臭氧/混凝预处理工艺降低膜污染的研究

采用臭氧和混凝工艺分别处理黄浦江原水后进行MF膜过滤试验,考察2种预处理工艺对有机物的作用,进而考察其对MF膜过滤特性的影响.结果表明,2种预处理工艺都存在一个使膜污染下降率达到最大的最佳投药量.2种预处理工艺中,混凝降低膜污染的效果要好于臭氧,这主要与2种预处理工艺所去除的有机物性质有关.黄浦江水中有机物相对分子质量主要集中在3×103～5×103范围内,膜化学清洗液的分析表明造成膜污染的有机物相对分子质量主要集中在4.5×103附近,臭氧对相对分子质量在3×103附近的有机物去除效果较好,而混凝主要去除5×103附近的较大相对分子质量的有机物,因而混凝对这部分污染膜物质的去除效果要好于臭氧,从而有效降低了膜污染.     

日本森林大气中过氧化物的浓度及其对森林植物的影响

为了研究森林衰退的原因,于2000,2001和2002年的8月,分别选择出现森林衰退的日本奥日光白根山落叶树森林和未出现森林衰退的长野县大芝高原红松森林设立监测点,对光化学氧化剂臭氧(O3)和过氧化物的浓度进行监测,同时利用人工气候室对森林植物山毛榉和白桦进行了50′10-9O3、100′10-9O3和50′10-9O3+2′10-9~3′10-9过氧化物(过氧化氢(H2O2)及甲基过氧化氢(MHP))的暴露实验.野外监测结果表明,监测期间奥日光和长野的O3平均浓度相同,奥日光的H2O2及MHP平均浓度均高于长野;大气中的H2O2和MHP总是与O3共存,并且其浓度随O3浓度的增加而增加.暴露实验结果表明,暴露于50′10-9O3+2′10-9~3′10-9过氧化物的山毛榉和白桦出现了不同于O3暴露的叶片伤害症状;与100′10-9O3相比,50′10-9O3+2′10-9~3′10-9过氧化物导致植物出现了严重的叶片伤害和显著的光合速率下降.研究结果表明,除O3外,大气中的过氧化物也是导致森林衰退的原因之一.     

A numerical study of summer ozone concentration over the Kanto area of Japan using the MM5/CMAQ model

We assessed the ability of the MM5/CMAQ model to predict ozone (O3) air quality over the Kanto area and to investigate the factors that a ect simulation of O3. We find that the coupled MM5/CMAQ model is a useful tool for the analysis of urban environmental problems. The simulation results were compared with observational data and were found to accurately replicate most of the important observed characteristics. The initial and boundary conditions were found to have a significant e ect on simulated O3 concentrations. The results show that on hot and dry days with high O3 concentration, the CMAQ model provides a poor simulation of O3 maxima when using initial and boundary conditions derived from the CMAQ default data. The simulation of peak O3 concentrations is improved with the JCAP initial and boundary conditions. On mild days, the default CMAQ initial and boundary conditions provide a more realistic simulation. Meteorological conditions also have a strong impact on the simulated distribution and accumulation of O3 concentrations in this area. Low O3 concentrations are simulated during mild weather conditions, and high concentrations are predicted during hot and dry weather. By investigating the e ects of di erent meteorological conditions on each model process, we find that advection and di usion di er the most between the two meteorological regimes. Thus, di erences in the winds that govern the transport of O3 and its precursors are likely the most important meteorological drivers of ozone concentration over the central Kanto area.     

低温等离子体-催化协同降解挥发性有机废气

低温等离子体-催化协同技术适合于各类挥发性有机物的治理,特别是大气量低浓度的有机废气的处理.高效催化剂的加入可 以显著提高等离子体反应中有机废气的降解效率,减少有害副产物的生成以及提高反应器的能量利用率.从反应器、催化剂以及背景气体等方面探讨了该技术实现产业化需要解决的问题,结合低温等离子体与催化剂的相互作用、等离子体...     

广州大气挥发性有机物的臭氧生成潜势及来源研究

2008年秋季在广州城区及其下风向沿海乡村地区采用活性炭吸附管采集大气挥发性有机化合物(VOC),应用二次热解吸-GC/MS联用技术测量56种VOC的大气浓度,研究在典型海陆风条件下VOC的组成特征和日变化规律,并采用臭氧最大增量及OH自由基反应活性两种方法估算了该地区各VOC的臭氧生成潜力,探讨了VOC优先控制物种及...     

