On-board measurements of gaseous pollutant emission characteristics under real driving conditions from light-duty diesel vehicles in Chinese cities

A total of 15 light-duty diesel vehicles(LDDVs) were tested with the goal of understanding the emission factors of real-world vehicles by conducting on-board emission measurements. The emission characteristics of hydrocarbons(HC) and nitrogen oxides(NOx) at different speeds, chemical species profiles and ozone formation potential(OFP) of volatile organic compounds(VOCs) emitted from diesel vehicles with different emission standards were analyzed. The results demonstrated that emission reductions of HC and NOxhad been achieved as the control technology became more rigorous from Stage I to Stage IV. It was also found that the HC and NOxemissions and percentage of O2 dropped with the increase of speed, while the percentage of CO2 increased. The abundance of alkanes was significantly higher in diesel vehicle emissions, approximately accounting for 41.1%–45.2%, followed by aromatics and alkenes. The most abundant species were propene,ethane, n-decane, n-undecane, and n-dodecane. The maximum incremental reactivity(MIR)method was adopted to evaluate the contributions of individual VOCs to OFP. The results indicated that the largest contributors to O3 production were alkenes and aromatics, which accounted for 87.7%–91.5%. Propene, ethene, 1,2,4-trimethylbenzene, 1-butene, and1,2,3-trimethylbenzene were the top five VOC species based on their OFP, and accounted for 54.0%-64.8% of the total OFP. The threshold dilution factor was applied to analyze the possibility of VOC stench pollution. The majority of stench components emitted from vehicle exhaust were aromatics, especially p-diethylbenzene, propylbenzene, m-ethyltoluene, and p-ethyltoluene.     

池火灾评价法在环氧乙烷罐区的应用研究

以某石油化工厂区为工程应用背景,通过对环氧乙烷储罐区计算模型的建立,应用池火灾评价法对环氧乙烷储罐发生池火灾的热辐射伤害区域进行了定量计算,得出环氧乙烷罐区发生池火灾的各级影响半径和造成的伤害程度。结果表明,只有当人员撤离罐区67.35 m范围外方可避免受到热辐射伤害。从环氧乙烷罐区的整体安全性出发,提出了具体的防护措施和建议,为企业的安全管理工作提供参考依据。     

石墨烯修饰的二氧化钛纳米管电极光电催化去除铜氰络合物研究

首先采用阳极氧化法制备了二氧化钛纳米管电极,进一步通过电化学循环伏安法制备了石墨烯(GO)修饰的二氧化钛纳米管电极.同时,采用SEM对电极的形貌进行了表征分析.光电化学测试分析结果表明,石墨烯修饰二氧化钛纳米管电极的电极光电响应性能得到了提高.最后,采用制备的电极为光阳极,通过光电催化氧化方法对铜氰络合物进行了去除研究.结果表明:在电压为2.0 V的条件下,采用二氧化钛纳米管电极,反应120 min后,剩余总氰的含量及铜的回收率分别为4.0%和96.3%;采用石墨烯修饰的二氧化钛纳米管,反应60 min后,剩余总氰的含量及Cu的回收率分别为0.3%和99%.可以看出,经石墨烯修饰的二氧化钛纳米管显示出了较好的光电催化去除铜氰络合物的效果.     

三合一脱硝技术在中小型燃水煤浆锅炉上的应用研究

中小型燃煤锅炉燃烧化石燃料过程中释放的氮氧化物,对环境造成的污染早就已经变成万众瞩目的焦点话题.而中小型锅炉又是当前大部分聚酯厂家的首选,解决这类型的锅炉的脱销难题,对于聚酯行业在当前环保指标压力下,研究中下锅炉脱销技术效果及组合应用,具有较强的现实意义.当前对于NOx的治理方法,有低氮燃烧、选择性非催化还原法(SNCR)和选择性催化还原法(SCR)等.本文就是在此背景下综述三合一脱硝技术在中小型燃水煤浆锅炉上的应用研究,及在工厂实际改造的工程运用案例.通过对氮氧化物的形成机理,工厂实际工况,选择脱销方法的考虑角度,以及实际采取的解决办法,并且对比脱销前后的指标数据的分析等方面,详细的阐述了三合一技术的充分可靠性,以及经济适用性.     

