Water quality characteristics along the course of the Huangpu River （China）

Huangpu River is about 114.5 km from upriver Dianfeng to downriver Wusong,near the estuary of the Yangtze River.It plays a key role in supplying water for production,life,shipment and irrigation.With the industrial development,the pollution of the Huangpu River has become serious recently.The biological oxygen demand (BOD),total nitrogen (TN),total phosphorus (TP),oil,phenol and suspended solids (SS) were lower in the upstream sites than in the downstream sites,indicating pollutants being input along its course. Water quality was the worst in the Yangpu site,near the center of Shanghai City.Dissolved oxygen (DO) content was less than 2 mg/L in the site of Yangpu in July.Among relations between thirteen characteristics,relations between BOD,DO,TN,TP,NH_4~ -N, NO_3~--N and the count of total bacteria or Escherichia coli were significant and interdependent.Inner relationships between these main characteristics in the Huangpu River were studied.High nutrient concentration led to growth of microorganisms,including E.coli. Degradation of organic matters and respiration of bacteria made oxygen concentration decreased in the water body,and DO was a key factor for nitrification-denitrification process of nitrogen.In the Yangpu site,DO was decreased to less than 3.0 mg/L with BOD higher than 7.5 mg/L in May and July.Low DO concentration will decrease nitrification rate.Nitrification need at higher DO value than other organic substrate oxidation.Consequently,river water contains low NO_3~--N values with high amounts of TN and NH_4~ -N there.This will block the self-purification of surface water,by decreasing the rate of nitrification-denitrification transformation process in the water body.     

Improvement of the antifouling characteristics in a bioreactor of polypropylene microporous membrane by the adsorption of Tween 20

Surface modification by physical adsorption of Tween 20 was accomplished on polypropylene microporous membranes (PPMMs). Attenuated total reflection-Fourier transform infrared spectroscopy (ATR/FT-IR) and scanning electron microscope (SEM) were used to characterize the chemical and morphological changes on the membrane surfaces. Water contact angles and relative pure water fluxes were measured. The data showed that the hydrophilic performance for the modified membranes increased with the increase in the adsorption amount of Tween 20 onto the surface or into the pores of polypropylene microporous membranes. To test the antifouling property of the membranes by the adsorption of Tween 20 in a membrane bioreactor (MBR), filtration for active sludge was performed using synthetic wastewater. With the help of the data of water fluxes and the FE-SEM photos of the modified PPMMs before or after operating in a MBR for about 12 d, the PPMMs with monolayer adsorption of Tween 20 showed higher remained flux and stronger antifouling ability than unmodified membrane and other modification membranes studied.     

Denitrification potential enhancement by addition of external carbon sources in a pre-denitrification process

The aim of this study is to investigate the denitrification potential enhancement by addition of external carbon sources and to estimate the denitrification potential for the predenitrification system using nitrate utilization rate （NUR） batch tests. It is shown that the denitrification potential can be substantially increased with the addition of three external carbon sources, i.e. methanol, ethanol, and acetate, and the denitrification rates of ethanol, acetate, and methanol reached up to 9.6, 12, and 3.2 mgN/（g VSS.h）, respectively, while that of starch wastewater was only 0.74 mgN/（g VSS,h）. By comparison, ethanol was found to be the best external carbon source. NUR batch tests with starch wastewater and waste ethanol were carried out. The denitfification potential increased from 5.6 to 16.5 mg NO3-N/L owing to waste ethanol addition. By means of NUR tests, the wastewater characteristics and kinetic parameters can be estimated, which are used to determine the denitrification potential of wastewater, to calculate the denitrification potential of the plant and to predict the nitrate effluent quality, as well as provide information for developing carbon dosage control strategy.     

太湖五里湖底泥污染特性研究

五里湖是太湖污染最严重的水域。为对其治理提供依据,在该湖区设置了4个采样点,对底泥的表层样、柱状样、间隙水样和上覆水体作了重金属和营养盐分布测试,并作了数据统计分析。结果表明：以地积累指数评价,五里湖底泥的重金属污染程度为轻度,总体可达到《土壤环境质量标准》（GB15618-1995）三级标准,根据超出背景值的倍数分析,五里湖重金属含量顺序为Cu>Cd>Pb>Hg>As>Cr。重金属含量表层（0～5 cm）相对较低,第二层（5～10 cm）和第三层（10～20 cm）是主要的污染沉积层,这与底泥沉积特征是相对应的。表层底泥总氮、总磷和有机质含量较高并具有明显的相关性,相关系数介于0.757 6～0.862 2之间,显示了污染物质的同源性。表层底泥和间隙水中营养盐含量明显高于湖水,相对于湖水呈可释放状态,是湖体内源污染之一。     

太湖东北部沉积物理化特征及磷赋存形态研究

对太湖东部和北部8个沉积物样品进行了理化性质及磷赋存形态分析,在此基础上探讨了沉积物各理化性质与磷赋存形态间的相关关系。研究结果表明：太湖沉积物的总磷含量为307.43～1454.39 mg/kg,阳离子交换量为15.18～22.68 meq/100g土,有机质含量为1.66%～3.45%;颗粒组成以粉砂级和粘粒级为主,占总量的54.39%～76.83%;主要矿物组成为石英和长石,粘土矿物以伊利石/蒙脱石混层为主,其次是伊利石、绿泥石和高岭石;沉积物中氧化物以SiO2、Al2O3和TFe2O3为主,且它们的含量随沉积物中总磷含量的不同变化较大。磷的形态以无机磷为主,污染较重沉积物中铁/铝磷的含量明显升高,有机磷的比例降低,钙磷变化不大。沉积物的各理化性质与磷赋存形态间关系密切,随着沉积物中总磷含量的增加, 阳离子交换量和有机质的含量都逐渐升高,细颗粒含量（<2 μm）逐渐增多,铁/铝形态的磷在总磷中所占比例也逐渐增大。     

