青冰滩冰川水文特征初步分析

通过对青冰滩冰川的综合考察,对该地区2008-08-01日至08-31日的水文、气象以及水环境进行了连续观测。结果表明:冰川表面大量覆盖冰碛增加了冰川表面的反射率,加速了冰川消融;整个8月日均气温在8℃以下,气温的日较差较大,冰川消融期的降水以降雪和冰雹为主;冰川融水的电导率和溶解性固体相关系数可达0.98,两者与气温的相关度也可达到0.8以上。     

Using multivariate regression modeling for sampling and predicting chemical characteristics of mixed waste in old landfills

Municipal solid waste landfills pose a threat on environment and human health, especially old landfills which lack facilities for collection and treatment of landfill gas and leachate. Consequently, missing information about emission flows prevent site-specific environmental risk assessments. To overcome this gap, the combination of waste sampling and analysis with statistical modeling is one option for estimating present and future emission potentials. Optimizing the tradeoff between investigation costs and reliable results requires knowledge about both: the number of samples to be taken and variables to be analyzed.This article aims to identify the optimized number of waste samples and variables in order to predict a larger set of variables. Therefore, we introduce a multivariate linear regression model and tested the applicability by usage of two case studies. Landfill A was used to set up and calibrate the model based on 50 waste samples and twelve variables. The calibrated model was applied to Landfill B including 36 waste samples and twelve variables with four predictor variables.The case study results are twofold: first, the reliable and accurate prediction of the twelve variables can be achieved with the knowledge of four predictor variables (Loi, EC, pH and Cl). For the second Landfill B, only ten full measurements would be needed for a reliable prediction of most response variables. The four predictor variables would exhibit comparably low analytical costs in comparison to the full set of measurements. This cost reduction could be used to increase the number of samples yielding an improved understanding of the spatial waste heterogeneity in landfills.Concluding, the future application of the developed model potentially improves the reliability of predicted emission potentials. The model could become a standard screening tool for old landfills if its applicability and reliability would be tested in additional case studies.     

好氧颗粒污泥自生动态膜生物反应器处理碱减量印染废水

自生动态膜生物反应器(SFDMBR)接种颗粒污泥启动,研究溶解氧浓度和水力停留时间对该反应器处理碱减量印染废水的影响。自生动态膜生物反应器形成稳定的动态膜后,出水浊度小于10 NTU,系统对浊度的去除率在90%以上,溶解氧和水力停留时间对反应器出水浊度基本无影响。系统对废水色度的去除率随着溶解氧浓度的提高和水力停留时间的延长而增加,但是系统对色度的去除效率一般不超过40%。溶解氧浓度由0.3 mg/L逐渐增大至2.4 mg/L,COD的去除率由40%提升至80%,而当溶解氧浓度大于1.0 mg/L后,UV254的去除率达到95%。水力停留时间在8~48 h时,COD去除效率由65%逐渐上升至85%左右;水力停留时间在8~32 h,UV254去除效率为68%~93%,超过32 h后水力停留时间对UV254去除效率的影响已不明显。     

复合填料热传导过程数值模拟

复合填料由废铸砂、粉煤灰、聚苯乙烯(EPS)颗粒、水泥和水按一定质量比例混合制成,具有低导热性、抗冻胀和轻质特性。根据热阻力法则和比等效导热系数相等法则,将材料视为由大量正方形单元体组成,其中心为一个球形EPS颗粒,这种单元体与总体的导热系数相等。运用AN SY S软件对复合填料单元体的传热过程进行了有限元模拟,根据瞬态法导热系数测试原理,推求不同EPS掺入比情况下的复合填料导热系数,分析EPS颗粒与导热系数的关系,发现材料导热系数随着EPS掺入比的增加而快速降低。将材料导热系数数值模拟与实测结果作比较,发现有限元模拟值与实测值接近,说明采用有限元方法可以实现对材料传热过程的模拟。     

新型结构ABR的设计与水力特性研究

针对ABR自身的缺点,设计出一种新型结构的ABR.该反应器为双层结构,共有5部分组成,各部分容积各不相同.该反应器的设计思想是将ABR与生物滤池以及活性炭吸附等工艺相联合.这种设计能够最大程度地发挥各工艺的优势,进而达到更好的处理效果.通过脉冲响应实验对该反应器的水力特性进行研究,得出不同水力停留时间(HRT)下的停留...     

水力条件对复合人工湿地处理城市受污染河水效果的影响

通过对水力负荷、水力停留时间等水力条件的控制,观察其对复合垂直上行流人工湿地处理城市受污染河水效果的影响.一年多来的运行结果表明:水力条件对复合垂直上行流人工湿地去除其他污染物的影响显著,但对总氮去除的影响不大.水力停留时间的延长可提高总磷、氨氮、COD的去除效果;随着水力负荷的增加,总磷、氨氮、COD去除率都有所增加...     

