色关联分析方法对好氧颗粒污泥的重要参数污泥体积指数(SVI)、沉降速率、颗粒粒径和污泥浓度(MLSS)进行了关联影响分析.结果表明:对颗粒污泥SVI的影响顺序为沉降速率＞颗粒粒径＞ MLSS,说明沉降速率对活性污泥的形态转变和颗粒化过程的作用最明显,SVI可作为评判颗粒化进程的一个理想指标;沉降速率对MLSS的影响最弱;颗粒粒径的最佳值为1.3～1.5 mm,此时,颗粒粒径对SVI降低的贡献最大,从而使颗粒污泥的沉降性能得到很大改善,并且使MLSS达到最大.     

加速厌氧污泥颗粒化的研究进展

厌氧污泥颗粒化过程是一个多阶段过程,取决于操作条件、基质组成等多种因素.在简述污泥颗粒化机理及影响因素的基础上,综述了近年来加速厌氧污泥颗粒化的研究进展,指出厌氧污泥颗粒化应用前景广阔,并提出了几点建议.希望能为厌氧污泥颗粒化技术的工程实践提供一定的理论基础.     

厌氧反应器中污泥迅速颗粒化研究

以实验室规模的厌氧膨胀污泥床反应器(简称EGSB)内的活性污泥为研究对象，主要讨论影响活性污泥迅速颗粒化的因素，以加快絮状污泥的颗粒化进程。采用对比的实验方法，分别在反应器内加入小球藻和活性炭为载体进行对照实验。结果表明，小球藻和活性炭的加入在迅速提高COD去除率，污泥粒径增大和增强颗粒污泥沉降性方面有明显优势，胞外多聚物的含量均比接种时和对照实验中的相关数据有明显增加，颗粒污泥表面以产甲烷丝状菌和杆状菌为主。小球藻和活性炭的加入有助于加快活性污泥的颗粒化进程。     

Fe3O4对厌氧处理系统的强化作用研究

投加Fe₃O₄能够在一定程度上强化有机物的厌氧降解过程,而进水有机负荷是影响厌氧系统处理效率的重要因素.本研究通过分阶段提升进水有机负荷,对比考察了Fe₃O₄的加入对UASB厌氧反应器运行效能及污泥性质的影响.结果表明,当有机负荷低于3.2 kg·m^-3·d^-1时,两反应器内有机物厌氧水解效率并无显著性差别.而当有机负荷提升至6.4、12.8、25.6 kg·m^-3·d^-1时,Fe₃O₄对有机物厌氧水解效率表现出一定的促进效果,且有机负荷越高,Fe₃O₄对厌氧水解的促进效果越显著.与此同时,Fe₃O₄对厌氧产甲烷过程也表现出明显的促进作用,在有机负荷分别为1.6、3.2、6.4、12.8、25.6 kg·m^-3·d^-1时,添加Fe₃O₄的反应器中平均甲烷产率分别为对照组的3.55、2.37、1.26、1.16和1.06倍.这一现象表明Fe₃O₄对产甲烷过程的促进效果与有机负荷密切相关,且有机负荷越低,Fe₃O₄对厌氧产甲烷效率的增强作用越明显.此外,本研究还分析了运行过程中污泥粒径和胞外聚合物的变化,发现Fe₃O₄的加入可以有效促进厌氧污泥颗粒化进程.