盐城市区环境空气污染原因分析及对策建议

通过对盐城市区建成空气自动监测站来的数据分析,简要说明了盐城市区环境空气质量下降的原因,并提出了改善城市大气污染的建议措施。     

A hybrid method for quasi-three-dimensional slope stability analysis in a municipal solid waste landfill

Limited space for accommodating the ever increasing mounds of municipal solid waste (MSW) demands the capacity of MSW landfill be maximized by building landfills to greater heights with steeper slopes. This situation has raised concerns regarding the stability of high MSW landfills. A hybrid method for quasi-three-dimensional slope stability analysis based on the finite element stress analysis was applied in a case study at a MSW landfill in north-east Spain. Potential slides can be assumed to be located within the waste mass due to the lack of weak foundation soils and geosynthetic membranes at the landfill base. The only triggering factor of deep-seated slope failure is the higher leachate level and the relatively high and steep slope in the front. The valley-shaped geometry and layered construction procedure at the site make three-dimensional slope stability analyses necessary for this landfill. In the finite element stress analysis, variations of leachate level during construction and continuous settlement of the landfill were taken into account. The "equivalent" three-dimensional factor of safety (FoS) was computed from the individual result of the two-dimensional analysis for a series of evenly spaced cross sections within the potential sliding body. Results indicate that the hybrid method for quasi-three-dimensional slope stability analysis adopted in this paper is capable of locating roughly the spatial position of the potential sliding mass. This easy to manipulate method can serve as an engineering tool in the preliminary estimate of the FoS as well as the approximate position and extent of the potential sliding mass. The result that FoS obtained from three-dimensional analysis increases as much as 50% compared to that from two-dimensional analysis implies the significance of the three-dimensional effect for this study-case. Influences of shear parameters, time elapse after landfill closure, leachate level as well as unit weight of waste on FoS were also investigated in this paper. These sensitivity analyses serve as the guidelines of construction practices and operating procedures for the MSW landfill under study.     

Environmental assessment of garden waste management in the Municipality of Aarhus, Denmark

An environmental assessment of six scenarios for handling of garden waste in the Municipality of Aarhus (Denmark) was performed from a life cycle perspective by means of the LCA-model EASEWASTE. In the first (baseline) scenario, the current garden waste management system based on windrow composting was assessed, while in the other five scenarios alternative solutions including incineration and home composting of fractions of the garden waste were evaluated. The environmental profile (normalised to Person Equivalent, PE) of the current garden waste management in Aarhus is in the order of −6 to 8 mPE Mg⁻¹ ww for the non-toxic categories and up to 100 mPE Mg⁻¹ ww for the toxic categories. The potential impacts on non-toxic categories are much smaller than what is found for other fractions of municipal solid waste. Incineration (up to 35% of the garden waste) and home composting (up to 18% of the garden waste) seem from an environmental point of view suitable for diverting waste away from the composting facility in order to increase its capacity. In particular the incineration of woody parts of the garden waste improved the environmental profile of the garden waste management significantly.     

Substituting missing data in compositional analysis

Multivariate analysis of environmental data sets requires the absence of missing values or their substitution by small values. However, if the data is transformed logarithmically prior to the analysis, this solution cannot be applied because the logarithm of a small value might become an outlier. Several methods for substituting the missing values can be found in the literature although none of them guarantees that no distortion of the structure of the data set is produced. We propose a method for the assessment of these distortions which can be used for deciding whether to retain or not the samples or variables containing missing values and for the investigation of the performance of different substitution techniques. The method analyzes the structure of the distances among samples using Mantel tests. We present an application of the method to PCDD/F data measured in samples of terrestrial moss as part of a biomonitoring study.     

Engineered nanomaterials in rivers--exposure scenarios for Switzerland at high spatial and temporal resolution

Probabilistic material flow analysis and graph theory were combined to calculate predicted environmental concentrations (PECs) of engineered nanomaterials (ENMs) in Swiss rivers: 543 river sections were used to assess the geographical variability of nano-TiO₂, nano-ZnO and nano-Ag, and flow measurements over a 20-year period at 21 locations served to evaluate temporal variation. A conservative scenario assuming no ENM removal and an optimistic scenario covering complete ENM transformation/deposition were considered. ENM concentrations varied by a factor 5 due to uncertain ENM emissions (15%-85% quantiles of ENM emissions) and up to a factor of 10 due to temporal river flow variations (15%-85% quantiles of flow). The results indicate highly variable local PECs and a location- and time-dependent risk evaluation. Nano-TiO₂ median PECs ranged from 11 to 1′623 ng L⁻¹ (conservative scenario) and from 2 to 1′618 ng L⁻¹ (optimistic scenario). The equivalent values for nano-ZnO and nano-Ag were by factors of 14 and 240 smaller.     

