规划环评中土地适宜性评价——以武汉某产业基地PEIA为例

通过运用层次分析法（AHP）方法建立评价指标,确定评价因子,评定得分,以规划环评导则为基础介绍了武汉某产业基地土地利用类型的变化。评价表明,产业基地土地利用适宜性基本适宜,这为规划环评（PEIA）的土地适宜性评价分析提供一种思路。     

锅炉烟尘测试中锅炉负荷率的计算方法探讨

GB5468 -91规定 ,锅炉烟尘测试时 ,必须对锅炉的运行负荷进行测试 ,而实际监测过程中 ,许多锅炉房不具备测试的计量条件 ,为了解决这一问题 ,文章提出利用烟气量和空气过剩系数计算锅炉负荷率。在实际监测工作中 ,该方法方便、易于操作 ,所得结果和标准规定方法所得结果有很好的一致性     

Classification and mapping forest sites using geographic information system (GIS): a case study in Artvin Province

The productivity of forest sites has been indirectly determined with solo wood production objective in forest management. Forest site productivity should, however, be determined directly in order to implement ecosystem based multipurpose forest management philosophy. This article tackles the problem in distinguishing and mapping forest sites using both direct method and indirect method in Genya Mountain located in central of Artvin State Forest Enterprise. About 112 sample plots were designed and distributed over the area. In each sample plot, soil samples were collected and the classical timber inventory measurements were taken. According to direct method, Soil Moisture Regime (SMR) method is preferred due to a water deficiency in the study area. Water holding capacity was used as an essential criterion for the classification of the forest site. Forest site classifications were assigned regarding the physiographic factors such as landform, aspect, and slope. Five different forest sites classes; dry, moderate fresh, fresh, humid and hygric were determined. According to direct method, the guiding curve was used to generate anamorphic site index (SI) equations and three site index classes; good (SI=I–II), medium (SI=III) and low (SI=IV–V) were determined. Some important differences between the methods were realized. The forest sites determined with site index estimation method indicate that site index I and II is 505.99 ha, III 1095.79 ha and IV and V 992.95 ha, whereas forest sites determined with direct method related to dry site of 937.58 ha, moderate fresh site of 931.90 ha, fresh site of 1,797.71 ha, humid site of 80.48 ha and hygric site of 356.55 ha. The forest site maps of both methods were created using GIS functions. The forest sites of open and degraded areas should be determined according to direct method.     

中小城市空气质量预报试验与问题研究

当前中国大气污染形势严峻,迫切需要开展环境空气质量预报预警业务工作。为调研国内中小城市开展空气质量预报的基础条件和业务需求,促进全国城市空气质量业务体系建设,中国环境监测总站组织8个典型中小城市,利用基于数值预报基础的统计模式预报系统开展了空气质量预报实验工作。在此基础上,针对开展全国预报业务体系建设所需的中小城市预报方法、基础条件、人员技术水平等方面进行专项调研,并对国内中小城市开展空气质量预报能力建设和业务工作面临的问题、困难提出了建议和参考对策。     

中国财产保险业巨灾损失赔付能力实证分析

商业保险是社会化巨灾风险分散机制的重要组成部分,要在中国现阶段巨灾事件频发的复杂环境中构建合理的损失分摊机制,不能不考虑以损失补偿为主要功能的财产保险业应对巨灾损失的能力。在Cummins、Doherty和Anita的保险赔付能力度量模型框架及改进后的损失对数正态分布假设下,引入1998～2008年中国财产保险业经营数据,对2009年初时点上在中国大陆经营财产保险业务的39家财产保险公司及全行业巨灾损失赔付能力进行了实证分析。结果显示,由于全行业资本与盈余的低水平以及再保险市场发展的严重滞后,在1 200亿到2 000亿元的损失区间内,中国财产保险业的赔付能力缺口在26.8亿到815.6亿元之间,且缺口增长速度大于损失增长速度。通过与2008年初的赔付能力实证分析结果对比发现,灾害频发的2008年客观上显著降低了中国财产保险行业应对极端损失的能力。度量结果从实证基础上昭示了政府大力扶持和参与巨灾保险体系建设的必要性和紧迫性。     

