VEGETATION INFLUENCE ON SMALL STREAM SILTATION1

ABSTRACT: A meandering stream channel was simulated in the Hydraulics Laboratory at Colorado State University and a series of tests was conducted using four types of vegetation to evaluate the potential effects of vegetation on sediment deposition and retention in a stream channel. The data collected included average flow velocity, flow depth, length of vegetation, density of vegetation, cross-sectional area of the vegetative stem, wetted perimeter of the vegetative stem, and injection and flushing time. The findings indicated that the vegetation could retain from 30 to 70 percent of the deposited sediments. The ability of vegetation to entrap and retain sediment is related to the length and cross-sectional area of the vegetation. The variables describing the flow and the vegetative properties were combined to form a predictive parameter, the sedimentation factor (S_d) that can be compared with the amount of sediment entrapped by vegetation in a stream system. A relation was developed correlating vegetation length to sediment retention after flushing for flexibility and rigid vegetation.     

移栽期变化对黑龙江省水稻低温冷害的影响——以2002年为例

针对影响黑龙江省水稻生产的低温冷害问题,利用黑龙江省水稻主要种植区域10个农业气象观测站1999-2004年每年5-9月的水稻生长观测数据和逐日平均温度数据,运用统计方法建立了产量构成与温度指标的关系方程,并结合黑龙江省2002年逐日平均温度格点化数据,对3个不同移栽日期情况下低温冷害的发生情况进行了分析。结果显示:2002年的低温冷害在黑龙江中部最严重,东部次之,西部受害最轻;北部地区受害面积和冷害损失比南部地区更大;在3个移栽日期中,随着移栽日期的推后,水稻产量有5%～11%的不同程度的减少,冷害损失逐渐增大,即按时间5月中旬—5月下旬—6月初依次递增。     

流体动力系统噪声控制研究

以泵为例分析了液压动力系统中噪声产生的机理和危害，结合多年来的生产经验，给出降低和控制液压动力系统噪声的思路和几种基本方法。     

An investigation on the fuel savings potential of hybrid hydraulic refuse collection vehicles

Refuse trucks play an important role in the waste collection process. Due to their typical driving cycle, these vehicles are characterized by large fuel consumption, which strongly affects the overall waste disposal costs. Hybrid hydraulic refuse vehicles offer an interesting alternative to conventional diesel trucks, because they are able to recuperate, store and reuse braking energy. However, the expected fuel savings can vary strongly depending on the driving cycle and the operational mode. Therefore, in order to assess the possible fuel savings, a typical driving cycle was measured in a conventional vehicle run by the waste authority of the City of Stuttgart, and a dynamical model of the considered vehicle was built up. Based on the measured driving cycle and the vehicle model including the hybrid powertrain components, simulations for both the conventional and the hybrid vehicle were performed. Fuel consumption results that indicate savings of about 20% are presented and analyzed in order to evaluate the benefit of hybrid hydraulic vehicles used for refuse collection.     

Effects of sludge retention time, carbon and initial biomass concentrations on selection process: From activated sludge to polyhydroxyalkanoate accumulating cultures

Four sequence batch reactors (SBRs) fed by fermented sugar cane wastewater were continuously operated under the aerobic dynamic feeding (ADF) mode with different configurations of sludge retention time (SRT), carbon and initial biomass concentrations to enrich polyhydroxyalkanoate (PHA) accumulating mixed microbial cultures (MMCs) from municipal activated sludge. The stability of SBRs was investigated besides the enrichment performance. The microbial community structures of the enriched MMCs were analyzed using terminal restriction fragment length polymorphism (T-RFLP). The optimum operating conditions for the enrichment process were: SRT of 5 days, carbon concentration of 2.52 g COD/L and initial biomass concentration of 3.65 g/L. The best enrichment performance in terms of both operating stability and PHA storage ability of enriched cultures (with the maximum PHA content and PHA storage yield (Y_PHA/S) of 61.26% and 0.68 mg COD/mg COD, respectively) was achieved under this condition. Effects of the SRT, carbon concentration and initial biomass concentration on the PHA accumulating MMCs selection process were discussed respectively. A new model including the segmentation of the enrichment process and the effects of SRT on each phase was proposed.     

