Investigation of heavy metal contaminations in the lower Sakarya river water and sediments

In this work, water and sediment samples were collected from three different stations located along the Sakarya river between May and September 2003. Lead, copper, chromium, zinc, nickel and cadmium concentrations were determined by using solvent extraction and flame atomic absorption spectrometric method. The results show that differences based upon sampling times, regions, sediment and water samples were observed. The mean levels of copper, nickel, chromium, lead, cadmium, zinc for sediment samples are; 4.630 μg g⁻¹, 13.520 μg g⁻¹, 8.780 μg g⁻¹, 2.550 μg g⁻¹, 9.990 μg g⁻¹ and for water samples are; 0.851 μg g⁻¹, 1.050 μg g⁻¹, 0.027 μg g⁻¹, 1.786 μg g⁻¹, 0.236 μg g⁻¹, 0.173 μg g⁻¹, respectively.     

Optical and Chemical Methods of Metal Ash Analysis and Tin Recovery

‘Metal ash’ presents a waste disposal problem in most of the developing countries as the industries employ obsolete technologies. In this paper we describe analysis of tin ash, zinc ash and aluminium ash by means of optical methods, such as X-ray diffraction (XRD), inductively coupled plasma mass spectrometry (ICP-MS), electron probe micro analysis (EPMA), scanning electron microscopy (SEM) and chemical methods. The results of tin ash obtained by XRD method matched well with the cassiterite, a naturally occurring mineral of tin. ICP-MS studies reveal the presence of a large number of tracer metals, which may cause pollution by tertiary dispersion and this aspect is discussed. Conversely, the data generated by chemical methods are limited. However, the methods are simple and cost-effective. Then, they can easily be adopted by low-budget industries. Simple and cost-effective process to recover tin from tin ash is described. It is based on heating tin ash with sodium cyanide to about 900°C to separate tin component from the metal ash. The process recovers good quality tin and offers a very high yield. The process can be scaled up to small pilot plant.     

Effective removal of coordinated copper from wastewater using a new dithiocarbamate-type supramolecular heavy metal precipitant

A new dithiocarbamate-type heavy metal precipitant, sodium 1,3,5-hexahydrotriazinedithiocarbamate (HTDC), was prepared and used to remove coordinated copper from wastewater. In the reported dithiocarbamate-type precipitants, HTDC possesses the highest percentage of the effective functional groups. It could effectively precipitate copper to less than 0.5 mg l⁻¹ from both synthetic and actual industrial wastewater containing CuEDTA in the range of pH 3–9. UV–vis spectral investigation and elemental analysis suggested that the precipitate was a kind of coordination supramolecular compound, [Cu₃(HTDC)₂]_n. The toxicity characteristic leaching procedure (TCLP) and semi-dynamic leaching test (SDLT) indicated that the supramolecular precipitate was non-hazardous and stable in weak acid and alkaline conditions. Tests of an anion exchange resin D231 provided a clue to simultaneously remove excess HTDC and residual CuEDTA in practical process of wastewater treatment.     

Removal of aqueous lead by poorly-crystalline hydroxyapatites

The use of a phosphorus amendment in altering Pb to a chemically less mobile phase is a promising strategy based on minimizing ecotoxicological risk and improving time and cost efficiency. This study evaluated crystalline and poorly-crystalline hydroxyapatite sorbents on removal of aqueous Pb in response to reaction time, solution pH, and Pb concentration. Batch experiments were conducted using a commercially-available crystalline hydroxyapatite (HA), and two poorly-crystalline hydroxyapatites synthesized from gypsum waste (CHA) and incinerated ash of poultry waste (MHA). Poorly-crystalline hydroxyapatites had greater capacity for Pb removal from a solution with a wider pH range as compared to a crystalline hydroxyapatite. The maximum sorption capacity of Pb determined by the Langmuir model was 500 mg g⁻¹ for CHA, 277 mg g⁻¹ for MHA and 145 mg g⁻¹ for HA. Removal of aqueous Pb by CHA was not dependent on solution pH, with a 98.8% reduction throughout the solution pH range of 2–9, whereas aqueous Pb removal by HA and MHA was pH-dependent with less removal in the neutral solution pH. Poorly-crystalline hydroxyapatites may provide an effective alternative to existing remediation technologies for Pb-contaminated sites.     

