Usability of non-standard lower anchor configurations for child restraint system (CRS) installation

Abstract

Objectives: The objective of this study was to determine whether the amount of tension required for proper child restraint system (CRS) installation varies with lower anchor spacing and to determine whether nonexperts can produce adequate tension on wider-than-standard lower anchor configurations.

Methods: CRSs were installed by certified child passenger safety technicians (CPSTs; n?=?6 subjects, n?=?72 installations) and nonexperts (n?=?30 subjects, n?=?120 installations) on a mock-up vehicle seat fixture with lower anchors set at 11 (standard), 15, 19, and 23 in. apart from one another. Each CPST installed a rear-facing (RF) infant base, RF convertible, and forward-facing (FF) convertible into each of the 4 spacing configurations in random order. The CPSTs were instructed to tighten the lower connector strap until the tension was exactly at the threshold between passing and failing the 1-in. test. Each nonexpert installed one CRS model into all 4 spacing conditions in random order. Nonexperts were instructed to install the CRS to the best of their ability. The tension produced on the lower connector strap was recorded via load cell in the lower anchor assembly of the vehicle seat. Resultant tension magnitudes were compared across spacing conditions using matched pair t-tests. The CPSTs’ mean 1-in. test threshold values were compared to tensions produced by nonexperts. Installations were visually evaluated for errors and qualitative usability feedback was collected via survey.

Results: CPSTs installed the infant base with higher tensions in the 15-, 19-, and 23-in. configurations compared to the standard 11-in. configuration (P = .034, .032, and .003, respectively). The nonexperts installed the infant base with higher tension in the 15- and 23-in. configurations compared to the 11-in. configuration (P = .004 and .026, respectively). The RF convertible and FF convertible installations showed no significant differences in tension among any of the spacing configurations for either group. Only 19% of the nonexperts’ installations were tight enough to pass CPST thresholds, and the pass rate did not vary with respect to lower anchor spacing. In feedback surveys, the nonexpert group did not show a consistent preference for either standard or wider-than-standard lower anchor configurations.

Conclusions: The amount of tension required to pass the 1-in. rule did not vary with lower anchor spacing configurations for the RF and FF convertible CRS, but the infant base required more tension in wider anchor configurations. Nonexperts tended to produce less than ideal tension in all configurations, although their tension magnitudes increased for the infant base in wider configurations.     

供水管网震后流量监测点的动态分级优化布局研究

为了提高管网地震监测点布局的准确性和合理性,基于管网微观水力计算模型和动态分级法,提出供水管网震后流量监测点的动态分级优化布局模型。首先,利用管网微观水力计算模型计算管段流量的影响系数,构建管段的影响系数矩阵,并利用信息熵确定管段权重;其次,标准化处理影响系数矩阵,通过聚类迭代提出供水管网地震流量监测点优化布局的动态分级方法,对供水管网震后流量监测点进行优化布置分级评定;最后,根据工程实例进行方法实践,结果表明:供水管网中的管线分类较为科学合理,地震监测点在供水管网上分布也比较均匀,而且该模型在一定程度上消除了人为因素的影响,保障了震时管网的监控效果和日常建设的合理性。     

走滑断层作用下X80管道设计应变规律和神经网络预测

走滑断层是埋地管道常见的地质灾害威胁,断层作用下管道会发生较大的拉压应变而失效。为得到X80管道的设计应变,基于有限元方法建立了走滑断层作用下管道的应变响应数值计算模型,模型使用壳单元模拟管道,非线性弹簧单元模拟土壤约束,采用西二线实际工程的管道应变影响参数范围,计算了管道的设计应变;为预测管道的设计应变值,基于以上参数化分析得到的4 817组设计应变结果,采用人工神经网络建立了管道设计应变预测模型。结果表明:该神经网络模型预测结果的最大相对误差小于10%,预测准确性良好,且该方法具有较高的计算效率,可以为断层作用下埋地管道的应变设计与评估提供参考。     

H∞ loop-shaping controller design for a grid-connected single-phase photovoltaic system

This paper presents a H_∞ loop-shaping controller for controlling dc-link voltage by regulating the switching signal of the inverter associated with a grid-connected single-phase photovoltaic system. To facilitate a robust control design, state-space realisation of the system model is made with uncertainties represented by linear fractional transformation. The controller is achieved through H_∞ synthesis followed by obtaining desired loop shapes through the choice of the proper weighting functions. The controller order is reduced by Henkel-norm method for facilitating its practical implementation. Controller performance is evaluated through carrying out simulations on MATLAB/Simulink platform under standard and changing atmospheric conditions, and fault condition.     

