膜电解法在线再生酸性蚀刻液及回收铜新技术

采用极化曲线法研究了酸性蚀刻液阴、阳极电化学行为,并构建了离子膜电解反应体系,考察了在线再生酸性蚀刻液及回收铜的效果。结果表明,阳极氧化过程发生浓差极化,存在极限电流密度,Cu＋含量越高,极限电流密度越大;阴极还原分4步反应进行,存在极限电流密度;强化溶液传质可有效提高阴、阳极极限电流密度,有利于避免电解过程中析出氯气和氢气;在线实验表明,通过监控阳极液ORP,可避免析出氯气;分步降低电流电解有利于避免析出氢气,形成致密的金属铜块;在电流为9～24A范围内分4步电解23．5h可再生酸性蚀刻液23．5L,同时电沉积回收510g铜,纯度高达99．98％。阴极电流效率达到95．2％,吨铜电耗3251kWh。电解过程中无氯气和氢气析出,无废液排放,表明膜电解法在线再生酸性蚀刻液具有良好的应用前景。     

陶瓷膜污染过程分析与膜清洗方法优化

采用膜孔径为50 nm的陶瓷膜错流过滤方式,对碱性高浓度有机洗涤废水进行9个周期的膜通量衰减及反向脉冲清洗再生实验研究.通过设计膜污染阻力构成实验,测算膜污染总阻力及其构成比例.实验结果表明,膜固有阻力比例较低,浓差极化污染较弱,Rt和Rc+Rirt污染阻力稳定性较高,膜堵塞形式兼有孔内堵塞和滤饼过滤;选择质量分数0.1％的稀盐酸和0.2％的草酸溶液膜清洗效果均较好,清洗时间为3 min,脉冲时间和频率为3 s/5 s.     

混凝剂品种对混凝-超滤联合工艺膜污染的影响

本实验以工业化学合成聚合硫酸铁混凝剂和自制生物聚合硫酸铁为例,考察了铁系混凝剂品种对地表水浊度、TOC和UV254的去除效果,混凝剂品种对混凝-超滤联合工艺处理地表水过程中超滤膜污染的影响。混凝实验结果表明,在10 mg/L(以Fe3+计)最佳投加量下,两类混凝剂对浊度、TOC和UV254的去除率基本相同。超滤膜污染实验结果表明,生物聚合铁预处理水样通量衰减速度略大于化学聚合铁预处理水样;膜污染阻力分析结果显示,随着循环次数的增加,工业化学合成聚合铁预处理水样造成的不可逆污染阻力逐渐增加,而生物聚合铁预处理水样造成的不可逆污染阻力却略有下降;膜污染机理分析表明,2组过滤过程的膜污染类型基本相似,由最初的膜孔堵塞过渡到最终的滤饼层污染。SEM分析表明,生物聚合铁预处理水样的膜污染较为严重。     

Fenton氧化-序批式膜生物反应器耦合处理干法腈纶废水

采用Fenton氧化-序批式膜生物反应器(SBMBR)组合工艺处理干法腈纶废水。结果表明,在废水初始pH值为3.0,H2O2投加量为90.0 mmol/L,Fe2+投加量为20.0 mmol/L,反应时间为2.0 h的条件下,Fenton氧化预处理对腈纶生产废水的COD去除率达到47.0%以上,COD由1 091 mg/L降至560 mg/L,废水的BOD5/COD由0.32升至0.69,废水的可生化性得到显著提高。Fenton处理出水与丙烯腈废水等比例混合后,采用SBMBR进行生化处理,在水力停留时间为24 h,90 min缺氧/150 min好氧交替运行的条件下,COD、NH4+-N和TN的平均去除率分别为71.7%、97.2%和47.4%,碳源不足是限制TN去除效果的主要影响因素。在无外加碳源的条件下,组合工艺处理后出水COD和NH4+-N浓度分别为117 mg/L和1.7 mg/L,出水水质可以稳定达到国家一级排放标准(GB8978-1996)。     

无机陶瓷膜处理油田采出水

针对陶瓷膜在油田采出水处理过程中操作参数的选择及污染机理进行了研究。通过现场实验,分析了不同的操作参数对膜通量的影响,陶瓷膜对含油量及悬浮物的去除效果,膜阻力组成及膜污染清洗方法。实验结果表明,在确定出水水质达到低渗透油田注水水质A1级标准条件下,陶瓷膜过滤最佳操作条件为:跨膜压差0.16 MPa、温度50℃、膜面流速5.0 m/s。同时发现,NaOH和HNO3联合清洗有助于恢复膜通量。     

