复叠机组低温机排气冷却器的必要性及计算

复叠机组低温机排气温度较高,容易引起各种损害,特别是造成分油不良,油在蒸发器存入过多,影响换热,从而使蒸发温度降低,使回油更加困难,且较低的蒸发温度会造成更大的排气过热,如此形成恶性循环.因此在低温机排气加装排气冷却器,及冷却器的正确选择计算是重要的.本文就此项问题提出一种冷却器结构及计算方法.     

Effects of injection timing,injector opening pressure and nozzle geometry on the performance of cottonseed oil methyl ester-fuelled diesel engine

Increasing petroleum prices, increasing threat to the environment from exhaust emissions and global warming have generated intense international interest in developing renewable and alternative non-petroleum fuels for engines. Evolving technology and a recurring energy crisis necessitates a continuous investigation into the search for sustainable and clean-burning renewable fuels. In this paper, cottonseed oil methyl ester (COME) was used in a four-stroke, single-cylinder variable compression ratio diesel engine. Tests were carried out to study the effects of fuel injection timing, fuel injector opening pressure (IOP) and injector nozzle geometry on the performance and combustion of COME biodiesel fuel used in a compression ignition engine with a single fuel mode. Fuel injection timing varied from 19° to 27° before top dead centre (bTDC) in incremental steps of 4° bTDC; fuel IOP varied from 210 to 240 bar in incremental steps of 10 bar. Fuel nozzle injectors with three, four and five holes, each of 0.3 mm size, were selected for the study. The results suggested that with retarded injection timing of 19° bTDC, increased IOP of 230 bar and a four-hole nozzle injector of 0.3 mm size resulted in overall better engine performance with an increased brake thermal efficiency and reduced HC, CO and smoke emission levels.     

车用乙醇汽油和无铅汽油对电喷汽车排放性能的影响

分别对电喷车长时间燃用乙醇汽油、无铅汽油前后的喷油器流量进行了测试,并采用轻型汽车整车排放测试系统对燃用不同油时的主要污染排放物HC、CO和NO_x进行了分析.结果表明:与无铅汽油相比,乙醇汽油能有效降低发动机排放的CO和HC(均约10%)及经过三元催化转化器作用后HC、CO和NO_x的排放,燃用无铅汽油时整车在装有三元催化转化器下的排放达到或接近欧洲1号排放标准,换用乙醇汽油后,CO降低较明显,达30%左右,HC和NO_x分别降低约18%、10%,此时排放在欧洲1号排放标准之上或接近欧洲2号排放标准;乙醇汽油还具有优于无铅汽油的其它性能,如对喷油器有轻微的清净作用,发动机排放的CO和HC恶化趋势较慢,延长三元催化转化器的使用寿命.     

基于马尔可夫的地面控制井下安全阀可靠性评估

为保障地面控制井下安全阀系统的安全运行，防止系统发生故障，建立了井下安全阀可修复系统的马尔可夫模型；针对系统设备构成复杂及共因故障等问题，基于β因子模型描述共因失效，同时将模型划分为3个独立模块，通过克罗内克积方法合并，评估系统可靠性；参照OREDA可靠性数据，定量求解井下安全阀系统可用度、可靠度以及稳态指标，研究模型中状态转移概率对系统稳态可用度的影响。研究结果表明:井下安全阀系统的可用度随时间增长而迅速到达稳态值；系统检修周期应小于2.5 a；根据可靠性分析结果，运营方应考虑系统经济与可靠性间的博弈关系，合理优化系统冗余结构与维修周期管理，防止井下安全阀系统失效。     

新型电磁脉冲阀的性能特点及应用

阐述了袋式除尘器的配件新型电磁脉冲阀的工作原理及性能特点,它突破了脉冲阀沿用了几十年橡胶膜片的传统,并介绍了新型电磁脉冲阀的试用情况。     

An experimental study of an LPG tank at low filling level heated by a remote wall fire

This paper describes an experimental study of 2300 L pressure vessels exposed to remote fire heating by a natural gas fuelled wall fire simulator. The tanks were filled to 15% capacity with commercial liquid propane. The flame intensity and distance were varied to study the effect of different heating levels on the tank and its lading.The fire simulator is first characterized with tests including fire thermocouples, radiative flux meters and thermal imaging. With the appropriate positioning of a target tank it is possible to get very realistic fire heat fluxes at the tank surface.Three tests were conducted with the 2300 L tanks filled to 15% capacity with propane. The tanks were positioned at three different distances from the wall fire resulting in measured average peak heat flux at the tank surfaces ranging between 24 and 43 kW m^?2. The data shows rapid rise in vapour space wall temperatures, significant temperature stratification in the vapour space, and moderate rate of pressure rise. These results provide excellent data for the validation of computer models used to predict the response of pressure vessels exposed to moderate heating from a remote fire.     

上海某电厂320MW 机组“电改袋”工程

针对上海某电厂4×320 MW机组中的3、4号炉电除尘器提标改造为袋式除尘器项目，介绍了改造背景、改造技术以及改造后袋式除尘器的运行情况。除尘器投运至今，运行稳定，各项指标达到设计要求。     

气相爆轰实验系统设计

设计了一套内径139 mm、总长10 m的气体、粉尘爆轰管道式反应装置,装置由试验管道系统、测试系统、辅助实验系统和控制系统4部分构成。测试系统包括高频响动态压力传感器、火焰传感器、超动态应变仪、数据采集卡、高速摄像系统等设备,以便测试可燃气体、粉尘的爆轰参数和管道的动力学响应特征参数。实验装置可用于可燃气云和粉尘的燃烧、爆炸特性以及爆轰波对结构加载作用的研究,研究成果可用于燃气输送管道的设计、校核,为安全生产保驾护航。     

气体管道中阀门内漏声发射信号特性研究

针对石化企业气体阀门内漏在线诊断问题,设计并建立气体截止阀内漏检测实验装置,根据声发射技术理论与实验相结合研究截止阀内漏特性,对比不同压差下信号参数分布规律。结果表明,阀门泄漏率与信号振幅和平均信号电平ASL均呈指数分布,与能量和均方根AERMS呈对数分布,并拟合了泄漏率与AERMS的函数关系式。因此,可以综合各对应关系对阀门是否泄漏进行检测,并利用泄漏率与AERMS的函数关系式定量估算阀门泄漏率。     

Impaired behavior and changes in some biochemical markers of bivalve (Ruditapes decussatus) due to zinc toxicity

Susceptibility and response of bivalves, the clam Ruditapes decussatus, to zinc (Zn) were studied by monitoring behavior using valve movement and some biochemical parameters. The LC₅₀ was 4.1 mg L^?1 at 7 days. Depuration of Zn from their tissues was also followed. Accumulation of Zn increased with concentration and duration of exposure. After 20 days, Zn caused impairment of valve movement as well as the antioxidant system, decreasing glutathione and protein levels and increasing the lipid peroxidation which is indicative of oxidative damage. Results suggested that behavior and biochemical parameters of clam R. decussatus were sensitive and suitable responses for assessing the effects of Zn on the aquatic ecosystems. It could be concluded that there is a time–dose–response relationship of Zn with behavior and oxidative stress of R. decussatus.