辽河流域畜禽养殖污染源仿真研究

随着国家对流域水质改善要求的逐渐提高,流域污染源管理变得日益重要。提出了一种基于CPNTOOLS的辽河流域畜禽养殖行业污染源仿真技术,并采用CPNTOOLS软件对辽河流域内一家典型畜禽养殖基地进行了仿真研究,经过多次仿真与数据统计分析,分别得出了该畜禽养殖基地的CODCr,BOD5,NH3-N,TP,TN日排放量的正态分布均值在90%,95%,99%置信水平下的置信区间,并结合排水量分别计算出各污染物指标排放浓度的区间。结合BAT处理技术对污染物浓度削减进行了计算仿真,并得出了处理后CODCr,BOD5,NH3-N,TP,TN排放浓度的正态分布均值在90%,95%,99%置信水平下的置信区间以及排放浓度的极大值和极小值。     

畜禽养殖中沙门氏菌污染的PCR快速检测

针对畜禽养殖是造成农村水环境生物性污染的主要原因,指出用常规生化检测技术耗时长、效率低,不能满足环境管理的要求：应用PCR技术检测沙门氏菌,特异性高、敏感性强、耗时短,与常规分离鉴定方法比较,完全符合实验证明,PCR技术可很好的应用于沙门氏菌污染的调查与监测。     

新时期医疗废物处置技术体系的变革及发展

近20年来,我国在推进医疗废物无害化管理和处理处置方面开展了大量的工作,成绩举世瞩目。但处于新的历史时期,如何更好地基于可行技术,探索与其相匹配的管理模式,解决医疗废物处理处置短板已成为迫在眉睫的工作。我国目前存在针对医疗废物处理处置技术适用性考虑不足、农村及偏远地区医疗废物处置能力缺乏、医疗废物应急处置能力存在短板以及医疗废物领域科技创新能力有待提升等问题。因此,结合各种医疗处置技术特点及适用性,提出基于技术的适用性推进医疗废物处理处置技术布局优化、通过管理和技术进步解决农村和边远地区医疗废物处置难题、合理配置疫情期间应急处置能力以及推进科技创新等建议,为打造新时期医疗废物处理处置技术体系提供参考。     

我国水源污染事故风险点定量识别方法

水源事故的频发会对城市供水系统产生威胁,有必要针对供水系统风险进行评估和防控。针对水源事故频发及高发因素定量甄别研究,筛选统计了国内近20年来1 900多起水质突发事故案例,梳理了触发水源水质污染的多种因素,通过构建水源水质安全事故树和贝叶斯网络进行了相互验证分析。结果表明：我国水源污染事故主要因素贡献为依次突然排放(0.466)、污染长期累积(0.242)、交通事故(0.109)等;采用贝叶斯网络计算进行验证,其结果与事故树方法一致性较好。该方法有助于水源污染防控工作中风险点甄别和排序,可为我国饮用水安全保障水平的提升提供支撑。     

热水洗辅助微生物修复高含油落地油泥

为解决油田落地油泥含油率高但不能直接进行生物无害化处置的问题,探索一种热水洗辅助微生物修复工艺。利用热水洗实验考察了清洗配方和水温对降低含油率的影响;从落地油泥中分离出石油烃降解菌,以用于含油残砂的微生物降解过程,同时探究填料和烃降解微生物对残砂中石油烃降解效果的影响。结果表明,鼠李糖脂清洗剂在总用量为0.5%、水洗时间30 min和50 ℃条件下,可将油泥含油率由107.1 mg·g⁻¹降至为39.3 mg·g⁻¹;水洗后残砂中的土著菌群数量出现了明显下降。分离获得了2株烃降解菌,并优选出具有增加油泥溶氧和保水的沼渣。将烃降解微生物和优选沼渣加入残砂后,石油烃生物降解效率得到显著提升,200 d后含油率降为4.62 mg·g⁻¹。在此过程中,微生物优先降解分子量小的饱和烃和芳香烃组分,对胶质和沥青质等组分降解程度偏低。该研究结果可为油田高含油落地油泥的环保处置提供参考。     

