微电解-生化法处理大蒜废水工程实例

针对大蒜废水特点,采用了铁屑微电解-UASB-接触氧化工艺进行处理.运行结果表明:在设计进水水质、水量范围内,COD、BOD5、氨氮和ss去除率分别为98%、99%、70%和98%,出水各项指标均达到GB 8978--1996<污水综合排放标准>中的一级排放标准,系统运行费用为1.19元/m3.     

无机-有机复合絮凝剂PST处理印染废水效果研究

以模拟印染废水和实际印染废水为实验对象,检验了一种新合成有机-无机复合絮凝剂(PST)的絮凝效果。结果表明,PST具有良好的絮凝性能。在受试条件下,絮凝效果与絮凝剂投加量、染料浓度有较大相关性。废水的pH值应用范围较宽;搅拌时间对COD去除率和脱色率没有显著影响。采用PST处理广东省高明市某印染厂的印染废水后,COD去除率为75.16%,脱色率为76.18%,处理效果良好,处理成本明显低于目前市场上普遍使用的聚铝等絮凝剂。     

己内酰胺生产废水的铁碳微电解深度处理与机理研究

采用铁碳微电解方法对己内酰胺生产废水进行深度处理,探讨了pH值、停留时间、铁碳质量比对处理效果的影响。在pH为4、停留时间为120 min、铁碳质量比为4的最佳处理条件下,COD去除率可达57.8%,色度去除率可达68.4%。微电解对己内酰胺废水的作用主要通过铁的絮凝作用,处理过程中的酸性条件、微电解的氧化还原和电场作用,从而提高其去除效率。     

加压气浮法处理含油废水中溶气压力对出水水质的影响与应用研究

以实际工作中的含油废水为研究对象,采用加压气浮处理工艺,通过多年的实际应用与对监测数据的分析,总结出气浮压力对气浮处理效果的影响,通过对溶气罐压力的调整,可得到最佳的出水水质。该项研究结果操作方便、处理效率高、易于控制、对今后的工作具有指导意义,有很好的推广价值。     

焦化废水对蚕豆和大麦毒性的影响

以COD作为主要参照指标,研究了焦化废水在符合GB 13456-92<钢铁工业水污染物排放标准>焦化一级、二级排放标准限值要求时,对蚕豆和大麦幼根生长、根尖细胞遗传毒性的影响.结果表明:在实验周期内,焦化废水对蚕豆幼根根长、根重和有丝分裂指数的影响不大;对大麦幼根根重无明显影响,而对大麦根长和有丝分裂指数有促进作用.焦...     

低温水解酸化-A~2/O（PACT）-混凝沉淀处理印染废水

低温条件下对水解酸化-A2/O（PACT）-混凝沉淀组合工艺处理印染废水进行了中试研究。考察印染废水中COD和色度去除效果,结果表明：低温对工艺负面影响较大,未加粉末活性炭时好氧段COD和色度的去除率分别为42.6%和58.9%;投加粉末活性炭后,去除率分别达55.8%和65.4%,提高了13.2%和6.5%,显示出低...     

印钞废水处理工艺的改进实验

印钞废水属高浓度难降解有机废水,对环境污染严重。鉴于现有处理工艺出水普遍不达标的情况,通过对比实验确定了改进方案:超滤浓缩液离心出水在进入接触氧化池前,增加新的处理单元(Fenton氧化-混凝)。Fenton氧化最佳条件:FeSO4.7H2O投加量14 g/L,H2O2的投加量34 mL/L,初始pH值6.0,氧化反应时间1.5h,温度18.8℃;混凝过程最佳条件:PAC投加量4 g/L,PAM(5‰)投加量10 mg/L,pH值7。新增单元对废水中COD去除率接近80%,可生化性提高1.6倍,色度降低36%。     

四川某中小城镇污水处理厂进水水质统计分析

生活污水水质对处理工艺的选择、设计参数的选取以及稳定运行十分重要。运用SPSS软件,对四川某中小城镇污水处理厂为期一年的进水指标(水量、COD、氨氮、总磷、pH、SS)进行方差和相关性分析。方差分析结果显示进水量、氨氮和SS在月份和季节之间存在显著性差异,而总磷和pH仅在月份之间存在显著差异,COD在季度和月份之间无显著性差异;指标相关性分析表明,进水量和氨氮之间呈负相关,氨氮和总磷、COD和总磷之间呈正相关,且相关性显著。在此分析的基础上对污水处理厂设计、工艺选择及运行管理提出了一些建议。     

Impacts of wastewater sludge amendments in restoring nitrogen cycle in p-nitrophenol contaminated soil

The possible impacts on nitrogen-cycle in a p-nitrophenol (PNP) polluted soil and the e ectiveness of wastewater sludge amendments in restoring nitrification potential and urease activity were evaluated by an incubation study. The results indicated that PNP at 250 mg/kg soil inhibited urease activity, nitrification potential, arginine ammonification rate and heterotrophic bacteria counts to some extents. After exposure to PNP, the nitrification potential of the tested soil was dramatically reduced to zero over a period of 30 days. Based on the findings, nitrification potential was postulated as a simple biochemical indicator for PNP pollution in soils. Nitrogen-cycling processes in soils responded positively to the applications of wastewater sludges. A sludge application rate of 200 tons/ha was su cient for successful biostimulation of these nitrogen processes. The microbial activities in sludge-amended, heavy PNP-polluted soils seemed to recover after 30–45 days, indicating the e ectiveness of sludge as a useful soil amendment.     

TiO2 nanotubes as solid-phase extraction adsorbent for the determination of polycyclic aromatic hydrocarbons in environmental water samples

An analytical method based on TiO2 nanotubes solid-phase extraction (SPE) combined with gas chromatography (GC) was established for the analysis of seven polycyclic aromatic hydrocarbons (PAHs): acenaphtylene, acenaphthene, anthracene, fluorene, phenanthrene, fluoranthene and pyrene. Factors a ecting the extraction e ciency including the eluent type and its volume, adsorbent amount, sample volume, sample pH and sample flow rate were optimized. The characteristic data of analytical performance were determined to investigate the sensitivity and precision of the method. Under the optimized extraction conditions, the method showed good linearity in the range of 0.01–0.8 g/mL, repeatability of the extraction (RSD were between 6.7% and 13.5%, n = 5) and satisfactory detection limits (0.017–0.059 ng/mL). The developed method was successfully applied to the analysis of surface water (tap, river and dam) samples. The recoveries of PAHs spiked in environmental water samples ranged from 90% to 100%. All the results indicated the potential application of titanate nanotubes as solid-phase extraction adsorbents to pre-treat water samples.