美人蕉根系对不同基质结构水平潜流人工湿地水力特性的影响

为了研究植物根系对不同基质结构潜流人工湿地水力特性的影响,根据填料渗透系数,分别设置单层及多层基质结构潜流人工湿地小试实验系统,以美人蕉作为湿地植物,在植物栽种前与成熟后对两系统分别开展示踪试验研究.实验结果表明,美人蕉根系对于单层结构人工湿地水力特性有较明显的改善作用,有效体积从0.49提高到了0.53,短路值由0.60降低到0.41,水力效率提高最大由43%提高到59%.比较而言,植物根系对多层结构湿地有效体积和短路值有轻微负面影响,而对水力效率则有明显的改善作用(由64%提高到83%).此外,植物成熟后,两人工湿地系统中示踪剂回收率均有所下降,其中,单层结构湿地降低较显著,回收率由72%降到62%.可见,植物根系对系统水力特性有较大影响,应在人工湿地设计过程中给予考虑.     

渭河陕西段潜流带沉积物重金属变化初步分析

为厘清潜流带沉积物重金属时空变化及与水量交换、沉积物颗粒结构间的关系,于2013年春夏两季对渭河陕西段5个研究断面66个测试点位沉积物的野外原位渗透系数、颗粒粒径、重金属含量进行分析.结果表明:影响渭河沉积物渗透系数的主要因素是沉积物粒径,同时沉积物垂向分层、排列组合也影响其渗透性能;沉积物重金属Cu、Zn、Pb、Cd质量分数在垂向上不同深度其含量大小不同,在时间上总体呈现春季夏季,富集系数(EF指数)分析结果显示春季Cu、Zn(除华县)、Pb(除眉县)、Cd富集严重且主要受人为输入源影响,夏季除Cd元素外,Cu、Zn、Pb的EF值均1.5,说明其含量主要来源于地壳和岩石圈的自然风化过程;Pearson相关分析发现粘土与粉砂(粒径0.075 mm)百分比与沉积物重金属质量分数呈弱相关,重金属粒径效应不显著,粒径不是控制重金属含量的主要环境影子;对单一重金属垂向不同深度含量进行相关性研究发现除Cd外,其余3种重金属在垂向上的相关系数均0.5(p0.01),说明单一重金属在垂向上具有同源性且存在相互迁移与转化.     

水力停留时间对活性污泥系统的硝化性能及其生物结构的影响

利用微生物呼吸醌指纹谱图结合传统分析方法研究了水力停留时间(HRT从30 h逐步缩短至5 h)对活性污泥硝化性能及种群结构的影响.结果表明,对于NH₄⁺-N浓度为500 mg·L^-1的废水,在HRT≥20 h时,氨氮去除率可达98%以上.若继续缩短HRT,污泥流失严重,尽管进水NH₄⁺-N浓度降低,出水NH₄⁺-N和NO₂     

重碳酸型地下水矿化度测定方法的探讨——以洛阳市浅层地下水为例

矿化度是地下水化学成份测定的重要指标，在环境监测中，用重量法测定矿化度是目前普遍采用的方法。其缺点主要为费时，繁琐，耗电。本文通过测定洛阳市地下水的电导率，分析对比电导率与矿化度的关联，并进一步用回归方程确定电导率与矿化度之间的数量关系，探索出用电导率法间接测定地下水矿化度，具有快速，经济，准确的优点。     

MODIFIED WATER QUANTITY RECEIVING MODEL FOR FLORIDA CONSERVATION AREAS1

ABSTRACT: The Conservation Areas in South Florida have been considered as one of the major water storage areas to provide a water supply for the Everglades National Park and Lower East Coast (LEC). Due to the increasing water demands of the area, additional backpumping of the surplus runoff from the LEC area into the Conservation Areas has been considered as one of several alternative plans. The Receiving Water Quantity (EPA, 1971) model has been adapted and modified to be applicable in the Conservation Areas to investigate the possible impact of additional inflow under various backpumping cases. The modification of the model included Manning's roughness coefficient, depth of flow, width of hypothetical channels through marsh areas, rainfall input, seepage rate, etc. The use of the Monte Carlo technique for area computations was found to be easy and time saving both in area and weighting rainfall input to each node. Comparison of results generated by this modified model with the recorded values in Conservation Areas 1 and 2A indicated that the model not only can be a very good evaluation tool to simulate the hydraulic regime of the Conservation Areas system but also a proper tool for investigating the impact of additional inflow resulting from the backpumping related to the water use planning and management.     

