废催化剂浸出规律的静态实验方法

利用静态浸出实验方法对废催化剂中重金属在不同固水比和浸出次数条件下的浸出规律进行了系统研究。实验发现浸出次数大于３次后,重金属的浸出浓度和浸出速率趋于稳定,同时固水比的增加也没有明显改变废催化剂中重金属的浸出。认为在浸取次数大于３次以后,随着表面溶质的溶解,浸出过程主要为内扩散所控制。     

Auto-adaptive Air Distribution and Structure Optimization of Ejector Burner for Biomass Alcohol Fuels

A plenty of studies on the utilization of biomass alcohol fuels have been conducted, but combustion efficiency and stability of this fuels still need to be improved. Based on biomass alcohol fuels (bio-methanol and bio-ethanol), this paper studied auto-adaptive air distribution characteristics and optimum structure parameters of an ejector burner by numerical simulation method. Also, an experiment was conducted to verify the numerical results. The results show that the mole air entrainment ratio (MAER) keeps almost constant when the ejector fuel nozzle exit locates at the segment between the ejector throat and the suction chamber entrance, but a bigger ratio α would lead to a higher MAER till the α is bigger than 8.5 for bio-methanol and 11.5 for bio-ethanol. The bio-ethanol fuel is more beneficial for air carrying role because of its big molecular weight. Operation pressure (P_w) has a little impact on MAER of the two fuels, but the rise of back pressure (P_b) would lead to rapid decrease of MAER for the two fuels. For the optimum structure burners, the MAER can be maintained at the value of theoretical complete combustion. Its changing rate is less than 2.3% for bio-methanol and 2.5% for bio-ethanol when the burner load changes from 30% to 120%, which is highly consistent with the experimental results. The optimum burner can distribute air supply automatically with the changing of burner load.     

Calibration and Verification of SWMM for Low Impact Development

The Storm Water Management Model was used to simulate runoff and nutrient export from a low impact development (LID) watershed and a watershed using traditional runoff controls. Predictions were compared to observed values. Uncalibrated simulations underpredicted weekly runoff volume and average peak flow rates from the multiple subcatchment LID watershed by over 80%; the single subcatchment traditional watershed had better predictions. Saturated hydraulic conductivity, Manning's n for swales, and initial soil moisture deficit were sensitive parameters. After calibration, prediction of total weekly runoff volume for the LID and traditional watersheds improved to within 12 and 5% of observed values, respectively. For the validation period, predicted total weekly runoff volumes for the LID and traditional watersheds were within 6 and 2% of observed values, respectively. Water quality simulation was less successful, Nash–Sutcliffe coefficients >0.5 for both calibration and validation periods were only achieved for prediction of total nitrogen export from the LID watershed. Simulation of a 100‐year, 24‐h storm resulted in a runoff coefficient of 0.46 for the LID watershed and 0.59 for the traditional watershed. Results suggest either calibration is needed to improve predictions for LID watersheds or expanded look‐up tables for Green–Ampt infiltration parameter values that account for compaction of urban soil and antecedent conditions are needed.     

菌根真菌侵染对植物生物量累积的影响

为了从生态系统尺度探讨菌根资源与植物生物量累积的关系,调查了鼎湖山不同成熟度的三个森林群落主要优势树种的菌根侵染情况.综合分析各森林群落优势树种的个体数、生物量和菌根侵染率发现：1）菌根侵染率与径向生长速率相关,植物生长迅速的阶段菌根侵染率更高.中径级（胸径15-30 cm）的马尾松（Pinus massoniana）和锥（Castanopsis chinensis）的侵染率比小径级（胸径1-15 cm）个体的侵染率高,而大径级个体（胸径30 cm 以上）的侵染率略低于中径级个体的侵染率.木荷（Schima superba）则表现出侵染率随着胸径增大而增高的趋势.2）树种在群落内的侵染率越高,其对群落生物量的贡献率越大.如马尾松在马尾松林和混交林的侵染率分别为（77.30±18.02）%和（40.50±14.42）%,其对马尾松林群落生物量的贡献率达到87.43%,是对混交林生物量贡献率（17.51%）的5 倍.混交林和阔叶林的共有优势树种锥的侵染率和生物量贡献率也有存在相同规律.3）根系碳储量占群落总碳储量比例较高的群落其优势树种平均侵染率相对较高.马尾松林、混交林和季风常绿阔叶林中,根系碳储量占群落总碳储量的比例分别为55%、54%、42%,群落优势树种平均侵染率分别为（66.73±10.55）%、（46.97±27.28）%、（54.22±25.45）%,马尾松林的根系碳储量和平均侵染率均高于混交林和季风常绿阔叶林.以上结果表明,菌根真菌侵染对于植物个体生长速率以及群落水平的生物量累积具有-定的促进作用.     

