Fenton氧化工艺在某化工园区集中式污水处理厂升级改造工程中的应用

针对江苏省某化工园区集中式污水处理厂出水COD和TP高于DB32/939—2006《江苏省化学工业主要水污染物排放标准》规定的排放限值的情况,采用Fenton氧化工艺对该污水处理厂装置进行升级改造。小试最佳工艺条件为:初始污水pH 3.0~3.5,H_2O_2(质量分数30%)加入量0.8 m L/L,FeSO_4·H_2O加入量0.8 g/L,反应时间120min,Fenton氧化反应结束后中和反应的适宜pH约为7.0。升级改造工程包括2套并联运行的处理能力各为10 km~3/d的Fenton氧化系统,装置稳定运行后最终控制H_2O_2加入量为150 L/h,FeSO_4·7H_2O溶液加入量为700 L/h,相应的处理后出水COD和TP分别稳定在60 mg/L和0.4 mg/L以下,可达标排放。每吨污水的处理药剂成本约为0.9元。     

胺液脱硫系统再生性能下降原因分析及对策

中国石化茂名分公司两套胺液集中再生装置出现异常,再生后贫液中ρ(H_2S)达到2.0~3.0 g/L,远高于1.2g/L的工艺设计值。通过在实验室模拟装置上考察新鲜脱硫剂的吸收和再生性能、分析工厂胺液脱硫系统贫液的杂质组成和来源、对比实验室净化前后的效果,查明胺液脱硫系统脱硫剂再生性能下降的原因。据此对工厂胺液脱硫系统提出相应的操作建议,包括采取胺液净化技术将系统热稳盐含量(w)从2.35%降至0.95%、规范操作以降低Na~+含量等措施,使得胺液脱硫系统在整改后的两个月运行中,贫液中ρ(H_2S)从原来的最高1.68 g/L降至0.66 g/L以下,达到胺液脱硫系统稳定运行的目的。     

Investigation of metal ions binding of humic substances using fluorescence emission and synchronous‐scan spectroscopy

Abstract

The binding site interactions of IHSS humic substances, Suwannee River Humic Acid, Suwannee River Fulvic Acid, Nordic Fulvic Acid, and Aldrich Humic Acid with various metals ions and a herbicide, methyl viologen were investigated using fluorescence emission and synchronous‐scan spectroscopy. The metal ions used were, Fe(III), Cr(III), Cr(VI), Pb(II), Cu(II) and Ni(II). Stern‐Volmer constants, K_SV for these quenchers were determined at pH 4 and 8 using an ionic strength of 0.1M. For all four humic substances, and at both pH studied, Fe(III) was found to be the most efficient quencher. Quenching efficiency was found to be 3–10 times higher at pH 8. The bimolecular quenching rate constants were found to exceed the maximum considered for diffusion controlled interactions, and indicate that the fluorophore and quencher are in close physical association. Synchronous‐scan spectra were found to change with pH and provided useful information on binding site interactions between humic substances and these quenchers.     

Treatment of dairy manure using the microwave enhanced advanced oxidation process under a continuous mode operation

The microwave enhanced advanced oxidation process (MW/H₂O₂-AOP) was used to treat dairy manure for solubilization of nutrients and organic matters. This study investigated the effectiveness of the MW/H₂O₂-AOP under a continuous mode of operation, and compared the results to those of batch operations. The main factors affecting solubilization by the MW/H₂O₂-AOP were heating temperature and hydrogen peroxide dosage. Soluble chemical oxygen demand (SCOD) and volatile fatty acids (VFA) increased with an increase of microwave (MW) heating temperature; very high concentrations were obtained at 90°C. Insignificant amounts of ammonia and reducing sugars were released in all runs. An acidic pH condition was required for phosphorus solubilisation from dairy manure. The best yield was obtained at 90°C with an acid dosage of 1.0 %; about 92 % of total phosphorus and 90 % of total chemical oxygen demand were in the soluble forms. The MW/H₂O₂-AOP operated in a continuous operation mode showed pronounced synergistic effects between hydrogen peroxide and microwave irradiation when compared to a batch system under similar operating conditions, resulting in much better yields.     

Atrazine removal by ozonation processes in surface waters

Abstract

Atrazine (6‐chloro‐N‐ethyl‐N'‐isopropyl‐1,3,5‐triazinedyl‐2,4‐diamine) was treated with ozone alone and in combination with hydrogen peroxide or UV radiation in three surface waters. Experiments were carried out in two bubble reactors operated continously. Variables investigated were the ozone partial pressure, temperature, pH, mass flow ratio of oxidants fed: hydrogen peroxide and ozone and the type of oxidation including UV radiation alone. Residence time for the aqueous phase was kept at 10 min. Concentrations of some intermediates, including deethylatrazine, deisopropylatrazine and deethyldeisopropylatrazine, were also followed. The nature of water, specifically the alkalinity and pH were found to be important variables that affected atrazine (ATZ) removal. Surface waters with low alkalinity and high pH allowed the highest removal of ATZ to be reached. There was an optimum hydrogen peroxide to ozone mass flow ratio that resulted in the highest ATZ removal in each surface water treated. This optimum was above the theoretical stoichiometry of the process. Therefore, to reach the maximum removal of ATZ in a O₃/H₂O₂ process, more hydrogen peroxide was needed in the surface waters treated than in ultrapure water under similar experimental conditions. In some cases, UV radiation alone resulted in the removal of ATZ higher than ozonation alone. This was likely due to the alkalinity of the surface water. Ozonation and UV radiation processes yield different amounts of hydrogen peroxide. Combined ozonations (O₃/H₂O₂ and O₃/UV) lead to ATZ removals higher than single ozonation or UV radiation but the formation of intermediates was higher.     

