挥发性氯代烃在干燥土壤中的平衡吸附研究

吸附是挥发性氯代烃（volatile chlorinated hydrocarbons,VCHs）污染土壤的主要机制之一.采集长三角地区3类典型水稻土,用静态平衡吸附实验进行干燥土壤对6种VCHs的平衡吸附研究.结果表明,干燥土壤的平衡吸附等温线难以用Langmuir方程和BET方程描述,但用Dubinin-Astak...     

Sorption of 2,4-dinitroanisole (DNAN) on lignin

The present study describes the use of two commercially available lignins, namely, alkali and organosolv lignin, for the removal of 2,4-dinitroanisole (DNAN), a chemical widely used by the military and the dye industry, from water. Sorption of DNAN on both lignins reached equilibrium within 10 hr and followed pseudo second-order kinetics with sorption being faster with alkali than with organosolv lignin, i.e. k₂ 10.3 and 0.3 g/(mg hr), respectively. In a separate study we investigated sorption of DNAN between 10 and 40°C and found that the removal of DNAN by organosolv lignin increased from 0.8 to 7.5 mg/g but reduced slightly from 8.5 to 7.6 mg/g in the case of alkali lignin. Sorption isotherms for either alkali or organosolv lignin best fitted Freundlich equation with enthalpy of formation, ΔH⁰ equaled to 14 or 80 kJ/mol. To help understand DNAN sorption mechanisms we characterized the two lignins by elemental analysis, BET nitrogen adsorption-desorption and ³¹P NMR. Variations in elemental compositions between the two lignins indicated that alkali lignin should have more sites (O- and S-containing functionalities) for H-bonding. The BET surface area and calculated total pore volume of alkali lignin were almost 10 times greater than that of organosolv lignin suggesting that alkali lignin should provide more sites for sorption. ³¹P NMR showed that organosolv lignin contains more phenolic -OH groups than alkali lignin, i.e., 70% and 45%, respectively. The variations in the type of OH groups between the two lignins might have affected the strength of H-bonding between DNAN and the type of lignin used.     

CTMAB/CPAM复合改性膨润土吸附水中苯酚和硝基苯

用十六烷基三甲基溴化铵(CTMAB)和阳离子型聚丙烯酰胺(CPAM)改性膨润土,制得系列CTMAB-膨润土(C-Bt)、CPAM-膨润土(P-Bt)和复合改性膨润土(C/P-Bt).采用XRD分析了各类有机膨润土的底面间距,并比较了它们吸附水中苯酚和硝基苯的性能.结果显示,C/P-Bt的底面间距大于相应的C-Bt和P-Bt,表明CTMAB与CPAM能同时层插到膨润土层间.C/P-Bt吸附性能优于C-Bt及C-Bt加P-Bt,在相同平衡浓度下(苯酚为7 045 mg/L,硝基苯为409 mg/L),60C/4%P-Bt对苯酚和硝基苯的吸附量分别为150 mg/g和69 mg/g,吸附量比60C-Bt分别提高了26%和28%,比60C-Bt加4%P-Bt分别提高了22%和26%,表现出明显协同吸附效应.这说明CTMAB在C/P-Bt层间的排列模式受CPAM的影响,形成了对有机物亲和能力更强的吸附介质.该新型有机膨润土在有机污染控制中有良好的应用前景.     

