ALUM CONTROL OF INTERNAL PHOSPHORUS LOADING IN A SHALLOW LAKE1

ABSTRACT: Alum treatment of a shallow lake, with mean depth 2 m and area 137 ha, curtailed internal loading of P for at least one ear. Mean summer total P and chl a decreased from 76 and 27μg l^?1, respectively, in 1978 before treatment. to 29 and 14 μ l^?1, while mean summer Sed transparency increased from 1.6 to 2.2 m and blue green algae were no longer dominant. Macrophyte biomass and distribution retuned during the post-alum year, 1980-1981, to previous levels after a 1979 four-month lake level drawdown had reduced biomass by 84 percent The improved transparency, resulting from the decrease in chl a following treatment, could encourage greater biomass of macrophytes in the deeper area of the lake. Recovery of macrophyte biomass to predrawdown levels may restore internal loading of P through enrichment of deep water sediments during winter dieback and decomposition.     

AN EXAMINATION OF LAND USE - NUTRIENT EXPORT RELATIONSHIPS1

ABSTRACT: Lake and watershed management strategies and recent environmental legislation dictate that nonpoht nutrient sources associated with storm water runoff must be assessed. Accordingly, a nutrient flu assessment for phosphorus and nitrogen is conducted through an extensive literature review of nutrient export studies. These studies are reevaluated. The nutrient export coefficients are screened according to sampling design criteria and compiled according to land use. The ecological mechanisms within each land use influencing the magnitude of nutrient flux are also discussed     

钠盐量影响下DD6单晶高温合金的高温热腐蚀规律研究

目的 开展镍基单晶高温合金DD6在950 ℃下的热盐腐蚀试验(95%Na2SO4+5%NaCl)，探明涂盐量和涂盐方式(周期涂盐和单次涂盐)对DD6高温热腐蚀的影响规律和机理。方法 结合扫描电子显微镜、X射线能量色散谱、X射线衍射等设备，对不同涂盐量及涂盐方式下DD6的表面及横截面形貌进行观察分析，分析不同涂盐量和涂盐方式下DD6的高温热腐蚀机理。结果 DD6在950 ℃下主要发生碱性熔融热腐蚀，同时伴随氧化、硫化和氯化等过程。高温热腐蚀使得DD6合金表面生成的保护性氧化膜被熔融态的腐蚀介质破坏，导致O、S、Cl等外部元素通过氧化膜的缺陷进入DD6基体中，在合金的亚表面发生内氧化、内硫化以及内氯化反应，横截面上出现明显的腐蚀层，其主要由氧化物以及硫化物组成。随着热腐蚀的进行，DD6表面物质发生了剥蚀，沉积盐量的增加导致剥蚀现象越加严重，合金内部致密的组织结构也被破坏，横截面上出现了大量孔洞、裂纹等缺陷。在相同涂盐量下，周期涂盐法使得DD6的腐蚀程度高于单次涂盐法。结论 DD6高温热腐蚀行为与涂盐量及涂盐方式密切相关，相同涂盐方式下，涂盐量越大，DD6热腐蚀更加严重。涂盐量一定时，周期涂盐法使得DD6的热腐蚀剧烈程度大于单次涂盐法，且DD6在上述热腐蚀条件下均发生剥蚀破坏。     

有效磷含量对硝酸铵溶液热安全性的影响

为了了解硝酸磷肥生产过程中,硝酸铵溶液中加入磷酸一铵的安全性,通过自制实验装置,研究了有效磷含量对质量分数为85%的硝酸铵溶液热分解的影响。结果表明,质量分数为85%的硝酸铵和磷酸一铵混合溶液的临界爆炸温度高于纯质量分数为85%的硝酸铵溶液,稳定性更好;磷酸一铵抑制硝酸铵的热分解,随着有效磷含量的增加,硝酸铵混合溶液临界爆炸温度升高;升温速率对硝酸铵混合溶液的临界爆炸温度影响很大,随着升温速率由2℃/min升高到3℃/min,质量分数为85%的硝酸铵混合溶液的临界爆炸温度升高,不易发生爆炸,安全性更好。研究结果对硝酸磷肥的生产安全有一定的指导意义。     

内排压脚与边坡稳定性的关系

为了研究边坡角及边坡形状与边坡稳定性的关系,采用有限元软件ANSYS模拟了不同边坡角对应的稳定系数,以及不同平盘宽度和压脚高度所形成的等储备强度边坡的稳定系数。模拟中假设材料符合相关联的理想弹塑性本构关系,强度准则符合Drucker-Prager准则,用计算收敛性作为边坡稳定性的准则,用强度折减法得出边坡的稳定系数。为了形成等储备强度边坡,由下到上分步骤进行压脚。先在平面边坡最下台阶压脚,这样提高了边坡稳定系数,在边坡进入临界状态时,最下两台阶的塑性状态相同,则压脚停止;再在最下两台阶同时压脚,在边坡进入临界状态时,最下3个台阶的塑性状态相同,则压脚停止;以此类推,在最下边n个台阶同时压脚,在边坡进入临界状态时,压到与第n+1个台阶的塑性状态相同为止。结果表明,边坡总是从坡脚开始形成塑性区,在重力加载过程中,塑性区以弧形条带向坡顶扩展,形成滑带。最有效的内排压脚是从最下台阶开始形成等储备强度边坡的压脚。     

