UASB法处理城市生活垃圾焚烧场渗滤液

垃圾焚烧场的渗滤液具有pH低、污染成分复杂、COD_(Cr)浓度高、可生化性好等特点。本研究探索了UASB法处理焚烧场渗滤液时的快速启动方法,考察了水力停留时间、容积负荷对COD_(Cr)去除率的影响及产气量与COD_(Cr)去除率的关系,结果表明,在水力停留时间6d、容积负荷5kg/(m3.d)的情况下,COD_(Cr)去除率可达到93%,每升原水产气量可达22.5L,折合热值492.7kJ。     

多功能粉煤灰治理垃圾场渗滤液

以具絮凝、吸附、降解多功能粉煤灰污水处理材料,填充成絮凝沉降降解过滤箱,组合有鼓气、臭氧的连续式5级垃圾场渗滤液集成处理系统。垃圾渗滤液流量、鼓气量、臭氧量分别为40Lh、40L(m3·h)、15mgL的工艺条件下,渗滤液的悬浮物、色度、CODCr、BOD5、氨氮、硫化物等主要污染物指标分别降低93%、90%、96%、92%、86%和92%,达到垃圾场渗滤液二级控制标准。     

图象法确定底泥颗粒物的表面分形维数(Ds)

研究了不同标度下底泥颗粒物的表面分形特征.结果表明,底泥颗粒的表面在几个nm到几个μm之间一般都具有多重分形特征,而且在不同的标度范围内表面分形维数(Ds)具有一定的差异,在100-102量级之间,随图象分辨率的增大,相应的Ds一般呈变小的趋势.SEM图象计算出的Ds为2.32-2.42,AFM图象计算出的Ds为2.00-2.46,它们是是纯粹几何意义上的表面粗糙特征的描述.     

聚合氯化铝-腐殖酸(PACl-HA)絮体的物理与分形特征研究

采用低温急速冷冻-真空干燥技术制备了PACl-HA絮体的粉末样品,研究了这些样品的物理与分形特征.结果表明,PACl-HA絮体具有无定形结构,主要组成元素为C、O、Al,所含特征官能团保留了絮体组成原料的一些特征;絮体的BET比表面积为130～161 m²·g^-1,BJH累积吸附孔体积为0.38～0.52 cm³·g^-1,BJH脱附平均孔径为7.7～9.6nm,PSD峰值对应孔径8.4～11.2nm.PACl-HA絮体具有自相似性的粗糙表面,呈现多尺度分形特征;图象法和N₂吸附/脱附等温线法确定的表面分形维数Ds分别为2.03～2.26、2.24～2.37,前者的分形尺度大约处于23～390nm之间,主要属于絮体外表面尺度,而后者的分形特征尺度区间的下限大约为0.2nm,属于孔表面尺度;另外,对同一絮体,N₂吸附法和脱附法确定的孔表面分形维数不同.热力学模型计算出的D_s远大于3,与Sahouli等的研究不符.     

好氧膜生物反应器的硝化性能研究

以含有高浓度氨氮的垃圾渗滤液为对象,针对好氧膜生物反应器的硝化性能进行了研究。结果表明:当进水氨氮<1000mg/L和负荷<1.5kgNH4+-N/m3d时,氨氮去除率保持在80%～99.7%之间,表明好氧MBR具有良好的硝化性能;硝酸菌在进水氨氮浓度>600mg/L时受到了抑制,而亚硝酸菌在进水氨氮浓度>1200mg/L时才受到抑制;在试验过程中,MBR污泥经历了由以异养细菌为主到自养细菌为主的转型过程。以硝化菌为主的污泥具有良好的沉淀性能,污泥的SV和SVI分别稳定在20%～30%之间和40～70mL/g之间。     

Taxonomic and functional variations in the microbial community during the upgrade process of a full-scale landfill leachate treatment plant – from conventional to partial nitrification-denitrification

• Upgrade process was investigated in a full-scale landfill leachate treatment plant. • The optimization of DO can technically achieve the shift from CND to PND process. • Nitrosomonas was mainly responsible for ammonium oxidation in PND system. • An obviously enrichment of Thauera was found in the PND process. • Enhanced metabolic potentials on organics was found during the process update. Because of the low access to biodegradable organic substances used for denitrification, the partial nitrification-denitrification process has been considered as a low-cost, sustainable alternative for landfill leachate treatment. In this study, the process upgrade from conventional to partial nitrification-denitrification was comprehensively investigated in a full-scale landfill leachate treatment plant (LLTP). The partial nitrification-denitrification system was successfully achieved through the optimizing dissolved oxygen and the external carbon source, with effluent nitrogen concentrations lower than 150 mg/L. Moreover, the upgrading process facilitated the enrichment of Nitrosomonas (abundance increased from 0.4% to 3.3%), which was also evidenced by increased abundance of amoA/B/C genes carried by Nitrosomonas. Although Nitrospira (accounting for 0.1%–0.6%) was found to stably exist in the reactor tank, considerable nitrite accumulation occurred in the reactor (reaching 98.8 mg/L), indicating high-efficiency of the partial nitrification process. Moreover, the abundance of Thauera, the dominant denitrifying bacteria responsible for nitrite reduction, gradually increased from 0.60% to 5.52% during the upgrade process. This process caused great changes in the microbial community, inducing continuous succession of heterotrophic bacteria accompanied by enhanced metabolic potentials toward organic substances. The results obtained in this study advanced our understanding of the operation of a partial nitrification-denitrification system and provided a technical case for the upgrade of currently existing full-scale LLTPs.     

