微生物絮凝剂改善城市污水厂浓缩污泥脱水性能的研究

采用酱油曲霉(Aspergillus sojae)产生的微生物絮凝剂(MBF)作为污泥絮凝脱水剂,对城市污水处理厂浓缩污泥进行调理,确定该絮凝剂对浓缩污泥脱水的处理工艺参数为：微生物絮凝液最佳投加体积为6%～8%（体积比）,发挥絮凝作用的最适污泥温度为28～32℃,最适pH为6～7。经微生物絮凝剂调理的污泥在3 000 r/min离心9 min,污泥脱水率高达82.7%,滤饼含水率降低至77.3%,污泥脱水后体积减至原来的1/5左右。     

Carbon dioxide emissions from cities in China based on high resolution emission gridded data

Based on the China high resolution emission gridded data (1 km spatial resolution), this article is aimed to create a Chinese city carbon dioxide (CO₂) emission data set using consolidated data sources as well as normalized and standardized data processing methods. Standard methods were used to calculate city CO₂ emissions, including scope 1 and scope 2. Cities with higher CO₂ emissions are mostly in north, northeast, and eastern coastal areas. Cities with lower CO₂ emissions are in the western region. Cites with higher CO₂ emissions are clustered in the Jing-Jin-Ji Region (such as Beijing, Tianjin, and Tangshan), and the Yangtze River Delta region (such as Shanghai and Suzhou). The city per capita CO₂ emission is larger in the north than the south. There are obvious aggregations of cities with high per capita CO₂ emission in the north. Four cities among the top 10 per capita emissions (Erdos, Wuhai, Shizuishan, and Yinchuan) cluster in the main coal production areas of northern China. This indicates the significant impact of coal resources endowment on city industry and CO₂ emissions. The majority (77%) of cities have annual CO₂ emissions below 50 million tons. The mean annual emission, among all cities, is 37 million tons. Emissions from service-based cities, which include the smallest number of cities, are the highest. Industrial cities are the largest category and the emission distribution from these cities is close to the normal distribution. Emissions and degree of dispersion, in the other cities (excluding industrial cities and service-based cities), are in the lowest level. Per capita CO₂ emissions in these cities are generally below 20 t/person (89%) with a mean value of 11 t/person. The distribution interval of per capita CO₂ emission within industrial cities is the largest among the three city categories. This indicates greater differences among per capita CO₂ emissions of industrial cities. The distribution interval of per capita CO₂ emission of other cities is the lowest, indicating smaller differences of per capita CO₂ emissions among this city category. Three policy suggestions are proposed: first, city CO₂ emission inventory data in China should be increased, especially for prefecture level cities. Second, city responsibility for emission reduction, and partitioning the national goal should be established, using a bottom-up approach based on specific CO₂ emission levels and potential for emission reductions in each city. Third, comparative and benchmarking research on city CO₂ emissions should be conducted, and a Top Runner system of city CO₂ emission reduction should be established.     

湿法脱硫真空皮带机运行控制分析与改进

介绍了真空皮带机脱水过程的基本原理及其在石灰石—石膏湿法脱硫系统中的应用情况,分析了PID控制真空皮带机运行的原理。由于真空皮带机常规PID控制系统的滞后严重,采用模糊控制后系统的响应得到了较好的改善,实际应用结果证明了理论的正确性。     

天然气引射调峰系统的噪声形成及其治理研究

采用天然气引射调峰技术,能使上海某储配站10台天然气高压球罐的储气调峰能率提高68%,大大有助于解决天然气用气高峰时的供需平衡问题,并能节约初投资人民币1亿元.但使用超音速引射器后,当球罐压力下降到某一值时会产生高频噪声,影响管束区操作环境.本文分析了噪声产生的原因,提出了合理的噪声治理方案,并进行了方案的实施.实践证明:噪声治理效果良好,降低了管束区噪声污染,达到了国家"工业企业噪声卫生标准".     

可用于去除高盐废水中有机污染物的混凝-Fenton氧化联合工艺

以某环氧树脂生产厂产生的高盐有机废水为对象,对比研究了Fenton、Fenton-混凝、混凝-Fenton等工艺去除废水中有机污染物的效能。考察了Fenton反应中Fe2+、H2O2投加比、初始pH、反应时间以及混凝反应中混凝剂种类、投加量等参数对处理效果的影响。结果表明：Fenton工艺的最佳条件为亚铁和过氧化氢投加比1：20,投加量分别为25 mmol·L-1和500 mmol·L-1,初始pH 3,反应时间120 min,TOC去除率为62.50%;混凝工艺选择FeSO4混凝剂,投加量为300 mg·L-1,TOC去除率为23.78%;废水经过Fenton-无混凝剂混凝、Fenton-混凝剂混凝、混凝-一级Fenton氧化和混凝-二级Fenton氧化工艺处理,TOC去除率分别为68.32%、71.51%、80.69%和89.27%。     

