木浆造纸黑液活化磷矿矿浆生产普钙的研究

利用木浆造纸黑液活化磷矿矿浆,降低矿浆流动起点水分,既简化普钙生产流程,降低普钙生产成本,又能消除造纸黑液污染。试验结果表明：木浆造纸黑液活化磷矿矿浆最佳黑液投入量为0.027mL/g矿粉,当矿浆含水率控制在26％～28％之间时,矿浆粘度可降至0.70Pa·s以下,所生产的鲜钙能满足质量要求。为造纸黑液活化磷矿矿浆生产普钙提供了理论和技术依据     

精制氯化铵母液循环周期及其污染控制

在现有工艺条件下 ,精制氯化铵母液循环使用必有其限度 ,以此决定母液循环使用的周期性 ,并推导出母液循环周期的定量表达式 ,为其污染控制和现场环境执法提供便利。     

化学氧化法处理资源回收后的J-酸和吐氏酸染料中间体废液

萘系磺酸染料中间体Ｊ－酸和吐氏酸废母液经有用资源的回收后,尚须进行最终出水的达标处理．通过吐氏酸和Ｊ－酸废母液萃余液的后处理试验,确定了盐回收－混凝沉淀－化学氧化的达标处理工艺方案,并确定了相应的工艺参数．其中化学氧化采用Ｆｅｎｔｏｎ试剂（以双氧水作氧化剂,绿矾为催化剂）,在经济合理的投量范围内经２—４ｈ反应,萃余液ＣＯＤＣｒ去除率达８０％以上,最终出水ＣＯＤｃｒ在２００ｍｇ／Ｌ以下,满足有关工业废水排放标准．     

微气泡及其产生方式对活性污泥混合液性质的影响

微气泡曝气有助于强化氧传质过程,在废水好氧生物处理中具有潜在的应用优势;同时,微气泡及其产生方式可能对污泥混合液性质产生影响.本研究采用SPG膜微气泡发生系统研究了微气泡及其产生方式对污泥混合液性质的影响.结果表明,微气泡曝气中,微气泡附着于污泥絮体导致污泥上浮聚集,从而造成反应器中污泥浓度(MLSS)下降,以及污泥沉降性能变差.微气泡产生过程中,液体循环泵(离心型)产生的强水力剪切力作用于污泥混合液,造成污泥絮体破碎、污泥粒径减小以及污泥絮体EPS释放,进而使得上清液浊度和有机碳(特别是胶体有机碳)浓度升高,污泥絮体的再絮凝能力丧失.微气泡产生过程中,污泥破碎导致的污泥有机物的释放使得污泥混合液的黏度增加,但混合液表面张力保持不变.     

造纸黑液中木质素的提取和用作橡胶补强剂的研究

提出从碱法制备浆黑液中提取适合于用作橡胶补强剂的木质素的工艺路线,对３种沉淀剂作了比较,筛选出了化学改性剂,对木质素的含水率与其颗粒表面性质的关系作了研究,按此工艺制备的木质素可与硬碳黑并用,用作一般橡胶制品的补强剂。     

同时产甲烷反硝化与硝化串联工艺处理淀粉废水

采用UASB作为同时产甲烷反硝化反应器、AUSB作为好氧硝化反应器的串联工艺处理实际淀粉废水.结果表明:①将好氧反应器的出水硝化液按1:1～3:1的回流比回流到UASB反应器,可在其中实现同时产甲烷反硝化,进水有机(以COD计)负荷约为11kg·m-3·d-1时,COD去除率为95%;NO-3-N负荷可达0.48 kg·m-3·d-1,NO-3-N去除率高达100%.②UASB反应器的出水进入AUSB反应器,其有机负荷为0.5～2 5 kg·m-3·d-1,去除率为63%～91%;氨氮负荷为0.2～0.9 kg·m-3·d-1,去除率在98.8%以上.③串联工艺在回流比为1:1、2:1、3:1下,COD去除率分别为98.7%、98.3%、99.3%,总氮去除率分别为72.9%、76.3%、82.9%.④随着UASB反应器内进水硝酸盐负荷的增加,其颗粒污泥与接种污泥相比,粒径明显增加,平均密度先增加后减小,最大比产甲烷活性先降低,而后有较大提高.     