Heavy metals in bark of <Emphasis Type="Italic">Pinus massoniana</Emphasis> (Lamb.) as an indicator of atmospheric deposition near a smeltery at Qujiang,China

Goal, Scope and Background Rapid urbanization and the expansion of industrial activities in the past several decades have led to large increases in emissions of pollutants in the Pearl River Delta of south China. Recent reports have suggested that industrial emission is a major factor contributing to the damages in current natural ecosystem in the Delta area. Tree barks have been used successfully to monitor the levels of atmospheric metal deposition in many areas, but rarely in China. This study aimed at determining whether atmospheric heavy metal deposition from a Pb-Zn smeltery at Qujiang, Guangdong province, could be accurately reflected both in the inner bark and the outer bark of Masson pine (Pinus massoniana L.). The impact of the emission from smeltery on the soils beneath the trees and the relationships of the concentrations between the soils and the barks were also analyzed. Methods Barks around the bole of Pinus massoniana from a pine forest near a Pb-Zn smeltery at Qujiang and a reference forest at Dinghushan natural reserve were sampled with a stainless knife at an average height of 1.5 m above the ground. Mosses and lichens on the surface barks were cleaned prior to sampling. The samples were carefully divided into the inner bark (living part) and the outer bark (dead part) in the laboratory, and dried and ground, respectively. After being dry-ashed, the powder of the barks was dissolved in HNO₃. The solutions were analyzed for iron (Fe), manganese (Mn), copper (Cu), zinc (Zn), chromium (Cr), nickel (Ni) and cobalt (Co) by inductively coupled plasmas emission spectrometry (ICP, PS-1000AT, USA) and Cadmium (Cd) and lead (Pb) by graphite furnace atomic absorption spectrometry (GFAAS, ZEENIT 60, Germany). Surface soils (0–10 cm) beneath the sample trees were also collected and analyzed for the selected metals. Results and Discussion Concentrations of the selected metals in soils at Qujiang were far above their environmental background values in the area, except for Fe and Mn, whilst at Dinghushan, they were far below their background values, except for Cd and Co. Levels of the metals, in particular Pb and Zn, in the soils beneath the sample trees at Qujiang were higher than those at Dinghushan with statistical significance. The result suggested that the pine forest soils at Qujiang had a great input of heavy metals from wet and dry atmospheric deposition, with the Pb-Zn smeltery most probably being the source. Levels of Cu, Fe, Mn, Zn, Ni and Pb at Qujiang, both in the inner and the outer bark, were statistically higher than those at Dinghushan. Higher concentrations of Pb, Fe, Zn and Cu may come from the stem-flow of elements leached from the canopy, soil splash on the 1.5 m height and sorption of metals in the mosses and lichens growing on the bark, which were direct or indirect results from the atmospheric deposition. Levels of heavy metals in the outer barks were associated well with the metal concentrations in the soil, reflecting the close relationships between the metal atmospheric deposition and their accumulation in the outer bark of Masson pine. The significant (p<0.01) correlations of Fe-Cu, Fe-Cr, Fe-Pb, Fe-Ni, Pb-Ni, and Pb-Zn in the outer barks at Qujiang again suggested a common source for the metals. The correlation only occurred between Pb and Ni, Cd and Co in the outer barks at Dinghushan, which suggested that those metals must possibly have other uncommon sources. Conclusions Atmospheric deposition of the selected metals was great at Qujiang, based on the levels in the bark of Pinus massoniana and on the concentrations in the soils beneath the trees compared with that at Dinghushan. Bark of Pinus massoniana, especially the outer bark, was an indicator of metal loading at least at the time of sampling. Recommendations and Perspectives The results from this study and the techniques employed constituted a new contribution to the development of biogeochemical methods for environmental monitoring particularly in areas with high frequency of pollution in China. The method would be of value for follow up studies aimed at the assessment of industrial pollution in other areas similar with the Pearl River Delta.     

