论我国灾害历史的研究

灾害史的研究是灾害学研究的一个重要领域，本文在列举我国历史灾害资料的基础上，论述了灾害历史研究的必要性。     

孤岛工作面支承压力影响下顶板破坏机理研究

为了探讨孤岛工作面支承压力影响下顶板破坏机理,通过采用理论分析,建立薄板力学模型,对孤岛工作面顶板弯矩分布规律进行分析,并结合实验室数值模拟手段对工作面顶板支承压力集中系数及顶板围岩塑性区演变规律进行研究。研究结果表明:在支承压力作用下,随着推进距离的增大,顶板支承压力集中系数呈现增大的趋势;工作面顶板煤壁中部弯矩显著大于煤壁两侧弯矩,该结果合理解释了工作面方向上支架工作阻力不相等的规律;顶板断裂的塑性区演变特征存在时空效应及力学特征,顶板四周所形成的横向“O”型破断与横向“X”型破断,共同构成了顶板破断的横“O-X”破断形式。     

The effect of positive work reflection during leisure time on affective well‐being: Results from three diary studies

Previous research showed that psychological detachment from work during leisure time is beneficial and that reflecting on negative aspects of work is detrimental for employees' well‐being. However, little is known about the role of positive reflection about work during leisure time. In the present research, we examined the effects of positive work reflection on affective well‐being. Additionally, we tested the effectiveness of an intervention to increase positive work reflection and to improve well‐being with a randomized controlled field experiment. Findings from three diary studies showed that positive work reflection was related to an increase in affective well‐being with regard to both positive and negative moods. The results further indicated that the benefits of positive work reflection were incremental to that of psychological detachment and the absence of negative work reflection. Contrary to our expectation, no evidence was found for the effectiveness of the intervention. Theoretical implications of main findings as well as supplementary findings are further discussed. Copyright © 2015 John Wiley & Sons, Ltd.     

β-环糊精增敏催化动力学光度法测定亚硝酸根

在磷酸介质中利用亚硝酸根催化条件下溴酸钾氧化甲基红的褪色反应,建立了β-环糊精（β-CD）增敏催化动力学光度法,对亚硝酸根进行测定。该方法最佳反应条件为：0.05 mol/L甲基红溶液加入量8.0%（φ,下同）,0.1 mol/L溴酸钾溶液加入量12.0%,1.0 mol/L稀磷酸加入量12.0%,0.15 mol/L β-CD溶液加入量16.0%,反应温度40 ℃,反应时间15 min。亚硝酸根测定的线性范围为8.0×10^-6~6.0×10^-4 g/L,线性回归方程的相关系数为0.996 6,检出限为4.0×10^-7 g/L。亚硝酸根的加标回收率为99.0%~102.0%,水样测定结果的相对标准偏差为2.4%~3.2%。加入β-CD后测定亚硝酸根的灵敏度增加了2.5倍。     

炭化核桃壳对废水中Cr（Ⅵ）的吸附

制备了炭化核桃壳,采用SEM,EDX,FTIR等方法对炭化核桃壳进行了表征,研究了炭化核桃壳对废水中Cr（Ⅵ）的吸附效果。表征结果显示,炭化后的核桃壳为片状结构,且形成了大量的微孔,微孔数量的增加使得核桃壳的比表面积明显增大。实验结果表明,炭化核桃壳吸附处理含Cr（Ⅵ）废水的最佳工艺条件为：初始废水pH 2.0、炭化核桃壳加入量16 g/L、吸附温度25 ℃、转速150 r/min、吸附时间180 min,在此最佳工艺条件下吸附处理Cr（Ⅵ）质量浓度为20 mg/L废水,Cr（Ⅵ）去除率高达98.7%,最大吸附量为8.731 mg/g。Langmuir吸附等温模型可更好地描述炭化核桃壳对Cr（Ⅵ）的吸附过程,吸附属于单分子层吸附。拟二级动力学方程能更好地描述炭化核桃壳对Cr（Ⅵ）的吸附行为,此吸附过程以化学吸附为主控步骤。     