加盐蒸馏回收盐酸和混凝剂制备技术资源化利用盐酸酸洗废液

为了实现钢材酸洗废液的资源化,能够同时回收盐酸和铁盐,提出了加盐蒸馏回收盐酸与蒸馏母液制备聚铁混凝剂两段组合工艺相结合的技术.实验对质量浓度为9.28%的实际盐酸废液进行了研究,考察了添加盐的种类、盐的投加量和蒸馏量等因素对再生盐酸回收效果和聚铁混凝剂溶液混凝效果的影响.研究表明,氯盐可以明显改变氯化氢、水的相对挥发度,当CaCl2投加量为1 mol/L,体积蒸馏量在30%时,为此工艺的最佳条件.在此工艺条件下,再生盐酸质量浓度约22.3%;蒸馏母液制备得到的聚铁混凝剂溶液应用实验表明,对印染废水脱色效果良好.此工艺不仅实现了酸洗废液中残酸和铁离子的资源化利用,而且达到酸洗废液的零排放.     

草浆黑液碱回收方法的研究

研究了 2种不同的碱回收方法—隔膜电解法和物理化学法回收草浆黑液中残碱的可行性及处理效果 ,并进行了回收碱液蒸煮纸浆的实验。实验结果表明 ,两种回收方法均具有较高的碱回收率—分别达到 94%和 6 0 %以上 ,所制纸浆与原液浆比较性能也无明显差异 ,且 2种方法均有操作简便、设备一次性投资少、处理黑液效果较好等特点 ,为中小型造纸厂解决黑液污染问题提供了新的技术思路     

Detection of dioxygenase genes present in various activated sludge

GOAL, SCOPE AND BACKGROUND: Activated sludge from refineries contains various microorganisms that could utilize aromatics under aerobic conditions due to the oxygenase enzymes. Dioxygenase enzymes are oxygenases, which are involved in the ring cleavage step of aromatic hydrocarbons. In this study, the selected catabolic loci involved in ring cleavage have been monitored in the activated sludge samples at different time intervals. The investigation of the dioxygenase genes in the Effluent Treatment Plants (ETPs) and evaluation of their presence at different time points provides a clue for the aromatic utilizing potential of the inherent microbial flora. METHODS: The catabolic gene loci pheB, xylE, tod-isp, bed and nahG responsible for the enzymes catechol 1,2-dioxygenase, catechol 2,3-dioxygenase, toluene dioxygenase-iron-sulphur protein component, benzene dioxygenase and naphthalene dioxygenase were used respectively. The time dependent change in eubacterial population was demonstrated by the amplification of 16S rDNA product, followed by restriction digestion. The template DNA was obtained from the activated sludge collected from ETPs. The supporting physiological data for the overall performance of sludge was developed using respirometric analysis. The on-site COD and MLSS analysis for ETP was used in final evaluation. The study was carried out with samples collected from three different ETPs and also from a selected ETP at different time intervals. RESULTS AND DISCUSSION: The respirometric studies were carried out with phenol, catechol, toluene, and naphthalene to arrive at the target genotypes for further study by PCR protocol. The respirometric analysis coupled with the COD and MLSS analysis represented the physiological capacity of the various sludges. Initially, the tracking protocol was optimized by using different sludge samples, which were collected from refineries. The selected genotypes were amplified and their presence has been confirmed using Southern analysis. The gene loci tod-isp, bed and xylE were commonly observed at various time intervals of the sludge from the same source. The gene loci pheB and nahG were found to be relatively rare. CONCLUSION: The 16S rDNA PCR products after restriction digestion produced different DNA fingerprint patterns, suggesting that the microbial community composition was diverse in the three sources. Similarly, the presence of the catechol 2,3-dioxygenase, benzene dioxygenase and toluene dioxygenase genes confirmed the aromatic degrading potential in the various sludges. The probes could not pick the nahG and pheB genes. However, the respirometeric assay suggested that the oxidative capacity to use naphthalene as a substrate exists. RECOMMENDATION AND PERSPECTIVE: Our study of the diversity at various time points from the ETP provided an overview of the shifts of the catabolic composition of the sludge. This also depends on the influential parameters like the incoming pollutant level and the environmental conditions that are prevailing and often changing from time to time. The results of direct DNA extraction and PCR amplification do reflect the relative abundance of a particular catabolic genotype, which could be used to monitor the efficiency of treatment.     

从铜氨废液中回收铜

分别采用化学沉淀法和电解法从电镀污泥水热合成铁氧体后过滤分离的铜氨废液中回收铜。实验结果表明：采用化学沉淀法处理铜氨废液,以体积比为1：1的盐酸调节铜氨废液pH为5．4～6．4,沉淀出碱式氯化铜固体,铜回收率在98％以上,1L铜氨废液可回收碱式氯化铜5．83g（合铜3．50g）;采用电解法处理铜氨废液,在电流密度250A／m^2、电解时间5h、电解温度60℃的条件下,1L铜氨废液可回收3．54g铜粉,铜回收率超过99％,铜粉的粒径和纯度均可达到GB5246-85《电解铜粉》的要求。