两株壬基酚和双酚A高效降解菌株的筛选和降解特性

以桂林市上窑污水处理厂污泥脱水车间剩余污泥、上窑堆肥厂的堆肥堆料和桂林雁山镇森林土壤为菌源进行驯化,分离纯化并筛选得到2株能分别以壬基酚(NP)和双酚A(BPA)为唯一碳源和能源生长的降解菌株N-1和B-1。通过对菌株的16S r DNA序列同源性分析,初步鉴定N-1和B-1菌分别为Cupriavidus(贪铜菌属)、Acinetobacter(不动杆菌属)。通过两菌株分别降解NP和BPA的单因素实验,确定了降解动力学以及时间、温度、p H值对降解过程的影响。研究结果表明,细菌N-1,B-1的最佳初始目标污染物质量浓度为5~10 mg/L,降解40 h,N-1去除率可达49.63%,B-1去除率可达62.34%。细菌N-1对NP的去除半衰期t1/2为41.44~48.02 h;B-1对BPA的去除半衰期t1/2为35.23~37.33 h。细菌N-1,B-1的最佳降解温度均为30℃,最佳p H值均在6.5~7.5之间,即两种细菌在中温、中性条件下对NP和BPA降解效果最佳。     

分段变速加载对含瓦斯突出煤力学特性影响试验研究

为探究采动应力变化对含瓦斯突出煤力学特性的影响,利用RLW-500G煤岩三轴蠕变-渗流试验系统,对新景矿含瓦斯突出煤进行了不同围压和瓦斯压力下的常规三轴和分段变速加载力学试验。结果表明:煤样在2种应力路径下的全应力应变曲线均可分为压密、线弹性、塑性变形、应力跌落和残余应力5个阶段;随着围压的升高或者瓦斯压力的降低,煤体在2种应力路径下的强度和弹性模量均增大;相较于常规三轴,煤体在分段变速加载路径下的强度普遍增大,峰值轴向应变、峰值环向应变绝对值和峰值体积应变绝对值也普遍增大,失稳破坏瞬间应力跌落和能量释放更加剧烈。Mohr-Coulomb强度准则仍然适用于分段变速加载条件下的含瓦斯突出煤,该研究对于认识煤与瓦斯突出的发生机制具有一定的指导意义。     

UASB-FEO-氨吹脱-CASS工艺在垃圾渗滤液处理中的应用

针对垃圾渗滤液可生化性差、氨氮含量高等特点和国内处理工艺现状,采用UASB-FEO-氨吹脱-CASS工艺处理合肥市龙泉山城市垃圾填埋场垃圾渗滤液。介绍了工艺的重要构筑物及其设计参数。运行实践表明,整套装置运行平稳,出水水质满足设计要求。根据出水水质对该工艺进行技术分析以及运行结果的讨论,并与新发布的技术规范及排放标准进行对比分析。     

混凝与Fenton联用处理垃圾渗滤液的效能及成本

为对混凝/Fenton工艺与Fenton/混凝工艺处理垃圾渗滤液的效果和成本进行比较,分别对年轻渗滤液和老龄渗滤液原液按照混凝/Fenton工艺与Fenton/混凝工艺2种技术路线进行处理。实验结果表明,Fenton试剂对年轻垃圾渗滤液和老龄垃圾渗滤液COD去除率最高的反应条件为pH=3.5、H2O2和Fe2+的摩尔比为6、H2O2和渗滤液原液的COD质量比为3、反应时间4 h;在PAC与渗滤液原液的COD质量比为0.6时,PAC混凝对渗滤液原液的COD去除率最高。在对渗滤液COD去除率最高的Fenton反应和PAC混凝反应条件下,混凝/Fenton工艺对年轻渗滤液和老龄渗滤液的COD去除率分别为90.56%和86.56%;Fenton/混凝工艺对年轻渗滤液和老龄渗滤液的COD去除率分别为89.99%和85.99%,2种技术路线对渗滤液COD的去除率相差不大,但先PAC混凝后Fenton氧化工艺比先Fenton后混凝工艺每t节省62.6元,是更优化的渗滤液处理工艺。