类水滑石衍生复合氧化物催化水解羰基硫的研究

采用共沉淀法制备了一系列的类水滑石衍生复合氧化物催化剂,利用正交实验设计对催化剂的制备条件进行了优化,研究了金属组合、合成pH、M2+/M3+、二价金属比、焙烧温度和晶化温度等6个因素对羰基硫催化水解过程中催化剂硫容的影响。结果表明,金属组合、二价金属比和焙烧温度的影响极其显著(p=99%),晶化温度的影响显著(p=95%),合成pH与M2+/M3+对催化剂活性影响不显著(p=90%)。在设定实验条件下,金属组合取Co-Ni-Al、合成pH为9,M2+/M3+为3,二价金属比1,焙烧温度取350℃,晶化温度50℃时制得的催化剂具有最高的催化活性。对最佳制备条件下得到的催化剂进行了重复性实验以及XRD表征,结果表明制备的催化剂的硫容为7.10 g硫/g催化剂,Co3O4可能是其活性中心。     

基于双指标的安康水库防洪预报调度规则研究

随着水文预报水平的提高,考虑预报信息的防洪预报调度方式日益受到重视。对安康水库实施防洪预报调度的可行性进行了分析,采用“逐级调节法”反复试算修正,确定了以“预报累积净雨量”为主判断指标、“库水位”为辅助指标的安康水库双指标防洪预报调度规则,并对设计洪水及实际洪水进行了调节,调节结果与常规调度比较,水库水位提前降低至汛限水位以下,增加了防洪库容,减小了洪峰段下泄流量,降低了水库最高水位,提高了防洪能力。同时选择不同起调水位,对设计洪水及实际洪水进行调节, 确定合适起调水位,并分析了预报调度和常规调度的风险。结果显示：起调水位抬升,防洪预报调度的风险有所增加,但仍小于常规调度风险,为更好的实现洪水资源的有效利用,建议预报调度起调水位定为3260 m     

混合胺MEA＋DETA吸收CO2的影响因素

以MEA为主体,DETA为添加剂,考察1h内,在温度298～338K,压力300～700kPa,混合胺溶液初始浓度（质量分数）4％～20％范围内,MEA＋DETA不同配比的混合吸收剂吸收CO2的特性。获得MEA＋DETA混合胺吸收CO2的最佳吸收条件为：308K、500kPa、总胺质量浓度为20％,MEA与DETA的配比为8：2。     

臭氧微气泡深度处理染料废水生化出水

采用臭氧氧化法对某厂染料废水生化出水进行深度处理,考察了废水初始pH值和臭氧气泡大小对废水处理效果的影响,研究了臭氧微气泡对气液传质的影响。结果表明,在pH 2.5~11范围内,废水初始pH值越大,处理效果越好;加载微孔膜片后,臭氧气泡粒径变小,增大了臭氧的传质比表面积,延长了臭氧气泡在反应柱内的停留时间,强化了传质效果,处理废水的臭氧利用率可增大10%~30%,强化了臭氧氧化作用。加载5 μm孔径的膜片相比无膜片的情况,COD去除率提高了近30%,TOC去除率提高了16%。     

Effects of a gradually increased load of fish waste silage in co-digestion with cow manure on methane production

This study examined the effects of an increased load of nitrogen-rich organic material on anaerobic digestion and methane production. Co-digestion of fish waste silage (FWS) and cow manure (CM) was studied in two parallel laboratory-scale (8 L effective volume) semi-continuous stirred tank reactors (designated R1 and R2). A reactor fed with CM only (R0) was used as control. The reactors were operated in the mesophilic range (37 °C) with a hydraulic retention time of 30 days, and the entire experiment lasted for 450 days. The rate of organic loading was raised by increasing the content of FWS in the feed stock. During the experiment, the amount (volume%) of FWS was increased stepwise in the following order: 3% – 6% – 13% – 16%, and 19%. Measurements of methane production, and analysis of volatile fatty acids, ammonium and pH in the effluents were carried out. The highest methane production from co-digestion of FWS and CM was 0.400 L CH4 gVS^?1, obtained during the period with loading of 16% FWS in R2. Compared to anaerobic digestion of CM only, the methane production was increased by 100% at most, when FWS was added to the feed stock. The biogas processes failed in R1 and R2 during the periods, with loadings of 16% and 19% FWS, respectively. In both reactors, the biogas processes failed due to overloading and accumulation of ammonia and volatile fatty acids.