不同物质对铬价态测定结果的影响

采用单波长法和双波长法,分别考察了KH2PO4、H3PO4、H2SO4、KNO3、牛肉膏和蛋白胨对Cr(III)和Cr(VI)质量浓度测定的影响。结果显示,Cr(III)和Cr(VI)在测量中是相互影响的,并且Cr(III)对Cr(VI)影响较显著。在单波长法测定中,牛肉膏、蛋白胨及2种酸对Cr(III)和Cr(VI)的影响较钾盐对其影响更为显著,H3PO4和H2SO4对Cr(III)和Cr(VI)的特征吸收峰值影响最大,降低幅度在20%～50%。这些物质对双波长法测定Cr(VI)几乎没有影响;但对Cr(III)测定中,H2SO4和H3PO4的影响较大,其相对误差分别为14.57%和8.87%,其余物质产生的相对误差均小于1.6%。因此,双波长法可用于生物样品中Cr(III)和Cr(VI)的测定,线性范围分别为0～160 mg/L和0～80mg/L。     

Fractionation of heavy metals and phosphorus in suspended sediments of the Yamuna river,India

The Yamuna river is the largest tributary of the Ganges river system. It originates in the Himalayas and flows through a varied geological terrain encompassing a large basin area. Metals Fe, Mn, Pb, Zn, Cu in different chemical fractions of suspended sediments such as exchangeable, carbonates, Fe–Mn oxides, organics and residual fractions were studied. Phosphorus associated with different chemical forms are discussed. The metals are mostly associated with residual fractions in the sediments followed by organics, Fe–Mn oxides, exhangeable and carbonates. Intensive use of chemical fertilizers and pesticides in agriculture in the basin affects the high inorganic phosphorus content in sediments.     

Heavy metals uptake from aqueous solutions using marine algae (Colpomenia sinuosa): kinetics and isotherms

The adsorption of copper, zinc, cobalt, lead and cadmium ions onto Colpomenia sinuosa was studied as a function of contact time, initial metal ion concentration and initial pH. In addition, desorption studies were performed. Characterisation of this adsorbent was also confirmed by Fourier transform infrared (FTIR) spectroscopy and scanning electron microscopy (SEM) analysis. Batch adsorption experimental data were analysed using Langmuir, Freundlich and Dubinin–Raduschkevich (D–R) adsorption isotherms. The results indicated that the biosorption equilibrium was well described by both the Freudlich and D–R isotherms. Moreover, sorption kinetics was performed and it was observed that equilibrium was reached in<60 min, which could be described by the pseudo-second-order kinetic model for all heavy metals. The sorption of heavy metals onto the biomass was largely dependent on the initial solution pH. The elution efficiency for heavy metal ions desorption from C. sinuosa was determined for 0.1 M HCl, 1.0 M HCl and 1.0 M HNO₃. Desorption efficiency and also adsorption capacity were highest for Pb(II). The results indicate that C. sinuosa has great potential for the removal of heavy metals in an ecofriendly process.     

Roe and red deer as bioindicators of heavy metals contamination in north-western Poland

The present paper examines the degree of environmental contamination in areas covered by the Natura 2000 programme, located in north-western Poland, with selected heavy metals based on their concentration in target organs of roe and red deer. Lead, cadmium, copper, iron, and zinc concentrations were determined by inductively coupled plasma–atomic emission spectrometry. Residues of lead and cadmium were found in most of the analysed samples of roe and red deer organs The concentration of cadmium in the organs of the animals studied was much higher than that of lead. The median for Pb in liver and kidneys was 0.055 and 0.092 μg/g dry weight (d.w.) in roe deer, and 0.067 and 0.081 μg/g d.w. in red deer, respectively. The median for liver and kidney cadmium was 0.770 and 6.139 μg/g d.w. in roe deer, and 0.422 and 6.365 μg/g d.w. in red deer, respectively. Our study has demonstrated that this area is laden with lead and cadmium. This is evidenced by the fact that maximum permissible levels of these elements in the organs of red and roe deer, which were used as bioindicators of environmental contamination, were exceeded.     

The gastropod Osilinus atrata as a bioindicator of Cd,Cu, Pb and Zn contamination in the coastal waters of the Canary Islands

The aim of this study was to assess the use of Osilinus atrata (Gastropoda, Mollusca) as a biomonitor of heavy metals (Cd, Cu, Pb and Zn) within the coastal zone of the Canary Islands. In general, this top-shell snail showed high intraspecific variability in its tissue metal concentrations, which decreased according to the following sequence: Cu≥Zn>Cd≥Pb. In particular, Cd and Zn concentrations were higher in males than in females, whereas Cu concentrations increased slightly with weight, and Pb concentrations decreased. Cd and Cu concentrations showed notable spatial variability; Cd concentrations were higher in the eastern islands (Alegranza, La Graciosa, Lanzarote and Fuerteventura) and La Palma, whereas Cu levels were highest in some western islands (Gran Canaria, La Gomera and El Hierro). The arrival of waters from the African coastal upwelling, the pollution of coastal waters with agricultural fertilisers and the competition for uptake between metals appear to be the likely causes within these patterns of accumulation. In conclusion, O. atrata presents a great potential as a biomonitor of heavy metals, however, more information and further studies are necessary.     