O3氧化结合化学吸收同时脱硫脱硝的动力学及热力学研究

构建了O3氧化多种污染物的反应机制,并对O3氧化SOx、NOx过程进行动力学模拟,然后利用热力学原理计算出Ca(OH)2和CaCO3湿法烟气同时脱硫脱硝吸收反应达到平衡时SOx和NOx的分压力.结果表明,Ca(OH)2作吸收剂湿法烟气同时脱硫脱硝比CaCO3作吸收剂效果好,而且两者几乎100％地去除烟气中的SOx和NO...     

漓江上游植被覆盖度时空变化对地表热场影响

自20世纪80年代以来,桂林漓江由于上游森林遭受破坏出现水生态环境快速恶化的趋势。地表热场的时空变化直接影响森林蒸散及水文效应。因此,对漓江上游1989~2006年5景TM/ETM+卫星图像,利用归一化植被指数反演植被覆盖度,利用单窗算法反演地表温度,提出归一化温度使不同时相地表热场具有可比性,分析植被覆盖度时空变化对地表热场的影响。结果表明,在空间上,地表温度随植被覆盖度的增加而降低,在植被覆盖度很高或很低时,这种影响相对变弱;在时间上,漓江上游1989~2000年植被中、高度覆盖面积从96.1%逐年下降到65.9%,导致归一化地表温度数值较高的像元比例相应增加;2000~2006年植被中、高度覆盖面积逐渐恢复上升到90.8%,但仍略低于1989年,使得归一化地表温度数值较高的像元比例相应减少。植被覆盖可以有效地降低漓江上游地表温度     

An overview of the methods used in the characterisation of natural organic matter (NOM) in relation to drinking water treatment

Natural organic matter (NOM) is found in all surface, ground and soil waters. During recent decades, reports worldwide show a continuing increase in the color and NOM of the surface water, which has an adverse affect on drinking water purification. For several practical and hygienic reasons, the presence of NOM is undesirable in drinking water. Various technologies have been proposed for NOM removal with varying degrees of success. The properties and amount of NOM, however, can significantly affect the process efficiency. In order to improve and optimise these processes, the characterisation and quantification of NOM at different purification and treatment processes stages is important. It is also important to be able to understand and predict the reactivity of NOM or its fractions in different steps of the treatment. Methods used in the characterisation of NOM include resin adsorption, size exclusion chromatography (SEC), nuclear magnetic resonance (NMR) spectroscopy, and fluorescence spectroscopy. The amount of NOM in water has been predicted with parameters including UV-Vis, total organic carbon (TOC), and specific UV-absorbance (SUVA). Recently, methods by which NOM structures can be more precisely determined have been developed; pyrolysis gas chromatography-mass spectrometry (Py-GC-MS), multidimensional NMR techniques, and Fourier transform ion cyclotron resonance mass spectrometry (FTICR-MS). The present review focuses on the methods used for characterisation and quantification of NOM in relation to drinking water treatment.     

Virtual phosphorus ore requirement of Japanese economy

Phosphorus is indispensable for agricultural production. Hence, the consumption of imported food indirectly implies the import of phosphorus resources. The global consumption of agricultural products depends on a small number of ore-producing countries. For sustainable management of phosphorus resources, the global supply and demand network should be clarified. In this study, we propose the virtual phosphorus ore requirement as a new indicator of the direct and indirect phosphorus requirements for our society. The virtual phosphorus ore requirement indicates the direct and indirect demands for phosphorus ore transformed into agricultural products and fertilizer. In this study, the virtual phosphorus ore requirement was evaluated for the Japanese economy in 2005. Importantly, the results show that our society requires twice as much phosphorus ore as the domestic demand for fertilizer production. The phosphorus contained in “eaten” agricultural products was only 12% of virtual phosphorus ore requirement.     

制药废水有机污染物特性分析与处理

分析了某制药企业废水生物处理站进出水中有机污染物的相对分子质量分布和气相色谱—质谱图谱,提出了根据废水水质特性有针对性地确定制药废水处理工艺的新思路.实验结果表明:进出水中的有机污染物主要是相对分子质量小于1 000的物质,且主要来源于车间5排放的COD比重大、水量小的工段废水;采用旋转蒸馏预处理法处理车间5废水,可使...