Development of a fuel cell propulsion system for the existing Mercedes B-Class 160 of petrol driven car

This paper presents a theoretical comparison between fuel cell (FC) power train and conventional petrol driven propulsion system. FC has potential to reduce the CO₂-emissions from road. However, FC power trains require energy storing device, to meet the peak power during extreme drive situations and also able to recover the kinetic energy of the vehicle during break operation. The proposed system includes a polymer electrolyte membrane fuel cell (PEMFC) based drive train and a super capacitor connected in parallel. The system is designed and dimensioned for a conventional petrol driven propulsion system of the Mercedes B-Class160. The feasibility study also includes comparison between the existing conventional systems. It is shown that although FC power train is heavier compared to existing system, urban performance is better and produces no CO₂ and other harmful emissions.     

公众生态文明素养及其科普教育研究

本文对国家文明城市芜湖市进行实地问卷调查发现:公众具有一定生态意识,但生态文明素养整体状况不佳。公众对生态文明概念比较了解和很了解的只占17.7%;各类人群对周围环境关注度较高,均在65%左右;有相关生态知识或行为的公众占92%;有76.7%的人表示没有破坏环境的行为;64.8%的受访者表示他们有保护环境的行为。通过生态科普教育现状调查发现:受访者对目前生态科普教育满意度只有25.9%,政府在生态科普教育方面还存在活动流于形式、创新性不强、投入不足、制度不完善、不能及时回应公众关切热点、专项科普匮乏、媒体不给力、内容不接地气、无区域特色、平台手段落后等问题。提出了提升公众生态文明素养需构建四个相互联动的科普教育体系:高度重视生态科普教育的思想体系、支撑生态科普教育的技术能力体系、生态科普教育的长效机制体系和具有区域特色生态科普教育内容体系。     

生态文明制度体系研究——以江苏省为例

生态文明制度体系是由制度构成的一个相互配合、有机联系的整体。本文基于文献统计分析与实地调研咨询,从广义和狭义层面,分别对生态文明制度进行梳理。根据国家生态文明建设需求与省级层面实际情况,本文将广义的生态文明制度体系分为源头保护制度体系、损害赔偿与激励体系、追责考评制度体系和污染治理制度体系四大板块,并针对国家与省级重点生态文明制度,构建生态资源保护制度链与污染防治制度链。同时,对制度地位、制度衔接、相互关系及其优化选择进行分析,以提高环境管理效能,推进生态文明研究纵深发展。     

于GRI体系的机场企业环境信息披露研究

机场作为民航运输的关键节点和重要枢纽,肩负着服务区域经济的重要使命,同时也面临环境保护与可持续发展的巨大挑战。作为公共基础设施和城市形象窗口,机场上市公司具有披露环境信息的义务与责任。在充分研究国内机场上市公司环境信息披露制度背景的基础上,本研究借鉴全球报告倡议组织（GRI）发布的《可持续发展报告指南》（第四版）及机场运营者行业补充（GRI-AOSS）构建了适用于我国机场的环境信息披露评价指标体系,并利用公开数据对国内6家机场上市公司的环境信息披露情况进行了实际测评。结果表明：我国机场环境信息披露程度较低,存在内容简单、量化不足、质量下降等问题。机场上市公司环境信息披露亟待在法律法规层面进行系统规范。建议借鉴GRI等相关国际标准及成功经验,制定适用于我国的科学可行的环境信息披露标准和制度体系。     

水环境中石油类物质分析方法探讨

在详述了国内外石油类分析方法的基础上,对各方法的适用范围、优缺点及可比性进行了深入分析,阐述了各类方法存在的共性问题,指出按照石油类物质毒性大小分别定量分析的方法将是未来的发展趋势。     

金属冶炼进口物料的固体废物鉴别方法

建立了金属冶炼进口物料的固体废物鉴别方法,并利用该方法对海关查扣的3种金属冶炼进口物料进行了固体废物鉴别。鉴别结果显示:物料1、2和3的自然属性分别为砷含量超标铜精矿、锰阳极泥、回转窑氧化锌,产生来源分别为有害物质超标的产品、污染控制设施产生的物质、有意识加工的目标产物;物料1和2属于我国禁止进口的固体废物,物料3不属于固体废物。本文建立的固体废物鉴别方法可行,可为金属冶炼进口物料的固体废物鉴别和监管提供参考。