上海浦东国际机场飞机尾气排放对机场附近空气质量的影响

统计2012年10月和11月浦东机场飞机机型和航班架次,根据各类飞机起降的污染物排放设计工作参数,估算出2012年浦东机场飞机起降时排放的NO2、SO2、CO和HC的估算值。利用浦东新区13个空气监测子站二氧化氮和二氧化硫数据绘制等值线图。结果显示,机场所在的江镇点位和祝桥点位二氧化氮浓度变化受飞机影响很大,而飞机排放的二氧化硫对两个点位的影响可以忽略不计。建议采用改进飞机滑行路线、探讨征收飞机碳排放税等措施减少飞机尾气排放对空气质量的影响。     

Packed in-tube solid phase microextraction with graphene oxide supported on aminopropyl silica: Determination of target triazines in water samples

On-line in-tube solid phase microextraction (in-tube SPME) coupled to high performance liquid chromatography and tandem mass spectrometry (HPLC-MS/MS) was successfully applied to the determination of selected triazines in water samples. The method based on the employment of a packed column containing graphene oxide (GO) supported on aminopropyl silica (Si) showed that the extraction phase has a high potential for triazines extraction aiming to its physical-chemical properties including ultrahigh specific surface area, good mechanical and thermal stability and high fracture strength. Injection volume and loading time were both investigated and optimized. The method validation using Si-GO to extract and concentrate the analytes showed satisfactory results, good sensitivity, good linearity (0.2–4.0 µg L^?1) and low detection limits (1.1–2.9 ng L^?1). The high extraction efficiency was determined with enrichment factors ranging from 1.2–2.9 for the lowest level, 1.3–4.9 intermediate level and 1.2–3.0 highest level (n = 3). Although the analytes were not detected in the real samples evaluated, the method has demonstrated to be efficient through its application in the analysis of spiked triazines in ground and mineral water samples.     

钙钛矿型催化剂催化湿式氧化处理煤气化废水纳滤浓缩液

采用溶胶-凝胶法制备了Mn掺杂钙钛矿型催化剂LaFexMn1-xO3,并以其为催化剂催化湿式双氧水氧化处理煤气化废水纳滤浓缩液。采用XRD,SEM,FTIR技术对催化剂进行了表征。表征结果显示：制备的催化剂均具有标准的钙钛矿型结构,其中,LaFe0.9Mn0.1O3的结构稳定,比表面积大。实验结果表明：制备的催化剂中LaFe0.9Mn0.1O3的催化活性最高,且稳定性好,连续使用5次后催化活性未见明显减弱;在H2O2投加量3.0 g/L、n（H2O2）∶n（LaFe0.9Mn0.1O3）=12∶1、反应温度160 ℃、反应压力1 MPa、浓缩液pH 3、反应时间60 min的最优条件下,COD、UV254和TOC的去除率分别达到80.9%、95.2%和68.0%,BOD5/COD由0.02提升至0.40,可生化性大幅提高。     

聚氯化铝/聚丙烯酰胺复合絮凝剂处理染料废水的研究

研究了聚氯化铝-Fe_3O_4-聚丙烯酰胺复合絮凝剂对硫化黑染料废水的去除效果。研究结果表明,该复合絮凝剂对硫化黑染料废水具有较好的絮凝效果,在絮凝剂投加量为20 mg/L、废水pH值为8.0的条件下,该复合絮凝剂对硫化黑染料废水的浊度、色度、COD的去除率分别为95.59%,97.67%,85.55%。     

Proposing of new building scheme and composite towards global warming mitigation for Malaysia

The building sector has been regarded as a potential sector where there is large capacity to reduce the climate change effect. This study has proposed solutions to mitigate environmental impacts and achieve low CO₂ emission from residential sector. Therefore, full life cycle assessment (LCA) has been run to assess the CO₂ emission and its effect on the atmosphere and climate change. Based on the result, timber scheme is the best choice due to releasing less CO₂ emissions to the atmosphere. However, house builders in Malaysia have almost completely neglected timber as a building material, with timber use as building components reduced to 5%. In this study, LCA Software was used to assess CO₂ emissions from different wall construction. The alternative building scheme has been made by reinforce steel stud, wooden beam and timber wall (S8) to improve the scheme deficiency while releasing less CO₂ emissions compared to other schemes. Therefore, S8 has a decreased CO₂ effect by 85% less than precast concrete frame and 90% less than brick over their lifetime. (S8) increased the load bearing compared to conventional timber beam. Thus, new scheme S8 could be replaced by current scheme and promote more adjustable scheme for Malaysian housing.     

