酸化液对厌氧释磷好氧吸磷速率的影响研究

采用序批式试验研究了酸化液对聚磷菌厌氧释磷好氧吸磷速率的影响。同一活性污泥混合液中聚磷菌的释磷潜力相当,混合液中挥发性脂肪酸越多则越有利于激发聚磷菌的释磷潜能。酸化液投加量越大,对应的混合液中聚磷菌的平均释磷速率也越大。当酸化液投加量为30 mg/L(以TOC计)时,聚磷菌的平均释磷速率达0.137 mg/(mg.d),是未投加酸化液工况的3.26倍。聚磷菌厌氧释磷过程中,活性污泥的MLVSS值逐渐增大,而MLSS值却不断减小,这是由聚磷菌释磷反应过程中聚磷颗粒和糖原的消耗,以及PHB的生成而产生的。碳源充足与否,对聚磷菌的平均好氧吸磷速率影响不大,研究各工况中,聚磷菌的平均吸磷速率在0.129~0.160 mg/(mg.d)内。碳源越充足,则聚磷菌在好氧吸磷反应持续的时间越长,因此,具有更强的超量吸磷能力。酸化液投加量为20 mg/L时(以TOC计),聚磷菌在好氧吸磷结束时,出水的SP浓度能减少到0.5 mg/L以下。     

建阳市农业面源污染调查与防治对策研究

就目前建阳市农业面源污染的现状进行调查,并提出防治对策。     

环境管理过程中对锅炉型号的识别

通过对锅炉型号的简要介绍,提高对锅炉的认识,增强在污染源动态更新调查表的填报过程中锅炉技术指标的填报能力是十分必要的。     

岩溶地下河系统中有机氯的分布特征与来源分析

选取重庆老龙洞、青木关岩溶地下河为研究对象,采用气相色谱仪-微池电子捕获检测器(GC-μECD)分析两条地下河水体中21种有机氯农药(OCPs)的浓度.结果表明,南山地下河中六六六(HCHs)和艾氏剂类化合物(ALDs)是主要检出物,青木关地下河中HCHs和甲氧滴滴涕是主要检出物.南山、青木关地下河中均未检出o,p'-DDE、p,p'-DDE、o,p'-DDD,同时,青木关地下河还未检出o,p'-DDT、狄氏剂,其余OCPs在两条地下河中检出率高达100%.青木关地下河中OCPs浓度范围为145~278 ng·L-1之间,平均值为213 ng·L-1;南山老龙洞地下河中OCPs浓度介于17.7~40.8 ng·L-1之间,平均值为32.7ng·L-1.两条地下河中各OCPs组分表现为地下河出口大于入口.通过对OCPs污染来源分析,发现两地下河流域滴滴涕(DDTs)主要来自于历史上工业DDTs输入,氯丹主要来自于大气沉降.六六六(HCHs)主要来源是林丹的输入,南山地下河属于历史污染,青木关地下河上游的甘家槽有新的HCHs输入.与国内外其他各水体相比,南山地下河水体中HCHs、DDTs浓度处于低水平;青木关下河处于中等偏高水平.结合中外用水卫生标准,发现南山地下河和青木关地下河未超过饮水安全标准.青木关应禁止农田施用有机氯农药,保护地下河生态环境.     

Compositions and sources of organic acids in fine particles (PM2.5) over the Pearl River Delta region, south China

Organic acids as important constituents of organic aerosols not only influence the aerosols' hygroscopic property, but also enhance the formation of new particles and secondary organic aerosols. This study reported organic acids including C14–C32fatty acids, C4–C9dicarboxylic acids and aromatic acids in PM2.5collected during winter 2009 at six typical urban, suburban and rural sites in the Pearl River Delta region. Averaged concentrations of C14–C32fatty acids, aromatic acids and C4– C9 dicarboxylic acids were 157, 72.5 and 50.7 ng/m3, respectively. They totally accounted for 1.7% of measured organic carbon. C20–C32fatty acids mainly deriving from higher plant wax showed the highest concentration at the upwind rural site with more vegetation around, while C14–C18fatty acids were more abundant at urban and suburban sites, and dicarboxylic acids and aromatic acids except 1,4-phthalic acid peaked at the downwind rural site. Succinic and azelaic acid were the most abundant among C4–C9dicarboxylic acids, and 1,2-phthalic and 1,4-phthalic acid were dominant aromatic acids. Dicarboxylic acids and aromatic acids exhibited significant mutual correlations except for 1,4-phthalic acid, which was probably primarily emitted from combustion of solid wastes containing polyethylene terephthalate plastics. Spatial patterns and correlations with typical source tracers suggested that C14–C32fatty acids were mainly primary while dicarboxylic and aromatic acids were largely secondary. Principal component analysis resolved six sources including biomass burning, natural higher plant wax, two mixed anthropogenic and two secondary sources; further multiple linear regression revealed their contributions to individual organic acids. It turned out that more than 70% of C14–C18fatty acids were attributed to anthropogenic sources, about 50%–85% of the C20–C32fatty acids were attributed to natural sources, 80%–95% of dicarboxylic acids and 1,2-phthalic acid were secondary in contrast with that 81% of 1,4-phthalic acid was primary.     

