城市生活垃圾卧式气流分选特性研究

利用处理能力100 kg/h的卧式气流分选机开展生活垃圾中塑料分选实验。实验结果表明:进风角度为10°、15°时,分别对应存在>8.5 m/s、7.7～9.3 m/s的风速范围,使塑料的纯度和分选效率达到80%以上;利用Fluent软件模拟,结果表明:进风角度>15°时,分选机内气流复杂,塑料纯度和分选效率的波动性大,仅存在较窄的风速范围可使总纯度和分选效率同时达到80%以上。     

沉降土体对管道跨越结构应力影响的分析

为了更好地保障长输管道的安全稳定运行,针对长输管道当中的跨越结构进行了应力分析与计算。基于管道跨越结构其结构的特殊性,极容易受到断层、土体塌陷等地质灾害的影响。因此建立了跨越段埋地管道与土壤相互作用的有限元力学模型,分析了30°、40°、50°、60°跨越结构和不同范围土体发生沉降时,管道的应力变化情况。结果显示,当跨越结构中斜管段的角度确定后,便可计算出相应的安全沉降长度;当斜管段角度为50°时,沉降长度控制在13.6m以内,可保证跨越结构不发生塑性变形。通过研究为管道跨越段的安全设计提供了理论依据,该方法可应用在类似的管道跨越结构的应力设计当中。     

水平弯管内硫沉积数值模拟研究

元素硫在集输管道中沉积会引起堵塞和腐蚀问题,而弯管是集输管道中较易出现硫沉积的部位之一。为此,采用数值模拟的方法研究水平弯管内的硫沉积问题,首先利用雷诺应力模型对流场进行模拟,其次采用Lagrange颗粒轨道模型对硫颗粒进行模拟追踪,研究不同因素对硫颗粒在弯管中沉积率的影响。结果表明:弯管内壁会出现负压区和低速区,气流速度和弯曲比会对流场产生影响;硫颗粒在弯管中的沉积率随流速、粒径和弯曲比的增大而增大;硫颗粒沉积是重力和离心力共同作用的结果,其中离心力是导致弯管中沉积率增大的重要原因。     

近3年西双版纳州勐腊县大气污染基本特征及污染原因分析

对西双版纳州生态环境局勐腊分局2017年8月-2020年8月逐日空气质量数据的分析表明,2-4月是勐腊县空气质量指数（Air Quality Index,AQI）频繁达到二级及以上的时段,空气质量分指数（Individual Air Quality Index,IAQI）能够达到二级及以上标准的污染物为PM_2.5、PM₁₀、O₃、SO₂中的一种或几种,PM_2.5、PM₁₀污染较为严重,PM_2.5对空气质量的影响最大,可使空气质量达到重度污染,混合污染出现比例远大于单一污染.2019、2020年3-4月勐腊县轻度及以上连续污染日数超过5 d的5次过程中,4次污染过程的主要潜在源区在勐腊上风方向老挝西北部及泰国与其相邻的区域,权重潜在源贡献因子（Weight Potential Source Contribution Function,WPSCF）大于0.6的区域与同年3、4月泰国西北部、老挝西北部的火点密集区有较好的对应关系,4次污染过程与老挝西北部及泰国与其相邻区域的生物质燃烧关系密切;1次污染过程的主要潜在源区主要在当地,当地建筑施工、交通运输、生物质燃烧和餐饮行业细颗粒物的排放会导致勐腊县空气质量出现明显下降.为验证勐腊县连续污染过程受到了周边国家烧荒的影响,利用逐日气溶胶光学厚度（Aerosol Optical Thickness,AOT）对2020年3月23-4月9日的污染过程进行了个例分析,发现AOT大值区位于勐腊上风方向,高浓度污染物持续稳定地向勐腊传输导致勐腊出现持续重污染.     

新型复合式除尘器

针对电、布除尘器的特点,提出了一种新型静电布袋混合式除尘器,并已应用于工业中。在没有使用任意阀门的前提下,该产品将电除尘器和布袋除尘器结合在一起,取长补短,充分发挥了电除尘器能大量收尘、节能、维护检修工作量小,还可捕集高比电阻和低比电阻等特殊干性粉尘,解决了电除尘难以净化的含微米或亚微米烟尘的难题。兼具布袋除尘器对粉尘粒度和比电阻不敏感、排放浓度低的优点。一级静电除尘器效率可达90%,对于粉尘浓度为30 g/m3左右的燃煤锅炉,经过静电除尘后进入滤袋的粉尘浓度只有3 g/m3。对于这种粉尘浓度,滤袋的清灰周期可达3 h以上。由于清灰周期的大大增长,可大大提高滤袋的寿命。该产品性价比优良、占地面积少、结构简单。尤其在净化效率、气体阻力等主要技术指标方面达到了环保要求。     

