Laboratory evidence of natural remobilization of multicomponent DNAPL pools due to dissolution

Mixtures of dense non-aqueous phase liquids (DNAPLs) trapped in the subsurface can act as long-term sources of contamination by dissolving into flowing groundwater. In general, the components of higher solubility are removed more quickly, thus altering the composition of the remaining DNAPL, and possibly leading to changes in its physical properties. Through the development of a simple compositional model, Roy et al. [J. Contam. Hydrol. 2002 (59) 163] showed that preferential dissolution of a mixed DNAPL could potentially result in changes in density and interfacial tension that could subsequently lead to remobilization of an initially static DNAPL pool. The laboratory experiments presented in this next paper provide a proof-of-concept for the previously presented theory, demonstrating and quantifying this process of remobilization. In addition, the experiments provide a data set for evaluation of the model presented by Roy et al. [J. Contam. Hydrol. 2002 (59) 163]. In the four experiments, a DNAPL pool comprised of tetrachloroethene and benzene was created as an open pool overlying glass beads within a water-saturated 2-D flow box. Experiments included rectangular and triangular pools. In each of the experiments, remobilization (as breakthrough) was observed more than 2 weeks after formation of the initial pool. During each experiment, the pool height declined as mass was lost by dissolution, while sampling indicated a decrease in the mole fraction of benzene, the more soluble component. Small protuberances formed along the bottom of the pool as its composition changed with time and the displacement pressure was achieved for various pore throats. Eventually one of the protuberances extended further, forming a finger (breakthrough). In general, the pool emptied as the finger proceeded further into the beads. It was also shown theoretically and experimentally that remobilization will occur sooner for pools with a triangular (pointing down), rather than rectangular, shape. The experimental results were simulated using the model developed by Roy et al. [J. Contam. Hydrol. 2002 (59) 163]. The model matched the observations well, suggesting that it accurately represents the primary mechanisms involved with natural remobilization under the conditions of the study.     

固定化微生物技术在无泡供氧膜生物反应器中的应用研究

实验采用中空纤维膜作为无泡供氧及生物膜载体，采用包埋固定化技术进行挂膜及污水处理研究。通过装置改进，较好地解决了无曝气条件下的底物传质问题，提高了传质效率，确定了最佳包埋剂及固定化条件，缩短了挂膜时间和提高了污染物的去除效果。实验结果表明，采用PVA作为包埋剂，且包泥量为1：1的情况下，挂膜时间可缩短为一周左右，COD和氨氮的去除率分别稳定在90％和80％左右。     

焚烧法处理环己酮生产中的皂化液

用环已烷氧化生产环已酮的生产过程中会产生大量的皂化液 ,它含有大量的有害物质 ,是一种难处理的高污染有机废水。某石化厂在借鉴造纸行业的黑液焚烧技术的基础上 ,采用焚烧法来处理皂化液 ,并得到副产蒸气和回收了碳酸钠 ,实现了皂化液的无害化与资源化 ,具有良好的社会效益、环境效益和经济效益 ,每处理 1t皂化液可盈利 10 0～ 2 0 0元     

微氧膜生物反应器同时去除有机物和氮的研究

采用微氧颗粒污泥膜生物反应器处理生活污水,进行同时去除有机物和氮的研究。结果表明,膜出水COD不受水力停留时间变化的影响一直稳定在较低值,为15~35mg/L,去除率在94%以上。氮通过发生同时硝化反硝化反应而去除。在水力停留时间为16h以上时, 系统总氮去除率为65% ~92%,平均去除率为77%。     

无机陶瓷纳滤膜分离高钠盐废水中的锶

本实验研究表明,仅用截留分子量为1000的无机陶瓷纳滤膜分离高钠盐模拟溶液中的锶,分离效果并不理想.为提高陶瓷纳滤膜对锶的选择分离效果,选择了分子量为3000的聚丙烯酸作为陶瓷纳滤膜分离的强化剂,重点探讨了溶液pH值、聚丙烯酸浓度、温度及离子强度对模拟溶液盐分离效果和膜通量的影响,并得到了适宜的锶钠分离条件.实验结果表明,在适宜条件下,通过聚丙烯酸强化和两级分离,陶瓷纳滤膜可大大提高模拟溶液中锶离子的选择分离效果,锶/钠的分离因子高达205.     