Evaluation of the adsorption potential of titanium dioxide nanoparticles for arsenic removal

The adsorption potential of titanium dioxide (TiO2) nanoparticles for removing arsenic from drinking water was evaluated. Pure and iron-doped TiO2 particles are synthesized via sol-gel method. The synthesized TiO2 nanoparticles were then immobilized on ordinary sand for adsorption studies. Adsorption isotherms were conducted on the synthesized nanoparticles as well as the sand coated with TiO2 nanoparticles under varying conditions of air and light, namely, the air-sunlight (A-SL), air-light (AL), air-dark (AD) and nitrogen-dark (ND). X-Ray diffraction (XRD) analysis showed that the pure and the iron-doped TiO2 nanoparticles were in 100% anatase crystalline phase with crystal sizes of 108 and 65 nm, respectively.Adsorption of arsenic on the three adsorbents was non-linear that could be described by the Freundlich and Langmuir adsorption models. Iron doping enhanced the adsorption capacity of TiO2 nanoparticle by arresting its grain growth and making it visible light responsive resulting in a higher affinity for arsenic. Similarly, the arsenic removal by adsorption on the sand coated with TiO2 nanoparticles was the highest among the three types of sand used. In all cases, As(V) adsorbed more compared with As(III). Solution pH appeared to be the most important factor in controlling the amount of arsenic adsorbed.     

环境中生物氧化锰的形成机制及其与重金属离子的相互作用

微生物参与形成的锰氧化物是环境中一种高活性的锰氧化物.研究表明,锰氧化菌主要通过分泌多铜氧化酶来氧化Mn(Ⅱ)而形成锰氧化物.微生物形成锰氧化物过程的主要初级产物是与δ-MnO₂或与酸性钠水锰矿类似的层状锰酸盐.生物氧化锰是环境中重要的吸附剂、氧化剂和催化剂.通过吸附、氧化作用,生物氧化锰影响着重金属离子在环境中的迁移转化,在重金属元素生物地球化学循环中起重要作用.研究锰氧化物的生物形成过程、生物氧化锰的结构特征及其与重金属离子之间的相互作用,对于了解生物氧化锰在重金属元素生物地球化学循环过程中的作用以及在重金属污染修复中的应用有着重要意义.本文综述了环境中生物氧化锰的形成机制、性质、结构特点及其吸附、氧化重金属离子的机制.     

Contribution of black carbon to nonlinearity of sorption and desorption of acetochlor on sediment

In order to investigate the contribution of various black carbon (BC) contents to nonlinearity of sorption and desorption isotherms for acetochlor on sediment, equilibrium sorption and desorption isotherms were determined to measure sorption and desorption of acetochlor in sediment amended with various amounts of BC. In this paper, two types of BC referred to as BC400 and BC500 were prepared at 400°C and 500°C, respectively. Higher preparation temperature facilitated the formation of micropores on BC to enhance its sorption capacity. Increase of the BC content obviously increased the sorption amount and reduced the desorption amount for acetochlor. When the BC500 contents in total organic carbon (TOC) increased from 0 to 60%, Freundlich sorption coefficient (K _f) increased from 4.07 to 35.74, and desorption hysteresis became gradually obvious.When the content of BC in TOC was lower than 23%, the sorption isotherm had a significant linear correlation (p = 50.05). In case of desorption, a significant nonlinear change could be observed when the content of BC was up to 13%. Increase of BC content in the sediment would result in shifting the sorption-desorption isotherms from linearity to nonlinearity, which indicated that contribution of BC to nonlinear adsorption fraction became gradually remarkable.     

耐盐鲁氏酵母(Zygsoaccharomyces rouxii)CICC1379吸附水中重金属Cu~(2+)研究

为了研究耐盐鲁氏酵母(Zygosaccharomyces rouxii)CICC1379细胞冻干粉对重金属Cu2+的吸附作用及机理,对影响该酵母脱除水中Cu2+的主要因素(温度、初始pH和吸附时间等)进行了探讨,并对Cu2+的吸附动力学和吸附模型进行了研究.结果表明,温度(25～40℃)对耐盐鲁氏酵母粉吸附Cu2+的影响不大;初始pH(2～7)对Cu2+脱除率影响较大,最适pH值在4～6之间,而pH=2时的吸附效果较差.经耐盐鲁氏酵母处理后,溶液pH发生了变化,基本维持在4.00～6.99之间,且均趋向于相同质量氯化铜溶于水后的自然pH值(5.2).耐盐鲁氏酵母粉在5min内对Cu2+的吸附量可达到其最大吸附量的89.2%,30min可达到吸附平衡,其吸附动力学适合采用准二级动力学方程描述.与Langmuir方程相比,耐盐鲁氏酵母对Cu2+的吸附过程更适合采用Freundlich方程描述.     

