加压上流式好氧污泥床(PUASB)法处理制药废水初探

在进水ＣＯＤ为５００－６００ｍｇ／Ｌ、压力ｐ＝０．２ＭＰａ、回／流比Ｒ＝６条件下,加压上流式好氧泥泥床平均ＣＯＤ去除率为７１％,出水基本达到国家排放标准;进水ＣＯＤ为１０００ｍｇ／Ｌ以上,在ｐ＝０．３ＭＰａ、Ｒ＝６条件下,ＣＯＤ去除率仍可达到７０％左右。     

我国典型钢铁行业主要工艺环节排放颗粒物源成分谱特征

鉴于我国钢铁行业排放颗粒物源成分谱数量不足,有待更新的现状,致力于服务精细化颗粒物源解析的需求,采用稀释通道系统对武汉市某钢铁公司的3个主要工艺环节(烧结、炼钢、炼铁)排放源进行了采样.构建了3类PM_(2.5)源成分谱及3类PM_(10)成分谱,对源谱主要化学组分特征进行了研究,并与国内其他区域已有的钢铁行业源谱研究进行了对比.结果表明:(1)烧结工艺源成分谱中,SO_4~(2-)、Al和NH_4~+等含量高,PM_(2.5)源谱中质量分数依次为22. 2%、4. 5%和3. 5%,PM_(10)源谱中依次为36. 0%、5. 2%和2. 7%,炼铁工艺Fe元素含量最高,在PM_(2.5)源谱和PM_(10)源谱中分别达到28. 3%和24. 5%,炼钢工艺源谱Ca、Fe元素等为主要组分;(2)元素组分中,烧结工艺S元素含量最高,地壳元素在PM_(10)源谱中含量更高,炼铁工艺Pb、Cr等重金属含量偏高,炼钢工艺Cr富集;(3)源谱之间分歧系数的计算显示,同类工艺粗细粒径源谱相似性偏高,烧结工艺与其他两类工艺源谱之间差异性较高,炼钢工艺与炼铁工艺差异性较低.同国内其他区域研究源谱相比,发现Fe、Si和Ca等为钢铁行业排放颗粒物中标识性组分,而碳组分和SO_4~(2-)等组分特征随生产方式、除污设备等不同表现出不同特征.     

反硝化颗粒污泥在纳米零价铁胁迫下的性能恢复

为探明纳米零价铁(nZVI)对反硝化颗粒污泥(DGS)潜在的胁迫效应,本研究通过连续多批次实验,考察了经历n ZVI短期冲击后,DGS反硝化活性在不同C/N比条件下的恢复情况.结果表明,当nZVI投加量高于5 mg·L~(-1)时,DGS比反硝化速率(μ)会出现下降,对应的比反硝化抑制率(IR)与基质C/N比、nZVI投加量呈现正相关.当nZVI投加量达到100 mg·L~(-1)时,胞外蛋白与多糖含量均明显降低.此时,充足的外加碳源(C/N≥4)将有助于促进DGS反硝化活性的恢复和减少去除单位硝态氮所消耗的COD值.由Freundlich和Langmuir吸附等温线的拟合结果可知,基质C/N比越高,DGS对n ZVI的吸附能力就越强.在恢复期内,泥相中总铁含量(Qe)的持续削减为高C/N比条件下,DGS反硝化活性的提升创造了有利条件.当Qe降至0.4 mg·g~(-1)以下时,μ值可达到或接近对照组的水平.     

Emissions of SO2, NO and N2O in a circulating fluidized bed combustor during co-firing coal and biomass

This paper presents the experimental investigations of the emissions of SO2, NO and N2O in a bench scale circulating fluidized bed combustor for coal combustion and co-firing coal and biomass. The thermal capacity of the combustor is 30 kW. The setup is electrically heated during startup. The influence of the excess air, the degree of the air staging, the biomass share and the feeding position of the fuels on the emissions of SO2, NO and N2O were studied. The results showed that an increase in the biomass shares resulted in an increase of the CO concentration in the flue gas, probably due to the high volatile content of the biomass. In co-firing, the emission of SO2 increased with increasing biomass share slightly, however, non-linear increase relationship between SO2 emission and fuel sulfur content was observed. Air staging significantly decreased the NO emission without raising the SO2 level. Although the change of the fuel feeding position from riser to downer resulted in a decrease in the NO emission level, no obvious change was observed for the SO2 level. Taking the coal feeding position R as a reference, the relative NO emission could significantly decrease during co-firing coal and biomass when feeding fuel at position D and keeping the first stage stoichiometry greater than 0.95. The possible mechanisms of the sulfur and nitrogen chemistry at these conditions were discussed and the ways of simultaneous reduction of SO2, NO and N2O were proposed.     