臭氧处理循环冷却水节能减排效益分析

文章基于臭氧(O3)处理法处理循环冷却水因可以同时达到阻垢脱垢、缓蚀、杀菌等多重功能,其在国外已得到广泛应用,同时国内也逐步普及应用的环境下,结合国内外长期的工程实践经验,从节水、节能、减排和公共卫生效益四个方面,详细分析了臭氧处理循环冷却水所带来的巨大经济效益、社会效益和环境效益。     

臭氧对枯草芽孢杆菌孢子的灭活研究

隐孢子虫灭活困难,给饮用水安全带来了挑战。实验以枯草芽孢杆菌孢子(ATCC6633)作为隐孢子虫的指示菌,研究了臭氧浓度、浊度、有机物、温度等因素对臭氧灭活枯草芽孢杆菌孢子的影响。研究表明,臭氧对枯草芽孢杆菌孢子的灭活与CT值相关,臭氧浓度对消毒效果影响较小;降低浊度、有机物含量,能提高臭氧对枯草芽孢杆菌孢子的灭活效率;温度降低,为保证一定的消毒效率,所需的CT值越大。研究结果为水厂合理控制运行参数提供了借鉴。     

Carbonyl emissions from heavy-duty diesel vehicle exhaust in China and the contribution to ozone formation potential

Fifteen heavy-duty diesel vehicles were tested on chassis dynamometer by using typical heavy duty driving cycle and fuel economy cycle. The air from the exhaust was sampled by 2,4- dinitrophenyhydrazine cartridge and 23 carbonyl compounds were analyzed by high performance liquid chromatography. The average emission factor of carbonyls was 97.2 mg/km, higher than that of light-duty diesel vehicles and gasoline-powered vehicles. Formaldehyde, acetaldehyde, acetone and propionaidehyde were the species with the highest emission factors. Main influencing factors for carbonyl emissions were vehicle type, average speed and regulated emission standard, and the impact of vehicle loading was not evident in this study. National emission of carbonyls from diesel vehicles exhaust was calculated for China, 2011, based on both vehicle miles traveled and fuel consumption. Carbonyl emission of diesel vehicle was estimated to be 45.8 Gg, and was comparable to gasolinepowered vehicles （58.4 Gg）. The emissions of formaldehyde, acetaldehyde and acetone were 12.6, 6.9, 3.8 Gg, respectively. The ozone formation potential of carbonyls from diesel vehicles exhaust was 537 mg O3/km, higher than 497 mg O3/km of none-methane hydrocarbons emitted from diesel vehicles.     

化学合成类制药行业工艺废气VOCs排放特征与危害评估分析

以浙江台州6家典型化学合成类制药企业为代表,对其排放工艺废气中的18项挥发性有机物(VOCs)特征污染物(如甲苯、甲醛、二氯甲烷等)进行监测和分析,并采用臭氧产生潜力(OFP)和健康风险评价指标对VOCs所产生的环境与健康危害进行初步的评价.结果表明,化学合成类制药企业排放的总VOCs浓度为14.9~308.6 mg·m-3,其产生环境危害的OFP值为3.1~315.1 mg·m-3,主要贡献物质为甲苯、四氢呋喃、乙酸乙酯等6种物质,存在较大的潜在环境危害.另外,健康危害中的非致癌风险指数和总致癌风险指数介于9.48×10-7~4.98×10-4a-1和3.17×10-5~6.33×10-3之间,主要是苯、甲醛和二氯甲烷这3种致癌物.     

Fe-Ce/GAC催化臭氧降解高浓度腐殖酸废水

采用浸渍焙烧法制备了Fe-Ce/GAC催化剂,并用于催化臭氧降解模拟高浓度腐殖酸废水.以废水COD、腐殖酸浓度为考察指标,研究了Fe-Ce/GAC催化剂的前驱体无机铁盐种类、焙烧温度、铁盐浓度、助剂稀土元素种类及浓度、分散剂硝酸钾浓度等不同制备条件对催化臭氧降解腐殖酸的效果.试验表明,在腐殖酸浓度为3.00 g·L~(-1)、pH值约8.0、温度为25℃、臭氧投量为1.24 g·h~(-1),反应40 min后COD、腐殖酸去除率仅为17.1%、43.0%;添加以2.0%硝酸铁、1.5%硝酸铈、1.0%硝酸钾溶液浸渍,经350℃焙烧3 h后制备的Fe-Ce/GAC催化剂,可使COD、腐殖酸去除率分别提高40.3%、31.8%.且Fe-Ce/GAC催化剂具有较好的稳定性,重复使用5次后,COD、腐殖酸去除率仅小幅降低了4.2%、9.1%.SEM图象显示活性炭经改性后,比表面积明显增大,有利于活性物质的负载;EDS分析表明催化剂负载了大量的Fe、Ce等金属物质;XRD图谱显示催化剂含有Fe_2O_3、CeO_2等多种活性物质.Fe-Ce/GAC催化臭氧的机理可解释为:活性成分氧化铁在催化过程中生成的羟基氧化铁会促进羟基自由基的生成,而铈元素在催化过程中不仅会提高催化剂的活性,而且生成的化学吸附氧可促进对有机物的吸附及氧化.