永磁磁轨制动技术在轨道交通中的应用

介绍国外永磁制动技术在轨道交通中的应用情况;阐述旋转型永磁制动器和直线型永磁制动器的结构和工作原理;对永磁磁轨制动安装方式、控制方法、联合制动模式进行探讨。介绍了直线型永磁制动器的3种磁化形式:Halbach磁化、水平磁化和垂直磁化;运用准静态磁场分析方法,得出了各部分的磁场分布控制方程,矢量磁势A、磁感应强度B和涡流损耗的分布;从而得出了制动力的计算方法。实践证明永磁磁轨制动技术在轨道交通有着广阔的应用前景。     

可用于去除高盐废水中有机污染物的混凝-Fenton氧化联合工艺

以某环氧树脂生产厂产生的高盐有机废水为对象,对比研究了Fenton、Fenton-混凝、混凝-Fenton等工艺去除废水中有机污染物的效能。考察了Fenton反应中Fe2+、H2O2投加比、初始pH、反应时间以及混凝反应中混凝剂种类、投加量等参数对处理效果的影响。结果表明：Fenton工艺的最佳条件为亚铁和过氧化氢投加比1：20,投加量分别为25 mmol·L-1和500 mmol·L-1,初始pH 3,反应时间120 min,TOC去除率为62.50%;混凝工艺选择FeSO4混凝剂,投加量为300 mg·L-1,TOC去除率为23.78%;废水经过Fenton-无混凝剂混凝、Fenton-混凝剂混凝、混凝-一级Fenton氧化和混凝-二级Fenton氧化工艺处理,TOC去除率分别为68.32%、71.51%、80.69%和89.27%。     

高炉细灰冷压成型回收铁锌

在资源短缺和环保形势日益严峻的情况下,高炉细灰的回收再利用逐渐被人们重视。XRF、SEM、EDS和XRD分析确定了细灰的元素含量、分布状态、颗粒形貌及物相组成。高炉细灰原样和添加5%的CaCO3的高炉细灰的TG-DSC分析表明细灰冷压块高温焙烧的最低温度应为950℃。按一定比例的马铃薯全粉和水配加不同比例的CaO制备复合黏结剂,配加到高炉细灰中压块并测定强度,当CaO含量在7%时,压块强度最大。在充入保护性气氛N2的管式炉中,950、1 050、1 150、1 250℃,分别焙烧CaO配比为7%的压块1 h,分析结果表明1 150℃时细灰去Zn效果良好,焙烧所得物质主要为Fe。该工艺除可以调节细灰的碱度外,也可以有效利用马铃薯全粉。     

新型膜-生物反应器在不同通量下的膜污染特性研究

选择适当的膜通量是膜-生物反应器控制膜污染的有效手段之一.本文根据膜通量与临界通量的关系选取了5个不同的膜通量,考察在这些通量条件下新型膜-生物反应器膜污染发展特性的变化.试验结果表明,膜通量的变化会影响膜污染的发展特性.当膜通量小于临界通量区时,膜污染发展具有"2阶段"趋势,并且膜通量越小"第1阶段"和"第2阶段"的膜污染发展速率对比越显著.当膜通量在临界通量区通量内时,首先出现短暂的膜污染快速增长期,随后膜污染发展仍呈现"2阶段"现象.当膜通量大于临界通量区通量时,膜操作压力(TMP)从开始运行即迅速上涨直至试验结束.     

中国南方某城市自来水厂处理工艺对多环芳烃的去除效果研究

讨论了中国南方某城市自来水厂饮用水中的多环芳烃残留规律以及现有净水工艺对多环芳烃的去除效果。研究结果表明,该自来水厂饮用水中检出多环芳烃以2~4环芳烃为主,强致癌性高环数多环芳烃均在检出限以下,且多环芳烃总量未超出中国供水行业标准(2000年)的相关限值。各处理工艺段中,砂滤过程对多环芳烃的去除效果最好,相较于原水对多环芳烃总量的去除率可达64%。     

