186菌生物流化床处理甲醇废水

用三相生物流化床工艺处理甲醇废水COD_(cr)容积负荷达4.24～12.32kg/m~3·d,去除率达82.7％～93.1％;甲醇容积负荷达1.8～3.9kg/m~3·d,去除率达81.4％～98.1％。加186菌种后,甲醇的容积负荷可提高到3.02～3.36kg/m~3·d,COD_(cr)去除率可达到89.3～96.7％。     

颗粒活性炭对UASB处理垃圾渗滤液促进作用的研究

通过对比研究,考查了用UASB处理垃圾渗滤液时,投加颗粒活性炭对加速UASB反应器中污泥颗粒化进程、缩短启动时间、提高处理效果的影响。结果显示:启动时间缩短了近1/3,最大有机负荷提高近40%且出现了更大颗粒污泥,但COD去除效率没有明显提高。     

有机负荷和溶解氧的变化对SBR污泥膨胀的影响及控制方法

本文研究SBR工艺处理汽车电泳废水在不同有机负荷、溶解氧条件下污泥膨胀的现象 ,分析膨胀发生机理 ,分别提出控制方法。实验结果表明 ,在低、中、高负荷时 ,只要溶解氧发生变化 ,均有可能发生膨胀。低负荷、正常溶解氧时发生的膨胀可以通过前联好氧生物选择器加以控制 ;中负荷、低溶解氧及高负荷、低溶解氧活性污泥发生膨胀时可以通过强化曝气得到控制     

Purification and molecular weight distribution of a key exopolysaccharide component of Bacillus megaterium TF10

Extracellular polymeric substances (EPS) are organic metabolic compounds excreted by microorganisms. They largely impact microbial aggregate structures and functions. Extracellular polysaccharides (EP) in EPS are responsible for the formation of microbial aggregates. In this work, we successfully separated and characterized EP from EPS of the bacterium Bacillus megaterium TF10. Extraction of EP from EPS was optimized using Sevag''s reagent. Chemical characteristics, functional groups, and molecular weight (MW) distribu-tion of EP were compared with the harvested EPS and soluble microbial products (SMP). We found that the polymers of lower MW and free proteins were successfully removed by Sevag''s reagent. The higher MW components of EPS were predominantly polysaccharides, while the polymers of lower MW tended to secrete to the supernatant and were described as SMP. A part of the proteins in the EP was polysaccharide-bonded. Our results can be further used in elucidating the complex flocculation mechanisms in which EP play a major role.     

Characteristics of molecular weight distribution of dissolved organic matter in bromide-containing water and disinfection by-product formation properties during treatment processes

The characteristics of dissolved organic matter (DOM) and bromide ion concentration have a significant influence on the formation of disinfection by-products (DBPs). In order to identify the main DBP precursors, DOM was divided into five fractions based on molecular weight (MW), trihalomethane formation potential and haloacetic acid formation potential were determined for fractions, and the change in contents of different fractions and total DBPs during treatment processes (pre-chlorination, coagulation, sand filtration, disinfection) were studied. Moreover, the relationship between bromide concentration and DBP generation characteristics in processes was also analyzed. The results showed that the main DBP precursors were the fraction with MW < 1 kDa and fraction with MW 3−10 kDa, and the DBP''s generation ability of lower molecular weight DOM (< 10 kDa) was higher than that of higher molecular weight DOM. During different processes, pre-chlorination and disinfection had limited effect on removing organics but could alter the MW distribution, and coagulation and filtration could effectively remove organics with higher MW. For DBPs, trihalomethanes (THMs) were mainly generated in pre-chlorination and disinfection, while haloacetic acids (HAAs) were mostly generated during pre-chlorination; coagulation and sand filtration had little effect on THMs but resulted in a slight removal of HAAs. In addition, the results of ANOVA tests suggested that molecular sizes and treatment processes have significant influence on DBP formation. With increasing bromide concentration, the brominated DBPs significantly increased, but the bromine incorporation factor in the processes was basically consistent at each concentration.     

