倾角和循环流量对平板型光催化反应器性能的影响

考察了平板倾角和循环流量对平板反应器流动特性和性能的影响 ,并讨论了以太阳光为辐射光源时平板型反应器的最佳倾角问题 .研究表明 ,平板上液体体积 (V)和水膜厚度 (b)与倾角 (β)、循环流量 (Q)分别存在定量关系 .入射辐射条件相同时 ,在悬浮催化剂体系中 ,平板倾角越小 ,循环流量越大 ,反应器性能越高 ;在固定催化剂体系中 ,平板反应器 (长 1m,宽 0.48m)的性能最佳时的循环流量为 500L/h、倾角为 10°,相应雷诺数为 286.无论在悬浮催化剂还是固定催化剂体系中 ,周期性地辐射能提高反应速率 .     

Efficiency enhancement in solar air heaters by modification of absorber plate-a review

This paper outlines a complete review on modifications made on the absorber plate of solar air heaters in order to improve the turbulence and heat transfer rate, thereby efficiency. Corrugated sheets, fins, extended surfaces, wire mesh, porous medium, etc., are a few of the modifications used. Most of such alterations in the absorber plate resulted with an increase in efficiency but associated with drawback of increased pumping power due to raising friction factor. Pumping power is considered here as a predominant comparison parameters of various solar air heaters with different absorber plate in terms of effective efficiency.     

好氧活性污泥中自养硝化细菌分离方法研究

分别采用琼脂平板、琼脂糖平板、水洗洋菜平板和硅胶平板分离培养城市污水处理厂好氧活性污泥中的硝化细菌。在相同的培养条件下,琼脂平板和水洗洋菜平板有杂菌生长;硅胶平板制作过程繁琐,培养后期出现失水性干裂;琼脂糖平板没有杂菌生长。通过对分离菌株的表观形态观察和NorB基因检测鉴定分离菌株,证明琼脂糖分离出了目的菌株,适合生长周期长的自养硝化细菌分离培养。     

异波折板水解酸化-A~2O一体化反应器实验研究

设计了异波折板水解酸化-A2O一体化反应器,进行生活污水处理的实验研究。10个月的实验结果表明,系统的最佳水力停留时间(HRT)为8 h时,最适COD进水浓度为240~600 mg/L,最佳混合液回流比(r)-污泥回流比(R)为250%~100%。控制反应器于以上运行参数下,25±2℃所对应的COD、TN和TP去除率分别为96.84%、67.55%和81.92%。当温度降至7℃时,其COD、TP和TN分别降至86.35%、50.25%和65.68%。基于实验分析结果,阐明了一体化反应器高效性的机理在于异波折板水解酸化段具有高效传质特性和A2O段具有复合式活性污泥-接触氧化好氧池的特点。     

海上含聚污水电化学处理装置的优化

为解决传统电化学方法在含聚污水处理时电极板消耗严重、絮渣量大的问题,通过改进电极板材料、组合数及结构等,研究适度降解-除油一体化电化学技术,在降低渣泥量的同时保证处理效果。实验结果表明:最佳电极板组合为"网状惰性金属复合物极板(阳)-网状铝极板(阴)-网状铝极板(阴)-网状惰性金属复合物极板(阳)";在电解电流为4.0 A、极板间距为8.0 cm、面体比(电极板面积与处理污水量的比值)为2/17 cm~2/mL、电解时间为30 min的最佳处理条件下,几乎无絮渣产出,含聚污水的浊度去除率为93.3%、聚合物降解率为92.0%、除油率为95.0%,展现了优良的处理效果。     

汽车制动系统的匹配设计

通过对汽车制动系统的原理及结构性能的探讨,进一步掌握整车新产品开发设计中制动系统的匹配计算.     

电除尘器分布板孔形对气流分布影响的仿真研究

针对不同气流分布板孔形,采用欧拉-拉格朗日多相流模型,应用CFX软件对电除尘器内部流场进行数值模拟计算,获得气流分布板孔形对气流均匀性影响的关系规律。仿真结果表明,孔形为方形的气流分布板能获得较佳的气流分布均匀性。     

不锈钢-气氮板式热沉仿真研究

目的研究不锈钢-气氮板式热沉中,氮气压力、氮气入口流速以及热沉自身流道深度对热沉传热性能的影响。方法利用AnsysFluent软件,对板式热沉壁面温度分布情况以及进出口压力损失进行模拟仿真。结果提高氮气压力和氮气入口速度可以提升热沉的温度均匀性,但热沉进出口压力损失也会增大。对于气氮-板式热沉而言,流道深度的改变对热沉温度均匀性的影响不大,但流道深度较小时,进出口压力损失较大。结论建议在设计气氮-板式热沉时,流道深度选择在8~10 mm,外流程中氮气压力控制在0.3~0.4 MPa,氮气流速控制在20 m/s为宜。     

Experimental study of recirculating flows generated by lateral shock waves in very large channels

Due to the lack of data on hydraulic-jump dynamics in very large channels, the present paper describes the main characteristics of the velocity field and turbulence in a large rectangular channel with a width of 4 m. Although a hydraulic jump is always treated as a wave that is transversal to the channel wall, in the case of this study it has a trapezoidal front shape, first starting from a point at the sidewalls and then developing downstream in an oblique manner, finally giving rise to a trapezoidal shape. The oblique wave front may be regarded as a lateral shockwave that arises from a perturbation at a certain point of the lateral wall and travels obliquely toward the centreline of the channel. The experimental work was carried out at the Coastal Engineering Laboratory of the Water Engineering and Chemistry Department of the Technical University of Bari (Italy). In addition to the hydraulic jump formation, a large recirculating flow zone starts to develop from the separating point of the lateral shock wave and a separate boundary layer occurs. Intensive measurements of the streamwise and spanwise flow velocity components along one-half width of the channel were taken using a bidimensional Acoustic Doppler Velocimeter (ADV). The water surface elevation was obtained by means of an ultrasonic profiler. Velocity vectors, transversal velocity profiles, turbulence intensities and Reynolds shear stresses were all investigated. The experimental results of the separated boundary layer were compared with numerical predictions and related work presented in literature and showed good agreement. The transversal velocity profiles indicated the presence of adverse pressure gradient zones and the law of the wall appears to govern the region around the separated boundary layer.     

利用果胶培养基分离番茄根际细菌

采用平板稀释和PCR-DGGE相结合的方法,比较了4种培养基(果胶富营养培养基PM,只含果胶一种营养的培养基PA,添加果胶的寡营养培养基YPP以及与YPP营养成分一致但不添加果胶的寡营养培养基YPG)分离番茄根际细菌的能力.结果显示:PA培养基能够分离到42种形态的细菌;YPP培养基可以分离到最高的细菌菌落数,分离获得的种类比PA少;YPP培养基分离获得细菌的种类和菌落数量比YPG培养基要多.聚类分析也显示只有果胶一种营养的PA培养基能分离到最多种类,分离获得的菌群与自然环境中微生物群落最相似.研究结果表明添加番茄根际主要分泌物——果胶到培养基中可以提高培养基分离细菌的能力.