电厂燃煤过程中汞控制技术研究

燃煤电厂汞控制技术分燃烧前、燃烧中和燃烧后脱汞,燃烧后脱汞技术为主要汞控制排放工艺,其中吸附剂吸附方法的研究较为广泛。基于国内外近几年燃煤电厂烟气脱汞技术的研究,综述了汞控制技术的最新进展。     

层燃螺旋炉排焚烧技术处理含油污泥研究

通过对几种含油污泥无害化处理技术的比选,分析不同处理技术物耗、能耗情况,优选出经济有效的含油污泥焚烧技术,结合新疆油田含油污泥的特点,采用层燃螺旋炉排焚烧技术,利用其燃烧热能生产蒸汽用于原油生产,采用余热吸收急冷与碱液半干法除酸技术,有效控制了二次污染;采用布袋除尘与烟尘固化技术确保了烟气达标排放。年节省成本支出3095.88万元。     

电厂袋式除尘器滤袋故障分析及处理

以北京高井热电厂为对象,运用故障树分析的方法,对袋式除尘器及滤袋失效进行了故障树分析,并将之演变为成功树,提出了防止滤袋失效的措施。     

生活垃圾焚烧处理技术发展分析

综述了国内外的城市生活垃圾焚烧处理概况,探讨了生活垃圾焚烧处理与环境的关系,介绍了生活垃圾焚烧处理工艺,并对我国生活垃圾焚烧处理技术现状进行了分析。     

医疗废物焚烧处理核心技术的开发及应用

国内已建成的医疗废物焚烧设施目前普遍存在进料系统不稳定、玻璃结渣和高浓度HCl气体的排放的问题。这些技术难点已成为医疗废物焚烧处置行业发展的瓶颈。本文介绍了可解决上述问题的"可调节医疗废物恒流量进料技术"、"医废焚烧防玻璃结渣技术"和"含高浓度氯化氢医废尾气处理技术"三项医疗废物焚烧处理核心技术的主要特点及技术指标与应用实例。     

衡水市医疗废物处理现状调查及对策

医疗废物是一类成分复杂并有特殊危害的危险废弃物。通过分析衡水市医疗废物处理过程中存在的分散处置、处理率低等问题,提出了加强管理监督机制、提高医疗废物收集处理率的应对策略。通过综合比较分析几种医疗废物处理方法的优缺点,指出高温焚烧法集中处置是衡水市医疗废物的最佳处理方法。     

石膏浆液旋流器的分离性能实验研究

通过理论分析及工程经验对石灰石/石膏法烟气脱硫工艺中石膏浆液脱水系统的旋流器进行优化设计,在与工业实际相近的操作条件下,优选出了一根综合性能较好的旋流器。考察了该旋流器的压力、流量与分离效率之间相互关系,与常规石膏浆液旋流器的分级效率进行了比较,确定了最佳操作条件。结果表明,旋流器的进口流量随着进出口压力差的增大而增大,分离效率随着流量增加先上升后下降。在进口硫石膏颗粒平均粒径为24μm,流量为11.8~14.8 m3/h时,分离效率在85%以上,底流出口10μm、15μm以下的颗粒分别占底流出口颗粒总体积的1%、10%左右,起到了很明显的分级浓缩作用,分离性能也优于常规使用的石膏浆液旋流器。     

氧化镁烟气脱硫反应特性研究

利用实验室规模的鼓泡式反应装置,对比了碳酸钙、氧化镁和氧化镁/硫酸镁脱硫剂的反应活性,证实脱硫液中高浓度硫酸镁的存在是保证镁法脱硫效率高于钙法的重要因素,并考察了硫酸镁浓度、脱硫剂(氧化镁)浓度、烟气量、SO2浓度和吸收液温度等因素对脱硫效率的影响。结果表明,脱硫反应可以根据pH分为2个不同阶段;反应过程中脱硫效率随着硫酸镁浓度的增加而显著升高;烟气量增加将会导致脱硫效率有所下降;入口SO2浓度升高,脱硫效率下降;氧化镁浓度、温度对脱硫效率影响不显著。结合实验现象进行推断,氧化镁脱硫的反应过程受SO2在气液两相界面的传质扩散和其水解产物在液相的扩散控制。     

Radon, helium and CO2 measurements in soils overlying a former exploited oilfield, Pechelbronn district, Bas-Rhin, France

The Pechelbronn oilfield (Rhine Graben, France), where mining activity ended in the 1960s, has been used for waste disposal for twenty years. Since the wastes are varied, work is underway to identify the discharged materials and their derivatives, as well as to locate and quantify potential discharge sites. Two major goals were assigned to the present work. The first was to identify or refine the location of hidden structures that could facilitate gas emanation up to the surface, by studying soil gas concentrations (mainly ²²²Rn, CO₂, CH₄ and helium) and carbon isotope ratios in the CO₂ phase. The second was devoted to examining, from a health and safety viewpoint, if the use of the oilfield as a waste disposal site might have led to enhanced or modified gas emanation throughout the area.It appeared that CO₂ and ²²²Rn evolution in the whole area were similar, except near some of the faults and fractures that are known through surface mapping and underground observations. These ²²²Rn and CO₂ anomalies made it possible to highlight more emissive zones that are either related to main faults or to secondary fractures acting as migration pathways. In that sense, the CO₂ phase can be used to evaluate ²²²Rn activities distant from tectonic structures but can lead to erroneous evaluations near to gas migration pathways. Dumping of wastes, as well as oil residues, did not appear to have a strong influence on soil gaseous species and emanation. Similarly, enhanced gas migration due to underground galleries and exploitation wells has not been established. Carbon isotope ratios suggested a balance of biological phenomena, despite the high CO₂ contents reached. Other monitored gaseous species (N₂, Ar, H₂ and alkanes), when detected, always showed amounts close to those found subsurface and/or in atmospheric gases.     

沿面放电氧化液相亚硫酸铵

为了解决湿式氨法烟气脱硫生成不稳定亚硫酸铵（（NH4）2SO3）副产物的问题,设计了以不锈钢弹簧和溶液分别作为高压和低压电极的沿面放电系统,对液相（NH4）2SO3的氧化进行了研究。空气从反应器上方进入后经放电区域形成活性物质,再由底部的曝气头鼓入溶液并与（NH4）2SO3发生反应。比较了沿面放电处理与传统曝气处理的氧化效率,考察了放电电压、载气气量和初始浓度等因素对（NH4）2SO3氧化的影响。结果表明,沿面放电对（NH4）2SO3有显著的氧化效果;优化条件下的（NH4）2SO3氧化率接近100%;溶液中（NH4）2SO4与（NH4）2SO3的浓度比小于1时有利于（NH4）2SO3的氧化。