玉米秸秆生物炭对贵州黄壤持水能力的影响

生物炭具有丰富的微孔结构,能够影响土壤的持水性能,对植物生长和土壤中养分的保持有着重要意义。而土壤水分特征曲线又是表征土壤持水能力的一个重要指标。本文通过压力膜法测定添加不同比例生物炭的黄壤水分特征曲线,并结合van Genuchten模型对实测结果进行拟合,推导水动力学参数。结果表明,随着生物炭施入量的增加(0、5%、10%),土壤的田间持水量增加,凋萎含水量降低,土壤有效含水量增加。生物炭添加能够显著提高土壤的持水能力,增强水分的可利用性。同时,van Genuchten模型拟合结果同实测值高度相似,可以用作预测生物炭改良土壤的水动力学参数。     

外源Ca2+对SBR启动期活性污泥胞外多聚物的动态影响

利用无机物如Ca~(2+),加快活性污泥反应器启动,强化活性污泥絮体性能和结构稳定性,受到越来越多的重视.采用序批式反应器,研究进水中添加Ca~(2+)对反应器启动期活性污泥沉降性能和胞外多聚物的影响.结果表明运行至28 d,与进水中不添加Ca~(2+)的反应器(对照反应器)相比,进水中添加150 mg·L~(-1)外源Ca~(2+)的反应器中活性污泥MLSS和MLVSS值分别高出了89.6%和75.6%,SVI值则降低了47.9%;活性污泥胞外多聚物总量增加了76.4%,多糖增加了28.8%,蛋白质减少了31.6%,添加150 mg·L~(-1)外源Ca~(2+)的反应器中污泥胞外多聚物中多糖/蛋白质值为68.8,对照反应器的活性污泥胞外多聚物多糖/蛋白质值仅为36.6.三维荧光光谱和红外光谱分析表明外源Ca~(2+)导致活性污泥胞外多聚物组分发生了变化.实验结果为进水中添加外源Ca~(2+)改善活性污泥沉降性能提供了基础数据.     

铝合金-丁腈橡胶航空带垫卡箍典型环境损伤研究

目的研究典型环境对丁腈橡胶-铝合金带垫卡箍的损伤效应。方法通过模拟铝合金-丁腈橡胶航空带垫卡箍使用时的装配结构和应力状态,应用GJB 150A—2009中的湿热和太阳辐射两种典型老化环境,采用宏观形貌观察、卡箍保持力测试和橡胶衬垫拉伸性能测试方法,结合扫描电子显微镜和傅里叶红外光谱技术,分析带垫卡箍的性能劣化过程。结果带垫卡箍在湿热和太阳辐射环境中老化50 d后,卡箍橡胶衬垫表面出现大量微孔缺陷,拉伸性能大幅降低,导致卡箍保持力分别下降了35%和51%。结论带垫卡箍在模拟装配状态下进行湿热和太阳辐射环境暴露实验,卡箍橡胶衬垫内部结构由致密逐渐变得疏松,部分碳碳双键发生氧化交联反应,并在一定程度上提高了聚合物的交联密度,材料硬度提高,回弹性能减弱,橡胶衬垫对芯轴的包裹能力降低,导致卡箍保持力性能降低。     

生态高负荷土地快速渗滤系统处理猪场废水的效能及微生态

以经过厌氧反应器处理后的猪场废水为研究对象,探讨了新型生态高负荷土地快速渗滤系统对废水中COD、氨氮及总氮的去除情况;同时分析了该系统中的微生物群落结构以及过氧化氢酶、脲酶、硝酸盐还原酶的含量.结果表明,在水力负荷为11 cm·d~(-1)、进水COD为700 mg·L~(-1)左右的条件下,一级土地渗滤柱与二级土地渗滤柱对COD的去除率分别为78.8%与63.0%,总去除率达到了92.6%;而当水力负荷增大到22 cm·d~(-1)时,总的COD去除率仍在90.0%以上;该系统对于氨氮的去除更为显著,去除率可达99%左右.一级土地快速渗滤系统中上、中、下部的过氧化氢酶含量分别为1.899、0.990、0.323 m L·g~(-1),表明猪场废水中的有机物主要在该系统的上部与中部得以去除;二级土地快速渗滤系统上、中、下部的硝酸盐还原酶含量分别是3.453、3.831、1.971 m L·g~(-1),表明脱氮作用主要发生二级土地快速渗滤系统的上部与中部.该土地快速渗滤系统中微生物以Gram Negative与Gram Positive为主,特别是在二级土地快速渗滤系统中,AM Fungi与Actinomycetes占有一定比例,为猪场废水中难降解有机物的去除提供了保障.     

海水生物滤器氨氮沿程转化规律模型

生物滤器是海水循环水养殖系统中的核心水处理单元,其主要用于去除对养殖生物有害的氨氮、有机物等.本研究基于吸附原理和一级反应生物膜理论构建了氨氮在生物滤器中沿程转化规律的数学模型,并通过实验加以验证.实验所用生物滤器采用竹制空心生化球填料,装填高度为70 cm,在pH为7.1～7.6,DO为5～7 mg.L-1,气水比20∶1左右,有机负荷约为4g.(m3.h)-1,水力停留时间(HRT)为1 h条件下,生物滤器中氨氮的去除主要发生在填料高度0～10 cm处,10～70 cm处氨氮去除量很少.进水氨氮质量浓度的增大和水力停留时间的降低都会导致出水氨氮质量浓度增大.此外,模型对进水氨氮质量浓度较低时的沿程出水氨氮质量浓度具有很好的预测效果;当进水氨氮质量浓度较高时,预测值略低于实际结果.