异波折板水解酸化-A~2O一体化反应器实验研究

设计了异波折板水解酸化-A2O一体化反应器,进行生活污水处理的实验研究。10个月的实验结果表明,系统的最佳水力停留时间(HRT)为8 h时,最适COD进水浓度为240~600 mg/L,最佳混合液回流比(r)-污泥回流比(R)为250%~100%。控制反应器于以上运行参数下,25±2℃所对应的COD、TN和TP去除率分别为96.84%、67.55%和81.92%。当温度降至7℃时,其COD、TP和TN分别降至86.35%、50.25%和65.68%。基于实验分析结果,阐明了一体化反应器高效性的机理在于异波折板水解酸化段具有高效传质特性和A2O段具有复合式活性污泥-接触氧化好氧池的特点。     

烟草下脚料发酵制取乙醇

通过单因素实验考察了硫酸浓度、固液比和水解时间对硫酸水解的影响。结果显示最优条件为:硫酸浓度为50%(w/w),固液比为10%(w/v),时间为100 min。烟草下脚料在最佳硫酸水解条件下,经5倍稀释,中和pH值至5～6。取经过滤后的水解液(FH)用酿酒酵母(Sacchharomyces cerevisiae)发酵产生乙醇,最大的乙醇浓度和乙醇产量分别为1.09g/L和54.5 g/kg。未过滤水解液(UFH,包括水解残渣)加入纤维素酶(70 U/100 mL)和酿酒酵母(Sacchharomyces cerevisiae)进行发酵,最大的乙醇浓度和乙醇产量分别为1.23 g/L和61.5 g/kg。     

Electrochemical Monitoring of Methylparathion Degradation in an Acid Aqueous Medium in Presence of Cu(II)

Abstract

A study was undertaken to determine the effect of Cu(II) in degradation of methylparathion (o,o-dimethyl o, 4-nitrophenyl phosphoriotioate) in acid medium. Initial electrochemical characterization of Cu(II) and methylparathion was done in an aqueous medium at a pH range of 2–7. Cu(II) was studied in the presence of different anions and it was observed that its electroactivity depends on pH and is independent of the anion used. Methylparathion had two reduction signals at pH ≤ 6 and only one at pH > 6. The pesticide's transformation kinetic was then studied in the presence of Cu(II) in acid buffered aqueous medium at pH values of 2, 4, and 7. Paranitrophenol appeared as the only electroactive product at all three pH values. The reaction was first order and had k values of 5.2 × 10^?3 s^?1 at pH 2, 5.5 × 10^?3 s^?1 at pH 4 and 9.0 × 10^?3 s^?1 at pH 7. It is concluded that the principal degradation pathway of methylparathion in acid medium is a Cu(II) catalyzed hydrolysis reaction.     

养殖固体废物在硝酸和磷酸溶液中的水解特性

养殖固体废物掺杂磷肥工艺中养殖固体废物与酸的反应直接影响其有机组成。以鸡粪为研究对象,采用L16(45)正交试验研究了鸡粪粒径、酸浓度、鸡粪与酸溶液质量比、反应温度和反应时间对鸡粪在硝酸和磷酸溶液中水解过程的影响。结果表明,硝酸溶液中影响因素显著性依次为鸡粪与硝酸质量比、反应时间、硝酸浓度、鸡粪粒径、反应温度,最优工艺条件为鸡粪粒径0.20mm、硝酸质量分数15%、鸡粪与硝酸质量比0.2∶1.0、反应温度95℃、反应时间4h;在磷酸溶液中影响因素显著性依次为鸡粪与磷酸质量比、反应温度、鸡粪粒径、磷酸浓度、反应时间,鸡粪水解率与反应温度间呈正相关关系,最优工艺条件为鸡粪粒径0.40mm、磷酸质量分数60%、鸡粪与磷酸质量比0.1∶1.0、反应温度95℃、反应时间8h。鸡粪比表面积及其单位质量耗酸量、美拉德反应是制约鸡粪在硝酸和磷酸中水解反应的内因。研究结果为养殖固体废物掺杂有机磷肥的研发和推广提供了理论基础。     

热水解超声组合预处理对污泥厌氧消化产气潜力的影响研究

针对城市污泥厌氧消化由于融胞困难所导致的消解速率低、产气量低等问题,采用热水解与超声组合的方法对污泥进行预处理,考察经预处理后污泥融胞效率的变化及对厌氧消化产气潜力的影响.结果显示,热水解与超声波组合工艺对污泥的破胞作用明显,在30 min热水解与0.53 W/mL超声声能密度组合工艺反应60 min条件下,相对于处理前污泥,预处理后污泥溶解性COD(SCOD)溶出率可提高41.6％,蛋白质增加值达282.7 mg/L,污泥厌氧消化的产气潜力显著增加;30 min热水解分别与0.53、0.33 W/mL超声声能密度组合工艺对污泥破胞效率的差异不大;随着超声时间的延长,在组合预处理工艺前20 min内SCOD的溶出速率较慢,20260 min时溶出速率逐渐提高.试验结果可为城市污泥厌氧消化预处理工艺的选择提供一定的理论依据.     