改性氧化石墨烯/壳聚糖功能材料对刚果红的吸附研究

以氧化石墨烯(GO)和壳聚糖(CS)为前体物,以乙二胺四乙酸二钠(EDTA-2Na)为表面改性剂,制备了一种新型改性氧化石墨烯/壳聚糖功能材料(GEC),并将此材料作为吸附剂用于水中刚果红的吸附去除,探讨了时间、pH值、吸附剂投加量、温度及初始浓度对GEC吸附去除刚果红的影响.结果表明,GEC对水中刚果红具备良好的吸附能力,且在pH=2~12的范围内都具有较佳的吸附效果.GEC对刚果红的吸附动力学可以较好地用伪二级动力学模型进行描述,其吸附数据可应用Langmuir吸附等温模型进行拟合,其吸附过程是自发的吸热反应过程.根据Langmuir模型计算得到GEC室温条件下最大吸附量为175.43 mg·g~(-1).用2 mol·L~(-1)NaOH溶液在60℃水浴条件下对GEC进行脱附再生实验,在重复循环利用6次后,GEC对刚果红的吸附量仅下降了5.89%,刚果红的去除率仍保持在88%以上.以上结果表明,GEC适合作为一种有效的吸附剂去除水中刚果红.     

纳米氧化锌对EBPR系统的长期作用机制研究:从宏观到微观

研究了纳米氧化锌(ZnO NPs)对强化生物除磷(EBPR)系统的长期作用机制,系统分析了EBPR系统在ZnO NPs长期抑制下宏观运行性能与微观结构的变化.结果发现,当进水开始添加ZnO NPs后,系统沉降性能随之降低.厌氧释磷速率与好氧吸磷速率均出现显著降低并降至0 mg·g~(-1)·h~(-1)(以每g MLSS释(吸)P量(mg)计,下同),从而使得系统丧失除磷效果.同时,厌氧段COD开始积累.ZnO NPs浓度增加至10 mg·L~(-1)时,多糖与蛋白质含量在抑制条件下均开始减少.通过高通量技术对微观层面进行分析发现,ZnO NPs将会严重抑制聚磷菌的正常生长.ZnO NPs对系统内不同细菌有截然不同的作用,Proteobacteria门在试验过程中比例减小,而Bacteroidetes门却受到促进作用.恢复阶段,较低浓度(2 mg·L~(-1))抑制条件下,EBPR系统恢复速度与程度均优于高浓度(6、10 mg·L~(-1))抑制条件.然而,即使系统得到一定程度恢复也难以恢复到初始水平.     

NO/SO_2臭氧协同氧化与吸收特性的实验研究

为研究燃煤烟气中NO/SO_2协同高效脱除方法,某热电厂通过现场实验研究了O3对烟气中NO、SO_2的选择性氧化规律以及脱硫浆液、半干法循环脱硫灰对氧化产物的吸收效能。结果表明:烟气中NO、SO_2同时存在时,烟气中的O3优先氧化NO,当O3过量30%时,SO_2氧化率可达到42%;实际湿法脱硫循环浆液对混合烟气中SO_2吸收率达到近100%,对NOx(x>1)最大吸收率仅为42%;含水量1)最大吸收率仅为30%,且吸收剂在218s后即丧失脱除效能;含水量为15%的半干法脱硫灰对混合烟气中SO_2吸收率达到100%,对NOx(x>1)最大吸收率为75%,吸收剂脱除效果良好且具备长时间稳定脱除效果。     

用外加热回转窑生产高纯活性氧化镁回收二氧化碳新工艺

针对当前镁制品生产过程中存在的严重资源浪费和环境污染严重的问题，提出以废弃菱镁矿渣为原料，利用新型外加热回转窑生产高纯氧化镁，并从生产废气中回收食品级液态二氧化碳的新工艺。     

CuO和Cu(Ⅱ)催化臭氧氧化的研究

以乙二酸为实验对象,研究了CuO/Al_2O_3和Cu(II)对臭氧的催化作用实验结果表明,在低pH条件下,CuO/Al2O3有较强的催化臭氧氧化能力,可以将乙二酸的去除率提高约15%而在中性条件下,20g·l-1CuO/Al2O3的催化效果有限磷酸盐缓冲液可以强烈抑制臭氧氧化乙二酸以及CuO/Al2O3的催化作用与CuO/Al2O3相比,Cu(II)离子有更强的催化臭氧氧化乙二酸的能力     

Effect of transition metal ions on photocatalytic activity of ZnO in bleaching of some dyes

The photocatalytic bleaching of some dyes (erythrosin-B, fast green FCF and eosin Y) was carried in the presence of semiconducting zinc oxide and was observed spectrophotometrically. The effects of various operating variables like pH, concentration of dyes, amount of semiconductor and light intensity on the efficiency of the reaction were also observed. Attempts have been made to study the effect of the addition of other metal ions (Fe²⁺, Ni²⁺, Ag⁺, Cu²⁺, Co²⁺, V²⁺ and Mn²⁺). All the added metal ions increase the reaction rate to some extent. It was also observed that Fe²⁺ is most effective in photobleaching of erythrosin-B, whereas V²⁺ is more effective in the cases of fast green FCF and eosin Y. A tentative mechanism has been proposed.