错流式动态膜-生物反应器中污泥活性的研究

应用错流式动态膜-生物反应器(CDMBR)对己内酰胺废水进行了180 d的实验,实验过程中测定反应器的膜出水和上清液的水质,并对污泥进行了耗氧呼吸速率测定.结果表明,上清液COD一直保持在100mg/L以下,而膜出水的则保持在50 mg/L以下,膜对上清液的COD去除率达50%,而对氮的去除没有贡献.可溶性细胞产物(SMP)在反应器内容易积累,停留足够的时间后能被生物降解.通过投加抑制剂测定耗氧呼吸速率,发现异养菌、硝化细菌和亚硝化细菌的活性由于F/M的降低和SMP积累受到一定的抑制,但不影响系统的处理效率.跨膜压力、膜面流速越大,通量衰减得也就越快.     

膜生物反应器在污水处理中的应用现状及展望

综述了膜生物反应器（MBR）的研究进展，介绍了其分类及特点、处理机理与MBR运行的影响因素以及膜污染的控制等，并概括了MBR的发展及展望。MBR是近来发展较迅速的一种污水治理设备，具有占地少、能耗低等优点，但也存在一定的缺点，其中膜污染是影响其推广应用的主要因素，目前国内外学者一般都以膜污染作为切入点进行研究，通过改变料液性质、优化操作参数、提高膜清洗效率等方法得以防治膜污染。     

气-水联合反冲洗膜污染防治技术研究

采用气水联合反冲洗技术,考察了气水比(Qg/Ql)、反冲洗周期及其对膜污染的防治效果。结果表明,气水联合反冲洗较单独气或水反冲洗效果好;在过滤周期20min,反冲洗时间1min,气水比1.5时,气水联合反冲洗能够恢复膜通量到膜清水通量的80%以上。此法可大幅度清除沉积在膜表面的泥饼层,恢复膜通量,维持膜过滤性能的稳定,是一种较为有效的膜污染防治技术。     

Investigation on the influence of methanol on adsorption and leaching of pesticides with soil column liquid chromatography

The effect of methanol of low concentration on adsorption and leaching of atrazine and tebuconazole was studied in this paper. The adsorption coefficients and the retardation factors (R^m) of pesticides on EUROSOIL 3# log-linearly decreased as volumetric fraction of methanol (f^c) was increased in the binary solvent mixtures of methanol and water. These data are consistent with solvophobic theory formerly outlined for describing the adsorption and transport of hydrophobic organic chemicals from mixed solvents. Nevertheless, the adsorption of these pesticides in soil–water system slightly increased when the soil was pre-washed with methanol in comparison with that pre-washed with water (pure water system). Furthermore, their adsorption coefficients were still higher in binary solvent systems with methanol of very low concentrations, i.e. f^c<0.03 for atrazine and f^c<0.01 for tebuconazole, than those in pure water system. The adsorption coefficients (logK^w) of atrazine and tebuconazole predicted by solvophobic theory were 0.5792 and 1.6525, respectively, and their experimental logK^w were 0.3701 and 1.6275 in pure water system. Obviously, the predicted logK^w of the two pesticides was higher than the experimental log K^w in pure water system. The predicted K^w and the retardation factor (R^w) in pure water system by solvophobic theory are thus possibly inaccurate.     

Fenton试剂在乳化液废水处理中的应用

用Fenton试剂处理乳化液废水，通过试剂在不同配比条件下对废水处理效果的实验比较，选择了最佳反应条件，废水处理后的COD测量结果表明，反应处理在实验室可行。