湖北宣恩七姊妹山天师栗(Aesculus wilsonii)群落特征

天师栗（Aesculus wilsonii）是我国特有的珍稀树种,其天然分布比较零散,极少有大面积的自然群落存在。对湖北宣恩七姊妹山天然分布的天师栗群落采用相邻格子法进行调查,研究了群落的物种多样性、空间格局、群落结构和种群径级结构等群落特征。结果表明：（1）天师栗是群落的主要优势树种,其重要值为22.7,远大于重要值排在第二位的红枝柴（重要值为13.7）,且在群落中呈聚集分布类型;（2）群落物种比较丰富,相对于灌木层和草本层,乔木层丰富度指数和均匀度指数较低,优势度指数较高,说明乔木层物种没有灌木层和草本层多,且分布不均匀,但优势种作用显著,成层现象明显;（3）群落的年龄〖JP2〗结构显示,该群落虽然目前处于稳定阶段,但群落中5个优势种群的幼年个体补充都严重不足,潜在的影响群落以后的生存和发展。应采取保护措施,促进群落的自然演替.     

合肥市臭氧及其前体物污染特征及源解析

利用合肥市臭氧和VOCs连续观测数据分析了合肥市臭氧及其前体物污染特征,并使用NAQPMS模型研究了合肥市不同季节臭氧来源情况。结果表明:O₃已经成为影响合肥市环境质量的主要污染因子,O₃高值区主要集中在5—6月和9月。合肥市大气VOCs中烷烃含量最丰富,其次是烯烃、芳香烃和炔烃;主要物种为乙烷、丙烷、乙炔、正戊烷、乙烯、环戊烷、异戊烷、正丁烷、异丁烷和甲苯。合肥市O₃生成主要受VOCs控制,其中,烯烃是合肥市O₃生成贡献最大的关键活性组分,乙烯的OFP贡献率居首位。合肥市不同季节O₃来源差异较大,其中,本地排放是主要来源,夏季占比为50%,其余季节占比为30%~45%,O₃存在跨省长距离输送特征,主导风向的变化是造成合肥市臭氧来源季节性变化的重要因素。     

河北省某大型焦化厂地下水中多环芳烃的污染特点、源解析及生态风险评价

为研究焦化厂地下水中美国EPA优先控制的16种多环芳烃(PAHs)的分布特点和污染来源,本研究联合使用统计技术、正定矩阵因子分析(PMF)模型和风险商值法,深入分析了焦化厂地下水中PAHs的分布规律,定量解析了PAHs的污染来源,并且对其生态风险进行了科学评价.结果表明,焦化厂地下水中16种PAHs的总检出率较高,达到46.7%.地下水中∑₁₆PAHs的浓度范围是n.d.～444.9μg·L^-1,均值为1.88μg·L^-1.不同生产车间地下水中PAHs的浓度存在明显差异,其中污染最重的车间位于焦油精制区,地下水中∑₁₆PAHs的浓度为444.92μg·L^-1.应用PMF源解析模型,识别出该焦化厂地下水中PAHs有二类污染源：一是石油的燃烧源,二是煤和生物质燃烧以及石油类的泄漏,二种污染源对焦化厂地下水中PAHs的贡献率分别为38.6%和61.4%.焦化厂地下水中∑₁₆PAHs处在高生态风险等级,且有53.4%的地下水采样点单体PAHs的生态风险处在高风险等...     

四川红层浅层风化带裂隙水水化学特征的聚类分析

四川红层盆地浅层风化带裂隙水是区内分布最为广泛和目前开采最多的浅层地下水类型,本文通过对大量控制性水样分析结果进行聚类分析,探讨了该地区浅层风化带裂隙水的水化学成分特征及其分布规律,结果表明区内91%以上的浅层风化带裂隙水为HCO3-型淡水,主要分布在中部方山丘陵小区、南部台状低山丘陵小区和东部侵蚀构造平行岭谷低山丘陵小区。该研究可为开发利用浅层地下水提供地学依据。     

广东省船舶排放源清单及时空分布特征研究

分别采用基于船舶引擎功率和耗油量的排放因子法,估算了广东省地区2010年的船舶排放清单,并选取客货运输吞吐量、航道通航能力因子和港口地理坐标等数据作为权重因子,研究了该地区各类船舶排放的时空分布特征.结果表明,广东省各类船舶在2010年的SO2、NO x、CO、PM10、PM2.5和VOCs排放总量分别为14.6×104t、23.1×104t、3.0×104t、7.9×103t、7.2×103t和9.3×103t.广东省客货运输船舶月排放波动较小;渔业船舶在1月、4月和11月份的排放比例最高.广东省客货运输船舶水域排放集中在西江干线水道和珠江三角洲高等级航道网内,港口排放主要分布在广东省珠江三角洲沿海发达城市地区;渔船港口排放量呈显著的沿海条带状空间分布特征.