辽宁省背景地区降水化学特征及其与大气传输的关系

为了解辽宁省背景地区降水化学特征及其与大气传输的关系,于2007年2月─2008年1月在辽中县水文监测站进行了降水化学特征观测,测量项目包括降水pH,电导率和离子浓度. 观测期间降水pH为3.4～7.3,降水量加权平均值为4.6,整体呈酸性. 降水中主要阴离子为SO₄2-和NO₃-,浓度分别为154.3和53.4 μeq/L,二者占阴离子总量的76.8%; 主要阳离子为NH₄+和Ca2+,浓度分别为124.6和89.2 μeq/L,占阳离子总量的70.6%. 利用后向气流轨迹分析了降水气团来源对降水化学的影响,结果表明:在辽宁省及周边地区的局地气团影响下,降水中离子浓度最高;而在起源于东亚地区,经朝鲜半岛到达的南-东南气团影响下,降水次数虽最多,但离子浓度最低.      

An Evaluation of the NIOSH Lifting Equation: A Psychophysical and Biomechanical Investigation

Using the results of psychophysical and biomechanical experiments, NIOSH (National Institute for Occupational Safety and Health) Recommended Weight Limit (RWL), the Lifting Index (LI), the form of the asymmetry multiplier, and the criterion for compression force were investigated. Analysis of the results indicated a significant difference between the NIOSH RWL and the reported Maximum Acceptable Weight of Lift (MAWL). Contrary to the NIOSH lifting equation, the form of the asymmetry multiplier was found to be non-linear. The overall average of peak compression force on the L5/S1 was 3685 N. Fifty-eight percent of all compression forces reported in the biomechanical experiment were found to exceed the suggested 3400 N set by NIOSH guidelines. These results support previous research findings on the validity of NIOSH guidelines.     

Isometric Pull and Push Strengths of Paraplegics in the Workspace: 2. Statistical Analysis of Spatial Factors

The effect of reach levels, horizontal angles, and vertical angles on isometric pull and push strengths of male and female was determined. Highly significant increases in men’s push strength were found between extreme to maximum reaches, and from extreme to normal reaches. However, for women’s push strength, a significant increase was found only between extreme to maximum reach. Significant or highly significant increases were found in men’s and women’s pull strength between the horizontal angle (θ) sagittal through the active shoulder (90°) and other angles (0, 45, and 135°). However, for men’s push strength, highly significant increases were found between the horizontal angle 45° from the frontal plane, and other angles. For women’s push strength, significant or highly significant increases were found between the horizontal angles 0° and angles of 90 and 135°. For men’s and women’s pull strength, significant or highly significant increases were found between the vertical angle (?), 90°, and other angles (–20, 0, and 45°). Similar increases were found for women’s push strength between the 45° angle and other angles. In the design of a workstation for paraplegics that requires pull and push forces, consideration must be given to the spatial factors.     

Testing Sleeping Bags According to EN 13537:2002: Details That Make the Difference

The European Standard on sleeping bag requirements (EN 13537:2002) describes a procedure to determine environmental temperature limits for safe usage of sleeping bags regarding their thermal insulation. However, there are several possible sources of error related to this procedure. The main aim of this work was to determine the influence of the various measuring parameters on the acuity of the respective parameters in order to judge the requirements. The results indicated that air velocity, mattress insulation and time between unpacking the bag and measurement had a significant impact on the result, with a difference of up to 5–15% in thermal insulation between minimum and maximum allowable parameter levels. On the other hand, manikin weight, thickness of the artificial ground and presence of a face mask were found to have a negligible influence. The article also discusses more general aspects of the standard including the calculation methods used.     

燃煤电厂烟气脱硫设施脱硫效率计算方法的探讨

为准确评估燃煤电厂脱硫设施在实际运用中的脱硫效率,根据目前脱硫效率的三种计算方法在实际运用中的问题,并应用燃煤电厂的实测数据,对比了三种方法计算得出脱硫效率的相对误差。结果表明：根据折算浓度评估脱硫效率,综合考虑了烟气泄漏对计算脱硫效率的影响,并且不受烟气旁路排放等因素影响,理论上和实践中都可以得到准确的脱硫效率。