松花江野生鱼类重金属残留分析与评价

以松花江流域的野生鱼类为研究对象,在松花江流域选取松林、大顶子山、佳木斯3个具有代表性的点位,在2014—2016年的每年5月底6月初采集鲤鱼和鲫鱼样品,3年内共制备45个鲤鱼单样,44个鲤鱼混样,30个鲫鱼混样,共计119个。采用电感耦合等离子体-质谱法对鱼类肌肉组织中残留的As、Cd、Cr、Pb、Hg 5种重金属进行检测。检测结果显示,As、Cd、Cr、Pb、Hg 5种重金属全部检出,检测结果全部达标,达标率为100%。根据检测结果采用单因子指数法和金属污染指数法等评价了松花江流域鱼体重金属残留状况及食用安全性,评价结果为松花江流域鱼类重金属残留量相对较少,鱼体健康,食用安全。     

薄膜扩散梯度技术在重金属生物有效态监测中的应用

重金属生物有效性是评估重金属元素迁移性、生物可利用性和生态影响的关键参数。薄膜扩散梯度技术(DGT)是一种原位被动采样技术,因其具有原位富集性、形态选择性,可提供被监测物质在监测时间段内的平均浓度等优点,可作为生物对重金属摄取的模拟替代物对环境介质中重金属的生物可利用度进行预测,已被广泛应用于环境介质中重金属生物有效性的测定。研究主要介绍了DGT技术的原理、组成和特点,评述了其近年来在水体、土壤、沉积物中重金属生物有效态应用方面的新进展,提出了DGT技术未来要提高抗生物污染能力及寻找可与DGT技术联用的相关技术的观点。     

典型地区农用地污染调查及风险管控标准探讨

针对《土壤污染风险管控标准——农用地土壤污染风险管控标准》(GB 15618—2018),提出以土壤中全量浓度筛选值和管控值作为衡量农用地土壤污染风险管控的标准,对湖南省部分稻田农用地土壤及点对点稻米样品中镉、铅、砷、汞的总量和有效态浓度及稻米中含量进行监测,根据重金属总量浓度分为低风险、中风险、高风险3组。结果显示:(1)土壤及稻米中镉含量基本为随着风险级别的升高而增加,铅、砷在土壤和稻米中含量无规律性结果,汞监测结果均为未检出。(2)低风险组稻米镉超标率为12. 0%,高风险组稻米镉达标率为33. 3%,表明利用总量浓度对农用地土壤潜在风险进行分组存在一定的局限性。(3)依据4种重金属在土壤中总量及稻米(早稻)中含量情况,对风险级别进行调整并综合判断:有58个样品为低风险组,占样品总数的68. 2%,超标率为零;有15个样品为中风险组,占样品总数的17. 7%,超标率为80. 0%;有12个样品为高风险组,占样品总数的14. 1%,超标率为100. 0%。调整后评价结果与上述标准的划分目标更接近,能够提高上述标准的准确性和实用性。     

基于双指标多等级的土壤重金属生态风险评价

采用土壤中重金属的全量和有效态双重指标,建立基于多等级综合评估的土壤中重金属生态风险评价模型,将联合概率曲线法引入土壤评价模型,分析重金属暴露浓度与毒性数据的概率分布,考察重金属对土壤生物的毒害程度,从而确定土壤中重金属对于生态系统的风险。建立从简单到复杂的多等级综合评价方法,表征重金属的污染等级、浓度效应、多种重金属污染物的协同效应、不同重金属的毒性效应和土壤对不同重金属污染物的敏感性。选择典型地区采集有代表性的土壤样品,测定不同重金属的总量和有效态,验证评价模型的实用性和评价分级的合理性。旨在解决土壤重金属风险评价的方法学问题,为土壤环境质量管理提供支持。     

金属材料海水腐蚀试验方法的编制及标准解读

为了使相关人员更好地理解标准,更好地完成试验,回顾了我国金属材料海水腐蚀试验方法和标准的编制历程,对金属材料海水腐蚀试验的两个现行国家标准进行了解读和比较。