Using multivariate regression modeling for sampling and predicting chemical characteristics of mixed waste in old landfills

Municipal solid waste landfills pose a threat on environment and human health, especially old landfills which lack facilities for collection and treatment of landfill gas and leachate. Consequently, missing information about emission flows prevent site-specific environmental risk assessments. To overcome this gap, the combination of waste sampling and analysis with statistical modeling is one option for estimating present and future emission potentials. Optimizing the tradeoff between investigation costs and reliable results requires knowledge about both: the number of samples to be taken and variables to be analyzed.This article aims to identify the optimized number of waste samples and variables in order to predict a larger set of variables. Therefore, we introduce a multivariate linear regression model and tested the applicability by usage of two case studies. Landfill A was used to set up and calibrate the model based on 50 waste samples and twelve variables. The calibrated model was applied to Landfill B including 36 waste samples and twelve variables with four predictor variables.The case study results are twofold: first, the reliable and accurate prediction of the twelve variables can be achieved with the knowledge of four predictor variables (Loi, EC, pH and Cl). For the second Landfill B, only ten full measurements would be needed for a reliable prediction of most response variables. The four predictor variables would exhibit comparably low analytical costs in comparison to the full set of measurements. This cost reduction could be used to increase the number of samples yielding an improved understanding of the spatial waste heterogeneity in landfills.Concluding, the future application of the developed model potentially improves the reliability of predicted emission potentials. The model could become a standard screening tool for old landfills if its applicability and reliability would be tested in additional case studies.     

抗铬菌株的筛选鉴定及其生物学特性和吸附特性

利用微生物分离纯化技术,在培养基中加入不同浓度的Cr3+、Cr6+,经过长时间驯化,从污染土壤中筛选出2株对Cr具有较高抗性的菌株(A和B),对其进行了形态、生理生化特性及分子生物学鉴定,并研究了其最佳生长条件及对Cr3+的生物吸附规律。结果表明,菌株A和B分别为蜡状芽孢杆菌(Bacillus cereus)和米根霉菌(Rhizopus oryzae)。菌株A和B的最适生长pH值均为7,最适生长温度均为30℃,最佳装液量为80~100 mL(250 mL摇瓶)。在培养时间一定时,随着Cr3+浓度的增加,菌株对Cr3+的吸附率减少,而生物吸附量则逐渐增大;在Cr3+浓度一定时,随着培养时间的延长,菌体对Cr3+的吸附率呈现出先增加后减少的趋势,这与生物吸附量的变化趋势基本一致。在Cr3+浓度为100 mg/L时,菌株A和B对Cr3+的吸附率达到最大,分别为51.47%和46.36%。     

石墨气体扩散电极的制备与性能优化

电极的制备工艺及参数直接影响电极材料的活性。主要考察了C/PTFE质量比、碾压压力、煅烧温度、造孔剂NH4HCO3及稀土掺杂等因素对电极产出H2O2的影响规律。研究结果表明,电极最佳制备条件为:石墨和PTFE质量比为2∶1、石墨、造孔剂和稀土元素质量比为6∶1∶1、碾压压力10 MPa、煅烧温度330℃。在pH=3、电解质Na2SO4浓度为0.05mol/L条件下,电解2 h后,改性电极产生的H2O2从95 mg/L提高到350 mg/L,提高了268.4%。     

膜吸收法净化低浓度甲醛和氨气简

基于膜吸收技术自制双层平板式膜吸收器,搭建净化低浓度甲醛和氨气污染模拟系统,考察不同膜结构参数、进气流量、吸收剂流量等因素对其净化效果的影响。结果表明,聚偏氟乙烯PVDF对低浓度甲醛和氨气的净化效率高于聚四氟乙烯PTFE。对同一材质膜,随着膜孔隙率的增大,甲醛和氨气的净化率呈上升趋势。随着进气流量的增加,甲醛和氨气的净化效率降低;而吸收剂流量对其净化效率影响不大。对于所有实验条件,平均膜孔径为0.22 μm的PVDF 4^#在进气流量u_g=120 L/h时,甲醛和氨气的净化效率最高,分别达94.7%和96.3%。     

A method for determining the analytical form of a radionuclide depth distribution using multiple gamma spectrometry measurements

When characterizing environmental radioactivity, whether in the soil or within concrete building structures undergoing remediation or decommissioning, it is highly desirable to know the radionuclide depth distribution. This is typically modeled using continuous analytical expressions, whose forms are believed to best represent the true source distributions. In situ gamma ray spectroscopic measurements are combined with these models to fully describe the source. Currently, the choice of analytical expressions is based upon prior experimental core sampling results at similar locations, any known site history, or radionuclide transport models. This paper presents a method, employing multiple in situ measurements at a single site, for determining the analytical form that best represents the true depth distribution present. The measurements can be made using a variety of geometries, each of which has a different sensitivity variation with source spatial distribution. Using non-linear least squares numerical optimization methods, the results can be fit to a collection of analytical models and the parameters of each model determined. The analytical expression that results in the fit with the lowest residual is selected as the most accurate representation. A cursory examination is made of the effects of measurement errors on the method.     