一种新型复合除砷材料的制备及其性能

将锆的水合氧化物固载于大孔螯合树脂D401上制备出一种新型除砷材料,并研究了不同实验条件下复合吸附剂D401-Zr对水溶液中As(V)的吸附性能。研究结果表明,在pH<5.2时D401-Zr对As(V)都具有较强的吸附性能;其吸附等温线与Langmuir吸附模型具有较高的吻合度;吸附动力学研究表明,D401-Zr对砷的吸附均遵循二级动力学方程;竞争吸附实验表明,与SO24-、Cl-共存时,D401-Zr对砷的去除率大于90%,而与PO34-、F-竞争离子共存时,其去除率明显下降。     

APEC会议期间天津市PM_(2.5)中水溶性无机离子的污染特征

2014年11月6—11日,亚太经济合作组织(APEC)会议在北京市召开,京津冀区域采取了最高级别的空气质量保障措施。于2014年11月3—20日同步手动采集天津市PM2.5样品,对APEC会议期间(2014年11月3—11日,在此期间实施了空气质量保障措施)及会议后(2014年11月12—20日)天津市PM2.5中水溶性无机离子组分浓度、二次转化特征等进行了分析。结果表明,APEC会议期间,天津市PM2.5平均质量浓度为78μg/m3,而会议后达到87μg/m3;会议期间PM2.5中水溶性无机离子的浓度为NO-3SO2-4NH+4Cl-K+Na+Ca2+Mg2+,会议后,除Mg2+外,各项离子浓度均有不同程度的上升;会议期间,PM2.5中NO-3浓度最高,在水溶性无机离子中所占比例为38.9%,其次为SO2-4(为22.0%)、NH+4(为20.8%),3者所占比例合计为81.7%,会议后3者所占比例降至75.0%;会议期间的大气污染以流动源为主;会议后,硫氧化率和氮氧化率均不同程度减弱,说明会议期间的二次离子转化更为明显;会议期间的停工停产措施对PM2.5中一次离子来源有明显改变,城市扬尘得到明显抑制。     

武汉市秋、冬季大气PM_(2.5)中水溶性离子污染特征及来源分析

采用离子色谱法测定武汉市秋、冬季大气PM2.5中水溶性离子浓度,对其化学组成、质量浓度变化特征及源解析等方面进行了研究。结果表明,NO-3、SO2-4、NH+4为武汉市秋、冬季大气PM2.5中主要的水溶性离子,相关性分析表明,燃烧源是秋、冬季大气PM2.5中水溶性离子的共同来源。成分分析表明,工业区的水溶性离子主要来源于燃烧源,交通区的水溶性离子主要来源于二次污染源,其中包括垃圾焚烧源,植物园的水溶性离子主要来源于二次污染源。     

铈离子光催化降解茜素绿的性能和机理简

主要研究了简单铈离子（Ce³⁺）在紫外光（UV）的作用下对蒽醌染料茜素绿（AG）的光催化降解效果和反应机理。结果表明,UV/Ce³⁺体系能够有效降解AG,初始反应速率随AG浓度的倒数值和Ce³⁺浓度的增加而线性增加,随初始溶液pH的增加先降低后增加,在酸性条件下有很高的TOC去除率。荧光探针实验表明,反应过程中可以产生·OH自由基。UV/Ce³⁺体系对其他类型染料和对硝基苯酚都有较好的降解效果。     

Pulsed discharge plasma induced Fenton-like reactions for the enhancement of the degradation of 4-chlorophenol in water

To sufficiently utilize chemically active species and enhance the degradation rate and removal efficiency of toxic and biorefractory organic pollutant para-chlorophenol (para-CP), the introductions of iron metal ions (Fe²⁺/Fe³⁺) into either pulsed discharge plasma (PDP) process or the PDP process with TiO₂ photo-catalyst were tentatively performed. The experimental results showed that under the same experimental condition, the degradation rate and removal efficiency of para-CP were greatly enhanced by the introduction of iron ions (Fe²⁺/Fe³⁺) into the PDP process. Moreover, when iron ions and TiO₂ were added together in the PDP process, the degradation rate and removal energy of para-CP further improved. The possible mechanism was discussed that the obvious promoting effects were attributed to ferrous ions via plasma induced Fenton-like reactions by UV light irradiation excited and hydrogen peroxide formed in pulsed electrical discharge, resulting in a larger amount of hydroxyl radicals produced from the residual hydrogen peroxide. In addition, the regeneration of ferric ions to ferrous ions facilitates the progress of plasma induced Fenton-like reactions by photo-catalytic reduction of UV light, photo-catalytic reduction on TiO₂ surface and electron transfer of quinone intermediates, i.e. 1,4-hydroquinone and 1,4-benzoquinone.