4种人工湿地基质对马拉硫磷的吸附特性

通过基质对马拉硫磷的等温吸附和吸附动力学实验,研究天然土壤、煤渣、沸石、砾石对马拉硫磷的吸附特性,为人工湿地处理含马拉硫磷废水提供理论依据.结果表明:马拉硫磷浓度为2.25 ～ 90 mg/L条件下,Langmuir和Freundlich方程均能较好地拟合4种基质对马拉硫磷的等温吸附过程,并且Freundlich方程的拟合效果要好于Langmuir方程.马拉硫磷的理论饱和吸附量大小依次为天然土壤(9.9304 mg/g)＞煤渣(1.6173 mg/g)＞沸石(0.6039 mg/g)＞砾石(0.3965 mg/g).4种基质对马拉硫磷的缓冲能力大小依次为天然土壤＞煤渣＞沸石＞砾石,即当进水马拉硫磷浓度波动较大时,作为湿地基质天然土壤使人工湿地系统维持稳定出水水质的能力最强.马拉硫磷浓度为4.5 mg/L条件下,吸附动力学模型Elovich方程能较好地拟合4种基质对马拉硫磷的吸附动力学特征,说明4种基质对马拉硫磷的吸附是表面吸附和内部扩散吸附共同作用的结果.因此,天然土壤和煤渣适宜作为处理含马拉硫磷废水的人工湿地基质.     

水泥窑协同处置过程中Pb、Cd的挥发特性

对铅、镉2种重金属的氧化物开展了热重实验、熟料煅烧以及熟料消解实验,以重金属的挥发率为主要指标,研究了水泥窑协同处置过程中铅、镉在等温条件下随时间的挥发特性。结果表明,2种重金属的挥发率均是随温度的升高,时间的增加而增大。Pb的挥发率为96%,Cd的挥发率达到98%,根据等温动力学及阿累尼乌斯方程,对Pb,Cd的挥发率随时间变化的规律进行动力学模拟,得到较好的线性拟合效果,其中,Pb挥发反应的表观活化能E为88.73 kJ/mol,Cd挥发反应可以分2个部分：1 200℃以下的表观活化能E为61 kJ/mol;1 250℃以上的表观活化能E为184.6 kJ/mol。     

HAN阻隔防爆模型研究

通过合理简化,利用多方气体状态方程,分别建立油品储运容器内可燃混合气体定容爆炸模型和装设阻隔防爆材料的油品储运容器内可燃混合气体爆炸模型,获得了阻隔防爆性能测试装置的燃爆容器抗爆设计限值,以及其在HAN阻隔防爆测试中燃爆容器试爆压力量级的控制下限值,同时,还给出HAN工程应用中容器留空率的计算方法,具有实际指导意义。     

Vertical migration of radionuclides in undisturbed grassland soils

Literature data on numerical values obtained for the parameters of the two most popular models for simulating the migration of radionuclides in undisturbed soils have been compiled and evaluated statistically. Due to restrictions on the applicability of compartmental models, the convection–dispersion equation and its parameter values should be preferred. For radiocaesium, recommended values are derived for its effective convection velocity and dispersion coefficient. Data deficiencies still exist for radionuclides other than caesium and for soils of non-temperate environments.     

HYDROLOGIC MODELING OF A BIOINFILTRATION BEST MANAGEMENT PRACTICE1

ABSTRACT: The goal of this research was to develop a methodology for modeling a bioinfiltration best management practice (BMP) built in a dormitory area on the campus of Villanova University in Pennsylvania. The objectives were to quantify the behavior of the BMP through the different seasons and rainfall events; better understand the physical processes governing the system's behavior; and develop design criteria. The BMP was constructed in 2001 by excavating within an existing traffic island, backfilling with a sand/soil mixture, and planting with salt tolerant grasses and shrubs native to the Atlantic shore. It receives runoff from the asphalt (0.26 hectare) and turf (0.27 hectare) surfaces of the watershed. Monitoring supported by the hydrologic model shows that the facility infiltrates a significant fraction of the annual precipitation, substantially reducing the delivery of nonpoint source pollution and erosive surges downstream. A hydrologic model was developed using HEC‐HMS to represent the site and the BMP using Green‐Ampt and kinematic wave methods. Instruments allow comparison of the modeled and measured water budget parameters. The model, incorporating seasonally variable parameters, predicts the volumes infiltrated and bypassed by the BMP, confirming the applicability of the selected methods for the analysis of bioinfiltration BMPs.     

SEDIMENT ROUTING FOR AGRICULTURAL WATERSHEDS1

ABSTRACT: A sediment routing technique was developed to route sediment yield from small watersheds through streams and valleys to the outlet of large watersheds. The technique is based on the modified universal sol loss equation and a first order decay function of travel time and particle size. Deposition is dependent upon settling velocities of sediment particles, travel time, and the amount of sediment in suspension. Sediment routing increases sediment yield prediction accuracy and allows determination of subwatershed contributions to the total sediment yield. Also, the locations and amounts of floodplain scour and deposition can be predicted. Another advantage of sediment routing is that measured sediment yield data are not required. The procedure performed satisfactorily in test routings on two Texas blackland watersheds Sediment routing will be useful in flood control evaluation, reservoir and channel design, water quality calculations, environmental impact assessment, and land-use planning.     