INTERACTIVE COMPUTER-AIDED HYDRAULIC DESIGN: CULVERTS1

ABSTRACT: Regular use of interactive computer programs in hydraulic design can materially increase the productivity of designers without sacrificing accuracy. This article considers the hydraulic design of culverts by interactive use of a computer program; this approach most profitably combines the speed and accuracy of the computer with the experience of the designer.     

COMPARATIVE STUDY OF FRESH-SALT WATER INTERFACES USING FINITE ELEMENT AND SIMPLE APPROACHES

ABSTRACT: The fresh-salt water interface in artesian aquifers has been investigated by various techniques on the basis of its analogy to the free surface in earth dams or cores of dams. Although various approximations are used, some more or less exact solutions exist. One of the simple methods, that would appeal to practical workers, was developed by the analysis of hydraulic forces. However, this method has not been checked thoroughly due to the lack of wide ranges of coverage by the more or less exact solutions. In this paper a suggested finite element method is used for the purpose of comparing with the method of hydraulic forces. The presented procedure eliminates some of the difficulties and uncertainties in current finite element procedures. Both methods proved to be in close agreement. Moreover, the hydraulic heads along the upper boundary of the artesian aquifer were found to be in close agreement with Dupuit's equation. The results of this investigation would greatly simplify the more complex management problems when the effects of discharge and/or recharge wells are added to the natural flow effects.     

SURFACE WATER RESOURCES OF ST. JOHNS RIVER,FLORIDA1

ABSTRACT: The St. Johns River basin is the largest watershed entirely within the State of Florida, and is one of the few northward flowing rivers in the United States. The river basin contains 11,431 square miles, of which 9,430 square miles are drained by the river and its tributaries. The remainder drains into the Atlantic Ocean or the Intracoastal Waterway. Its largest sub-basin is the Oklawaha River basin, which has a drainage area of 2,870 square miles. Ground elevations range from sea level to 200 feet above mean sea level in the main river basin and as high as 300 feet above mean sea level in the Oklawaha River basin. This study was designed to investigate the surface water resources of the St. Johns River and the existing consumptive uses. The analysis revealed that the river is an extremely large and valuable resource which has been under-utilized and could play a much stronger role in serving the needs of the people in the basin.     

INFLUENCES OF A FOREST ON THE HYDRAULIC GEOMETRY OF TWO MOUNTAIN STREAMS1

ABSTRACT The influence of a forest on the formation of steps in two small streams of the Colorado Rocky Mountains was studied. Steps provided by logs fallen across the channel added to flow energy reduction. The streams required additional gravel bars to adjust to slope. Average step length between logs and gravel bars was strongly related to channel gradient and median bed material size. Based on the average number of log steps per 50 feet of channel, an average of 116 percent of gravel bars were added at Fool Creek and 60 percent at Deadhorse Creek. The latter had 52 percent more logs in the channel and therefore required less bed material movement than the former. Although these are “rushing mountain streams,” most flow velocities ranged between 0.5 and 2.5 f.p.s. Exponents of a function relating rate of change of depth or velocity to discharge indicated that dynamic stream equilibrium was attained. Implications for forest management are that sanitation cuts (removal of dead and dying trees) would not be permissible where a stream is in dynamic equilibrium and bed material movement should be minimized.     

MIXING INDUCED BY AN INTERNAL HYDRAULIC JUMP1

ABSTRACT The efficiency of an inverted internal hydraulic jump as a mixing and dispersion mechanism in an aquatic environment was examined. The flow considered was a two-dimensional buoyant flow from a shallow channel over a sloping bottom into a deep reservoir. It could be seen that a rapidly varied flow associated with violent turbulent mixing occurred near the point of discharge if specific discharge conditions and downstream controls were met. Downstream from the mixing zone the flow was stably stratified. The main object of the study was to find the conditions under which a turbulent mixing zone occurred and the rate of turbulent entrainment. Energy loss and length of the mixing zone were also investigated. The independent variables were the outlet densimetric Froude number, the density differential between outfall water and receiving water, the relative depths of the upper and lower layers in the stratified flow portion, the total depth, and the slope of the transition. Theoretical calculations had to be confined to a step increase in depth, but experiments in a laboratory flume showed that results obtained with slopes of 23° and 90° were quite similar. Both theory and experiments showed, for example, that dilution (entrainment rates) up to 2:1 (2 parts heated water to one part cold water) can be achieved at very little energy expense and with downstream depths approximately 8 times the outlet depth. Theoretically, any amount of dilution can be obtained, but large depths may be required. Experimental results also indicate that the length of the mixing zone was frequently ten times the value of the outlet densimetric Froude number.