河道底泥陶粒比表面测定

讨论了以河道底泥和生活污泥为原料烧制陶粒比表面的测定原理、方法和结果，并对生活污泥添加量、粘结刑添加量和烧结温度对陶粒比表面的影响作了进一步分析。     

微波加热对活性炭表面基团及其对SO2吸附性能的影响

采用了微波加热技术,通过在不同微波功率和辐射时间条件下对不同粒径活性炭进行改性,研究了改性前后活性炭的表面化学基团、元素组成的变化,以及对SO2吸附性能的影响.结果表明,经过微波改性后活性炭的SO2吸附性能大为提高,微波功率是影响改性活性炭脱硫性能的主要因素.活性炭经微波热处理后,酸性基团发生分解,表面含氧量减少,碱性特征增强,是吸附性能增加的主要原因之一.     

Surface Consolidation of Pentelic Marble: Criteria for the selection of methods and materials - The Acropolis case (6 pp)

Goal and Scope In order to realize surface consolidation of Pentelic marble on the Acropolis monuments, we have collected the criteria that have to be fulfilled by the methods and materials without side effects on the marbles (and other stones). When the existing methods and materials did not satisfy the requirements (criteria), we invented new ones.Methods The criteria were collected from the literature, by thermodynamic and kinetic viewpoints, by laboratory experiments and in situ observations on monuments, both in Greece and in several countries in which the various methods and materials were applied. Concerning our method of ‘Inversion of sulfation’, performed by spraying a K2CO3 solution, its concentration and its temperature were controlled in order to have a total inversion (certified by liquid crystals) of gypsum back to CaCO3. For the new material of ours, ‘Reinforced Lime’, in order to eliminate the disadvantages of plain lime (low carbonation rate, low mechanical properties of CaCO3 formed, lack of carbonation in the bulk of lime), measurements of the rate of carbonation were performed in plain lime and in lime with a different CaCO3 concentration beforehand as well as in a different CO2 environments, using DTG and XRD to measure the rate of carbonation. The detachment (kg/cm2) of marble specimens stuck by lime in each case was also measured. A microscope was also used to measure the dimensions of the grain in each case as well as ammonium citrate and thymolphthalein to certify the depth of carbonation in each case. Part of the work was communicated in an international congress.Results A table with the criteria of the selection of the methods and materials for the consolidation of Pentelic marble surfaces (and other stones) was established. None of the employed methods and materials fulfilled the criteria. Only the ‘Inversion of gypsum ‘ and the ‘Reinforced Lime’ were adopted and applied to the Acropolis monuments and to other monuments in Greece and in several other countries.Recommendation and Outlook All criteria must be used for the selection of methods and materials for the consolidation of the monument surfaces. This is why we have already studied with the same procedures, methods and materials for restoration, surface cleaning and protection.     

低温降解六六六优势菌种的选育研究

通过实验,筛选出低温条件(≤10℃)下降解六六六的优势菌株--1号菌株,同时利用正交实验测得该菌株的最佳降解条件为:pH=5.5、接菌量2 g/L、NH4Cl 0.8 g/L、KH2PO4 0.6 g/L、MgSO4 0.2 g/L.在此条件下,经30 d驯化后的菌株对六六六的降解率由原来的54.71%提高到62.58%     

污泥的粘度与浓度、温度三者关系式的实验推导

通过融合污泥粘度与污泥浓度关系式、污泥粘度与温度关系式,得到一个新的关系式:污泥粘度与污泥浓度、温度的关系式,并通过实验数据拟合出各项参数,拟合效果比较理想.得出的污泥粘度与污泥浓度、温度的关系式对了解污泥的粘度变化非常有帮助,同时,该关系式也将为污泥处理、处置方案的制定提供参考依据.     

垃圾填埋场渗滤液处理工艺研究进展

介绍了垃圾渗滤液的来源和特点，结合近些年的工程实际和实验研究，主要综述了垃圾渗滤液的处理方案和技术，包括回灌法、土地处理法、物化法、生物法以及其他处理方法，在比较这些方法的基础上提出了一些建议。     

各种影响因子对电解法预处理医药废水的影响研究

探讨了电解法预处理医药废水时停留时间、电解电压、废水初始浓度、温度和废水pH值等影响因子对去除色度、COD和提高废水可生化性等处理效果的影响，并考察了其应用于工业实际废水处理的可行性。实验结果表明：电解法更适合高浓度医药废水的处理，色度的去除率可达到90％以上；电解时间宜控制在40-60min；电解电压越高，废水COD和色度去除效果越好；在实验温度范围内，温度对色度和COD去除率的影响不大；废水pH值为7．5时电解效果最佳，工程运用宜控制在6—9之间。     

Elman神经网络在抽水地面沉降预测中的应用

将Elman神经网络应用于南京奥体中心地铁站抽水试验初期对地面沉降的预测，提出了一种预测模型。该模型采用对已知数据样本进行分段的方法，把分段后的数据作为网络输入和期望输出训练网络，从而达到动态建模的目的。从预测结果来看，该模型误差较小，基本上能够反映2002—07—21当天地面沉降的真实情况，具有一定的可靠性和实用性，因此，该模型可作为后期由于基坑开挖和防渗排水所引起地面沉降的分析工具。     

负载型金催化剂用于室温下CO的消除

从催化活性、抗潮湿、抗硫中毒、稳定性等方面考察了负载型金催化剂对于ＣＯ氧化反应的性能。筛选出的２－３催化剂可在－２２℃下完全消除ＣＯ，并且在催化活性、抗潮湿、抗硫中毒、稳定性等方面具有现行催化剂无法比拟的优点。     

低温等离子体治理H2S污染的实验研究

低温等离子体技术是一种高效、快速的污染消除技术，国内外都在对其进行广泛而深入的研究。采用脉冲电晕放电等离子体对空气中的硫化氢进行降解研究，探索了、脉冲峰压、脉冲频率、气体流量以及气体初始浓度对净化效果的影响，气体浓度由气相色谱仪测定。结果表明，脉冲电晕放电可以有效消除硫化氢污染，净化率随脉冲峰压和脉冲频率的增加而提高，随气体初始浓度和流量的增加而下降，且在初始浓度360mg／m^2、流量1200mL／min、脉冲峰压30kV、脉冲频率80Hz的条件下，处理后的气体中已检测不到H2S，根据色谱检测限（0．29mg／m^3）计算出的净化率≥99．92％。采用离子色谱对产物进行了定性分析，发现H2S经放电处理后主要产物为SO2和SO3。