日本食品废物不同资源化技术下的碳排放比较研究

应用生命周期评价法(LCA),采用日本农林水产省和环境省的调查数据和统计数据,对不同资源化技术处理食品废物碳排放进行评价.10种资源化技术相比于3种非资源化(主要是焚烧)技术的结果表明,食品废物生命周期各阶段碳排放最多的是预处理+处理阶段,约占85％;最少的是回收阶段,可抵消部分排放.此外,全生命周期总排放,甲烷化(循...     

双循环流化床烟气悬浮脱硫技术工业化试验研究

在一台75t/h电站燃煤锅炉上，设计建造了基于双循环流化床烟气悬浮脱硫技术工艺的脱硫装置，烟气处理量为140000m^3/h，该脱硫装置主要特征是循环灰采用两经分离，内外双重循环方式和石灰浆液采用多层喷浆方式。介绍了该装置的系统组成、工作原理、工艺流程、工业化实验结果。实际表明：当Ca/S=1.3,△T=10℃时，脱硫效率达90%；固体颗粒物的循环使脱硫效率提高15%左右。     

热轧厂的高速过滤器改造及效果分析

对八钢公司热轧厂浊循环水工艺中的主要水处理设备高速过滤器的运行结果进行了分析,认为高速过滤器存在设计缺陷。针对高速过滤器存在的问题,对其进行了改造,改造后,其出水水质显著提高,运行效果良好。     

三相内循环流化床光催化反应器及其性能

依据流态化原理,设计出一种三相内循环流化床光催化反应器,对反应器的水力特性做了推算,确定了反应器的操作影响因素.对罗丹明B的降解实验结果显示出优越的性能,依据催化剂投加量及初始光强的不同,反应半衰期在4-10.5min之间.     

Dissipation of Tidal Energy and Associated Mixing in a Wide Fjord

This paper sets out to test the hypothesis that vertical mixing due to the dissipation of the internal tide accounts for a significant proportion of the total vertical mixing in a fjordic basin during a period of deep water isolation. During July and August 1999 two locations in the Clyde Sea were instrumented with moored RD Instruments Acoustic Doppler Current Profilers (ADCPs) and conductivity-temperature-pressure chains: Station C2, near the shallow entrance sill (55 m water depth), and station C1 in the deep basin (155 m water depth). A bottom pressure recorder was also deployed at station C3 by the seaward entrance to the Clyde Sea in the North Channel of the Irish Sea. A Free-falling Light Yo-yo shear microstructure profiler (FLY) was used to measure the dissipation rate of turbulent kinetic energy (TKE) throughout the water column over 25 h at both C1 and C2. These were interspersed with two-hourly conductivity-temperature-depth casts at both sites. The observations show agreement between the dissipation rate of TKE estimated by using a microstructure profiler and that estimated from the decay of the internal tide as measured by the two ADCPs. However, to account for all the implied mixing it is necessary to invoke an additional source of buoyancy flux, the most probable candidate mechanism is enhanced internal wave breaking near the sill and at the sloping boundaries of the deep basin. In addition, the vertical eddy diffusivity estimated from the micro-structure profiler (O(0.5 cm² s^–1) indicates that internal tide induced mixing away from any boundaries contributed significantly to the overall level of mixing which is required to account for the observed evolution of the deep basin water properties.     

城市中水回用于循环冷却水的氨氮去除试验研究

对氨氮浓度较高的城市中水回用于循环冷却水进行了静态和动态模拟试验，研究了氨氮在两种不同试验条件下的变化以及对系统产生的影响。试验结果表明：随着浓缩倍率的升高，循环水中氨氮浓度大幅度下降，大部分氨氮是由于冷却塔对氨的吹脱作用而被去除。试验过程中，氨氮浓度的降低没有导致系统的腐蚀。用氨氮浓度较高的城市中水回用于循环冷却水是可行的。     

含缺陷连续管冲蚀规律研究

针对内壁含缺陷的连续管冲蚀磨损严重、易失效的问题,基于冲蚀理论和液-固两相流,建立了含缺陷连续管内 壁冲蚀模型。利用Grant和Tabakoff模型求解砂砾冲蚀速率,借助实验数据验证了CFD数值模型。利用该模型研究了连续 管内壁周向均布缺陷数量及缺陷形状参数（深度、长度和宽度）对连续管内壁含缺陷时的冲蚀影响。研究表明:完整连 续管与含1个缺陷时对比,最大冲蚀率增加了4.5倍。对于深度或宽度较小的缺陷,冲蚀更为严重,缺陷会在冲蚀作用下 迅速加深或变宽,增速下降较快。含大长度缺陷连续管在压裂中会被加速损坏。     

污水处理生物转盘结构及组合工艺

针对生物转盘污水处理工艺,研究设计出能提高生物转盘处理效率的循环水轮的结构及一体化的安装工艺形式,以非能源的方式提高了系统耐冲击负荷能力和去除效率,并通过示范工程进行验证,充分肯定了该技术的高效性和实用性。     

首钢大石河铁矿采用“内循环方式”回收尾矿金属

针对当前黑色治金矿山企业选矿生产尾矿品位上升、金属流失严重问题,阐述了利用原有设备实施工艺改造,探索采用“内循环方式”回收尾矿金属,以降低尾矿品位,提高经济效益,节约矿石资源。     

循环流化床锅炉掺烧高炉煤气的应用

介绍了高炉煤气的主要燃烧特性,分析了高炉煤气在循环流化床锅炉中掺烧时对炉膛换热、过热蒸汽温度、锅炉负荷、热效率、分离装置以及环境的影响,并提出了消除不良影响的相应措施。