COMPARISON OF METHODS TO ESTIMATE DEEP PERCOLATION RATES1

ABSTRACT: Deep percolation rates are normally estimated from a water balance. Results are presented of a study undertaken to evaluate three alternative methods of estimating percolation below the root zone when knowledge about the history of applied water and evapotranspiration are not available. The alternative methods are: 1) use of Darcy's equation to calculate deep percolation rate; 2) measurement of the soil temperature prof and calculation of the deep percolation rate from the shape of the temperature depth curve; and 3) measurement of the tritium concentration in the soil water and its relationship to the history of the tritium concentration in rainfall. At the principal study site, the Darcy velocity of flow ranged from 9 cm per year determined by the temperature method, to 40 cm per year determined by the tritium method. Darcy's equation to calculate seepage rates resulted in an estimation of deep seepage of 18 cm per year. An average deep percolation rate at the principal study site of 22 cm per year was determined using the average of all three methods. Results for other sites based on the temperature method indicated a lower seepage rate.     

Sorption of chlorpyrifos and fonofos on four soils and turfgrass thatch using membrane filters

Abstract

Chemical transport in soil is a major factor influencing soil and water contamination. Four soils and turfgrass thatch, representing a wide range of organic carbon OC content were studied to determine sorption K_d and K_f parameters for the insecticides chlorpyrifos and fonofos. The batch equilibrium method was used. The concentration of insecticide was measured in the solution as well as in the solid phase to determine the most accurate sorption data. Four soils and thatch were equilibrated for 24 h at 22 ± 1^OC with aqueous insecticide solutions. Four concentrations of the insecticides, each <50% of their respective water solubilities, were selected for the experiments. After extraction with an organic solvent, the concentration of insecticides in the aqueous solution was determined by gas liquid chromatography using electron capture detection for chlorpyrifos, and nitrogen/phosphorus detection for fonofos. Data obtained were fitted to the log and simple linear form of the Freundlich equation. Mass balance Freundlich isotherm exponents n ranged between 0.82 and 0.93 for chlorpyrifos. 0.82 and 1.21 for fonofos, with r² ≥ 0.97. K_oc (percent of organic carbon %OC normalized Sorption coefficient) values were calculated by using experimentally developed K_d and K_f coefficients in relation to OC levels from 0.29 to 34.85%. K_d and K_f coefficients of both insecticides were positively correlated with OC (r² ≥ 0.96). organic matter OM (r² ≥ 0.96), and cation exchange capacity CEC (r² ≥ 0.90).     

The relationship between light intensity and nutrient uptake kinetics in six freshwater diatoms

In order to find effective measures to control diatom blooms, a better understanding of the physiological characteristics of nutrient uptake in diatoms is needed. A study of P and Si-uptake kinetics for diatom species from two light regimes was conducted at low (LL), moderate (ML) and high light intensities (HL) (2, 25 and 80 μmol photons/(m²·sec)), respectively. The results showed that P uptake of diatoms was heavily influenced by historic light regimes. P affinity changed with growth and photosynthetic activity. The lowest half saturation constant for P uptake (K_m(P)) was under HL for high-light adapted diatoms while the lowest half-saturation constant for low-light adapted diatoms was observed under LL. The Si half-saturation constant (K_m(Si)) increased with increasing light intensities for pennate diatoms but decreased for centric diatoms. Diatom volumes were correlated with the maximum Si uptake rates (V_m(Si)) at HL and K_m(Si) at ML and HL for six diatom species. Our results imply that when we assess the development of diatom blooms we should consider light intensity and cell volume in addition to ambient Si or P concentration. The relationship between light intensity and P-uptake suggests that we can find suitable methods to control diatom blooms on the basis of reducing phytoplankton activity of P-uptake and photosynthesis simultaneously.     

Effect of particle size on CO adsorption and thermodynamic analysis

The liquid nitrogen adsorption method was used to characterize the pore structure of non-cohesive coal in the 061,404 working face of the Lingxin coal mine. The amount of specific surface area of micropores in the sample continuously rose as particle sizes reduced. The volumetric method was used to measure the CO isothermal adsorption curves of three samples (sample I, 0.425–0.25 mm, sample II, 0.18–0.25 mm, and sample III, 0.15–0.18 mm). The experimental results were fitted by the Langmuir model. According to the experimental results, it was conducive to CO adsorption with the conditions of high pressure and low-temperature. The decrease in grain diameter increased the number and volume of micropores in the sample, which improved the adsorption capacity of the sample. In addition, according to the adsorption data, the CO adsorption thermodynamics of three samples were analyzed, including surface potential (Ω), Gibbs free energy change (ΔG) and entropy change (ΔS). The results demonstrated that CO adsorption by coal was a spontaneous process. Sample III has the most substantial adsorption capacity, whereas the sample I has the weakest adsorption capacity.