Sequestration of toxic Pb(Ⅱ) ions by chemically treated rubber(Hevea brasiliensis) leaf powder

Rubber leaf powder(an agricultural waste) was treated with potassium permanganate followed by sodium carbonate and its performance in the removal of Pb(Ⅱ) ions from aqueous solution was evaluated.The interactions between Pb(Ⅱ) ions and functional groups on the adsorbent surface were confirmed by Fourier transform infrared(FT-IR) spectroscopy,scanning electron microscopy(SEM) coupled with X-ray energy dispersive spectroscopy(EDX).The effects of several important parameters which can affect adsorption capacity such as pH,adsorbent dosage,initial lead concentration and contact time were studied.The optimum pH range for lead adsorption was 4-5.Even at very low adsorbent dosage of 0.02 g,almost 100% of Pb(Ⅱ) ions(23 mg/L) could be removed.The adsorption capacity was also dependent on lead concentration and contact time,and relatively a short period of time(60-90 min) was required to reach equilibrium.The equilibrium data were analyzed with Langmuir,Freundlich and Dubinin-Radushkevich isotherms.Based on Langmuir model,the maximum adsorption capacity of lead was 95.3 mg/g.Three kinetic models including pseudo first-order,pseudo second-order and Boyd were used to analyze the lead adsorption process,and the results showed that the pseudo second-order fitted well with correlation coefficients greater than 0.99.     

Sorption of heterocyclic compounds from a complex mixture of coal-tar compounds on natural clayey till

The sorption and desorption of heterocyclic organic compounds in a complex multisolute system to a natural clayey till was investigated. The composition of the solutes reflect a simplified composition of an aqueous phase in contact with coal tar. Sorption was studied for two ratios (s:l) of clayey till (solid) to aqueous phase (liquid). The effect of the complex mixture of solutes on sorption of the four heterocyclic compounds: benzofuran, dibenzofuran, benzothiophene, and dibenzothiophene is evaluated by comparison with their sorption measured in single-solute systems. Sorption of the four compounds is affected by the complex mixture, with sorption decreases for all four compounds at high s:l ratio indicating competitive sorption. The effect on sorption of the individual compounds is not related to solubility or hydrophobicity of the compounds. Freundlich-type isotherms are observed for all compounds in the high s:l-ratio experiments, but for the most hydrophobic compounds isotherms are close to linear. The sorption of N-compounds and benzofuran is apparently influenced by cation exchange and dipole–dipole attraction to clay minerals. At high concentrations a dramatic increase in the sorption of the most strongly sorbing compounds is observed in the low s:l-ratio experiment. The dramatic increase in sorption appears to be a result of multimolecular layer sorption or condensation on surfaces in the clayey till at high surface density of organic compounds, and the data are fitted by BET (Brunauer, Emmet, and Teller) type 2 isotherms. The increase may or may not be induced by the presence of N-heterocyclic compounds sorbed by cation exchange and dipole–dipole attraction. The desorption of the compounds was studied for the low s:l ratio where multimolecular layer formation apparently had occurred. Partially irreversible sorption, hysteric Langmuir type desorption with isotherms of very high K_l coefficient, or behaviour reflecting dissolution of a condensed phase is observed.     

强化一级处理污泥的吸附性能研究

强化一级处理污泥对以ＣＯＤ和ＳＣＯＤ表示的有机物质具有较大的吸附量。其吸附等温线和解吸等温线既符合Ｆｒｅｕｎｄｌｉｃｈ型,也符合Ｌａｎｇｍｕｉｒ型,但解吸不完全。