Sources and Transport of Phosphorus to Rivers in California and Adjacent States,U.S., as Determined by SPARROW Modeling

The SPARROW (SPAtially Referenced Regression on Watershed attributes) model was used to simulate annual phosphorus loads and concentrations in unmonitored stream reaches in California, U.S., and portions of Nevada and Oregon. The model was calibrated using de‐trended streamflow and phosphorus concentration data at 80 locations. The model explained 91% of the variability in loads and 51% of the variability in yields for a base year of 2002. Point sources, geological background, and cultivated land were significant sources. Variables used to explain delivery of phosphorus from land to water were precipitation and soil clay content. Aquatic loss of phosphorus was significant in streams of all sizes, with the greatest decay predicted in small‐ and intermediate‐sized streams. Geological sources, including volcanic rocks and shales, were the principal control on concentrations and loads in many regions. Some localized formations such as the Monterey shale of southern California are important sources of phosphorus and may contribute to elevated stream concentrations. Many of the larger point source facilities were located in downstream areas, near the ocean, and do not affect inland streams except for a few locations. Large areas of cultivated land result in phosphorus load increases, but do not necessarily increase the loads above those of geological background in some cases because of local hydrology, which limits the potential of phosphorus transport from land to streams.     

秦淮河干流沉积物磷形态沿程分布特征

应用化学连续提取法,分析了秦淮河干流14个表层沉积物样品的磷形态沿程变化特征及其影响因素.结果发现,秦淮河干流由上游至南京市区段,随城市化程度的提高,河流沉积物总磷和各种形态磷沿程增加的趋势十分明显.Ca-P和Fe-P平均含量分别占TP的26.8%和25.7%,是主要的磷形态.易吸附态磷(L-P)在TP中的比例最低,但在城区由于TP的高度富集,其含量均超过15 mg·kg-1.沉积物中的总磷含量在城区河段显著增加,但只有很少部分转化为稳定形态的磷,人口密集区生活污水等各种来源排放的磷仍然深刻影响着城市河流的水环境质量.随城市化程度的提高,秦淮河中下游沉积物样品中钙富集的趋势明显,与之相对应的是沉积物Ca-P含量均超过200 mg·kg-1,相关分析和通径分析结果表明,二者之间存在成因上的联系.钙的富集提高了沉积物的固磷能力,将上覆水体中的磷转化为钙结合态磷.城区河流沉积物中钙含量的升高,对于河流生态系统磷的迁移转化有重要影响.     

亚热带丘陵小流域土壤有效磷空间变异与淋失风险研究

肥料过施导致的土壤磷素累积和淋失是农业面源污染的重要方面.以湖南省长沙县金井镇脱甲河小流域(52 km2)为研究区,采用高密度布点采样、Arc GIS软件和属性相似反距离加权插值法研究了亚热带丘陵小流域表层(0~20 cm)土壤有效磷(Olsen-P)含量(以P计,下同)的空间分布特征与磷素的淋失风险.结果表明,菜地、果园、稻田和茶园土壤Olsen-P平均含量为62.0、16.1、14.4和13.7 mg·kg-1,是林地(平均含量为2.36 mg·kg-1)的5.8~26.3倍.5个土地利用类型土壤Olsen-P含量均具有高等变异水平和中等程度的空间自相关性(块基比C0/(C0+C)=50%),这与区内地形地貌、土壤母质、人工施肥等具有密切关系.根据土壤0.01 mol·L-1Ca Cl2浸提态P和Olsen-P的非线性关系可确定区内红壤和水稻土P的淋失风险临界值分别为69.97和98.40 mg·kg-1,并据此对脱甲河小流域土壤磷素淋失的风险进行了定量评价,结果表明旱地土壤具有明显较高的淋失风险,其中中等以上的比例占36.4%,而稻田土壤仅有0.2%,为中等以上淋失风险.因此,控制旱地(尤其是菜地)磷肥的投入是降低亚热带丘陵小流域土壤P淋失风险和减轻农业面源污染的关键.     

污泥龄对低氧丝状菌活性污泥微膨胀系统的影响

为了研究污泥龄(SRT)对低氧丝状菌活性污泥微膨胀系统的影响,采用序批式间歇反应器(SBR)进行试验,分别按照厌氧/好氧和单级好氧的方式运行,考察了不同SRT下丝状菌污泥微膨胀系统的沉降性、脱氮除磷过程以及污泥特性的变化.结果表明,在好氧水力停留时间充分的条件下,低氧环境不但不会影响丝状菌微膨胀污泥的硝化进程,而且还有助于同步硝化反硝化(SND)、单级好氧除磷的发生.厌氧/好氧运行时,SRT与活性污泥的比硝化速率、比释磷速率和比吸磷速率成反比,与SND率和污泥的含磷量成正比.单级好氧运行时,减小SRT对硝化过程影响不大,但是有助于改善除磷效果.活性污泥的比耗氧速率(SOUR)、胞外聚合物(EPS)中多糖与蛋白质含量的比值、以及粘度都与SRT成反比.适当地减小SRT可以改善丝状菌微膨胀污泥的沉降性.厌氧/好氧运行时,厌氧段微氧环境易引发过度丝状菌污泥膨胀;单级好氧运行时,SRT过低会造成污泥黏性骤增而引发黏性污泥膨胀.