上海城市表土磁性特征对重金属污染的指示作用

选取上海市城市表土作为研究对象,结合磁学方法与传统化学方法,研究了上海市192件表土样品的磁性特征和重金属含量,并探讨了磁学参数指示重金属污染的可行性.结果表明,上海市表土磁化率平均值为187.66×10~(-8)m~3·kg~(-1),亚铁磁性矿物占主导地位,颗粒较粗.上海市表土重金属Zn、Pb、Cu、Cr、Ni、Mn、Fe含量均超过背景值,属于轻度污染.重金属和磁学参数(磁化率、饱和等温剩磁)具有相似的空间分布,高值集中在宝山区和闵行区,低值集中在崇明区.工业生产和交通活动是上海市表土重金属、磁性矿物的主要来源.磁化率χlf指示污染负荷指数的半定量结果为:χlf38.90×10~(-8)m~3·kg~(-1)时,土壤属于清洁状态,无污染;38.90×10~(-8)m~3·kg~(-1)≤χlf258.69×10~(-8)m~3·kg~(-1)时,土壤遭受轻度污染;258.69×10~(-8)m~3·kg~(-1)≤χlf793.45×10~(-8)m~3·kg~(-1)时,土壤遭受中度污染;χlf≥793.45×10~(-8)m~3·kg~(-1)时,土壤遭受重度污染.因此,磁学参数对城市表土重金属污染有着一定的指示意义.     

Ag/Cu3(BTC)2复合催化剂的制备及其NH3-SCR催化性能

采用紫外还原的方法成功制备出Cu₃（BTC）₂（均苯三甲酸合铜）负载贵金属Ag纳米颗粒的Ag/Cu₃（BTC）₂复合催化剂,并用于氨法脱硝反应.应用X射线衍射（XRD）、透射电子显微镜（TEM）、BET测试等手段对催化剂的物理化学性能进行了表征.结果发现Ag纳米颗粒以球状结构高度均匀分散在Cu₃（BTC）₂骨架结构的表面.负载Ag纳米颗粒和Cu-MOF的协同作用,提高了Ag/Cu₃（BTC）₂催化剂的脱硝效率,负载量为15wt%的催化剂表现出最优脱硝效率,在220～260℃达到100%的NO转化率.同时,利用in-situ FTIR技术对NH₃-SCR的反应机理进行了探究.     

煤质粉末活性炭自燃和热稳定性分析

针对煤质粉末活性炭最显著的热危险特性——自燃危险性进行试验。采用粉尘层最低着火温度测定系统对煤质粉末活性炭进行自燃试验,测定煤质粉末活性炭的最低着火温度;采用SDT Q600热重分析仪测定煤质粉末活性炭在氮气和空气气氛中以20℃/min的速率升温至700℃时的热解和燃烧特性,通过TG/DTG曲线计算其着火温度,并进行热稳定性评价。粉尘层自燃试验结果表明,煤质粉末活性炭最低着火温度为400℃,具有自燃危险性,易形成阴燃;氮气气氛中热解试验表明,热解过程经历了室温~120.0℃和280.0~700.0℃两次轻缓失重阶段,646.44℃时挥发分热失重速率最大,对应热失重速率峰值为0.082 6%/℃,自燃危险性较低;空气气氛中燃烧试验表明,燃烧过程经历了室温~95.5℃和300.0~600.0℃两次剧烈失重阶段,分别为吸附水分受热蒸发和氧化生成的有机官能团分解脱附导致,565.35℃时挥发分热失重速率最大,对应热失重速率峰值为13.20%/min,粉末较强的氧气吸附效应和较低的导热系数导致其自燃倾向较高,火灾危险性较大。     

区域污染源排污总量分配方案初探

文章以实现区域可持续发展为目标,对区域污染物排污总量的分配进行了初步探索,通过分析对其有影响的各种因素,最终为特定区域发展规划的制定,可持续发展的实现,提供了一种较好的污染物排污总量分配方案。     

生物渗滤池运行参数优化研究

实验针对间歇投配污水的生物渗滤池处理生活废水的一些基本运行参数进行了优化研究。通过对生物渗滤池的出水量、不同填料性质、不同填料粒径以及不同进水水质与污染物(COD)去除率影响的研究,证实该系统的水力负荷与污染物去除率成反向关系,即当水力负荷减少时,污染物去除率会相对增加;研究还表明选用粒径为0.9～2mm自然河沙作为系统填料时,系统COD去除率较高,这时填料不易被堵塞且即使堵塞也较易恢复;运用生物渗滤池处理城市生活污水能使处理后污水COD达到城镇污水处理厂出水排放标准的一级标准。提高污水中营养物质的配比以及采用多级生物渗滤池联用,能高效处理高浓度污水,甚至使出水达标排放。