Evaluation of photolysis and hydrolysis of pyraclostrobin in aqueous solutions and its degradation products in paddy water

This study evaluated the hydrolysis and photolysis kinetics of pyraclostrobin in an aqueous solution using ultra-high-performance liquid chromatography–photodiode array detection and identified the resulting metabolites of pyraclostrobin by hydrolysis and photolysis in paddy water using high-resolution mass spectrometry coupled with liquid chromatography. The effect of solution pH, metal ions and surfactants on the hydrolysis of pyraclostrobin was explored. The hydrolysis half-lives of pyraclostrobin were 23.1–115.5?days and were stable in buffer solution at pH 5.0. The degradation rate of pyraclostrobin in an aqueous solution under sunlight was slower than that under UV photolysis reaction. The half-lives of pyraclostrobin in a buffer solution at pH 5.0, 7.0, 9.0 and in paddy water were less than 12?h under the two light irradiation types. The metabolites of the two processes were identified and compared to further understand the mechanisms underlying hydrolysis and photolysis of pyraclostrobin in natural water. The extracted ions obtained from paddy water were automatically annotated by Compound Discoverer software with manual confirmation of their fragments. Two metabolites were detected and identified in the pyraclostrobin hydrolysis, whereas three metabolites were detected and identified in the photolysis in paddy water.     

养殖固体废物在硝酸和磷酸溶液中的水解特性

养殖固体废物掺杂磷肥工艺中养殖固体废物与酸的反应直接影响其有机组成。以鸡粪为研究对象,采用L16(45)正交试验研究了鸡粪粒径、酸浓度、鸡粪与酸溶液质量比、反应温度和反应时间对鸡粪在硝酸和磷酸溶液中水解过程的影响。结果表明,硝酸溶液中影响因素显著性依次为鸡粪与硝酸质量比、反应时间、硝酸浓度、鸡粪粒径、反应温度,最优工艺条件为鸡粪粒径0.20mm、硝酸质量分数15%、鸡粪与硝酸质量比0.2∶1.0、反应温度95℃、反应时间4h;在磷酸溶液中影响因素显著性依次为鸡粪与磷酸质量比、反应温度、鸡粪粒径、磷酸浓度、反应时间,鸡粪水解率与反应温度间呈正相关关系,最优工艺条件为鸡粪粒径0.40mm、磷酸质量分数60%、鸡粪与磷酸质量比0.1∶1.0、反应温度95℃、反应时间8h。鸡粪比表面积及其单位质量耗酸量、美拉德反应是制约鸡粪在硝酸和磷酸中水解反应的内因。研究结果为养殖固体废物掺杂有机磷肥的研发和推广提供了理论基础。     

烟草下脚料发酵制取乙醇

通过单因素实验考察了硫酸浓度、固液比和水解时间对硫酸水解的影响。结果显示最优条件为:硫酸浓度为50%(w/w),固液比为10%(w/v),时间为100 min。烟草下脚料在最佳硫酸水解条件下,经5倍稀释,中和pH值至5～6。取经过滤后的水解液(FH)用酿酒酵母(Sacchharomyces cerevisiae)发酵产生乙醇,最大的乙醇浓度和乙醇产量分别为1.09g/L和54.5 g/kg。未过滤水解液(UFH,包括水解残渣)加入纤维素酶(70 U/100 mL)和酿酒酵母(Sacchharomyces cerevisiae)进行发酵,最大的乙醇浓度和乙醇产量分别为1.23 g/L和61.5 g/kg。     

铝系混凝剂优势形态分析及其混凝特性

聚合氯化铝（PACl）是常用的水处理混凝剂,在应用过程中通常表现出比传统铝盐更为优异的效果.研究表明,这种优异性能主要得益于其特殊的组成,特别是高分子聚合物Al₁₃和Al₃₀独特的物化特性.Al₁₃和Al₃₀是铝离子水解过程中的中间产物,在地球科学和环境化学等领域有着重要的研究价值.于水处理而言,二者的结构和分子特性是研究者关注的重点,大量研究基于此展开,很多重要的发现为实际应用奠定了基础.基于对PACl及其组成性质的研究,本文对PACl的混凝特性及其优势形态分子的分析进行了综合阐述.     