高炉细灰冷压成型回收铁锌

在资源短缺和环保形势日益严峻的情况下,高炉细灰的回收再利用逐渐被人们重视。XRF、SEM、EDS和XRD分析确定了细灰的元素含量、分布状态、颗粒形貌及物相组成。高炉细灰原样和添加5%的CaCO3的高炉细灰的TG-DSC分析表明细灰冷压块高温焙烧的最低温度应为950℃。按一定比例的马铃薯全粉和水配加不同比例的CaO制备复合黏结剂,配加到高炉细灰中压块并测定强度,当CaO含量在7%时,压块强度最大。在充入保护性气氛N2的管式炉中,950、1 050、1 150、1 250℃,分别焙烧CaO配比为7%的压块1 h,分析结果表明1 150℃时细灰去Zn效果良好,焙烧所得物质主要为Fe。该工艺除可以调节细灰的碱度外,也可以有效利用马铃薯全粉。     

活性污泥脱水性能与电化学阻抗谱参数的关联特性

为探究FeCl₃混凝调理过程中活性污泥脱水性能与电化学阻抗谱参数的关联关系,选取北京3座污水处理厂的剩余活性污泥,研究不同调理投药量下活性污泥的毛细吸水时间(CST)、比阻(SRF)、抽滤含水率、Zeta电位、电导率以及电化学阻抗等指标的变化,通过Pearson相关性分析讨论污泥脱水性能与阻抗谱参数(d_s/f_c)的相关性,并探讨d_s/f_c预测污泥脱水性能的可行性。实验结果表明,FeCl₃调理活性污泥的较适投加量为100 mg·g^-1;超过100 mg·g^-1时,活性污泥CST、SRF、抽滤含水率基本不再下降,Zeta电位却缓慢升高;电化学阻抗Z则随着投加量的增加而持续下降,且Nyquist图中高频区半圆面积减小,这表明电子更易转移、污泥更易导电。相关性分析表明,活性污泥的脱水性能均与d_s/f_c呈显著正相关(r > 0.639,p < 0.01);3种活性污泥CST、SRF、抽滤含水率分别与d_s/f_c的线性回归结果显示它们之间呈线性关系,且线性方程斜率为正值(R² > 0.921,p < 0.01)。上述研究结果表明,活性污泥的d_s/f_c参数可以作为指示脱水性能的潜在指标。本研究结果可为污泥减量化技术提供参考。     

不同环境因素对厌氧甲烷氧化型自养反硝化系统脱氮性能的影响及其微生物群落分析

采用序批实验研究了不同环境因素(甲烷供应、初始硝氮浓度和pH值)对厌氧甲烷氧化型反硝化系统脱氮性能的影响,并采用高通量测序对不同pH下反应器内微生物群落结构进行了分析.结果 表明:当甲烷供给充足时,系统反硝化效果明显;随着初始硝氮浓度的升高,系统平均脱氮率呈现先升高后下降的趋势,表明适当增大硝氮质量浓度(＜30 mg·...     

基于高效絮凝沉淀池与翻板滤池组合工艺的工程案例

以银川市某水厂为例,评估高效絮凝沉淀池与翻板滤池组合工艺的工程应用效果。结果表明,高效絮凝沉淀池与翻板滤池组合工艺能够适应较大水质波动,具有一定抗冲击负荷能力。其浊度去除率和高锰酸盐指数 (以COD_Mn计) 去除率较高,出水水质满足《生活饮用水卫生标准》 (GB/T5749-2006) 。通过调整排泥量和污泥回流比,能够有效解决沉淀池泥位超标问题。根据翻板滤池的过滤负荷和滤水阀门的开度调整反冲洗周期,能够提高过滤效率,节约电耗。少量无烟煤滤料的流失对翻板滤池出水浊度无影响。本研究结果可为低温低浊水处理工程提供设计经验和工程案例参考。     

城市生活垃圾热解重整制合成气计算分析

基于热化学平衡对热解重整制取合成气工艺进行了建模分析,考察了垃圾收到基水分Mar、干燥基灰分Ad、热解装置入口垃圾含水率和合成气燃烧比例对能量转化率、干合成气产率、干合成气低位热值、合成气组分等的影响。结果表明：该工艺对于收到基低位热值大于6.7?MJ·kg-1的生活垃圾可以产生标况下低位热值高于5.3?MJ·m-3的干合成气;垃圾收到基水分和干燥基灰分的增加会大幅降低能量转化率、干合成气产率和低位热值。