酸性条件下剩余污泥中Ca2＋和Mg2＋溶出对磷回收的影响

为了在酸性条件下实现剩余污泥中磷的高效回收,对pH=3时剩余污泥水解酸化过程中氨氮、正磷酸盐和钙镁离子的溶出现象以及磷回收进行了研究分析。结果表明：当pH=3时,所溶出的氨氮、镁离子和钙离子与磷酸盐的摩尔比均大于1,能满足采用鸟粪石沉淀法或者羟磷灰石沉淀法回收磷的要求;但所溶出的钙镁离子的摩尔比大于1,会对鸟粪石沉淀法回收磷的顺利进行有较大影响;有无外加镁剂对磷回收率影响不大。采用改型后的镁型强酸性阳离子交换树脂进行离子交换可以得到较高纯度的鸟粪石沉淀产品,通过XRD检测其纯度为95％以上。     

丙烯腈生产废水中聚合物的资源化利用

以丙烯腈生产废水中的丙烯腈低聚物为原料制备聚丙烯酰胺。通过正交实验考察了水解反应条件和交联反应条件对反应的影响。FTIR表征结果显示,丙烯腈低聚物中的氰基已完全水解为酰胺基,产物聚丙烯酰胺中含有酰胺基和羧基。实验结果表明,在自来水加入量100 m L、水解反应温度95℃、m(Na OH)∶m(丙烯腈低聚物)=2.0、水解反应时间3 h的最佳水解反应条件,交联反应温度60℃、质量分数37%~40%的甲醛加入量6 m L、交联反应时间2 h的最佳交联反应条件下,处理20 g丙烯腈低聚物,可得到产物聚丙烯酰胺14.50 g,聚丙烯酰胺的水解度为21.1%、相对分子质量为2.7×106。产品性能满足Q/SH 0046—2007《钻井液用聚丙烯酰胺技术要求》中部分水解聚丙烯酰胺的性能要求。     

Observations on the influence of water and soil pH on the persistence of insecticides

Abstract

The pH‐disappearance rate profiles were determined at ca. 25°C for 24 insecticides at 4 or 5 pH values over the range 4.5 to 8.0 in sterile phosphate buffers prepared in water‐ethanol (99: 1 v/v). Half‐lives measured at pH 8 were generally smaller than at lower pH values. Changes in half lives between pH 8.0 and 4.5 were largest (>1000x) for the aryl carbamates, carbofuran and carbaryl, the oxime carbamate, oxamyl, and the organophosphorus insecticide, trichlorfon. In contrast, half lives of phorate, terbufos, heptachlor, fensulfothion and aldicarb were affected only slightly by pH changes. Under the experimental conditions described half lives at pH8 varied from 1–2 days for trichlorfon and oxamyl to >1 year for fensulfothion and cyper‐methrin. Insecticide persistence on alumina (acid, neutral and basic), mineral soils amended with aluminum sulfate or calcium hydroxide to different pH values and four natural soils of different pH was examined. No correlation was observed between the measured pH of these solids and the rate of disappearance of selected insecticides applied to them. These observations demonstrate the difficulty of extrapolating the pH dependent disappearance behaviour observed in homogeneous solution to partially solid heterogeneous systems such as soil.     

Occurrence and migration of microplastics and plasticizers in different wastewater and sludge treatment units in municipal wastewater treatment plant

● Reduce the quantifying MPs time by using Nile red staining. ● The removal rate of MPs and PAEs in wastewater and sludge were investigated. ● MPs and PAEs were firstly analyzed during thermal hydrolysis treatment. ● The removal of PAEs from wastewater and sludge was mainly biodegradation. Microplastics (MPs) and plasticizers, such as phthalate esters (PAEs), were frequently detected in municipal wastewater treatment plants (MWTP). Previous research mainly studied the removal of MPs and PAEs in wastewater. However, the occurrence of MPs and PAEs in the sludge was generally ignored. To comprehensively investigate the occurrence and the migration behaviors of MPs and PAEs in MWTP, a series of representative parameters including the number, size, color, shape of MPs, and the concentrations of PAEs in wastewater and sludge were systematically investigated. In this study, the concentrations of MPs in the influent and effluent were 15.46±0.37 and 0.30±0.14 particles/L. The MP removal efficiency of 98.1% was achieved and about 73.8% of MPs were accumulated in the sludge in the MWTP. The numbers of MPs in the sludge before and after digestion were 4.40±0.14 and 0.31±0.01 particles/g (dry sludge), respectively. Fourier Transform Infrared Spectroscopy (ATR FT-IR) analysis showed that the main types of MPs were polyethylene terephthalate (PET), polypropylene (PP), polyethylene (PE), and polystyrene (PS). Six PAEs, including phthalate (DMP), diethyl phthalate (DEP), diisobutyl phthalate (DIBP), ortho dibutyl phthalate (DBP), butyl benzyl phthalate (BBP), and bis(2-ethyl) hexyl phthalate (DEHP), were detected in the MWTP. The concentrations of total PAEs (ΣPAEs) in the influent and effluent were 76.66 and 6.28 µg/L, respectively. The concentrations of ΣPAEs in the sludge before and after digestion were 152.64 and 31.70 µg/g, respectively. In the process of thermal hydrolysis, the number and size of MPs decreased accompanied by the increase of the plasticizer concentration.     

Glucose production from hydrolysis of cellulose over a novel silica catalyst under hydrothermal conditions

A novel silica catalyst was synthesized by evaporation-induced self-assembly (EISA) method and tested for the catalytic selective hydrolysis of cellulose to glucose. This silica catalyst exhibited a higher catalytic activity than other oxides prepared by the same method, such as ZrO₂, TiO₂, and Al₂O₃. Using silica as a catalyst, cellulose was selectively hydrolyzed into glucose with a glucose yield as high as 50% under hydrothermal conditions without hydrogen gas. The silica catalyst was characterized by Brunauer-Emmett-Teller (BET), X-ray diffraction (XRD) and transmission electron microscopy (TEM). The results of temperature-programmed desorption of ammonia (NH₃-TPD) and textural properties indicated that the synergistic effect between strong acidity and a suitable pore diameter of the silica catalyst may be responsible for its high activity. In addition, the catalyst was recyclable and showed excellent stability during the recycle catalytic runs.