Production of N2O in two biologic nitrogen removal processes: a comparison between conventional and short-cut nitrogen removal processes

The N2O production in two nitrogen removal processes treating domestic wastewater was investigated in laboratory-scale aerobic-anoxic sequencing batch reactors （SBRs）. Results showed that N2O emission happened in the aerobic phase rather than in the anoxic phase. During the aerobic phase, the nitrogen conversion to N2O gas was 27.7% and 36.8% of NH＋-N loss for conventional biologic N-removal process and short-cut biologic N-removal process. The dissolved N2O was reduced to N2 in the anoxic denitrification phase. The N2O production rate increased with the increasing of nitrite concentration and ceased when NH＋-N oxidation was terminated. Higher nitrite accumulation resulted in higher NEO emission in the short-cut nitrogen removal process. Pulse-wise addition of 20 mg NO2 -N. L- 1 gave rise to 3-fold of N2O emission in the conventional N-removal process, while little change happened with 20 mg NOS-N L-1 was added to SBR1.     

Effects of mid-trimester induced abortion on the subsequent pregnancy

The outcome of the pregnancy following (a) a mid-trimester termination of pregnancy (TOP) for fetal neural tube defect (NTD) (77 women=group 1); (b) mid-trimester TOP for fetal Down's syndrome (13 women=group 2); (c) delivery of a baby with NTD (119 women=group 3) was studied. The prenatal fetal loss was relatively high in all groups. In group 1 it was similar to that found in other studies after first trimester TOP, in group 2 it was associated with advanced maternal age and the unexpected finding in group 3 was not attributable to advanced maternal age. It is suggested that a previous NTD per se might increase the risk of fetal loss in the next pregnancy. A previous mid-trimester TOP for NTD was not associated with an increase in premature labour, small for dates babies or congenital abnormality in the next pregnancy, but there was a slight increase in the number of babies weighing less than 2500 g.     

FeCl3改性MOFs在低温下对Hg0的吸附性能

为提高吸附剂对Hg0（零价汞）的吸附效率,利用MOFs（金属有机框架）材料发达的孔隙结构和高比表面积（1 997.010 0 m2/g）,采用FeCl₃溶液浸渍改性,制备了吸附剂FeCl₃@MIL-101（Cr）用于脱除Hg0.在小型固定床反应器上考察了浸渍浓度、反应温度、氧含量等对Hg0去除的影响.结果表明:FeCl₃@MIL-101（Cr）在进口ρ（Hg0）为2×10-3 mg/L,c（FeCl₃）为0.2 mol/L,反应温度60℃,气体流速400 mL/min,φ（O₂）为1%的条件下,吸附穿透时间长达62 h,相应的吸附容量为14.27 mg/g.在此基础上,进一步利用BET（比表面积测试）、SEM（扫描电镜）-EDX（能量色散X射线光谱）、XRD（X射线衍射）、XPS（X射线光电子能谱）等常用表征手段研究了改性前后吸附剂的物理化学特性,证明了吸附剂FeCl₃@MIL-101（Cr）吸附零价汞是物理吸附与化学吸附共同作用的结果,含氯官能团在吸附Hg0过程中也发挥了相当大的作用,并且氧气可促进其吸附效果.最后,分析了其吸附机理.研究显示,该种吸附剂在低温条件下具有较为优良的脱汞性能,应用前景良好.      

清洁生产在制药企业中的实施

清洁生产是一种全新的发展战略,是环境保护战略具有重大意义的创新,是工业发展的必然选择,对制药企业清洁生产由为重要.随着企业不断的发展,生产规模不断的扩大,污水处理厂的能力接近饱和,已没有扩展的空间,这时,清洁生产由为重要,势在必行.     

改性沸石对焦化废水中COD的去除研究

本文研究了沸石经NaCl、NaOH、HDTMA(溴化十六烷基三甲胺)改性后对焦化废水中的COD的去除效果.比较得出HDTMA改性沸石对COD的去除能力较好,而且废水的色度明显减小.接着进一步研究了该废水处理过程中的影响因素,包括吸附时间、烘干温度、改性剂HDTMA的浓度、pH值等.结果表明,HDTMA改性沸石处理焦化废水可使其COD的浓度降低至150mg/L以下,这到污水综合排放二级标准.     

HA-SBR法在制药废水中的应用

介绍SBR法在制药废水中的应用及工艺流程.通过处理COD从3600mg/l降到130mg/l.COD总去除率达到96%,出水可以达标排放.