高效菌活性污泥法处理分散染料废水实验研究

针对复合微生物的筛选和分离进行了研究 ,分离出处理分散染料废水起高效降解作用的 2株菌种。结果表明 ,2株高效菌对分散染料废水降解能力很强 ,与普通菌结果对比CODCr去除率提高 17% ,并且高效菌对废水浓度的耐受性也明显提高     

石灰凝胶阻化剂防灭火技术在高硫矿的应用研究

在分析现有凝胶阻化剂防灭火机理的基础上 ,笔者针对我国高硫煤矿采空区发火特点 ,研制出石灰凝胶阻化剂的配方 ,并对其防灭火机理进行了详细探讨 ,确定了喷洒该种阻化剂的工艺过程及其应注意的问题。根据现场试验的测定数据表明 ,石灰凝胶阻化剂对高硫煤矿的防灭火效果好     

现代化工分离技术在环境保护中的应用

介绍了高效导向筛板、新型高效填料、超临界流体萃取等现代化工分离技术及其在清洁生产和废物处理方面的应用。     

五日生化需氧量(BOD5)测定方法探讨

本文针对GB／T7488-1987《水质五日生化需氧量(BOD5)稀释与接种法》中BOD5的测定和计算时接种稀释水的空白扣除方法，提出了直接测接种液的BOD5值，按接种液的比例在水样中进行扣除的方法，提高了BOD5值的准确性。更能反应BOD5的真实性。     

Assessment of the maximum possible liquid superheat during flashing leak flow

During the discharge of flashing liquids through leaks due to abrupt depressurization a transient thermodynamic non-equilibrium in the form of a boiling delay in the superheated liquid flow can occur. As a consequence the actual mass flow quality is smaller than calculated under the assumption of an immediate adjustment of the thermodynamic equilibrium between the phases. For the prediction of the leak mass flow for a given pressure difference the magnitude of this self-adjusting mass flow quality is needed.

Most of the models cited in the literature include only the equilibrium mass quality as limiting quantity and ignore further effects as that of the depressurization velocity or the mean nucleus distance. For the assessment of the maximum possible liquid superheat during flashing only the conduction heat transfer from a stagnant liquid to the bubble surface is used to describe the bubble growth.

The sub-model for the bubble growth due to expansion and mass transfer necessary for the global prediction of the transient thermodynamic non-equilibrium in flashing liquids was validated using bubble radii measured by Hooper et al. [Bubble growth and pressure relationship in the flashing of superheated water. Technical publication 6904, Mechanical Engineering Department, University of Toronto, 1969] for the case of a sudden depressurization of initially saturated water. On this basis the calculated time-dependent temperature field, the actual mass quality, the mean liquid temperature and, in comparison to the corresponding values based on the assumption of immediate thermodynamic equilibrium, the maximum possible liquid superheat are predicted.     

酒精废水消化液预处理试验研究

高浓度酒精糟液经厌氧生物处理后排出的消化液COD浓度为4500—6000mg/L，SS浓度高这1500—2．600mg,／L，且由于微小沼气泡附着在厌氧污泥上，沉降性能很差，难以与消化液相分离，对后续处理十分不剁。本研兜采用预曝气．化学混凝沉淀组合工艺，对该消化液进行去除高浓度SS的顸处理试验，研究探讨了曝气时间、混凝剂种类和投加量对SS和COD去除效果的影响。试验结果表明，预曝气．化学混凝沉淀组合工艺对消化液SS的去除效果十分显著。当预曝气时间为6．0h，FeCl3投加量为100mg/L时，消化液的SS去除率75．4％，COD去除率24．3％，可为后续的好氧生物处理提供较为有利的水质和负荷条件。     

On the response of 500 gal propane tanks to a 25% engulfing fire

This paper presents detailed data on the thermal response of two 500 gal ASME code propane tanks that were 25% engulfed in a hydrocarbon fire. These tests were done as part of an overall test programme to study thermal protection systems for propane-filled railway tank-cars.

The fire was generated using an array of 25 liquid propane-fuelled burners. This provided a luminous fire that engulfed 25% of the tank surface on one side. The intent of these tests was to model a severe partially engulfing fire situation.

The paper presents data on the tank wall and lading temperatures and tank internal pressure. In the first test the wind reduced the fire heating and resulted in a late failure of the tank at 46 min. This tank failed catastrophically with a powerful boiling liquid expanding vapour explosion (BLEVE). In the other test, the fire heating was very severe and steady and this tank failed very quickly in 8 min as a finite rupture with massive two-phase jet release. The reasons for these different outcomes are discussed. The different failures provide a range of realistic outcomes for the subject tank and fire condition.     

高层建筑物附近架空高压输电线路的走廊问题

采用镜像法实例计算了高层建筑物附近架空高压输电线路的工频电场和无线电干扰场强，并从电磁环评的角度对输电线路走廊的选择提出了一些建议。     

工程安全与工程安全人才培养

在当今人类社会,工程安全已成为威胁人类生存和发展的重大问题。工程安全事故因工程的固有属性而具有诱发原因的复杂性、客观表现的长期性和内在因素的关联性。工程安全事故产生的根本原因之一是人员的工程行为违背了工程安全的客观规律。在现代工程系统中,高级工程技术人员的工程行为对工程安全具有至关重要的影响,而高级工程技术人员的工程行为又与其接受的高等工程教育密切相关。从工程安全的角度审视我国现行高等工程教育,无论在人才培养的结构上,还是在人才培养的内容和方法上都存在诸多问题,改革的重点在于要将工程安全素质纳入工程人才的培养目标并建立与之相适应的工程人才培养模式,更新缺乏现代工程科学技术知识的课程体系和教学内容,创新注重工程安全实践训练的方法和培养途径。     

我国健身器材质量和检验现状分析及其对策

笔者从产品质量、检测体系和质检监管等方面系统地阐述了我国健身器材产业的现状 ;通过对国内外健身器材产业的比较和分析 ,指出了我国健身器材产业普遍存在技术含量低 ,质量不稳定 ,检测标准和设备欠缺 ,服务不完善等突出问题 ;同时还具体探讨了国内外健身器材的安全要求和使用性能在生化和环保两方面的不足 ;就上述种种问题提出了相应的发展对策 ,即遵循“以人为本 ,保障安全”的原则 ,积极发展现代化生产企业 ,前瞻性地开发高技术含量的安全型产品 ,健全符合国情实际的检测体系 ,从而全面提升我国健身器材的安全性能、服务水平和市场竞争力