Methane fluxes from tundra soils and snowpack in the maritime Antarctic

Methane fluxes were measured from three exposed tundra sites and four snowpack sites on the Fildes Peninsula in the maritime Antarctic in the summertime of 2002. The average fluxes at two normal tundra sites were −15.3 μg m⁻² h⁻¹ and −14.3 μg m⁻² h⁻¹, respectively. The fluxes from tundra site with fresh penguin dropping addition showed positive values with the average of 36.1 μg m⁻² h⁻¹, suggesting that the deposition of fresh droppings greatly enhanced CH₄ emissions from the poor Antarctic tundra during penguin breeding periods. The summertime variation in CH₄ flux was correlated with surface ground temperature and the precipitation. The correlation between the flux and PT₀, which is the product of the precipitation and surface ground temperature, was quite strong. The diurnal cycle of CH₄ flux from the tundra soils was not obtained due to local fluky weather conditions. The fluxes through four snowpack sites were also obtained by the vertical CH₄ concentration gradient and their average fluxes were −46.5 μg m⁻² h⁻¹, −28.2 μg m⁻² h⁻¹, −46.4 μg m⁻² h⁻¹ and −17.9 μg m⁻² h⁻¹, respectively, indicating that tundra soils under snowpack also consume atmospheric CH₄ in the maritime Antarctic; therefore these fluxes could constitute an important part of the annual CH₄ budget for Antarctic tundra ecosystem.     

对羟基苯甘氨酸生产废水的处理工艺研究

对羟基苯甘氨酸废水属于高浓度难处理有机废水,针对生产工艺的特点,采取了废水分类处理的新路线.试验结果表明,高浓度废水经过物化处理后,苯酚的回收率达到95%,每日回收硫酸铵约6t;低浓度废水采取水解酸化-接触氧化-沉淀-活性炭吸附工艺是可行的,COD、BOD5、NH3-N及挥发酚的总去除率分别为95.6%、94.6%、93.7%和99%.     

A new tracer technique for monitoring groundwater fluxes: the Finite Volume Point Dilution Method

Quantification of pollutant mass fluxes is essential for assessing the impact of contaminated sites on their surrounding environment, particularly on adjacent surface water bodies. In this context, it is essential to quantify but also to be able to monitor the variations with time of Darcy fluxes in relation with changes in hydrogeological conditions and groundwater - surface water interactions. A new tracer technique is proposed that generalizes the single-well point dilution method to the case of finite volumes of tracer fluid and water flush. It is called the Finite Volume Point Dilution Method (FVPDM). It is based on an analytical solution derived from a mathematical model proposed recently to accurately model tracer injection into a well. Using a non-dimensional formulation of the analytical solution, a sensitivity analysis is performed on the concentration evolution in the injection well, according to tracer injection conditions and well-aquifer interactions. Based on this analysis, optimised field techniques and interpretation methods are proposed. The new tracer technique is easier to implement in the field than the classical point dilution method while it further allows monitoring temporal changes of the magnitude of estimated Darcy fluxes, which is not the case for the former technique. The new technique was applied to two experimental sites with contrasting objectives, geological and hydrogeological conditions, and field equipment facilities. In both cases, field tracer concentrations monitored in the injection wells were used to fit the calculated modelled concentrations by adjusting the apparent Darcy flux crossing the well screens. Modelling results are very satisfactory and indicate that the methodology is efficient and accurate, with a wide range of potential applications in different environments and experimental conditions, including the monitoring with time of changes in Darcy fluxes.     

The effect of barriers on reducing thermal heat fluxes from a hydrocarbon pool fire

The radiant heat flux from a pool fire is frequently calculated using the solid flame model, where the flame envelope is approximated as a stationary cylinder whose surface emits thermal radiation at a constant rate. Radiant heat flux calculations using the solid flame model assume the target to be at a given elevation, typically at ground level, and to have an unobstructed view of the fire. The presence of obstacles (e.g., walls, buildings, etc.) or terrain features that would create shaded areas and provide shielding of a target from the fire is typically neglected in these calculations: this is a conservative approach, but it is not accurate. This paper presents a methodology to utilize the solid flame model to calculate the heat flux to a target while taking into account the presence of an obstruction between the target and the fire. The shielded solid flame method can quantitatively account for the presence of obstacles as a passive mitigation measure and allows project developers or designers to optimize their facility layout to meet safety requirements. The methodology presented in this paper uses the same correlations found in currently used solid flame models (e.g., LNGFIRE3), therefore, it remains consistent with current regulatory requirements for LNG facilities in the U.S.     

高压水射流清洗油井结垢管安全生产问题讨论

针对目前油田开发生产中出现的油井管存在结垢日益严重、清洗难度大、污染环境、影响油水井安全生产等问题,理论与实际结合,提出了利用高压水射流清洗结垢管技术。给出了结垢管安全清洗的工艺流程及清洗装置,并阐明射流清洗的工作原理、结构特点、技术标准、检验方法、安全保护措施等,同时进行了高压旋转喷头的设计和其他技术参数的优选。通过胜利油田孤东采油厂结垢管现场高压水射流安全清洗,证实该技术具有良好的经济效益和社会效益,保证结垢管的安全使用和油水井的安全生产。