采油废水处理方法与技术研究进展

采油废水具有成分复杂、可生化性差、含盐量高等特点,直接排放可对环境造成严重影响。对近年来国内外采油废水的特点和处理技术方法研究进展进行了综述,分析各类处理方法的特点,并提出了今后研究方向。     

新型单级A/O程序无回流复合膜生物反应器处理氨氮废水的试验

采用单级A/O程序复合膜生物反应器(HSMBR)处理高氨氮废水,研究在低DO浓度下系统对有机物、氨氮和总氮的去除效率。研究结果表明:在低DO浓度下,CODCr、氨氮的平均去除率分别为94.4%和92.8%。由于进水CODCr/TN值仅为2.01,则使得总氮平均去除率仅为69.4%,但是当系统亚硝化累积率从60.5%～67.1%提高到83.5%～86.4%时,系统总氮去除率提高了17.7%。另外,维持低DO浓度可以实现亚硝酸型同时硝化反硝化反应。     

环境监测实验室废液的管理与处理方法

环境监测实验室的废液处理常常被忽视,提出建立有效的废液管理制度的必要性.有针对性地介绍了环境监测实验室中常见废液的处理方法.     

超滤处理洗涤污水循环利用的中试研究

采用不同材质国产超滤膜聚丙烯（PP）、聚丙烯腈（PAN）和聚砜（PS）,进行了洗涤污水处理循环利用的现场中试研究.结合超滤工艺出水水质和膜污染分析,3种膜材质中PAN膜较优,有效去除了水中浊度、悬浮物、油脂等污染物,一定程度保留了游离阴离子表面活性剂（LAS）,长期循环洗涤对衣物的白度无不良影响.根据相关性分析,超滤出水较高COD值很大程度上是由水中LAS引起的.超滤膜对细菌、大肠菌群的去除率较低,出水通过紫外消毒,当紫外线密度≥3?750 J/m²时,微生物水平能够达到国家饮用水水质标准.根据不同水力反冲洗条件下膜渗透通量和净产水量比较,PAN膜最佳水力反冲洗条件为0.5 h反冲洗2 min.长期运行时超滤膜化学清洗方法采用碱洗法方便有效.     

蒽对太平洋牡蛎不同组织抗氧化酶活性差异性影响与膜脂质过氧化研究

在实验条件下采用生态毒理学和生物化学方法,选用常见的环境污染物多环芳烃蒽,以太平洋牡蛎(Crassostrea gigas)为实验材料进行毒理实验.研究了太平洋牡蛎消化腺、鳃、唇瓣和肌肉4种不同组织中的3种抗氧化酶--超氧化物歧化酶(SOD)、过氧化物酶(POD)和过氧化氢酶(CAT)对蒽胁迫的敏感性;同时研究了4种不同组织膜脂过氧化的差异.结果表明:(1)4种不同组织中3种不同抗氧化酶对蒽敏感性有显著差异性.(2)4种不同组织的膜脂过氧化伤害程度表现为:消化腺＞鳃＞唇瓣＞肌肉.     

固相萃取-UPLC-MS/MS法测定环境水体中多种抗生素

采用固相萃取-超高效液相色谱串联质谱法测定环境水样中25种磺胺类和喹诺酮类抗生素,通过优化试验条件,使方法在2.00μg/L～200μg/L范围内线性良好,方法检出限为1.01ng/L～2.85ng/L,7次测定结果的RSD为2.3%～8.0%。将该方法用于自来水和地表水测定,结果均为未检出,高、低质量浓度水平的加标回收率为61.2%～102%。     

HPLC-三重四级杆质谱法测定医疗废水中抗生素残留

采用固相萃取/高效液相色谱-三重四级杆质谱法同时测定医疗废水中的20种超痕量抗生素残留,通过优化试验条件,使方法在100μg/L～100μg/L范围内线性良好,方法检出限为024ng/L～122ng/L。空白水样和实际水样3个质量浓度水平的加标回收率分别为80.2%～108%和75.8%～114%,6次测定结果的RSD分别为2.4%～8.4%和1.7%～8.1%。将该方法用于测定重庆市2家三甲医院医疗废水中的超痕量抗生素残留,结果有11种抗生素检出,其余均为未检出。     

Improvement of the antifouling characteristics in a bioreactor of polypropylene microporous membrane by the adsorption of Tween 20

Surface modification by physical adsorption of Tween 20 was accomplished on polypropylene microporous membranes (PPMMs). Attenuated total reflection-Fourier transform infrared spectroscopy (ATR/FT-IR) and scanning electron microscope (SEM) were used to characterize the chemical and morphological changes on the membrane surfaces. Water contact angles and relative pure water fluxes were measured. The data showed that the hydrophilic performance for the modified membranes increased with the increase in the adsorption amount of Tween 20 onto the surface or into the pores of polypropylene microporous membranes. To test the antifouling property of the membranes by the adsorption of Tween 20 in a membrane bioreactor (MBR), filtration for active sludge was performed using synthetic wastewater. With the help of the data of water fluxes and the FE-SEM photos of the modified PPMMs before or after operating in a MBR for about 12 d, the PPMMs with monolayer adsorption of Tween 20 showed higher remained flux and stronger antifouling ability than unmodified membrane and other modification membranes studied.     

液液萃取-气相色谱/串联质谱法测定水中五氯酚及其钠盐

采用液液萃取处理水样,用气相色谱-串联质谱法测定样品中五氯酚及其钠盐,通过优化测定条件,使方法在1.00μg/L～500μg/L范围内线性良好.检出限和定量限分别为1.00μg/L和5.00μg/L,空白水样五氯酚钠3个质量浓度水平的加标回收率为89.8％～98.4％,5次平行试验测定结果的RSD为5.5％～10.7％...     

Highly efficient conversion of sugarcane bagasse pretreated with liquid hot water into ethanol at high solid loading

Liquid hot water (LHW), an environmental-friendly physico-chemical treatment, was applied to pretreat the sugarcane bagasse (SCB). Tween80, a non-ionic surfactant, was used to enhance the enzymatic hydrolysis of the pretreated SCB. It found that 0.125 mL Tween80 /g dry matter could make the maximum increase (33.2%) of the glycan conversion of the LHW-pretreated SCB. A self-designed laboratory facility with a plate-and-frame impeller was applied to conduct batch hydrolysis, fed-batch hydrolysis, and the process of high-temperature (50°C) fed-batch hydrolysis following low-temperature (30°C) simultaneous saccharification and fermentation (SSF) which was adopted to overcome the incompatible optimum temperature of saccharification and fermentation in the SSF process. After hydrolyzing LHW-pretreated SCB for 120 h with commercial cellulase, the total sugar concentration and glycan conversion obtained from fed-batch hydrolysis were 91.6 g/L and 68.3%, respectively, which were 9.7 g/L and 7.3% higher than those obtained from batch hydrolysis. With Saccharomyces cerevisiae Y2034 fermenting under the non-sterile condition, the ethanol production and theoretical yield obtained from the process of SSF after fed-batch hydrolysis were 55.4 g/L and 88.3% for 72h, respectively, which were 15.5 g/L and 24.7% higher than those from separate fed-batch hydrolysis and fermentation. The result of this work was superior to the reported results obtained from the LHW-pretreated SCB.