粉煤灰基层状金属氧化物对水中活性红X-3B的吸附

以粉煤灰(FA)为原料,采用共沉淀法制备了层状双金属氢氧化物(LDH)和层状金属氧化物(LMO,也称LDO),并采用XRD和BET技术进行了表征。比较了FA、LDH、LMO对活性红X-3B染料(X-3B)的吸附效果;考察了LMO吸附X-3B的影响因素,并探讨了吸附机理。XRD表征结果表明,LMO在吸附X-3B后重新恢复LDH层状结构。BET表征结果表明,LMO的比表面积大于LDH。吸附实验结果表明,3种吸附剂对X-3B吸附效果的优劣顺序为:LMOLDHFA;在初始X-3B质量浓度为50 mg/L、LMO投加量为2.0 g/L、吸附温度为25℃、吸附pH为7、吸附时间为30 min的条件下,X-3B去除率可达98.1%;LMO对X-3B的吸附符合Langmuir等温吸附方程,饱和吸附量为129.53 mg/g,且吸附过程可用准二级动力学方程描述。     

金属冶炼进口物料的固体废物鉴别方法

建立了金属冶炼进口物料的固体废物鉴别方法,并利用该方法对海关查扣的3种金属冶炼进口物料进行了固体废物鉴别。鉴别结果显示:物料1、2和3的自然属性分别为砷含量超标铜精矿、锰阳极泥、回转窑氧化锌,产生来源分别为有害物质超标的产品、污染控制设施产生的物质、有意识加工的目标产物;物料1和2属于我国禁止进口的固体废物,物料3不属于固体废物。本文建立的固体废物鉴别方法可行,可为金属冶炼进口物料的固体废物鉴别和监管提供参考。     

PbO_2复合电极预处理甲苯二胺废水

通过涂覆—热分解法与电沉积法制备了β-PbO_2/α-PbO_2/SnO_2-Sb2O3/Ti复合电极(PbO_2复合电极),采用X射线衍射(XRD)、扫描电子显微镜(SEM)、循环伏安法(CV)、线性极化法(LSV)和加速寿命试验对电极进行表征。将PbO_2复合电极用于处理甲苯二胺(TDA)废水,考察了电解质浓度、电流密度对TDA降解效果的影响。实验结果表明:α-PbO_2呈梭状,β-PbO_2呈花菜状,多层结构的PbO_2电极利于提高电极的稳定性和活性;PbO_2复合电极的析氧电位(1.9 V)明显高于TDA的氧化电位(1.28 V),其使用寿命长达486 d;在电流密度为60 m A/cm2、Na2SO4质量浓度为10 g/L、电解时间为240 min的条件下,对COD为4 791.74 mg/L、TDA质量浓度为486.4mg/L的废水进行处理,TDA去除率高达97.3%,COD去除率可达88.1%。     

一种包埋微生物复合填料的制备及性能评价

采用包埋法制备出一种复合生物填料,测其各项理化性质,并以NO。模拟废气验证其脱硝性能。填料主要由碳酸钙、牛粪堆肥腐殖质、菌剂载体、水泥、轻质珍珠岩、立体网状纤维及脱硝功能微生物等复合而成,粒径书12mm×20mm,自然堆积密度（471±0．8）kg／m2,持水量（49±1．3）％,比表面积3．91m2／g,平均机械强度（427．3±0．2）N,pH为10．5-0．2。填料能长期在潮湿环境中保持良好的粘结强度,并具有营养缓释及pH缓冲能力。包埋脱硝功能微生物复合填料中初期微生物数量5．3×10^5 CFU／g,运行60d后微生物数量达到8．6×10 8 CFU／g,闲置停运30d微生物有所减少,但重启后净化效率基本不变。当进气负荷低于I878mg／（13m3·h）,气体停留时间为14．47s时,BF,的去除率高达93．15％。     

铁氧化物复合氧化铝催化臭氧化过程中溴酸盐的生成控制

以市售活性炭、硅藻土和氧化铝小球为载体,考察了负载铁基活性组分对催化臭氧化过程中溴酸盐的控制情况,其中,铁基复合氧化铝小球体现出更好的溴酸盐还原特性和催化剂稳定性,证实催化剂中铁氧化物是溴酸盐得到有效控制的主要活性组分。进一步考察了铁基复合氧化铝小球催化臭氧化处理实际原水过程中对溴酸盐的生成控制,以及反应过程中溶解性有机碳（DOC）的去除情况。结果表明,与单独臭氧化相比,该催化剂既能有效去除水中的溶解性有机物,又能明显抑制溴酸盐的生成,反应50h,其活性并没有明显下降。催化剂失活主要归因于吸附位点数量的下降,可以通过负载铁氧化物来实现催化剂的再生。