基于Bishop条分法的多点多向地震动作用下边坡稳定性分析

以人工合成的多点、多向地震加速度时程作为地震动输入,基于Bishop条分法推导了地震边坡稳定安全系数的表达公式。在此基础上,针对某一具体算例,分析了不同地震峰值加速度下的不同坡高边坡稳定安全系数的变化规律,并与单点、单向地震动输入的结果进行了对比。结果表明,对于本文给出的算例,在坡高与地震峰值加速度都相同的条件下,多点、多向地震作用下的边坡安全系数要大于单点、单向作用下的安全系数;当坡高小于30 m、地震峰值加速度小于0.1 g时,多点、多向地震动作用下的边坡安全系数与单点、单向相差不大;当坡高大于30 m、地震峰值加速度大于0.1 g时,多点、多向地震动作用下的边坡安全系数相对单点、单向要小36%以上,此时边坡稳定性评价必须考虑地震动的多点、多向特性。     

外循环厌氧处理工艺中布水和三相分离的改进研究

污水处理中的布水设备和三相分离设备存在很多缺点,通过旋流配水装置和传统配水装置、小间距斜板三相分离装置和传统三相分离装置的比较试验,研究了旋流配水装置和小间距斜板三相分离装置的性能.研究结果表明:在相同膨胀率的条件下,旋流配水装置所需的回流量小,能耗相对较少;在水力上升流速为8 m/h时,采用旋流配水装置进水时,污泥分布曲线较平缓,污泥在高度上分布较均匀,而采用传统配水装置进水时,污泥主要分布在反应器底部,污泥浓度分布不均匀;在上升流速相同的情况下,采用小间距三相分离装置的反应器出水携带的颗粒污泥浓度较小;在相同的进水COD浓度时,小间距三相分离装置分离的沼气量较多.改进的布水和三相分离装置的性能明显优于传统的布水和三相分离装置.     

Isometric Pull and Push Strengths of Paraplegics in the Workspace: 2. Statistical Analysis of Spatial Factors

The effect of reach levels, horizontal angles, and vertical angles on isometric pull and push strengths of male and female was determined. Highly significant increases in men’s push strength were found between extreme to maximum reaches, and from extreme to normal reaches. However, for women’s push strength, a significant increase was found only between extreme to maximum reach. Significant or highly significant increases were found in men’s and women’s pull strength between the horizontal angle (θ) sagittal through the active shoulder (90°) and other angles (0, 45, and 135°). However, for men’s push strength, highly significant increases were found between the horizontal angle 45° from the frontal plane, and other angles. For women’s push strength, significant or highly significant increases were found between the horizontal angles 0° and angles of 90 and 135°. For men’s and women’s pull strength, significant or highly significant increases were found between the vertical angle (?), 90°, and other angles (–20, 0, and 45°). Similar increases were found for women’s push strength between the 45° angle and other angles. In the design of a workstation for paraplegics that requires pull and push forces, consideration must be given to the spatial factors.     

Occupational Accidents of Finnish-and Swedish-Speaking Workers in Finland: A Mental Model View

This article is based on 2 studies. The aim of the first study was to examine the differences in occupational accident frequency between the 2 main language groups in Finland. Based on 3 independent statistical data sets, it was shown that Swedish-speaking workers had about 40% fewer occupational accidents than Finnish-speaking workers. The aim of the second study was to confirm the difference at company level. A field study in the province of Vaasa with 14 small and medium-sized manufacturing companies revealed that the accident frequency of Swedish-speaking workers was 21% lower than that of Finnish-speaking workers.     

Validation of Methods for Determination of Metabolic Rate in the Edholm Scale and ISO 8996

The aim of this study was to validate the Edholm scale (Edholm, 1966) and the ISO 8996 standard (International Organization for Standardization [ISO], 1990) by comparing the metabolic rates estimated for both methods with the actual measured metabolic rate (M_Meas) in 6 manual material handling tasks simulated under laboratory conditions. The metabolic rate was calculated from oxygen consumption VO₂ (19 participants) according to Standard No. ISO 8996 (ISO, 1990). Additionally, the participants estimated perceived exertion using the Borg scale. The metabolic rates derived from the Edholm scale (M_Edh) overestimated 5 of 6 activities by 34-50% (α = .05). The metabolic rates derived from ISO 8996 (M_ISO) overestimated all activities by 7-38% (α =.05).