垂直流人工湿地水力学特性研究

通过示踪剂实验从停留时间分布（RTD）曲线及其统计特征值等方面对垂直流人工湿地的水力学特性进行了定性和定量的分析。研究表明水流在垂直流人工湿地中的流动是一种非理想的不均匀流动,存在一定的死区和水流的扩散;垂直流人工湿地较大的死区率与其表面布水的不均匀性有关,这也可能是其死区率大于表流人工湿地的最主要的原因。实验还表明,进水流量对垂直流人工湿地停留时间分布影响较大,随着进水流量的增加,平均停留时间减小,但标准平均停留时间增大,死区率减小;当进水流量为15L／h（水力负荷为620mm／d）时,水流在湿地中的散度最大,水流更接近全混流,不利于污染物的降解。     

Indirect measurements of field-scale hydraulic conductivity of waste from two landfill sites

Management and prediction of the movement and distribution of fluids in large landfills is important for various reasons. Bioreactor landfill technology shows promise, but in arid or semi-arid regions, the natural content of landfilled waste may be low, thus requiring addition of significant volumes of water. In more humid locations, landfills can become saturated, flooding gas collection systems and causing sideslope leachate seeps or other undesirable occurrences. This paper compares results from two different approaches to monitoring water in waste. At the Brock West Landfill in eastern Canada, positive pore pressures were measured at various depths in saturated waste. The downward seepage flux through the waste is known, thus the vertical saturated hydraulic conductivity of the waste at this landfill was determined to be 3 × 10(-7)cm/s. By comparison, the Spadina Landfill in western Canada is predominantly unsaturated. The infiltration of moisture into the waste was measured using moisture sensors installed in boreholes which determined arrival time for moisture fronts resulting from major precipitation events as well as longer-term change in moisture content resulting from unsaturated drainage during winter when frozen ground prevented infiltration. The unsaturated hydraulic conductivity calculated from these data ranged from approximately 10(-6)cm/s for the slow winter drainage in the absence of significant recharge to 10(-2)cm/s or higher for shallow waste subject to high infiltration through apparent preferential pathways. These two very different approaches to field-scale measurements of vertical hydraulic conductivity provide insight into the nature of fluid movement in saturated and unsaturated waste masses. It is suggested that the principles of unsaturated seepage apply reasonably well for landfilled waste and that the hydraulic behavior of waste is profoundly influenced by the nature and size of voids and by the degree of saturation prevailing in the landfill.     

Probabilistic Flood Inundation Forecasting Using Rating Curve Libraries

One approach for performing uncertainty assessment in flood inundation modeling is to use an ensemble of models with different conceptualizations, parameters, and initial and boundary conditions that capture the factors contributing to uncertainty. However, the high computational expense of many hydraulic models renders their use impractical for ensemble forecasting. To address this challenge, we developed a rating curve library method for flood inundation forecasting. This method involves pre‐running a hydraulic model using multiple inflows and extracting rating curves, which prescribe a relation between streamflow and stage at various cross sections along a river reach. For a given streamflow, flood stage at each cross section is interpolated from the pre‐computed rating curve library to delineate flood inundation depths and extents at a lower computational cost. In this article, we describe the workflow for our rating curve library method and the Rating Curve based Automatic Flood Forecasting (RCAFF) software that automates this workflow. We also investigate the feasibility of using this method to transform ensemble streamflow forecasts into local, probabilistic flood inundation delineations for the Onion and Shoal Creeks in Austin, Texas. While our results show water surface elevations from RCAFF are comparable to those from the hydraulic models, the ensemble streamflow forecasts used as inputs to RCAFF are the largest source of uncertainty in predicting observed floods.     

基于震后低压变化的供水管网功能可靠度分析

供水管网的抗震功能是指供水管网在地震作用下能够满足震后城市特定用水需要(需水量和水压)的能力。地震发生后,供水管网一般处于低压供水状态,使得管网中部分用户的水压和水量不能得到全部满足,导致管网部分节点的实际配水量小于需水量。为此,在传统的管网水力分析基础上考虑节点流量随节点水压的动态变化,通过求解非线性水力方程组,得到管网节点实际流量和水压;同时,借鉴结构可靠度分析方法,引入供水管网系统随机水力模型,给出了震后供水管网功能可靠度分析的一次二阶矩方法。以一实际管网为例,演示了震后低压供水时管网功能可靠度分析的应用方法。