超声波提取-恒波长同步荧光法测定淡水藻中叶绿素a的含量

针对绿藻,采用超声波提取,以荧光激发-发射波长差216nm,建立了同步荧光法测定绿藻叶绿素a含量的新方法,其线性范围为0.02～1.25 mg/L,检出限为1.6ug/L,加标回收率在97.0%～104%之间。与分光光度法测定叶绿素a的对比试验结果表明,两者无显著性差异,但该方法具有快速、灵敏,其他常见色素不干扰测定的优点,能够满足供水中绿藻叶绿素a含量快速检测的需要。     

Determination of o-phthalic acid in snow and its photochemical degradation by capillary gas chromatography coupled with flame ionization and mass spectrometric detection

Phthalic acid and its photochemical degradation has been determined in snow and rainwater samples collected during winters (2003-2010) in the Southeast of Massachusetts using capillary gas chromatography (GC) with flame ionization and mass spectrometric detection. Water samples were dried using a rotary evaporator and derivatized with a 14% BF₃/methanol reagent before GC analysis. The developed method proved simple and accurate. Phthalic acid was found in snow samples collected in a concentration range of 7.22-76.5 nM. The photodegradation of phthalate was carried out under 300 nm UV light. The direct photodecomposition of the acid is slow (5% h⁻¹). However, the addition of dissolved Fe(III) species at 2.0 μM accelerated the light-induced degradation of phthalic acid by 3.5 times in the atmospheric water samples. Photodegradation rates of phthalic acid increases with decreasing pH value of water samples in the range of pH 2.8-4.5.     

Photophysical and photochemical properties of the pharmaceutical compound salbutamol in aqueous solutions

Salbutamol is a potent β₂-adrenergic receptor agonist widely used in the treatment of bronchial asthma and chronic obstructive pulmonary disease. An increasing number of studies have detected salbutamol in natural water systems worldwide. Studies have shown that sunlight degrades salbutamol resulting in the formation of products; some showing higher toxicity to bacteria Vibrio fischeri than the parent compound. In this contribution, steady-state absorption and emission techniques, high-performance liquid chromatography, and transient absorption spectroscopy are used to investigate the photochemistry of salbutamol in aqueous buffer solutions at controlled pH values. Ground- and excited-state calculations that include solvent effects are performed to guide the interpretation of the experimental results. Salbutamol is sensitive to UVB light absorption in the pH range from 3 to 12, forming products that absorb light at longer wavelengths than the parent compound. Quantum yields of degradation reveal that the deprotonated species is 10-fold more photo-active than the protonated species. In line with this result, the fluorescence quantum yield of the protonated species is more than an order of magnitude higher than that of the deprotonated species. Transient absorption spectroscopy shows that population of the triplet state occurs with a rate constant of 7.1 × 10⁸ s⁻¹ in the protonated species, while a rate constant of 1.7 × 10¹⁰ s⁻¹ is measured for the deprotonated species. While degradation of the deprotonated species is not affected by the presence of molecular oxygen, a twofold increase in the photodegradation yield of the protonated species in air-saturated conditions is observed.     

O3氧化结合化学吸收同时脱硫脱硝的动力学及热力学研究

构建了O3氧化多种污染物的反应机制,并对O3氧化SOx、NOx过程进行动力学模拟,然后利用热力学原理计算出Ca(OH)2和CaCO3湿法烟气同时脱硫脱硝吸收反应达到平衡时SOx和NOx的分压力.结果表明,Ca(OH)2作吸收剂湿法烟气同时脱硫脱硝比CaCO3作吸收剂效果好,而且两者几乎100％地去除烟气中的SOx和NO...     

半干法烟气脱硫除尘多级功能处理装置技术与应用

文中介绍了一种炉窑烟气调质、烟气除尘、烟气脱硫在一个单体结构中的一体化装置和在烟气除尘脱硫技术上的应用,并对该脱硫除尘装置与传统的半干法烟气脱硫除尘装置进行了比较。