Ionic composition of submicron particles (PM1.0) during the long-lasting haze period in January 2013 in Wuhan, central China

In January 2013, a long-lasting severe haze episode occurred in Northern and Central China; at its maximum, it covered a land area of approximately 1.4 million km². In Wuhan, the largest city in Central China, this event was the most severe haze episode in the 21st century. Aerosol samples of submicron particles (PM_1.0) were collected during the long-lasting haze episode at an urban site and a suburban site in Wuhan to investigate the ion characteristics of PM_1.0 in this area. The mass concentrations of PM_1.0 and its water-soluble inorganic ions (WSIIs) were almost at the same levels at two sites, which indicates that PM_1.0 pollution occurs on a regional scale in Wuhan. WSIIs (Na⁺, NH₄⁺, K⁺, Mg²⁺, Ca²⁺, Cl^-, NO₃^- and SO₄^2-) were the dominant chemical species and constituted up to 48.4% and 47.4% of PM_1.0 at WD and TH, respectively. The concentrations of PM_1.0 and WSIIs on haze days were approximately two times higher than on normal days. The ion balance calculations indicate that the particles were more acidic on haze days than on normal days. The results of the back trajectory analysis imply that the high concentrations of PM_1.0 and its water-soluble inorganic ions may be caused by stagnant weather conditions in Wuhan.     

农村沼气在北方农业源减排中的应用浅析

农村沼气作为一种特殊的清洁能源,在沈阳市农村节能减排、应对气候变化和发展低碳经济、促进新农村建设方面发挥了巨大的作用。本文通过对沼气工程在北方地区应用的阐述,力图推动北方农村沼气在农业源减排工作中的应用。     

Improvement of welding heat source models for TIG-MIG hybrid welding process

Tungsten inert gas-metal inert gas (TIG-MIG) hybrid welding process is an effective way to improve welding productivity and quality due to advantages of the two processes. Mathematical analysis is crucial to fundamentally understand this synergetic welding process. In this study, based on experimental visualization of arc behaviors, some assumptions are proposed to deduce adaptive plane and volumetric heat source models separately for each involved welding method first. The influence of torch angles on distribution of temperature and geometry of weld bead are calculated and compared with experimental results. It shows that this developed algorithm of heat source can be employed to accurately predict welding process whether the electrode gun is slanted backward or forward to the direction of welding. Then TIG-MIG hybrid welding process is simulated and analyzed without considering the attractive or repulsive force of two arcs. The characteristic of TIG-MIG welding process is discussed compared to single MIG. It lays the foundation for the further research on the interaction of the two arcs during TIG-MIG hybrid welding.     

重金属抗性解磷细菌的磷溶解特性研究

从湖南省湘西州花垣县的铅锌矿表层土壤中,筛选出两株具有重金属抗性和解磷特性的细菌T PSB1和T PSB2.通过16S rRNA基因序列比对,分别鉴定为嗜麦芽寡养单胞菌(Stenotrophomonas maltophilia)和唐菖蒲伯克霍尔德菌(Burkholderia gladioli).T PSB1和T PSB2在含有难溶性无机磷液体培养基中,其上清液的可溶性磷含量最高分别达到了402.9 mg·L-1和589.9 mg·L-1;在难溶性有机磷固体和液体培养基中,固体平板上均出现解磷圈,而液体培养基上清液中,可溶性磷含量也分别达到了2.97 mg·L-1和4.69 mg·L-1.另外,两株细菌对重金属Zn2+的抗性最高,在其浓度为2000 mg·L-1固体和液体培养基条件下均可以生长,磷溶解浓度分别为114.8 mg·L-1和125.1 mg·L-1.而在含铬和铅的浓度为1 000 mg·L-1的液体培养基中,两株细菌同样表现出重金属抗性.在Pb2+浓度为1000 mg·L-1的液体培养基中,磷溶解浓度分别达到了57.9 mg·L-1和71.7 mg·L-1;而在Cr2+浓度为1000 mg·L-1的培养基中磷溶解浓度分别为60.1 mg·L-1和98.4 mg·L-1.     

磷回收对厌氧/好氧交替式生物滤池蓄磷/除磷的影响

为能提高生物除磷系统的除磷/回收磷效率,研究采用厌氧/好氧交替式生物滤池(AABF)处理低碳磷比废水,观察利用周期性扩增进水碳源进行磷回收时,生物滤池除磷效率及生物膜内微生物特性的变化.通过分析生物滤池除磷效率变化,生物膜多聚物染色、扫描电镜(SEM)观察以及荧光原位杂交(FISH)技术分析生物滤池系统实施周期性磷回收对生物膜内微生物菌群形态与组成的影响.结果发现,生物滤池在先后经历3次生物蓄磷-磷回收(PB-PR)的运行操作过程中,生物滤池除磷效率分别由磷回收前的60.3%、82.9%、86.6%提高到磷回收后的87.2%、91.2%、93.5%;生物滤池生物膜内优势菌群形态逐渐由大球菌演变为小球菌、杆菌与丝状菌;经过连续3个周期的PB-PR操作,生物滤池底部生物膜中聚磷菌所占比例由43%提高至70%;聚磷菌群在生物膜内混合菌群中的比例随着上流式生物滤池高度的增加而不断提高.结果表明,采用周期性的碳源扩增与回收磷的操作,可以提高生物滤池除磷效率;引起生物滤池生物膜内微生物菌群形态与组成发生变化,促进聚磷菌成为优势菌群.