Turbosorp湍流吸收循环流化床烟气脱硫技术在改造工程中的应用

循环流化床半干法烟气脱硫技术是目前世界上主流脱硫工艺技术之一,主要适用于大中型燃煤电厂的烟气脱硫,在国内外拥有大量成功运行的工程案例。本文章基于本公司实践论述Turbosorp湍流吸收循环流化床脱硫技术的技术特点、关键工艺控制要点以及在机组改造工程中的技术优势,为同类型机组改造工程中的方案选择提供参考。     

三江平原水田灌溉-排水过程中铁形态变化及输出贡献

采集三江平原农田灌溉地下水、稻田积水、渠系排水、土壤侧渗水,并采用切向超滤技术分离水体中不同形态铁,分析在灌溉排水及地下侧渗水中铁的迁移特征,并估算水田排水中铁的输出贡献.结果表明,在灌溉排水过程中,铁主要以低分子量形态和酸性不稳定形态迁移,地下水中Fe2+含量占可溶态铁的80.45%;地下水抽取到稻田后Fe2+含量显著降低,络合态铁含量升高,稻田积水中络合态铁占可溶态铁的75.50%;稻田积水排入渠系后,络合态铁中不稳定弱配位铁含量降低13.58%,其他铁形态变化不大.稻田积水通过地下侧渗进入渠系,随侧渗水体深度加深,Fe2+含量升高,络合态和胶体态铁含量降低,地下侧渗水向渠系水主要提供络合态和胶体态铁.三江平原湿地水田化改变了水体中铁的输出形态,同时,排水过程中铁的输出也对河流形成补给,水田灌溉排水过程可溶态铁的输出通量约为390kg.a-.1km-2,输出系数为0.186,灌溉-排水过程中残留在稻田土壤中铁的量约为1460kg.a-.1km-2,残留在排水渠系土壤中铁的量约为250kg.a-.1km-2,这对三江平原水土环境产生了深远影响.     

Enhanced struvite recovery from wastewater using a novel cone-inserted fluidized bed reactor

The feasibility of struvite recovery at low （12.5 mg/L） and high （120 mg[L） phosphorus concentrations was studied by constructing a novel fluidized bed reactor with cones （FBRwc） and without cones （FBRwoc）. The crystallization process was continuously operated for 133 days under different hydraulic retention times （HRT = 1-10 hr）, pH （7.5-10）, and molar ratios of Mg/P （0.75-1.75）, N/P （1-10） and Ca/Mg （0-2）. The optimum operating conditions of HRT, pH, Mg/P and N/P molar ratios were found to be 2 hr, 9, 1.25, and 7.5, respectively. Under these optimum conditions, the phosphorus precipitation efficiencies of FBRwc were 93% for low and 98% for high phosphorus influent; however, the efficiencies were 78% and 81% for FBRwoc, respectively. Due to crystal losses at each junction （17%-31%）, the crystal recovery efficiency of FBRwoc was relatively low （47%-65%） for both influent concentrations. However, the losses were minimal in FBRwc, which showed 75% and 92% crystal recovery for low and high phosphorus concentrations, respectively. At low calcium concentration, crystal chemical analysis showed the product to be pure struvite （〉 99%）. The scanning electron microscope and X-ray diffraction results further confirmed that the crystal recovered from FBRwc contained pure struvite, which could be considered a high quality fertilizer. Except HRT, all parameters （pH, Mg/P, N/P and Ca/Mg） were found to be influencing factors for FBRwc performance. Overall, inserting cones in each part of the reactor played a significant role in enhancing struvite recovery from a wide range of phosphorus-containing wastewater.     

树脂基纳米零价铁复合材料的制备及其去除重金属铅Pb(Ⅱ)的性能研究

凭借着优越的还原活性,纳米零价铁在环境污染治理和修复领域应用广泛。通过将纳米零价铁(n ZVI)颗粒负载到大孔阴离子和阳离子交换树脂上,成功制备出2种树脂基纳米零价铁复合材料。研究了2种复合材料及其载体对水溶液中Pb(Ⅱ)的去除性能,考察了不同载体功能基团对复合材料去除Pb(Ⅱ)性能的影响。结果表明:以大孔阴离子交换树脂为载体的D001-Fe0复合材料因具有离子交换和化学还原双重作用,对Pb(Ⅱ)的去除效率高、速率快。     

基于过程改变法的铁厂节水调控优化研究

将过程改变法应用到铁厂用水系统改造中,对其用水网络进行调优,实现废水排放量最小化。在厂区用水情况调查基础上,确定用水系统范围及限制杂质;并计算所确定用水系统的最小新鲜水用量和最小废水排放量;最后对其用水网络进行优化设计。改造后的铁厂用水网络新鲜水用量节约57.7%,废水排放量减少75.9%。     

AMD铁絮体改性生物炭对重金属吸附机理研究 ——以Pb(II)为例

以酸性矿山废水生成的铁絮体和秸秆生物炭为原料,采用化学改性和紫外辐射联用技术制备改性生物炭,并通过正交试验确定最佳改性条件,同时利用FTIR、SEM和BET等方法对吸附材料的形貌特征、孔隙结构及其表面化学性质进行表征.结果表明,通过改性使吸附材料比表面积增大,吸附位点增多,在25℃、pH为7时,吸附材料改性后比表面积为295.71 m²·g^-1,对Pb（II）的拟合吸附量可达278 mg·g^-1.改性材料对Pb（II）的吸附过程符合Langmuir吸附等温线模型和准二级动力学模型,主要为单分子层吸附,受化学吸附控制.