Pseudomonas flava WD-3固定化技术及其强化SBR污水处理的应用研究

由南四湖底泥中分离纯化出一株低温菌Pseudomonas flava WD-3,为提高其处理污水的效率并实现重复利用,本试验选取在低温(6~8℃)条件下,采用天然材料海藻酸钠(SA)和人工合成材料聚乙烯醇(PVA)共同作用的复合材料为包埋载体,利用正交试验探索其最优的固定化条件;并将最优的Pseudomonas flava WD-3固定化小球投入到SBR污水处理工艺中,探究其投加量和水力停留时间对生活污水处理效果的影响.结果发现,当SA质量分数为4%,PVA质量分数为6%,Ca Cl_2质量分数为5%,交联时间为24 h时,Pseudomonas flava WD-3固定化小球的物理性能最好,且对污水的处理效果最佳,分别是游离菌对COD、TP和NH+4-N去除效率的1.11、1.17、1.14倍.在SBR工艺中,通过连续3个月的监测数据发现,Pseudomonas flava WD-3的固定化小球对污水NH+4-N、TP、COD和TN的去除率分别介于72.78%~77.48%、62.04%~69.26%、89.08%~92.72%和85.08%~89.08%,且平均去除效率分别为未投加该菌的1.13、1.91、1.25、1.56倍,最终采取的最佳水力停留时间为8 h.并且,Pseudomonas flava WD-3在不同投加量及不同水力停留时间条件下,对污水中各污染物的降解过程符合一级动力学模型.     

UV降解水溶液中吲哚美辛的动力学研究

以中压汞灯为光源,研究水环境中吲哚美辛(IDM)的紫外光降解机制.实验结果表明,IDM的光解反应符合准一级动力学规律,其降解速率常数随自身浓度的增大而减小,当IDM浓度由1 mg·L~(-1)增至12 mg·L~(-1)时,其速率常数由0.0148 min~(-1)减至0.00412 min~(-1).通过模型研究IDM的紫外光解机制时发现,其降解包括直接光解和自敏化光解,直接光解常数为0.0151 min~(-1).研究环境因子对IDM光解的影响时发现,碱性环境有利于IDM的降解,而溶解氧抑制IDM的光解,腐殖酸通过光掩蔽和自由基猝灭两个作用抑制IDM的光解,硝酸根通过接受光量子产生·OH促进IDM的降解,并通过竞争反应实验测得·OH稳态浓度为2.10×10~(-1)4mol·L~(-1),IDM与·OH的二级反应速率常数为9.86×109L·mol~(-1)·s~(-1).     

ELPI 测定环境空气 PM2．5的现场比对研究

采用ELPI自动监测方法与手工采样－重量法对环境空气PM2．5监测进行现场比对研究,按照两种方法数据的相对偏差来评价ELPI方法的数据质量。实验结果表明,两种方法数据的相对偏差范围为－12．9％～17．4％,加权平均值为3．0％;相对偏差的绝对值范围为1．1％～17．4％,平均值为9．3％。 ELPI法的数据质量总体较好,方法的准确度尚可。只是随着空气PM2．5浓度测定值的升高,ELPI法与重量法相对偏差的绝对值显著减小,可见,在低浓度下,ELPI法的数据质量相对较差,此时方法的准确度有待进一步验证、提高。     

TGA analysis of tobacco rob pyrolysis and release characteristics of noncondensable gas in a fixed-bed reactor

In this study, the size of tobacco rob (TR) particle was considered as a major factor in determining the mass loss in thermogravimetric analysis (TGA) and product yield and composition at different reactor temperatures in the fixed-bed reactor. The TGA results showed that the conversion rate increased and the activation energy (ranged from 53.29 to 58.25 kJ/mol) decreased with a decrease in particle size. The experiments demonstrated that fuel gas yield (from 0.76 to 0.82 Nm³/kg at 900 °C) increased with a decrease in particle size while char and tar yield decreased. Smaller particle sizes resulted in higher H₂ (25.68%) and CO (27.36%) contents. Minimizing the size of raw materials is an alternative method to improve the gas quality of TR pyrolysis. The increase of gas yield was attributed to the decomposition of char and tar vapor as temperature increased.     

Biofuels – tools for achieving environmental goals or green place branding? Present drivers and future visions in two Swedish municipalities

This paper presents a study of two Swedish municipalities’ engagement in biogas development. To analyse the drivers of such biogas development, the conceptual framing incorporates two perspectives on local biogas policy: first, policy drivers as connected to environmental goals and, second, policy as a matter of green place branding. The results indicate that biogas engagement serves as a self-governing activity with the fulfilment of environmental goals as a driver; furthermore, it is a way of expressing the mission of municipalities as “engines” of environmental policy. In one studied municipality, biogas engagement has an important symbolic value for green identity, meaning that green place branding is a driver. Still, interviewed actors from both municipalities lack clear long-term visions of biogas. Further studies of biofuel production should critically investigate visions of the future among central and local governments and evaluate the implications of municipalities as biofuel producers.