MFC-MBR耦合系统运行效果

膜生物反应器(MBR)是一种高效的污水处理工艺,而微生物燃料电池(MFC)能有效降解污泥中的胞外生物有机质(EBOM)并回收电能.将MFC与MBR联用,建立了一套能够有效抑制膜污染同时回收电能的新系统——MFC-MBR耦合系统,MBR的剩余污泥经MFC处理后回流.以传统MBR为对照,对耦合系统中污水处理效果、膜污染情况和污泥混合液的性质进行研究.研究表明,耦合系统的污水处理效果没有明显恶化,COD去除率为94％,NH4+-N的去除率为92％.耦合系统能够有效减缓膜污染的发生,清洗周期延长了28％.污泥混合液的MLVSS/MLSS稳定在80％ ～ 88％,系统内几乎没有无机颗粒积累.松散结合态胞外聚合物(LB-EPS)降低了48％,使污泥混合液性质得到改善.较低的污泥比阻(2.69×1012m/kg)和标准化毛细吸水时间(1.67 s·L/g MLSS),证明耦合系统污泥混合液脱水性能提高了.     

乳状液膜法处理煤制兰炭废水

以磷酸三丁酯(TBP)为载体、煤油为膜溶剂、NaOH水溶液为内水相,采用乳状液膜法处理兰炭废水。实验结果表明:当TBP体积分数为4%、表面活性剂质量分数为4%、内水相NaOH质量分数为12%、油内比(乳状液的油相与内水相的体积比)为3∶2、乳水比为1∶5、萃取时间为15min时,废水中的酚类(以苯酚计)去除率达到85%以上,COD去除率达83%以上。     

Decay profile and metabolic pathways of quinalphos in water, soil and plants

The widespread occurrence of pesticide residues in different agricultural and food commodities has raised concern among the environmentalists and food chemists. In order to keep a proper track of these materials, studies on their decay profiles in the various segments of ecosystem under varying environmental conditions are needed. In view of this, the metabolites of quinalphos in water and soil under controlled conditions and in plants, namely tomato and radish in field conditions have been analysed and possible pathways suggested. In order to follow the decay of the pesticide, an HPLC procedure has been developed. Studies conducted in water at different temperatures, pH and organic content reveal that the persistence of the pesticide decreases with the increase in all the three variables. In the three different types of soils studied, the effect of pH is more or less apparent on a similar line. On an average a faster decay is observed in the case of plants than in water and soil. The decay profiles in all these cases follow first order kinetics. The metabolites were identified by GC-MS. The investigations reflect that degradation occurs through hydrolysis, S-oxidation, dealkylation and thiono-thiol rearrangement. The pathways seem to be complex and different metabolites were observed with the change in the matrix. Quinalphos oxon, O-ethyl-O-quinoxalin-2-yl phosphoric acid, 2-hydroxy quinoxaline and quinoxaline-2-thiol were observed in all the matrices. Results further indicate that the metabolites, 2-hydroxy quinoxaline and oxon, which are more toxic than parent compound, persist for a longer time.     

Mobile passive samplers: concept for a novel mode of exposure

Integrative passive sampling with devices such as semipermeable membrane devices generally relies on rigs for month-long static exposures in water. We evaluate here whether mobile exposures of passive samplers can provide reliable estimates of dissolved contaminant concentrations. Mobile exposures were obtained by towing samplers fastened to the end of a benthic trawl net. Significant and reproducible absorption of polycyclic aromatic hydrocarbons during 5 h-long deployments was made possible by high sampling rates resulting from high water turbulences during towing at 1.2-1.5 knots. Sampling rates (72-215 L d⁻¹) estimated from the dissipation of performance reference compounds were supported by in situ calibration with samplers exposed for a 30 days in the vicinity of the test site. Higher fluoranthene and pyrene absorption in samplers exposed to the trawling-induced sediment plume could be attributed to desorption from re-suspended sediments. This mode of exposure has the potential to be used in monitoring programmes.     

中型污水处理厂中药物和个人护理品的分布与去除

为了解15种药物及个人护理用品(PPCPs)在中小型污水处理厂中的分布及其去除效果,采用液相色谱-串联质谱(LC-MS/MS)技术对3座A2/O工艺的污水处理厂水样进行分析研究。结果显示,除普萘洛尔、吉非罗平和吲哚美辛在3座中小型污水处理厂各个工艺单元中均未被检出外,其余12种目标化合物的检出频率在90%~100%之间。进水水样中PPCPs的平均检出浓度为2 285.4 ng/L,其中咖啡因(CF)的平均检出浓度最高为973.3 ng/L,酮洛芬(KP)的平均检出浓度次之为844.7 ng/L,两者之和占进水水样中PPCPs平均含量的79.5%,表明污水处理厂的主要污染物为CF和KP。3座污水处理厂对CF的去除效果最为显著,平均去除率为95.3%,对15种PPCPs总去除效率在39.3%~82.8%之间。