Impact of heavy metals on bacterial communities from mangrove soils of the Mahanadi Delta (India)

This study aimed to assess soil nutrient status and heavy metal content and their impact on the predominant soil bacterial communities of mangroves of the Mahanadi Delta. Mangrove soil of the Mahanadi Delta is slightly acidic and the levels of soil nutrients such as carbon, nitrogen, phosphorous and potash vary with season and site. The seasonal average concentrations (μg/g) of various heavy metals were in the range: 14 810–63 370 (Fe), 2.8–32.6 (Cu), 13.4–55.7 (Ni), 1.8–7.9 (Cd), 16.6–54.7 (Pb), 24.4–132.5 (Zn) and 13.3–48.2 (Co). Among the different heavy metals analysed, Co, Cu and Cd were above their permissible limits, as prescribed by Indian Standards (Co=17 μg/g, Cu=30 μ g/g, Cd=3–6 μ g/g), indicating pollution in the mangrove soil. A viable plate count revealed the presence of different groups of bacteria in the mangrove soil, i.e. heterotrophs, free-living N₂ fixers, nitrifyers, denitrifyers, phosphate solubilisers, cellulose degraders and sulfur oxidisers. Principal component analysis performed using multivariate statistical methods showed a positive relationship between soil nutrients and microbial load. Whereas metal content such as Cu, Co and Ni showed a negative impact on some of the studied soil bacteria.     

Heavy metals distribution and risk assessment in soils affected by tannery effluents

Effluents collected from tanneries in Sialkot showed considerably higher levels of heavy metals. Sodium (12 660.91 mg/L) among macronutrients and Cr (592.20 mg/L) among heavy metals were found in the highest concentrations. Effluent parameters, i.e. biological oxygen demand (BOD; 12.40), chemical oxygen demand (COD; 16.53), Cd (5.90), Cr (592.20) and Fe (18.59) were the respective times higher than Pakistan National Environmental Quality Standards and their continuous unchecked discharge into agricultural soils poses a potential risk. Mean concentrations (mg/L) of Cr (592.20), Ni (2.66), Mn (1.16), Fe (37.17), Zn (0.90), Cd (0.59) and Pb (1.18) in this study exceeded levels recorded to date from different tanning hubs in Pakistan. Factor analysis/principal components analysis (FA/PCA) for the effluent parameters resulted in six varimax factors, i.e. VF1 (salinity, electrical conductivity, total dissolved solids, chloride, phosphate, BOD and COD; including characteristic tannery effluent features), VF2 (pH, Cr and alkalinity; tanning operations), VF3 (Cd and Pb; dyeing processes), VF4 (Mn and Fe; finishing operations), VF5 (Ni; retaining processes) and VF6 (hardness, Ca and Cu; bating processes). Cluster analysis performed on metal data resulted in three clusters confirming metal–metal relations obtained either from FA/PCA or a correlation matrix. The results of this study are useful for heavy metal source apportionment, assessment of risk to peripheral soils and the future management of environments around tanneries.     

Uptake of seven metals by two macrophytes species: potential for phytoaccumulation and phytoremediation

Aquatic macrophytes can be used in the studies of quality of water ecosystems and in monitoring of metals and other pollutants. The aim of this study was to assess concentration levels, accumulation and distribution of seven metals in selected plant parts of Typha angustifolia L. and Iris pseudacorus L., in comparison with sediment and water samples of a reservoir. Metal content in the samples was determined by optical emission spectrometry (ICP-OES iCAP 6500). The concentrations of all examined metals were higher in the sediment than in the water samples. In plants, metal concentrations depended on plant species and organs. The roots/rhizomes were primary organs for metal concentration and accumulation. T. angustifolia L. accumulated Mn and Cu, and I. pseudacorus L. accumulated Cd and Cu in the fruits. T. angustifolia L. hyperaccumulated As. The values of enrichment coefficients and translocation factors were: 0 to 3.31 and 0 to 2.39, respectively. The plant species investigated absorb, translocate and accumulate metals in their organs differently, which provides advantages in combining them for remediation of wasted aquatic ecosystems.     

Some aspects of heavy metals contamination remediation and role of biosurfactants

Contamination by heavy metals is the result of different industrial activities. The presence of heavy metals in soil and water causes serious problems, as these materials are not biodegradable and do contaminate both biological systems and the subsoil. Biological surface-active compounds otherwise known as biosurfactants in general and rhamnolipids biosurfactants in particular have been successfully employed in the remediation of environments contaminated with heavy metal ions. The aim of the present review is to highlight potential applications of these tensioactive compounds for use in environmental heavy metals removal and bioremediation and processes involved.     

Geochemical forms of trace metals in mangrove sediments—Red Sea (Egypt)

Seven sediment samples from mangrove sediments of the Red Sea were taken in order to evaluate the possible contamination of the sediments by trace metals (iron (Fe), manganese (Mn), zinc (Zn), copper (Cu), lead (Pb) and cadmium (Cd)). Sequential extraction techniques were performed to study the different geochemical forms of these metals. X-ray diffraction analysis has been performed to correlate the mineralogical composition with the geochemical forms of the studied elements. The results of Fe and Mn contents indicate that they are in large part from lithogenous origin. The elevated concentrations are associated with the residual form ranged from 70 to 93% for Fe and 46 to 70% for Mn. The percentage of Zn, Cu, Cd and Pb in the non-residual form was much greater than that of the residual fractions. This reflects the high mobility and bioavailability of these metals in mangrove sediments of the Red Sea. X-ray diffraction analysis revealed the presence of silicate components including quartz, feldspars and clay minerals in some locality. Non-silicate components recorded in the study area as calcite as well as, Mg-calcite. Quantitatively both components i.e. silicate and carbonate varied according to their source material.