游离氨对热水解联合中温厌氧消化处理剩余污泥的影响

热水解预处理强化了污泥厌氧消化过程,但同时增加了微生物受游离氨抑制的风险.对比传统工艺,在有机容积负荷率1.74~4.27gVS/(L·d)条件下,研究了游离氨(FA)对热水解联合中温厌氧消化工艺性能的影响.结果表明,组合工艺甲烷产量较传统反应器提高89%~121%,有机去除率提高1.21~1.46倍.但同时导致系统中游离氨浓度达89~382mgN/L,显著高于传统工艺中37~84mgN/L的范围.游离氨毒性测试显示,传统工艺中FA浓度从43mgN/L升至84mgN/L,没有抑制解乙酸产甲烷途径,而组合工艺中FA升至264mgN/L时,表现出抑制作用,尽管厌氧菌对高浓度FA表现更强的驯化趋势.结合氮负荷试验, FA浓度与基质利用能力,解乙酸产甲烷途径抑制程度和挥发性有机酸积累的关系表明,高有机负荷条件下组合工艺效率可通过控制氮负荷优化.     

复合金属氧化物Cu-Co-Al低温催化水解HCN

采用共沉淀法制备了Cu-Al、Co-Al和Cu-Co-Al复合金属氧化物催化剂,考察了3种催化剂对HCN的催化水解性能,并通过XRD、BET、XPS和H2-TPR等对催化剂的结构和性能进行表征.结果表明, Cu-Co-Al催化剂展示最高的催化活性. 反应温度200℃,反应180min后, Cu-Co-Al、Cu-Al和Co-Al催化剂对HCN的转化率分别为95%,90%,10%;NH3生成量分别为122,118,18mg/m3.低结晶度、高分散性、高比表面积的催化剂有利于低温HCN水解.适量的表面分子氧含量、较高的Cu2+和Co3+含量、较低的还原温度是Cu-Co-Al催化剂具有较高的HCN低温水解活性的主要原因.     

ABR工艺预处理木薯酒糟废水的工程应用

木薯酒糟废水有机物浓度高、悬浮物含量大、pH呈酸性、可生化性能较差 ,通常直接采用固液分离—厌氧 (UASB)—好氧曝气生化法处理效果并不理想 ,而采用ABR工艺进行厌氧水解酸化预处理木薯酒糟废水迄今为止未见报道。经绵阳市酒厂废水治理工程证明 ,强化ABR预处理工序是保证后续处理措施能否正常运行的关键     

蒽醌染整废水处理试验研究

本研究采用厌氧水解 好氧和单独好氧处理 2种生化方法对蒽醌染整废水进行了平行对照试验。试验结果表明 ,厌氧水解 好氧处理方法可有效地提高该废水的可生化程度 ,当进水CODCr浓度为 90 0mg L时 ,处理后出水CODCr可达 12 0～ 170mg L ,明显优于单独好氧处理的出水水质。经进一步混凝处理后 ,上述生化出水CODCr可近一步降低到10 0mg L左右     

温度对热水解预处理高含固污泥特性的影响

以含固率为10%的污泥为对象,研究不同温度和时间条件下热水解过程中有机物转化规律对污泥特性的影响。结果表明:随着热水解时间的延长和温度的升高,污泥中挥发性悬浮固体(VSS)的水解率逐渐升高。在热水解时间为20 min时,温度由150℃升高到180℃,VSS水解率由22.9%增至38.4%,污泥中VSS由46.28 g/L降低到40.63 g/L。水解液组分分析表明,溶解性化学需氧量(SCOD)主要组成为蛋白质(50%)、碳水化合物(15%~20%)、可挥发性脂肪酸(15%~20%)。水解液中氮主要以有机氮的形式存在。在热水解条件达到165℃、50 min时,氨氮浓度为1.16 g/L,之后,随着温度的升高和时间的延长,氨氮浓度基本不变。     

Electrochemical Monitoring of Methylparathion Degradation in an Acid Aqueous Medium in Presence of Cu(II)

Abstract

A study was undertaken to determine the effect of Cu(II) in degradation of methylparathion (o,o-dimethyl o, 4-nitrophenyl phosphoriotioate) in acid medium. Initial electrochemical characterization of Cu(II) and methylparathion was done in an aqueous medium at a pH range of 2–7. Cu(II) was studied in the presence of different anions and it was observed that its electroactivity depends on pH and is independent of the anion used. Methylparathion had two reduction signals at pH ≤ 6 and only one at pH > 6. The pesticide's transformation kinetic was then studied in the presence of Cu(II) in acid buffered aqueous medium at pH values of 2, 4, and 7. Paranitrophenol appeared as the only electroactive product at all three pH values. The reaction was first order and had k values of 5.2 × 10^?3 s^?1 at pH 2, 5.5 × 10^?3 s^?1 at pH 4 and 9.0 × 10^?3 s^?1 at pH 7. It is concluded that the principal degradation pathway of methylparathion in acid medium is a Cu(II) catalyzed hydrolysis reaction.