Biotreatability and kinetics of UASB reactor to mixtures of chlorophenol pollutants

In most natural ecosystems heterotrophic microorganisms encountercomplex mixtures of carbon sources, each of which is present at aconcentration of few micrograms per litre. This study examined the biotreatability and kinetics of an upflow anaerobic sludge blanket (UASB) reactor to complex mixtures of chlorophenols encountered in environmental conditions using on-line and off-line experimental studies. Results indicate that (1) steady-state concentration was quite lower (98.3 mg L^-1) with complex mixture of chlorophenols than steady-state concentration achieved when only 2.4 dichlorophenol (124 mg L^-1) was studied alone on the same reactor; (2) that toxiceffects of chlorophenols increase with increasing concentrationsof toxicant. (Onset of the inhibitory effect occurred at a lowerconcentration in multi-substrate than in single substrate utilization); (3) addition of alternative utilizable substrate can mitigate toxic effects and enhance degradation; (4) the relative concentration of substrate was critical in determiningutilization patterns. HPLC analysis of off-line experimental samples resulted in a steady-state treatment efficiency of68% for COD, 36% for 2-hlorophenol, 40.5% for 4-chlorophenol, 70.7% for 2,4-dichlorophenol, 53.2% for 2,4,6-trichlorophenol and 42% for pentachlorophenol in presence of glucose. Kinetic constant in terms of V _max and K _s were determined. K _s for the five chlorophenols ranged between 0.016 and 0.117 kg m^-3 day^-1 while V _max ranged between 0.056 and 0.244 kg m^-3 day^-1.     

Biodegradability: An assessment of commercial polymers according to the Canadian method for anaerobic conditions

The degradation of several biodegradable polymers was measured as a result of exposure to an anaerobic medium. The polymers investigated included materials based upon polylactic acid, polylactone, and poly(hydroxy butyrate/valerate) as well as those incorporating starch-based materials. The degradation was monitored by methane and carbon dioxide evolution. In addition, the physical and chemical changes were noted as a result of exposure. These measurements included changes in mass, dimension, and molecular weight. FTIR, UV-vis, proton, and¹³C NMR spectra were also recorded prior to and after exposure. The results clearly indicated that several biological and chemical degradation processes were occurring with the biodegradable polymers studied.Paper presented at the Bio/Environmentally Degradable Polymer Society—Second National Meeting, August 19–21, 1993, Chicago, Illinois.Issued as NRCC No. 37549.     

高浓度印染废水处理工程工艺条件与实例分析

研究以三相生物流化床作为工程化反应器处理印染废水的工程工艺条件及操作特性，分别测定流化床内的气相含率，兴体循环速度及体积氧传质系数。     

Mechanics Principle and Engineering Application of Split Layer and Bed Separation of Mining Overburden

<正>To control land surface subsidence caused the underground mineral exploitation and the catastrophic phenomena such as serious damage of buildings, waterbodies, cultivated lands, railways, bridges caused by land subsidence, bed separation grouting technology of overburden is put forward. To provide theoretical support for the technology, the characteristics and the mechanics mechanism of mining overburden from layer-split to formation of bed separation are studied. On the basis of elastic sheet board theory, calculation formula of rock sheet deflection is presented, and the mechanics criteria of the separation formation and the calculation formula of bed separation volume are set up. Finally, the applications and technics of bed separation grout technology of mining overburden to control land subsidence in china are introduced.     

MBBR处理低浓度污水的工程应用

用 2座体积 12 0m3的移动床生物膜反应器处理抚顺乙烯有限公司厂区的低浓度 (CODCr6 0～ 80mg L)生活污水 ,停留时间 2 4h ,出水通过高效纤维球过滤罐 ,CODCr降至 2 0mg L ,BOD5降至 5mg L ,SS降至 5mg L ,氨氮降至 1mg L ,达到了循环冷却水的回用标准。进水浓度过低 ,对MBBR挂膜不利 ,工程中采用外加营养物质的措施后 ,3d内反应器成功挂膜启动。     

两段接触氧化法处理生活污水的工程实例

本污水厂设计规模 70 0 0m3 d ,进水CODCr3 0 0mg L ,BOD515 0mg L ,SS 2 0 0mg L ,采用两段接触氧化法处理工艺 ,运行结果表明 ,出水水质达到GB8978 1996污水综合排放标准中的二级标准     

ASM1中废水和污泥组分浓度的测定方法研究

对呼吸计量法应用于校准ASM1作了简明的阐述。在呼吸速率与模型组分关系的基础上,介绍了ASM1中废水与污泥各组分浓度的测定方法,并指出模型组分细化的意义。     

铜镍电镀污泥的资源化与无害化处理试验研究

提出了铜镍电镀污泥的资源化与无害化处理的工艺流程 ,并用试验考察了各工序的技术经济指标。试验结果表明 ,铜粉品位大于 90 % ,铜的回收率大于 95 % ,硫酸镍质量达到工业一级 ,镍回收率大于 80 % ,浸出渣和净化渣经固化处理后可作普通建筑材料使用 ,工艺过程产生的废水可以达标排放     

骆马湖的氮磷平衡及实施截污工程对水质改善效果的研究

骆马湖“九五”期间的氮磷平衡分析结果表明：氮磷在骆马湖湖体中的滞留量分别为1188.89t/a和193.36t/a。根据骆马湖的水质要求，在骆马湖截污工程完成后，没有新的污染进入水体的前提下，对骆马湖水体通过自然净化恢复到要求状态所需的时间进行了详细的数学推导和科学论证，结果表明，在不考虑底泥营养物质的情况下，只需0.19年左右的时间就能恢复，如果考虑底泥的影响。也只需0.59年左右的时间就能恢复，因此得出结论：对骆马湖实施截污是加速骆马湖水体改善的最佳途径。     

污泥综合处理技术系统的可行性分析

通过对污泥处理技术现状与污泥组成的分析，认为降低污泥的含水率是改善污泥可处理性的关键。以机械脱水加工热干燥过程可达到充分降低污泥含水率的目的。以此为主干所形成的污泥综合处理系统经能量与经济平衡分析，发现其能量输出大于输入，经济成本合理，有一定的技术经济可行性。